| 1 x | ALU servo arm 90º 3 mm shaft |
| 1 x | ALU servo arm 3 mm shaft |
| 1 x | "L" servo arm 65x49 mm (2 pcs) |
| 1 x | ALU double servo arm 3 mm shaft |
| 1 x | Steering arm 12 mm Ø 4 mm (2 uds) |
| 1 x | Cierre cabina aluminio Ø5, I=16 mm |
| 1 x | Stainless steel cable Ø 0.5 mm (2 m) |
| 1 x | L cockpit anchor "tipe F3A" (2 pcs) |
| 2 x | Steering arm 16 mm Ø 3 mm |
| 1 x | SUS wire 3m (nylon coated) |
| 2 x | Stainless steel cable Ø 0.62 mm (10 m) |
| 1 x | Cap closure 33/23.5mm (2 uds) |
| 1 x | Canopy Lock V1 M3 Blue (2 pcs) |
| 1 x | One touch canopy lock |
| 1 x | Cierre cabina aluminio Ø4, I=10 mm |
| 1 x | Horizontal cockpit anchor "tipe F3A" (2 pcs) |
| 2 x | Screw-lock connector Ø 2 mm (2 uds) |
| 1 x | Screw-lock connector M2 (2 uds) |
| 1 x | Electric spoiler 250 mm (2 pcs) |
| 2 x | Conector MR-60 (pareja) |
| 1 x | Covered closure or fairings |
| 1 x | Steering arm 12 mm Ø 3 mm (2 uds) |
| 1 x | Locking cable tie 2.5x100 (uds) |
| 1 x | Steering arm 12 mm Ø 4 mm |
| 2 x | Crimping sleeves for cable 0.85 mm (10 pcs) |
| 2 x | Screw-lock pushrod conn snap Ø 1.5 mm (2 uds) |
| 1 x | Extension MPX-MPX 20 cm |
| 1 x | Stainless steel cable Ø 0.5 mm (10 m) |
| 1 x | Starter EM Gear Power 80 |
| 1 x | 800TVL CMOS camera for FPV |
| 1 x | Carbon fiber rod 1.5 mm x 2000 mm |
| 1 x | Carbon fiber rod 12 mm x 1000 mm |
| 1 x | Carbon fiber rod 2.5 mmx1000 mm |
| 1 x | Carbon fiber rod 8.0 mmx1000 mm |
| 1 x | Carbon fiber rod 4.0 mmx1000 mm |
| 1 x | Big-Malibu XL Roof box with surfboard rack GREY |
| 1 x | Red smoke canister 65 g |
| 1 x | Parachutist |
| 1 x | Green smoke canister 140 g |
| 1 x | ABS tube 9.0x7.0x1000 mm |
| 1 x | Silicone 0,35 qmm servos wire Futaba (100 m) |
| 1 x | Walnut wood slat 3.0x3.0x1000 mm |
| 1 x | Circlik for shaft 2.3 mm (10 pcs) |
| 2 x | DYMOND VTX UBS Programming adapter |
| 1 x | Support pumb/filter Xicoy X45 |
| 1 x | Aro pasacable Ø20 mm (4 pcs) |
| 1 x | Soporte filtro FESTO (4 pcs) |
| 1 x | Support XT60 conector (2 pcs) |
| 1 x | Tip wing protector 30x10 (2 pcs) |
| 1 x | Cable grommet Ø 4 mm (4 uds) |
| 1 x | Wheel collar 6 mm Ø (4 uds) |
| 1 x | Cable grommet 9.5 mm (4 uds) |
| 1 x | Window mounting channel Type H 2.5x0.5 (2 m) |
| 1 x | Cockpit aluminium closing |
| 1 x | Split pin 1.6x16 mm (10 uds) |
| 1 x | Cable grommet Ø 6.4 mm (4 uds) |
| 1 x | Landing gear frontal support 25x32x16 |
| 1 x | Tip wing protector 40x14 (2 pcs) |
| 1 x | 90 mm rods + T patellas set for direction control |
| 1 x | 11 mm Rubber pads (14 pcs) |
| 1 x | Servo GO-1013 MG 3.8kg |
| 1 x | Allen wheel collar M4x6 |
| 1 x | 45 mm rods + T patellas set for direction control |
| 1 x | Servo GO-1017MG 4.5 kg.cm 0.10s/60º |
| 2 x | Tip wing protector 28x10x12 (2 pcs) |
| 1 x | Servo GO-1081 MG 45 kg.cm 0.085s/60º |
| 1 x | Brazo servo KAVAN doble aluminio 25T - 2.5" M3 |
| 1 x | Pushrod greyline 4/3 with coupler M3 |
| 1 x | Triple rod con. 3mm Pushrod (2 pcs) |
