| 1 x | Screw M3x16 |
| 1 x | Horn for flap control (1 pcs) |
| 1 x | ABS tube 10.0x8.0x1000 mm |
| 1 x | Cierre cabina aluminio Ø4, I=10 mm |
| 1 x | Oracover Azul Cielo 2 m |
| 1 x | Carbon tube (L 1000 mm, Ø10 mm, Ø8 mm) |
| 1 x | 6 mm aluminium horn with patella |
| 1 x | ABS tube 6.0x4.0x1000 mm |
| 1 x | Ventus 1:4 set of instruments |
| 1 x | Cable tie mounts 4.3 (4 uds) |
| 1 x | Allen wheel collar M3x3 |
| 1 x | Horn 6/20 with M3 Bearing |
| 1 x | 3,2x1000 mm 2:1 red termoretract tube |
| 1 x | Connector Sub-D 2+5 Male |
| 1 x | DPSI Ampere battery backer |
| 1 x | Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH |
| 1 x | ABS tube 12.0x10.0x1000 mm |
| 1 x | 80 mm rods set for direction control |
| 1 x | DPS Switch JR/JR |
| 1 x | 4 LiPo XH>EH adapter |
| 1 x | Propeller balancer |
| 1 x | Extension 15 cm (Futaba) |
| 1 x | 6x4 tree blades propeller |
| 1 x | Propeller POWER-PROP 13x9 Izda |
| 1 x | Fiberglass heat shield Ø 6 mm 1000 mm |
| 1 x | 20x1000 mm Ring Strap Back To Back |
| 1 x | RUDDOG Protection and Heat Shield Tape (2mx50mm) |
| 1 x | Extension silicon 100 cm (Graupner) |
| 1 x | PROPELLER ELECTRIC glass 9,5x6 |
| 1 x | Carbon fiber rod 0.5 mmx1000 mm |
| 1 x | Cable-Tie 1.66x71mm / 0.07x2.8″ (20 pcs) |
| 1 x | Cable servo PREMIUM MAXI 200m (blanco/rojo/azul) PVC |
| 1 x | Dumper propeller 6/8 mm |
| 1 x | Pin hinge 26x11 mm (10 uds) |
| 1 x | Protective Cover for wires Ø 6 mm 1000 mm |
| 1 x | Pad self adhesive, up to 3mm / 0.12″, (10 pcs) |
| 1 x | Propeller electric carbon 10x8 |
| 1 x | Protective open Cover for wires Ø 13 mm 1000 mm |
| 1 x | 100m servo "Premium" wire (white/red/blue) |
| 1 x | 25 mm reinforced hinge |
| 1 x | Cinta Goldfix 1m |
| 1 x | Propeller POWER-PROP 14x10 |
| 1 x | Pin hinge 39x20 mm (10 uds) |
| 1 x | Pad Screw Mount M3, up to 3mm / 0.12″, (10 pcs) |
| 1 x | Protective Cover for wires Ø 3 mm 1000 mm |
| 1 x | Porpeller HUNTER 480 |
| 1 x | Propeller electric carbon 9.5x5 |
| 1 x | Carbon fiber rod 5.0 mmx1000 mm |
| 1 x | Extension MPX-MPX 20 cm |
| 1 x | SE Ring 350 mm (2 pcs) |
| 1 x | Propeller POWER-PROP 12x8 |
| 1 x | Nylon hinge 20x15x0,3 (10 pcs) |
| 1 x | Propeller POWER-PROP 12x9 |
| 1 x | Canopy hinges for Discus 2c, Discus 2a, Ventus 2cx (2pcs) |
| 1 x | Cable servo PREMIUM 1 m (blanco/rojo/negro) AWG21 + AWG26 TPE |
| 1 x | Extension 30 cm (Futaba) |
| 1 x | Cable S.BUS 3 salidas 300 mm |
| 1 x | Micro flex hinge (12 uds) |
| 1 x | Propeller POWER-PROP 10x7 Izda |
| 1 x | Carbon fiber rod 2.0 mmx1000 mm |
| 1 x | Protective Cover for wires Ø 20 mm 1000 mm |
| 1 x | 15x7 tree blades propeller |
| 1 x | 8x6 tree blades propeller |
| 1 x | 200m servo "Premium" wire (white/red/blue) |
| 1 x | 13 mm self adhesive Pinking Tape, saw tooth height 1.0 mm |
| 1 x | |
| 1 x | Extension 100 cm (Futaba) |
| 1 x | Green silicone 0,25 qmm wire (50 m) |
| 1 x | Ring 320 mm length (5 pcs) |
| 1 x | 0,14 mm PVC servo wire extension, ZH micro conector. |
| 1 x | Carbon fiber flat 1000x3.0x1.0 mm |
| 1 x | SE Ring 360 mm (2 pcs) |
| 1 x | Cable silicona macho batt. receptor 30 cm (Graupner) |
| 1 x | Camera Sony 4140+673 CCD with Built-in 200mw TX + antenna |
| 1 x | Propeller electric carbon 6.5x4 |
| 1 x | 15x7 tree blades propeller LEFT |
| 1 x | Indoor hinge with servo arm integraded |
| 1 x | Medium pin type hinge (12 uds) |
| 1 x | VPP system propeller for AXI VPP motors (spare) |
| 1 x | 43 x 10 mm cylidric hinge Ø 2,5 mm (10 pcs) |
| 1 x | Carbon fiber flat 1000x3.0x0.5 mm |
| 1 x | Cable set Premium™ MAXI "one4two" |
| 1 x | 33 x 8 mm cylidric hinge Ø 2,5 mm (10 pcs) |
| 1 x | SE Ring 200 mm (2 pcs) |
| 1 x | Carbon fiber rod 1.5 mm x 2000 mm |
| 1 x | AC-10 pre-rotacion with motor |
| 1 x | TX 250 mW especial GOPRO |
| 1 x | PPM Encoder Module |
| 1 x | BULL MØ1 2.600mm ORANGE |
| 1 x | BULL MØ1 2.600mm GREEN |
| 1 x | Nose wheel 62 mm |
| 1 x | E_brakes electronics |
| 1 x | MB339 Freece PNP 1790 mm |
| 1 x | Electric Landing Gear RS-200 w/o programmer ULTIMATUM 2.0 (Elekt |
| 1 x | BD-5J PNP |
| 1 x | Electric Landing Gear "Black Edition" BULL Mo1 2.6 (Elektron Re |
| 1 x | PC-21 2880 mm Propeller 5 blade 20x10 K45TP Scale composite |
| 1 x | PC-21 XXL 3.395 mm |
| 1 x | Press fitting for 1,0 diam. steel cable (10 pcs) |
| 1 x | VITAPROP CARBON FOLDING PROP 15x9.5" |
| 1 x | BULL MØ1 2.600mm "RED BULL" |
| 1 x | BULL MØ1 2.600mm RED |
| 1 x | BULL MØ1 2.600mm "AeroPANDA" |
| 1 x | BULL MØ1 2.600mm YELLOW |
| 1 x | BULL MØ1 2.600mm "ALPINE" |
| 1 x | BULL MØ1 2.600mm BLUE |
| 1 x | BULL MØ1 2.600mm (mono color) |
| 1 x | BULL MØ1 2.600mm "McLAREN-GULF" |
| 1 x | PC-21 2.880 mm WHITE/RED |
| 1 x | Electric Landing Gear GS-200 BULL Mo1 2.6 (Elektron Retracts) |
| 1 x | PC-21 2.880 mm RED |
| 1 x | Electric Landing Gear PC-21 Skymaster (Elektron Retracts) |
 |
| 61,674.90EUR |
