| 1 x | Electric spoiler 250 mm (2 pcs) |
| 1 x | Stainless steel cable Ø 0.5 mm (10 m) |
| 1 x | Vertical cockpit anchor "tipe F3A" (2 pcs) |
| 1 x | Crimping sleeves for cable 0.85 mm (10 pcs) |
| 1 x | Stainless steel cable Ø 0.62 mm (10 m) |
| 1 x | Canopy Lock V1 M3 Red (2 pcs) |
| 1 x | Steering arm 12 mm Ø 4 mm (2 uds) |
| 2 x | Stainless steel cable Ø 0.5 mm (2 m) |
| 1 x | Steering arm 12 mm Ø 3 mm (2 uds) |
| 1 x | Cap closure 33/23.5mm (2 uds) |
| 1 x | Extinguisher CO2 - 2 Kg |
| 1 x | One touch canopy lock |
| 1 x | Crimping sleeves for cable 1.3 mm (10 pcs) |
| 1 x | SUS wire 3m (nylon coated) |
| 1 x | L cockpit anchor "tipe F3A" (2 pcs) |
| 2 x | Locking cable tie 4.6x203 (uds) |
| 1 x | Stainless steel cable Ø 1.3 mm (10 m) |
| 1 x | Steering arm 16 mm Ø 4 mm |
| 1 x | Cockpit plastic closing |
| 1 x | Screw-lock pushrod conn snap Ø 1.5 mm (2 uds) |
| 1 x | Steering arm 12 mm Ø 4 mm |
| 1 x | Cabin latch Fox MDM1 4m (pair) |
| 1 x | Thixotropic agent TM 100, tin/ 75 g (approx. 1 l) |
| 1 x | Cotton Flocks, bag/ 500 g |
| 1 x | Thixotropic agent TM 100, tin/ 415 g (approx. 5 l) |
| 1 x | Glass Bubbles 0.19 g/cm³ Panda, tin/ 120 g (approx. 1 l) |
| 1 x | RUDDOG Protection and Heat Shield Tape (2mx50mm) |
| 1 x | SE Ring 450 mm (2 pcs) |
| 1 x | Softshell Hispano Aviación |
| 1 x | SE Ring 330 mm (4 pcs) |
| 1 x | SE Ring 240 mm (2 pcs) |
| 1 x | Epoxy SLOW-CURE™ 30 min (130g) |
| 1 x | Epoxy MID-CURE™ 15 min (130g) |
| 1 x | DUPLEX 2.4EX Central Box 210 |
| 1 x | Propeller POWER-PROP 14x9 |
| 1 x | Propeller APC 14x8.5 Electric Pusher |
| 1 x | FALCON 20X9 CARBON PROPELLER (GAS) |
| 2 x | Straightened rod Ø 14.0 mm x 1000 mm |
| 2 x | Propeller POWER-PROP 13x9 Izda |
| 1 x | LASER 73" 1.85m (05) PILOT |
| 1 x | Propeller POWER-PROP 14x9 Izda |
| 1 x | Socket head ball link M3 (2 uds) |
| 1 x | 1/12 Pilot "Langley" |
| 1 x | ABS Strip 1.5x6.0x1000 mm |
| 1 x | Para-RC Trike "RC-Bullix" |
| 1 x | Ferrita 27x14x7 mm |
| 1 x | Extension silicon 30 cm female (Futaba) |
| 1 x | Glases Stratus |
| 1 x | Oracover Yellow CADMIO 2 m |
| 1 x | Monokote BLANCO jet (1.8x0.65m) |
| 1 x | Soporte grifo FESTO (2 pcs) |
| 1 x | Wing bolts M6 Steel screw Red (2 pcs) |
| 1 x | Cierre cabina aluminio Ø5, I=16 mm |
| 2 x | Tube support Ø 6mm (10 pcs) |
| 1 x | 45 mm rods + T patellas set for direction control |
| 1 x | Stainless steel cable Ø 0.5 mm (20 m) |
