| 1 x | Aluminum Bayonet / strongal D12 mm / 0.5 m |
| 2 x | Wing-connector: Glass / Carbon tube (26.5/25 x 25/23) x 1000 mm |
| 1 x | Aluminum Bayonet / strongal D25 mm / 1 m |
| 1 x | TrainerCord (master-learner) |
| 1 x | Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm) |
| 1 x | CC 03 |
| 1 x | CM-3 |
| 1 x | 5 LiPo XH>EH adapter |
| 1 x | CC 05 |
| 1 x | "Y" charging 4mm wire (2 IN-1 OUT). |
| 1 x | JETImodel SINGLE BEC |
| 1 x | Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH |
| 2 x | 3 LiPo XH>EH adapter |
| 1 x | Futaba External voltage input cable Futaba CA-RVIN-700 |
| 1 x | TP/TopFuel - JST-EH 4/5S Adapter |
| 1 x | Bec MR UBEC 5A (5v/6v/7v) |
| 1 x | 30 cm BEC cable (male) |
| 1 x | 2 LiPo XH>EH adapter |
| 1 x | Balanceradapter JST-XH (Heli 47G) 2-6 c. |
| 1 x | CellPRO 4S Adaptader (GP/KO up to 4S) |
| 1 x | Balance "Y" Wire 6S, 2x JST-XH / 1x JST-EH |
| 1 x | Circlick securite |
| 1 x | Dean "T" - Futaba Adapter |
| 1 x | Adapter lead MPX/EC3 |
| 1 x | BEC 3A FOXY |
| 1 x | Ply-Span 450x600/13g Orange |
| 1 x | Vacuum pump P1-N |
| 1 x | Crimping tool |
| 1 x | ABS tube 5.0x3.0x1000 mm |
| 1 x | T-Connector 4.0 mm x 1000 mm |
| 1 x | ABS angle 5,0x5,0x1000 mm |
| 1 x | Camera Sony 4140+673 CCD with Built-in 200mw TX + antenna |
| 2 x | SCHARNHORST Battleship 1:200 |
| 2 x | SCHARNHORST accessories |
| 1 x | 14 mm portholes (10 pcs) |
| 1 x | Tapa estado carga XT-60 (6 pcs) |
| 1 x | 29,0 mm propeller (left propeller) |
| 1 x | 36,0 mm propeller (rigth propeller) |
| 1 x | 290 mm M4 7/8x212 mm shaft ship |
| 1 x | 290 mm M4/M4 6.0x4.0 mm shaft ship |
| 2 x | Support ECU Xicoy X-45 |
| 1 x | Support XT60 conector (2 pcs) |
| 1 x | 39,0 mm propeller (rigth propeller) |
| 2 x | Support conector MPX (6 pcs) |
| 1 x | 33,0 mm propeller (left propeller) |
| 1 x | 10 mm portholes (10 pcs) |
| 1 x | 38 mm fenders (10 pcs) |
| 1 x | 28 mm turnbuckle |
| 2 x | Support FUEL DOT V3 |
| 1 x | Support Pitot JETI |
| 1 x | Flat washer 3.2 mm (20 pcs) |
| 1 x | Lock washer 3.2 mm (20 pcs) |
| 1 x | LED blink wire flashing (green - 2pcs) |
| 1 x | NF-3X-80 liner Kit |
| 1 x | LED blink wire flashing (blue - 2pcs) |
| 1 x | Circlik for shaft 3.2 mm (10 pcs) |
| 1 x | Flat washer 2.2 mm (20 pcs) |
| 1 x | Blind nut M8 (10 pcs) |
| 1 x | Fast attachment for servos (25 pcs) |
| 1 x | Lock nut M2 (20 pcs) |
| 1 x | Jet Afterburner Simulator NF-Jet1RY Set |
| 1 x | LED lighting system High Power |
| 1 x | LED wire (orange - 2pcs) |
| 1 x | NF-1 RC set |
| 1 x | LED wire (blue - 2pcs) |
| 1 x | Jet Afterburner Simulator NF-Jet3 YSW |
| 1 x | Jet Afterburner Simulator NF-Jet2YY Set |
