| 1 x | 100 mm rods + T patellas set for direction control |
| 1 x | 100 mm rods set for direction control |
| 1 x | 140 mm rods set for direction control |
| 2 x | Cable grommet 9.5 mm (4 uds) |
| 2 x | Aluminun wheel collar 3 mm Ø (4 uds) |
| 1 x | Clip mini fixing for wing (2 pcs) |
| 2 x | Allen wheel collar M4x6 |
| 1 x | Cable grommet Ø 6.4 mm (4 uds) |
| 1 x | Cockpit aluminium closing |
| 1 x | 45 mm rods + T patellas set for direction control |
| 1 x | Allen wheel collar M4x4 |
| 1 x | Cable grommet Ø 3.2 mm (4 uds) |
| 2 x | Cable tie mounts 4.3 (4 uds) |
| 1 x | Cabin latch Fox MDM1 4m (pair) |
| 4 x | 38x4,5 mm wires output (2 pcs) |
| 1 x | 250 mm / 16 mm Airbrakes |
| 1 x | Clip fixing for wing (2 pcs) |
| 2 x | Cable grommet Ø 5 mm (4 uds) |
| 1 x | Canopy Lock V1 M3 Red (2 pcs) |
| 2 x | Aluminun wheel collar 2.5 mm Ø (4 uds) |
| 2 x | Canopy Lock V1 M3 Blue (2 pcs) |
| 2 x | Aluminun wheel collar 3.5 mm Ø (4 uds) |
| 2 x | Allen wheel collar M3x3 |
| 1 x | Aluminun wheel collar 6 mm Ø (4 uds) |
| 1 x | Canopy Latch |
| 1 x | 11 mm Rubber pads (14 pcs) |
| 1 x | Extinguisher CO2 - 2 Kg |
| 3 x | Cable silicona female batt. receptor 30 cm (Futaba) |
| 1 x | Premium servo extension 100cm |
| 1 x | Extension 100 cm (Futaba) |
| 1 x | Extension silicon 30 cm male (Graupner) |
| 2 x | Extension S-Bus 1-2 silicon 30 cm FUTABA |
| 1 x | Extension 15 cm (Futaba) |
| 1 x | Extension silicon 30 cm female (Futaba) |
| 2 x | Extension silicon 30 cm male (Futaba) |
| 2 x | Extension silicon 35 cm male (Futaba) |
| 2 x | Futaba Female 40 cm extension |
| 1 x | Extension silicon 30 cm female (Graupner) |
| 1 x | Extension silicon 100 cm (Graupner) |
| 2 x | servo adapter lead, JST-SH socket - JR male Pin, for GR-12SH+HoT |
| 1 x | Gates hinge black 30x16 mm (2 pcs) |
| 1 x | Pin type hinge Al 4,5x70 mm demount (2 pcs) |
| 1 x | Xplorer1 anemometro |
| 1 x | Large flex hinge (12 uds) |
| 1 x | 67 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs) |
| 1 x | Nylon hinge 15x0,3 (10 pcs) |
| 1 x | 18 mm reinforced hinge |
| 1 x | Xplorer2 anemometro |
| 1 x | Nylon hinge 20x15x0,3 (10 pcs) |
| 1 x | 48 mm cylidric hinge Ø 2,5 mm (5 pcs) |
| 1 x | 67 mm cylidric hinge Ø 5 mm (4 pcs) |
| 1 x | Canopy hinges for Discus 2c, Discus 2a, Ventus 2cx (2pcs) |
| 1 x | Fully Threaded Steel Rod alumin 30 mm M2,5 (2 pcs) |
| 1 x | Motor DLE 200cc Premium Muffler |
| 1 x | Wheel collar 4 mm Ø (4 uds) |
| 1 x | Silent-blocks DLE 170M |
| 1 x | Pushrod greyline 3/2 with coupler M2 |
| 1 x | Landing gear frontal support 25x32x16 |
| 1 x | Big Crow DLE-170M |
| 1 x | Pushrod octagone 3/2 with coupler M2 |
| 1 x | Motor DLE 430 cc - Paramotors |
| 2 x | Pushrod greyline 3/2 with coupler M3 L: 1000 mm |
| 1 x | Optical RPM Sensor |
| 1 x | PPM Encoder Module |
| 1 x | PIX Hawk with accesories |
| 1 x | DYNAMOMETER S-1580 |
| 1 x | Digital Air Speed Sensor And Pitot Tube Set |