| 1 x | Locking cable tie 3.2x142 (uds) |
| 1 x | Support Pitot JETI |
| 1 x | Support conector MPX (6 pcs) |
| 1 x | Fully Threaded Steel Rod alumin 90 mm M3 (2 pcs) knurled |
| 1 x | Prop Shaft Adapter 5 mm "long" |
| 1 x | Fully Threaded Steel Rod SUS303 65 mm M3 (2 pcs) |
| 1 x | Fully Threaded Steel Rod SUS303 70mm M3 (2 pcs) |
| 1 x | Fully Threaded Steel Rod alumin 60 mm M2,5 (2 pcs) |
| 2 x | Wheel collar 6 mm Ø (4 uds) |
| 1 x | 5 mm Prop Adapter CN-Spinner |
| 2 x | Cable tie mounts 4.3 (4 uds) |
| 2 x | Prop Shaft Adapter 8 mm/M12 "long" |
| 1 x | Prop Shaft Adapter 6 mm/M8 "long" 35 mm |
| 1 x | Fully Threaded Steel Rod Duralumin 90 mm M3 (2 pcs) |
| 1 x | Fully Threaded Steel Rod alumin 30 mm M2,5 (2 pcs) |
| 1 x | Fully Threaded Steel Rod alumin 60 mm M3 (2 pcs) knurled |
| 1 x | Fully Threaded Steel Rod Duralumin 100 mm M3 (2 pcs) |
| 1 x | Fully Threaded Steel Rod alumin 60 mm M3 (2 pcs) |
| 1 x | M2-250 mm Carbon Fiber Adjustable Push Rod Sets (2 pcs) |
| 1 x | Allen wheel collar M3x3 |
| 1 x | Wheel collar 3 mm Ø (4 uds) |
| 1 x | Wheel collar 3.5 mm Ø (4 uds) |
| 1 x | 5 mm Prop Adapter M8 |
| 1 x | Fully Threaded Steel Rod Duralumin 34 mm M3 (2 pcs) |
| 1 x | Fully Threaded Steel Rod alumin 100 mm M3 (2 pcs) |
| 1 x | Aluminun wheel collar 3 mm Ø (4 uds) |
| 1 x | |
| 1 x | 500 ml sealer (DOPE) |
| 1 x | Spray adhesive AEROFIX 2 |
| 1 x | GlassBubbles 2.5 g/cm³ Panda, tin (approx. 1 l) |
| 1 x | Horizontal cockpit anchor "tipe F3A" (2 pcs) |
| 1 x | |
| 2 x | 2 mm female connector (2 pcs) with safety connector |
| 1 x | XH female balance (2S) connector (2 pcs) |
| 1 x | XT-60 connector (female) |
| 1 x | MR30 connector female |
| 1 x | Red 4 mm connector holder |
| 1 x | XH female balance (8S) connector (2 pcs) |
| 1 x | Soporte carbono MR30 (2 pcs) |
| 1 x | XH male balance (4S) connector (2 pcs) |
| 1 x | Connectors MPX black female |
| 1 x | Connectors DEANS (T) micro |
| 2 x | Conector XT-30 (hembra) |
| 1 x | Connector CAN 15 |
| 1 x | Banna gold connector 2,5 mm (M/F) |
| 1 x | Connectors banna oro 2 mm (M/F) |
| 1 x | 2 mm male connector (2 pcs) with safety connector |
| 1 x | Hard aluminium thin-walled tube with fibreglass case ø30x1mm, 1m |
| 1 x | Tube Pitot to PIXHAWK |
| 1 x | Silent-blocks DLE 170M |
| 1 x | Prolongador S-Bus JR/JR 20cm |
| 1 x | ANGEL 48" pp red/blue/white |
| 1 x | Epoxy SLOW-CURE™ 30 min (260g) |
| 1 x | MR30 connector male |
