| 1 x | 3 LiPo XH>EH adapter |
| 1 x | 1,2x1000 mm 2:1 black termoretract tube |
| 1 x | Ball Link ALU M3 - RH (1 pcs) |
| 1 x | Pilot "Adolf" Legends Series (Slimline) |
| 1 x | Fully Threaded Steel Rod M2,5 (2 uds) |
| 1 x | Civilian pilot "Gramps" size 9cm (Slimline) |
| 1 x | Nylon hinge 20x20x0,3 (10 pcs) |
| 1 x | Conector FUTABA Servo male (10 pcs) |
| 1 x | 76 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs) |
| 1 x | Conector JR Servo female (10 pcs) |
| 1 x | SE Ring 240 mm (2 pcs) |
| 1 x | Nylon hinge 20x15x0,3 (10 pcs) |
| 1 x | Conector XT-150 6mm (Set: 5 pares) |
| 1 x | Connectors banna oro 0,8 mm (M/F) |
| 1 x | Conector JR Servo female (50 pcs) |
| 1 x | Cylidric hinge 33 mm Ø 2 mm (5 pcs) |
| 1 x | 48 x 10 mm cylidric hinge Ø 3,0 mm (10 pcs) |
| 1 x | Conector JAPAN G2 Set 5 pares |
| 1 x | Cable silicona macho batt. receptor 30 cm (Graupner) |
| 1 x | Aluminium tube (L 1000 mm, Ø3.0 mm, Ø2.1 mm) |
| 1 x | Vacuum pump 12 CFM |
| 1 x | Dust collector for mould cleaning |
| 1 x | Starter 12v (Max 90 and 15ccm) |
| 1 x | Fiberglass heat shield Ø 6 mm 1000 mm |
| 1 x | Aluminium tube (L 1000 mm, Ø4.0 mm, Ø3.1 mm) |
| 1 x | Horn 6/27 with M3 Bearing |
| 1 x | Quicklock washer 2.5 mm (10 pcs) |
| 1 x | Futaba male 40 cm extension |
| 1 x | Filter Capacitor JR |
| 1 x | Aluminium cap bolt washer M4 blue (8 pcs) |
| 1 x | Aluminium wide washer M4 Black (4 pcs) |
| 1 x | Cabel PVC 2 x 0.25 mm2 (5 m) red-black |
| 1 x | Disposable Injector Bags (30x16cm) 100 pcs |
| 1 x | ABS tube 7.0x6.0x1000 mm |
| 1 x | Cable servo PREMIUM MAXI 50m (blanco/rojo/azul) PVC |
| 1 x | Carbon tube (L 1000 mm, Ø18 mm, Ø16 mm) |
| 1 x | DPSI RV Mini 5 Magic |
| 1 x | ABS tube 5.0x4.0x1000 mm |
| 1 x | Soporte filtro FESTO (4 pcs) |
| 1 x | Ferrita 27x14x7 mm |
| 1 x | Support FUEL DOT V3 |
| 1 x | Recessed MPX connector support (6 pcs) |
| 1 x | Ferrita 14x8x5.5 mm |
| 1 x | Support Flush MPX Conector (6 pcs) |
| 1 x | Soporte grifo FESTO vertical (1 pcs) |
| 1 x | Support Pitot JETI |
| 1 x | DG-303 ACRO 3750 mm, winglets |
| 1 x | Servo HITEC HS-225 MG |
| 1 x | Servo HITEC HS-485 HB |
| 1 x | Brazo servo aluminio 1.25/1.5" Futaba/MKS/Savox |
| 1 x | Rotorshape Autogyro |
| 1 x | ALU servo arm 3 mm shaft |
| 1 x | Blue Aluminium double servo arm V3-Hitec 3-3,5inch |
| 1 x | LA500 rotor head shaft |
| 1 x | Servo HITEC HS-55 |
| 1 x | Servo HITEC D941 TW |
| 1 x | Tacometer mini ignition RCEXL |
| 1 x | Propeller diller for DA50, DLE55 red |
| 1 x | Propeller diller for EME35 and DLE35 |
| 1 x | Hard aluminium thin-walled tube with fibreglass case ø30x1mm, 1m |
| 1 x | Steering arm 12 mm Ø 4 mm |
| 1 x | Tip wing protector 30x10 (2 pcs) |
| 1 x | Cable grommet 9.5 mm (4 uds) |
| 1 x | Steering arm 16 mm Ø 3 mm (2 uds) |
| 1 x | PVC transparent red battery termo-retract 68 mm (10 m) |
| 1 x | Ply-Span 450x600/13g Orange |
| 1 x | Servo HITEC HS-5087 MH |
| 1 x | 7 Servo SET 9g DS MG + Full servo extension cable set for Avanti |
| 1 x | 10-15mm Servo Arm |
| 1 x | Servo HITEC D954 TW |
| 1 x | LA500 housing-upper cyclic |
| 1 x | Baal link 4/14/4 (5 pcs) |
| 1 x | LA500 front gear holder |
| 1 x | Motor rotor LA-500 |
| 1 x | Servo case HS-225MG/225BB/5245MG |
| 1 x | Servo AN-8 HBA |
| 1 x | Futaba 14/20 mm servo pull-pull double arm with ball link |
| 1 x | Futaba 76/92 mm servo pull-pull double arm with ball link HUB Al |
| 1 x | Transmitter JETI Duplex DC-16 II RED Carbon Line Mod.2 |
| 1 x | Transmitter Balancer Futaba FF9-DX7-JR-Hitec |
| 1 x | Futaba 38 mm servo arm |
| 1 x | Programador FUTABA USB CIU-3 |
| 1 x | Antenna Hole Cap V1 (Silver) |
| 1 x | Tx JETI Duplex DC-24 II Carbon Line Ruby |
| 1 x | Emisora JETI Duplex DS-16 II SILVER Multimode |
| 1 x | Servo arm with 6 mm hole to FEMA 9800A |
| 1 x | Albatros ,spare fuselage (Top Model) |
| 1 x | Bidule 111 3000 mm |
| 1 x | Fascination 3600 mm, Spare Wings (Top Model) |
| 1 x | Electric spoiler 300 mm (2 pcs) |
| 1 x | Canopy Astra |
 |
| 9,660.74EUR |
