2 x | Canister combo DLE 120 cc |
1 x | Ignition unit for DA-70/100/120/150/170/200 |
1 x | Ignition for DA-35 (without pickup sensor) |
1 x | Piston ring for DA-60 and DA-120 |
1 x | Rear crankcase DA-50R |
1 x | Piston ring for DA-85 and DA-170 |
1 x | Prop washer DA-50R/60/70 |
1 x | L ELBOW DA-150 "normal" (2 pcs) |
1 x | Piston ring for DA-50R and DA-100 |
1 x | Steel conrod DA-50R and DA-60 |
1 x | Reed valve carrier for DA-85, DA-100L and DA-120 |
1 x | Carburator spacer block DA-50R |
1 x | Reed valve for DA-60/70 |
1 x | L ELBOW 90º ø 25 mm |
2 x | BOSCH spark plug cap for DA 50-R, DA 100 and DA 150 |
1 x | Woodruff key for DA50/85/100/150 and DA 200 |
1 x | L ELBOW DA-120 long (2 pcs) |
1 x | Cylinder DA-50R, DA-100, DA-100L |
1 x | Low speed needle DA-50R/100I |
1 x | Front axi for DA85/DA100/DA100L/DA120 |
1 x | Hifht speed needle DA-50R/100I |
1 x | Stainless steel silencer for DA 150/150L |
1 x | Piston pin for DA50R/DA100 |
1 x | Cylinder for DA-85/170 (1 piece) |
1 x | Cylinder for DA-60 and DA-120 |
1 x | Sandwich carbon + poplar 4mm + carbon 480x290 mm |
1 x | FALCON 20X9 CARBON PROPELLER (GAS) |
1 x | Propeller APC 14x8.5 Electric Pusher |
1 x | Straightened rod Ø 14.0 mm x 1000 mm |
1 x | Propeller POWER-PROP 14x9 |
1 x | Propeller POWER-PROP 14x9 Izda |
1 x | Motor ST 7-160 B |
1 x | DLE-111 Crankcase V2 Conversion Kit |
1 x | DLE 30 complete electronic ignition |
1 x | Ball bearing middle DA-120 |
1 x | Cylindergasket DA 170 |
1 x | Aluminium-screw, M5x16mm Red |
1 x | Aluminium-screw, M5x20mm Red |
1 x | DA-100 Bearing |
1 x | Aluminium-Plate, carb>reed valve carrier, DA-85 DA-100L and DA-1 |
1 x | Piston for DA-50R, DA-100, DA-100L |
1 x | Reed valve Retainer, black rubber for DA-85, DA-100L and DA-120 |
1 x | Carbon tube (L 1000 mm, Ø12 mm, Ø10 mm) |
1 x | Sandwich carbon + poplar 2mm + carbon 480x290 mm |
1 x | Circlick securite |
1 x | BALSA trip 6.0x6.0x1000 mm |
1 x | Breatex™ Non-woven absorber 150 g/m² Roll 20m |
1 x | Buy Perforated film 100 cm / 50 m |
1 x | 0,14 mm PVC servo wire extension, ZH micro conector. |
1 x | Carbon Non-crimp ST 100 g/m² 50 cm x 10 m |
1 x | 15 mm reinforced hinge |
1 x | Aluminium blue ball links M3 V1 (10 pcs) |
1 x | Profile ABS triangular 2.0x1000 mm 90º |
1 x | Streamline Stainless Steel Tubing 10.5x5.7x1000 m |
1 x | A/C quality beech plywood 1520x750x3.0 mm |
1 x | Beech dowels 10 mm x 1000 mm |
1 x | Aluminium tube (L 1000 mm, Ø4.0 mm, Ø3.1 mm) |
1 x | Compact Pitts Muffler OS MAX.35.40 FP |
1 x | OS 40-FG 4T Motor |
1 x | Kwik link AL M4 L:40 mm (2 pcs) + Pin Ø 2,5 mm |
1 x | Cable coupler M3 (10 uds) |
1 x | Sandwich carbon + poplar 4mm + carbon 290x160 mm |
1 x | Dremel PERMAGRIT thin lime |
1 x | ABS "T" angle 8.0x8.0x1000 mm |
1 x | A/C quality beech plywood 600x300x6.0 mm |
1 x | Extension silicon 30 cm male (Futaba) |
1 x | ABS tube 8.0x6.0x1000 mm |
1 x | Nylon hinge 20x20x0,3 (10 pcs) |
1 x | Balsa panel 2.0x100x1000 mm |
1 x | Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 10 m |
1 x | Cabel "Y" 15 cm |
1 x | Cable S.BUS 3 salidas 100 mm |
1 x | Futaba male 40 cm extension |
1 x | AIREX® Sheets C 70.55 (YELLOW) 1200x550x2.0 mm (10 pcs) |
1 x | Breatex™ Non-woven absorber 150 g/m² Roll 50m |
1 x | 43 x 10 mm cylidric hinge Ø 2,5 mm (10 pcs) |
1 x | ABS angle 5,0x5,0x1000 mm |
1 x | Breatex™ Non-woven absorber 300 g/m² Roll 41 m |
1 x | Extension silicon 75 cm (Futaba) |
1 x | Extension lead 15 cm Multiplex |
1 x | ABS tube 18.0x16.0x1000 mm |
1 x | ABS tube 14.0x10.0x1000 mm |
1 x | Crimping tool |
1 x | DUBRO - KWIK TWIST TOOL - TO TWIST STEEL WIRE (1 PC) (301) |
1 x | ABS tube 9.0x8.0x1000 mm |
1 x | ABS tube 20.0x18.0x1000 mm |
1 x | Indoor hinge with servo arm integraded |
1 x | Adaptadores carga 6s JST-XH |
1 x | Extension silicon 10 cm (Graupner) |
1 x | Kwik link AL M3 L:30 mm (2 pcs) + Pin Ø 2,0 mm |
1 x | Digital scale up to 40 kg |
1 x | Futaba Female 40 cm extension |
1 x | Boxed KIT OF 7 Rotary Burrs FINE |
1 x | ABS 500 x 400 x 0,5 mm (white) |
1 x | Profile ABS half cane 2.5x1000 mm |
1 x | Oracover light Grey 2m |
1 x | EC-Cutter |
1 x | Carbon fibre tape 200 g/m² (unidirectional) 50 mm |
1 x | BALSA trip 8.0x8.0x1000 mm |
1 x | 2,5x60 mm allen screwdriver |
1 x | Cable coupler M2 (10 uds) |
1 x | Balsa panel 10x100x1000 mm |
1 x | 76 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs) |
1 x | ARAMID honeycomb 1300x2600x2 mm |
1 x | Extension 7.5 cm |
1 x | L-Connector 4.0 mm x 1000 mm |
1 x | Profile ABS Square 2 x 1000 mm |
1 x | Sandwich carbon + poplar 2mm + carbon 290x160 mm |
1 x | Ball Link Plier |
1 x | Aluminium tube (L 1000 mm, Ø5.0 mm, Ø4.1 mm) |
1 x | Digital precision scale up to 2000 g |
1 x | Kwik link AL M3 L:30 mm (2 pcs) + Pin Ø 1,6 mm |
|
8,402.11EUR |