| 1 x | Straightened rod Ø 8.0 mm x 1000 mm |
| 1 x | Straightened rod Ø 4.5 mm x 1000 mm |
| 1 x | Straightened rod Ø 5.0 mm x 1000 mm |
| 1 x | Straightened threaded rod M2-1m |
| 1 x | Brass rod Ø 0.5 mm x 1000 mm |
| 1 x | Straightened threaded rod M3 - 1m |
| 1 x | Brass hexagonal rod Ø 5 mm x 1000 mm |
| 1 x | Brass rod Ø 1.5 mm x 1000 mm |
| 1 x | Brass hexagonal rod Ø 4 mm x 1000 mm |
| 1 x | Bungee HLG Premium |
| 1 x | Straightened rod Ø 6.0 mm x 1000 mm |
| 1 x | Aluminium rod Ø 4.0 mm x 3000 mm |
| 1 x | Straightened rod Ø 1.0 mm x 1000 mm |
| 1 x | Straightened rod Ø 5.5 mm x 1000 mm |
| 1 x | Initior Receiver FRX2 Wireless |
| 3 x | Snap long M2 (10 uds) |
| 1 x | Cable Cargador FUTABA |
| 1 x | Aluminium cap bolt washer M4 green (8 pcs) |
| 1 x | M3-M4 rubber washer (8 pcs) |
| 1 x | Flat washer 3.2 mm (20 pcs) |
| 1 x | CC 05 |
| 1 x | Carbon fiber rod 0.8 mmx1000 mm |
| 1 x | Disposable Injector Bags (30x16cm) 100 pcs |
| 1 x | Crimping tool |
| 1 x | ORACOVER Fluor red (2 m) |
| 1 x | Soporte filtro FESTO (4 pcs) |
| 1 x | Aluminium coupler M2,5/2 with ball bearing (1 pcs) |
| 1 x | 10 mm dogdrive props |
| 1 x | 4 mm Prop Adapter M6 |
| 1 x | 6 mm Prop Adapter M8 |
| 1 x | 2,3 mm Prop Drive Günther M4 |
| 1 x | Extension silicon 10 cm (Graupner) |
| 1 x | Extension silicon 100 cm (Futaba) |
| 1 x | 0,14 mm PVC servo wire extension, ZH micro conector. |
| 1 x | Cable S.BUS 3 salidas 300 mm |
| 2 x | Cabel "Y" 15 cm |
| 1 x | Helices DJI Mavic Air STEALTH "Black" (4x Ud) |
| 1 x | Propeller mounting nuts Black / Silver Rocket 400 or Phatom simi |
| 1 x | Xplorer4 anemometro |
| 1 x | Extension silicon 25 cm (Graupner) |
| 1 x | Extension 7.5 cm |
| 1 x | Futaba male 40 cm extension |
| 1 x | Extension silicon 75 cm (Graupner) |
| 1 x | AL Axle Shaft 4.0x16 mm (2 uds) |
| 1 x | Cabel "Y" 30 cm (graupner) |
| 1 x | Extension silicon 50 cm (Futaba) |
| 1 x | Antenna holder bracket double |
| 1 x | Locking cable tie 4.6x203 (uds) |
| 1 x | Pushrod octagone 4/3 |
| 1 x | Aluminun wheel collar 4 mm Ø (4 uds) |
| 1 x | Motor DLE 200cc Std |
| 2 x | Tip wing protector 40x14 (2 pcs) |
| 1 x | Aluminun wheel collar 5 mm Ø (4 uds) |
| 1 x | Cockpit plastic closing |
| 1 x | Allen wheel collar M3x5 |
| 1 x | Split M1,2x10 (10 pcs) |
| 1 x | 26 mm self adhesive Pinking Tape, saw tooth height 1.0 mm |
| 1 x | 5 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
| 2 x | Tip wing protector 28x10x12 (2 pcs) |
| 1 x | Crimping sleeves for cable 0.85 mm (10 pcs) |
| 1 x | |
| 1 x | Glass Bubbles (0,12 g) 350 ml |
| 1 x | |
| 1 x | 20x200 mm battery rings |
| 1 x | Tip wing protector 30x10 (2 pcs) |
| 1 x | GlassBubbles 2.5 g/cm³ Panda, tin (approx. 1 l) |
| 1 x | Aluminium alloy coupler for carbon tube 6/M4 |
| 1 x | Landing gear frontal support 29x26x13,5 |
| 1 x | Control for forward wheel (MINI) |
 |
| 12,954.15EUR |
few units
temporarily out of stock
under request
enought units
