133.50EUR

Rainbow Autogyro
[MEGARAIN]



Aut. Rainbow con 4 palas

Aut. Rainbow con 4 palas

Aut. Rainbow con 4 palas

Aut. Rainbow con 3 palas

Aut. Rainbow con 3 palas

Aut. Rainbow con 3 palas
Autogyro was first built in 1923 by Spanish engineer Juan de la Cierva. Its development went on during thirties and in Second World War II was used in armies usually for observation purposes. In Czechoslovakia was then flown by Bata company.
Autogyro model RAINBOW is designed for model builders who has basic experiences with motor modelc comntrolled by elevator and rudder (or ailerons). No problems with starts form hand or grassy field. Landing si easy even with autogyro flying only with autorotation. Thanks to relatively big rotor diameter is flying very straightforward. In the air you can handle situations in which other models would be practically lost. Side movements of autogyro RAINBOW are made by rotor tilt. Elevator works well in the whole range of speeds and in autorotation mode allows almost vertical and very slow landing. For trasportation of autogyro it is possible to turn rotor blades back over the airframe (by slackening of two blade bolts)
Flying time varies from 10 to 20 minutes (battery 3xLion,1350mAh , motor MEGA RC 400/15/7, propeller APC10x5 E). You can use rechargeable batteries with both higher or lower capacity.
It is absolutely necessary to take off and land against the wind!

Available Options:

Combos:



temporarily out of stock
temporarily out of stock

Reviews

Customers who bought this product also purchased
3 blades set
3 blades set

temporarily out of stock
temporarily out of stock

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Conector MR-60 (pareja)
1 x Extension MPX-MPX 20 cm
1 x Servo GO-1035MG 16 kg.cm 0.08s/60º
1 x Starter EM Gear Power 80
1 x Crimping tool
1 x Angled clevis with threaded rod M3
2 x Clevis plastico I=30 mm / hole 2.5mm / pin 1 (2 pcs)
1 x Kwik link AL M2,5 L:23 mm (2 pcs) + Pin Ø 1,6 mm
1 x Threaded coupler Micro M2 Ø 0,8 mm (10 pcs)
1 x Circlik for shaft 1.2 mm (10 pcs)
1 x Angle of incidence meter
1 x Extension 100 cm (Futaba)
1 x Cable-Tie 1.66x71mm / 0.07x2.8″ (20 pcs)
1 x Universal Colour Paste signal white (RAL 9003) 1 Kg
1 x Rotorshape Autogyro
1 x AC-10 pre-rotacion with motor
1 x Blade Holder Full (4 blades)
1 x DPSI magnetic switch actuator (PCB)
1 x Epoxy adhesivo Elan-tech ADH 981.892 50ml (dark grey)
1 x SINGLE FUELING VALVE GASOLINE MK2 SMALL
1 x Racor 2/3 mm
1 x SERVO HOLDER
1 x Sandwich carbon + poplar 3mm + carbon 480x290 mm
1 x FALCON 20X9 CARBON PROPELLER (GAS)
1 x Propeller POWER-PROP 13x9 Izda
1 x Pulley brass 5/1,5 (2 pcs)
1 x Wire easy tensioner (red)
1 x wire tensioner (red)
1 x Soporte grifo FESTO vertical (1 pcs)
1 x Threaded coupler M2,5 (10 pcs)
1 x Z type of cable coupler Ø 2 (2 uds)
1 x Clevis plastico I=26 mm / hole 2mm / pin 1 (2 pcs)
2 x Pulley brass 8/2 (2 pcs)
1 x Threaded coupler M2 (10 pcs)
1 x Ø 2,5 mm pin for Kwik link MPJ2170/2173 (6 pcs)
1 x Soporte filtro FESTO (4 pcs)
1 x Set clevis for pull-pull (TY13233 & TY13234)
1 x Cable coupler M3 (10 uds)
1 x GM Propellers Spinner Scale ø 40mm Diameter, Motor shaft ø 6mm C
1 x Aluminium Hub for folding Props 37 mm M8 Shaft 5 mm
1 x Ø 1,6 mm pin for Kwik link MPJ2150/2157 (6 pcs)
1 x Spinner propeller pleg. 36 mm / 6,0 mm
1 x Aluminium Hub for folding Props 43 mm M8 Shaft 5 mm
1 x Pulley brass 10/2 (2 pcs)
1 x Support Pitot JETI
1 x Support conector MPX (6 pcs)
1 x Spinner propeller pleg. 38 mm/6,0 mm/7º
1 x Stainless steel 4 m Pull-Pull complet set (max 20 kg)
1 x Round Rod 1.0x3.5 cm
1 x Support ECU Xicoy X-45
1 x Turnbuckle M2x29/43 (2pcs)
1 x Wire easy tensioner (silver)
1 x Ø 1,6 mm pin for Kwik link MPJ2160/2161 (6 pcs)
1 x Spinner propeller pleg. 30 mm/6,0 mm/0º
1 x Spinner propeller pleg. 40 mm / 6,0 mm "Z" carbon
1 x Z type of cable coupler Ø 1.8 (2 uds)
1 x Porta Kwik link M4 3 mm (2 pcs)
1 x Pulley brass 2,5/1 (2 pcs)
1 x wire tensioner (blue)
1 x Spinner propeller pleg. 28 mm/5,0 mm
1 x Micro clevis (10 uds)
1 x Spinner propeller pleg. 42 mm/6,0 mm/0º
1 x Porta Kwik link M3 3 mm (2 pcs)
1 x 0,14 mm PVC servo wire extension, ZH micro conector.
1 x Extension 30 cm (Futaba)
1 x Cabel "Y" 30 cm (Futaba)
1 x Extension silicon 35 cm (Futaba)
1 x Extension silicon 35 cm male (Futaba)
1 x Extension PVC 150 cm (Graupner)
1 x Keypad ALTIS V4
1 x Carbon fibre tape 125 g/m², 3k, UD (25 mm) roll/ 50 m
1 x Release wax 250ml
1 x AIREX® Sheets C 70.55 (YELLOW) 1200x550x1.2 mm (10 pcs)
1 x 1/12 Pilot "Langley"
1 x 102x26 Ø6.0 mm aluminium core wheel
1 x 200 mm extensión servo HITEC/JR
1 x 20x200 mm battery rings
1 x 100x50 mm SLH KOVO wheel
1 x 102 mm aluminium spinner
1,691.38EUR
Manufacturers
Manufacturer Info
Mega Motor
Mega Motor Homepage
Other products
Languages
Español English
Currencies