| 1 x | Jet Afterburner Simulator NF-Jet4 RY |
| 1 x | LED wire (rojo - 2pcs) |
| 1 x | MPS Gas-Cap-Powerswitch |
| 1 x | Red copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | UBEC 6A KAVAN |
| 1 x | wing/fuselage connector for 6 pines AWG 20-24 (without pines) |
| 1 x | TP/TopFuel - XH 2/3S Adapter |
| 1 x | 4 LiPo XH>EH adapter |
| 1 x | Connector Sub-D 2+5 Female |
| 1 x | CC 01 |
| 1 x | Servo slow down unit (0,7-14,7 sec ) |
| 1 x | Interruptor RX/Batterie |
| 1 x | Pins M connect Multipin connectors AWG 20-24 |
| 1 x | Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm) |
| 1 x | Three-position switched channel, short |
| 1 x | Long Switch On/Off micro |
| 1 x | PWC4 wing/fuselage connector for 4 servos |
| 1 x | Connector CAN 15 |
| 2 x | Tirpiz Battleship 1:200 |
| 1 x | 42,0 mm propeller (left propeller) |
| 1 x | 120x60 mm SLH KOVO wheel |
| 1 x | La Capitania di Venetia 1:50 |
| 1 x | 25,0 mm 3-BL M4 hydro-propeller (left hydropropeller) |
| 1 x | 33,0 mm propeller (rigth propeller) |
| 1 x | 290 mm M5 Prop shaft |
| 1 x | 3 mm Leader (L 100 mm) |
| 1 x | wooden stairs (kit) 70 mm |
| 1 x | Anchor of tow Met. 60 mm |
| 1 x | Brass wire 0.5 mm (25 m) |
| 1 x | Axial ball bearing Ø 5 mm |
| 1 x | Regulador Actro-Marine 80A |
| 1 x | Spare Shaft Ø6mm L:450mm M5 |
| 1 x | 261 mm M4/M4 6.0x4.0 mm shaft ship |
| 1 x | Rudder 107-06 |
| 1 x | 10 mm dogdrive props |
| 1 x | Aro pasacable Ø20 mm (4 pcs) |
| 1 x | Dingi Pl. 26 mm (5 pcs) |
| 1 x | Spare Shaft Ø4mm L:450x23mm M4 |
| 1 x | Cleat 20 mm (2 pcs) |
| 1 x | 25 mm fenders (10 pcs) |
| 1 x | Block 21x19 mm (5 pcs) |
| 1 x | Cabestrante 13 x12 mm (5 pcs) |
| 1 x | Boat with oars 110 mm |
| 1 x | Motor A200-8 |
| 1 x | Motor A50-10L Turnado V3 Glider |
| 1 x | Sandwich carbon + poplar 2mm + carbon 480x290 mm |
| 1 x | MAMBO 17 |
| 1 x | KIRA 480-38 5,2:1 |
| 1 x | P 17×5.8 Prop-2PCS/PAIR |
| 1 x | Socket Head Screw M2,5x12 |
| 1 x | Propeller set 400 (2R+2L) |
| 1 x | Socket Head Screw M2x12 |
| 1 x | Spinner fixed propeller 60 mm / 5,0 mm |
| 1 x | Electronic fog horn |
| 1 x | Fueraborda RETRO |
| 1 x | Axle for motor A30-XL V2 |
| 1 x | AXI 2826/12 V2 Long |
| 1 x | AXI 2820/14 V2 Long |
| 1 x | AXI 2820/8 V2 Long |
| 1 x | AXI 2826/12 V2 |
| 1 x | Motor A200-6 |
| 1 x | Motor A30-10 XL V4 |
| 1 x | Motor A20-22 L EVO |
| 1 x | Motor A20-26 M EVO |
| 1 x | AXI 2217/16 V2 Long |
| 1 x | AXI 2814/16 V2 |
| 1 x | KIRA 400-39 5,2:1 |
| 1 x | KIRA 500-26 6,7:1 |
| 1 x | KIRA 500-36 6,7:1 |
| 1 x | KIRA 480-34 |
| 1 x | VIPER JET 2.2m + Electric landig Gear Deco: 01 Red-Blac-kWhit |
| 1 x | Jet Afterburner Simulator NF-Jet3 RY |
 |
| 11,467.23EUR |
