1 x | 13 mm self adhesive Pinking Tape, saw tooth height 1.0 mm |
1 x | 10 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
2 x | Tape GFK 38 mm |
2 x | RUDDOG Protection and Heat Shield Tape (2mx50mm) |
1 x | |
1 x | SE Ring 350 mm (2 pcs) |
1 x | 5 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
1 x | 13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
2 x | Tape GFK 50 mm |
1 x | Field folding model stand |
3 x | Pad self adhesive, up to 3mm / 0.12″, (10 pcs) |
1 x | 20 mm self adhesive Pinking Tape, saw tooth height 1.0 mm |
1 x | Cinta Goldfix 1m |
1 x | Angle measurer |
1 x | Medidor ángulos y/o incidencias |
2 x | Spikes Band (5 m) |
1 x | Field folding model stand SebArt |
1 x | Truck-trailer for gliders 720 x 239 mm |
1 x | Angle of incidence meter |
1 x | 20x200 mm battery rings |
1 x | Covered closure or fairings |
1 x | Stainless steel cable Ø 0.88 mm - 60 kp (10 m) |
2 x | Hard aluminium thin-walled tube with fibreglass case ø30x1mm, 1m |
2 x | Wing-connector: Glass / Carbon tube (13.7/12.5) x 1000 mm |
1 x | Steering arm 16 mm Ø 3 mm (2 uds) |
1 x | Locking cable tie 4.6x203 (uds) |
1 x | Crimping sleeves for cable 0.85 mm (10 pcs) |
2 x | 67 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs) |
1 x | Nylon hinge 20x20x0,3 (10 pcs) |
1 x | 48 x 10 mm cylidric hinge Ø 3,0 mm (10 pcs) |
2 x | Large flex hinge (12 uds) |
2 x | Small pinned hinge (12 uds) |
2 x | Nylon hinge 20x15x0,3 (10 pcs) |
1 x | Gates hinge aluminium (1 pcs) |
1 x | Unmounted aluminium pin 6x98 mm (2 pcs) |
1 x | Pin type hinge Al 3,0x50 mm (2 pcs) |
1 x | Long pinned hinge (6 uds) |
2 x | Canopy hinges for Discus 2c, Discus 2a, Ventus 2cx (2pcs) |
2 x | Gates hinge 30x16 mm (2 pcs) |
2 x | Nylon hinge for flaps 33x9 (2 pcs) |
1 x | Gates hinge black 30x16 mm (2 pcs) |
1 x | 33 x 8 mm cylidric hinge Ø 2,5 mm (10 pcs) |
1 x | Long pinned hinge (12 uds) |
1 x | Aluminium cap bolt washer M3 black (8 pcs) |
1 x | Spring lock washer 4.1 mm (20 pcs) |
1 x | Circlik for shaft 1.2 mm (10 pcs) |
1 x | L-Connector 4.0 mm x 1000 mm |
1 x | Civilian pilot "Gramps" size 9cm (Slimline) |
1 x | Bidule 55 V3 2460 mm |
1 x | Extension silicon 100 cm (Futaba) |
1 x | Horn 5/15 with M2 Bearing |
1 x | A50 Motor Mount Alu complete set |
1 x | Battery LiPo GENS 5500 mAh 2S 7.6V 120C (Gens Ace Hard Case) |
1 x | Battery LiPo GENS 5000 mAh 6S 22.2V 60C (Gens Ace) |
1 x | Battery LiPo GENS 2200 mAh 4S 14.8v 25C (Gens Ace) |
1 x | Battery LiPo GENS 450 mAh 3S 11.1V 25C (Gens Ace) |
1 x | Battery LiPo GENS 3300 mAh 3S 11.1v 25C (Gens Ace) |
1 x | Battery RX JETI LiIon RB 2600 7.2v |
2 x | SE Ring HACKER 300 mm (2 pcs) |
1 x | SE Ring 480 mm (2 pcs) |
1 x | Tape GFK 25 mm |
2 x | Pin type hinge Al 4,5x70 mm to wire (2 pcs) |
1 x | Pin type hinge Al 6x98 mm (2 pcs) |
1 x | Micro flex hinge (12 uds) |
1 x | Wing-connector: Glass / Carbon tube (26.5/25 x 25/23) x 1000 mm |
1 x | Wing bolts M3 Steel screw blue (2 pcs) |
1 x | Press fitting for 0,5 diam. steel cable (10 pcs) |
1 x | Cable grommet Ø 6.4 mm (4 uds) |
1 x | WingFix ULTRA Black Edition |
1 x | Ring 320 mm length (5 pcs) |
1 x | Snap for floding prop for 2 mm axi |
1 x | 80 mm rods set for direction control |
1 x | Cockpit latch closing I=10 mm |
1 x | 45 mm rods + T patellas set for direction control |
1 x | Wing bolts M6 Steel screw Red (2 pcs) |
1 x | Clip fixing for wing (2 pcs) |
1 x | Aluminum Bayonet / strongal D35 mm / 1 m |
1 x | Split pin 1.6x16 mm (10 uds) |
1 x | SE Ring 250 mm (2 pcs) |
1 x | SE Ring 360 mm (2 pcs) |
1 x | Pin type hinge Al 4,5x70 mm demount (2 pcs) |
1 x | Propeller balancer |
1 x | Landing gear frontal support 25x32x16 |
1 x | 67 mm cylidric hinge Ø 4,5 mm (5 pcs) |
1 x | Steering arm 12 mm Ø 4 mm (2 uds) |
1 x | Allen wheel collar M4x6 |
1 x | Lead with adhesive (2 pcs) |
1 x | 15 mm reinforced hinge |
1 x | Allen wheel collar M3x3 |
1 x | Nylon hinge for flaps/gates 27x10,5 (2 pcs) |
1 x | 76 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs) |
1 x | Steering arm 16 mm Ø 4 mm |
1 x | Civilian pilot "Curt" size 9cm (Slimline) |
1 x | Pilot "Goose" (Slimline) |
1 x | Pilot "Duke" Legends Series (Slimline) |
1 x | Civilian pilot "Joe" size 9cm (Slimline) |
1 x | 1/12 Pilot "Cougar" |
1 x | Militarian pilot "Fly Boy" size 9cm (Slimline) |
1 x | Pilot WWII US Navy Pacific 12" Scale 1/6-1/5 |
1 x | Pilot "Adolf" Legends Series (Slimline) |
1 x | LiPo Storage Box Type "BIG" |
1 x | Battery bed V2_S (black) |
1 x | Flap hinge (6 pcs) |
1 x | Cockpit plastic closing |
1 x | 1/12 Pilot "Tom" |
1 x | Snap pin for micro clevis (10 uds) |
1 x | Piloto Jet "Green" 1/6 Scale |
1 x | Gates hinge |
1 x | Pin type hinge Al 3,0x50 mm demount (2 pcs) |
1 x | 67 mm cylidric hinge Ø 5 mm (4 pcs) |
1 x | Canopy Latch |
1 x | 25 mm reinforced hinge |
1 x | 18 mm reinforced hinge |
1 x | Fast'n EZ-CA-Hinge (12 uds) |
1 x | Boomerang SPRINT V2 Red/White/Blue |
1 x | TURBINATOR 2 RED/WHITE 1778 mm Combo |
1 x | Aluminium Hub for folding Props 35 mm M8 Shaft 6 mm |
1 x | Cable servo PREMIUM 1 m (blanco/rojo/negro) AWG21 + AWG26 TPE |
1 x | Xoar Electric Beechwood Prop 21x10 |
|
6,372.75EUR |