| 1 x | Aluminun wheel collar 6 mm Ø (4 uds) |
| 1 x | Fully Threaded Steel Rod Duralumin 70 mm M3 (2 pcs) |
| 1 x | 10-15mm Servo Arm HITEC |
| 1 x | Servo KST X10 MINI wing 10mm 23g 7.5Kg |
| 1 x | Brazo servo aluminio 1.25/1.5" Futaba/MKS/Savox |
| 1 x | Crimping sleeves for cable 0.70 mm (10 pcs) |
| 1 x | Servo KST BLS815 HV V2.0 Servo 20mm 70g 20Kg |
| 1 x | Allen wheel collar M3x5 |
| 1 x | Fully Threaded Steel Rod alumin 100 mm M3 (2 pcs) |
| 1 x | 7 Servo SET 9g DS MG + Full servo extension cable set for Avanti |
| 1 x | Stainless steel cable Ø 0.5 mm (20 m) |
| 2 x | Snap pin for micro clevis (10 uds) |
| 1 x | Stainless steel cable Ø 0.52 mm - 15 kp (10 m) |
| 1 x | Fully Threaded Steel Rod SUS303 70mm M3 (2 pcs) |
| 1 x | TX 250 mW especial GOPRO |
| 1 x | SSPS105 Super Hi-Power servo |
| 1 x | Motor 2212 (1000KV) Quadcopter F450 |
| 1 x | Combo 4 pcs AXI 2204 Multicopter |
| 1 x | Carbon plate 550x350x1.0 mm ECOTECH |
| 1 x | Carbon Non-Woven, 240 g/m² 100 cm x 2m |
| 1 x | Fiberglass 25 g/m² 5000x1270 mm |
| 1 x | Carbon plate 350x150x2.0 mm |
| 1 x | Carbon plate 350x150x3.0 mm |
| 1 x | Carbon Non-Woven, 160 g/m² 100 cm 10 m |
| 1 x | Carbon Non-Woven, 160 g/m² 100 cm 25 m |
| 1 x | Camera Sony 4140+673 CCD with Built-in 200mw TX + antenna |
| 1 x | Jeti Box mini |
| 1 x | Carbon plate 550x350x1.5 mm ECOTECH |
| 1 x | Chopped glass fibre strands 0.2 mm |
| 1 x | Carbon Non-Woven, 240 g/m² 100 cm x 5m |
| 1 x | JetiBOX |
| 1 x | Jeti Advance Plus Program Card |
| 1 x | Jeti Advance Pro Program Card |
| 1 x | Tarjeta programadora RAY G2 |
| 1 x | Hacker X-Pro USB interface V2 |
| 1 x | ProgBOX MASTER Hacker |
| 1 x | Cable set Premium™ MAXI "one4two" |
| 1 x | BULLIT Wing 840 mm |
| 1 x | PC-6 Pilatus Porter Big "Tiger" (PICHLER) |
| 1 x | Cable set PREMIUM, SUB-Done 4three fuselage/wing 160 cm |
| 1 x | 100m servo "Premium" wire (white/red/blue) |
| 1 x | 30 cm MULTIPLEX female connector |
| 1 x | 200m servo "Premium" wire (white/red/blue) |
| 1 x | CARBON CUB FX-3 100-200CC ARF, 165" - 4200 mm (Hangar9) |
| 1 x | Fully Threaded Steel Rod alumin 70 mm M3 (2 pcs) knurled |
| 1 x | Servo GO-1035MG 16 kg.cm 0.08s/60º |
| 2 x | 140 mm rods + T patellas set for direction control |
| 1 x | KOBY 90 LV Esc |
| 1 x | M2-250 mm Carbon Fiber Adjustable Push Rod Sets (2 pcs) |
| 1 x | Wheel collar 2 mm Ø (4 uds) |
| 1 x | Wheel collar 4 mm Ø (4 uds) |
| 1 x | Pushrod octagone 4/3 |
| 1 x | Split pin 1x8 mm (10 uds) |
| 1 x | Soporte servo KST X08/H and Plus |
| 1 x | Servo KST X06H - 1.8Kg.cm 7mm 6g |
| 1 x | Press fitting for 1,0 diam. steel cable (10 pcs) |
| 1 x | Cockpit metalic closing |
| 1 x | Cable servo PREMIUM MAXI 1 m (blanco/rojo/azul) PVC |
| 1 x | Fully Threaded Steel Rod Duralumin 130 mm M3 (2 pcs) |
| 1 x | Servo GO-1070MG 40 kg.cm 0.10s/60º |
| 1 x | Cockpit aluminium closing 5.4g |
| 1 x | Fully Threaded Steel Rod alumin 50 mm M3 (2 pcs) |
 |
| 9,618.99EUR |