| 1 x | Rotor Mast |
| 1 x | Washer 2.2×4 |
| 1 x | Head lower part |
| 1 x | Head runner |
| 1 x | Raer wall |
| 1 x | XT-60 connector (male) |
| 1 x | Racor 2/3 mm |
| 1 x | SERVO HOLDER |
| 1 x | Epoxy adhesivo Elan-tech ADH 981.892 50ml (dark grey) |
| 1 x | Silicone adhesive ELASTOSIL® E4, tube/ 90 ml |
| 1 x | Partall paste 650 g |
| 1 x | Aluminum Bayonet / strongal D25 mm / 1 m |
| 1 x | Support Filtro FESTO |
| 1 x | Pasacables rectangular 40x15 mm (4 pcs) |
| 1 x | Axle for motor A30-XL V2 |
| 1 x | Motor A30-14 M V2 6 Poles |
| 1 x | Motor A30-10 XL V4 |
| 1 x | Cable grommet Ø 6.4 mm (4 uds) |
| 1 x | Support Antena 2.4 Ghz (2 pcs) |
| 1 x | Recessed MPX connector support (6 pcs) |
| 1 x | Angle support XT60 conector |
| 1 x | Spinner fixed propeller 60 mm / 5,0 mm |
| 1 x | Support pumb/filter Xicoy X45 |
| 1 x | Motor A20-20 L EVO |
| 1 x | Axi for motor A40-L Motor 8-Pole-Electric Turbine |
| 1 x | Motor A40-10 L V2 14-Pole Glider |
| 1 x | Motor A30-14 L V4 |
| 1 x | Shaft for A60-XS-V2 (112,5mm) |
| 1 x | Motor A60-7XS V4 28-pole kv330 |
| 1 x | Motor DLE 430 cc - Paramotors |
| 2 x | 10 mm Prop Adapter M12 |
| 1 x | 3,2 mm Prop Adapter M6 |
| 2 x | 3,2 mm Prop Adapter M6 |
| 1 x | 2 mm Prop Adapter M6 |
| 1 x | Motor A30-12 L V4 |
| 1 x | Motor A200-6 |
| 1 x | 5 mm Prop Adapter M8 |
| 1 x | Wheel collar 2 mm Ø (4 uds) |
| 1 x | 2,3 mm Prop Adapter M6 |
| 1 x | Aluminun wheel collar 5 mm Ø (4 uds) |
| 1 x | 3,2 mm Prop Adapter M8 |
| 1 x | Fully Threaded Steel Rod alumin 40 mm M2,5 (2 pcs) |
| 1 x | 41x5,5 mm wires output (2 pcs) |
| 1 x | 6 mm Prop Adapter M8 |
| 1 x | BEC extension JIVE |
| 1 x | Adapter SPEED 480 |
| 1 x | Canopy Latch |
| 1 x | FAN KOSMIK |
| 1 x | JIVE 120+HV Esc |
| 1 x | Conector XT-30 (macho) |
| 1 x | Conector JR Servo female (10 pcs) |
| 1 x | Connectors banna oro 4 mm (M/F) (ultralight) |
| 1 x | Conector JR Servo female (50 pcs) |
| 1 x | Blade holder lower |
| 1 x | Rotorshape Elevator |
| 1 x | DRIVE 550 (KIRA 500-26 6,7:1 + KOBY 55 LV) |
| 1 x | KIRA 600-17 |
| 1 x | Esc KOSMIK 210 HV-I COOL |
| 1 x | Conector JR Servo male (10 pcs) |
| 1 x | Conector FUTABA Servo female (10 pcs) |
| 1 x | Conector XT-150 6mm (Set: 5 pares) |
| 1 x | Conector JR/Uni Servo female BLUE silicon (10 pcs) |
| 1 x | Conector JR Servo male (50 pcs) |
| 1 x | Prop Shaft Adapter 5 mm/M8 "long" |
| 1 x | 30 cm DEANS female connector |
 |
| 11,960.31EUR |
