1 x | Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH |
1 x | Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH |
1 x | 30 cm BEC cable (male) |
1 x | Cabling for Fox MDM1 wings |
2 x | CC 01 |
2 x | Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm) |
1 x | Cabel charger transmitter GRAUPNER |
1 x | APM2.6 Power module with 5.3V DC BEC |
1 x | CellPRO 4S Adaptader (GP/KO up to 4S) |
1 x | 2 LiPo XH>EH adapter |
1 x | CC 02 |
1 x | Copper lacquer wire Ø0,2 mm (5 m) |
1 x | Connector CAN 15 |
1 x | 5 LiPo XH>EH adapter |
1 x | Circlick securite |
1 x | Connector Sub-D 2+5 Female |
2 x | CC 05 |
1 x | DPS Switch JR/JR |
1 x | CM-3 |
2 x | 3 LiPo XH>EH adapter |
1 x | "Y" charging 4mm wire (2 IN-1 OUT). |
1 x | Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm) |
2 x | Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm) |
1 x | Connector Sub-D 2+5 Male |
2 x | Dean "T" - Futaba Adapter |
1 x | Balanceradapter JST-XH (Heli 47G) 2-6 c. |
1 x | 30 cm BEC cable (female) |
1 x | BEC 3A FOXY |
2 x | Interface Realflight Simulator |
1 x | TrainerCord (master-learner) |
1 x | Locking cable tie 3.2x142 (uds) |
1 x | Screw-lock connector M2 (2 uds) |
1 x | Stainless steel cable Ø 0.88 mm - 60 kp (10 m) |
1 x | Cierre cabina aluminio Ø4, I=10 mm |
1 x | Micro screw-lock pushrod conn snap Ø 1 mm (2 uds) |
1 x | Locking cable tie 4.6x203 (uds) |
1 x | Canopy Lock V1 M3 Blue (2 pcs) |
1 x | Cockpit plastic closing |
1 x | Crimping sleeves for cable 0.70 mm (10 pcs) |
1 x | Cabin latch Fox MDM1 4m (pair) |
1 x | Screw-lock pushrod conn snap Ø 1.5 mm (2 uds) |
1 x | Stainless steel cable Ø 0.5 mm (10 m) |
1 x | One touch canopy lock |
1 x | Steering arm 12 mm Ø 4 mm (2 uds) |
1 x | Cierre cabina aluminio Ø5, I=16 mm |
1 x | Stainless steel cable Ø 0.62 mm (10 m) |
1 x | Aluminium alloy coupler for carbon tube 6/M4 |
1 x | Screw-lock connector Ø 2 mm (2 uds) |
2 x | Steering arm 16 mm Ø 3 mm (2 uds) |
1 x | Horizontal cockpit anchor "tipe F3A" (2 pcs) |
1 x | Covered closure or fairings |
1 x | Crimping sleeves for cable 1.3 mm (10 pcs) |
1 x | Steering arm 12 mm Ø 4 mm |
1 x | Steering arm 16 mm Ø 4 mm |
2 x | Big Crow DLE-170M |
1 x | Motor DLE 200cc Std |
1 x | Small Crow DLE-170M |
1 x | Motor DLE 200cc Premium Muffler |
1 x | Propeller FALCON 32,5x11 PUSHER Carbono |
1 x | Silent-blocks DLE 170M |
1 x | Spring lock washer 4.1 mm (20 pcs) |
1 x | SERVO HOLDER |
1 x | White smoke bombs AX-9 (10 pcs) |
1 x | Opto Gas Engine Kill Switch |
1 x | Jeti Black cap |
1 x | Oracover CARBON Metalic 1 m |
1 x | Support pump Xicoy X45 |
1 x | Pasacables rectangular 40x15 mm (4 pcs) |
1 x | Simulador RealFlight RF-9.5 S (sin emisora) |
2 x | GameCommander USB Universal |
2 x | EasyFLY Addon |
1 x | SIMtransmitter 6 Mode 2 |
1 x | Double conector with JR adapter and 200 mm extension |
1 x | Foreman, scale 1:32 |
1 x | 45 mm rods set for direction control |
1 x | Motor ACTRO 35-4-790 |
1 x | SPS 70V 100/200 A |
1 x | TMM 2512-3S heli |
1 x | 41x5,5 mm wires output (2 pcs) |
1 x | 90 mm rods + T patellas set for direction control |
1 x | Aluminun wheel collar 2.5 mm Ø (4 uds) |
1 x | Aluminium sheet 500x250x0,5mm |
1 x | Wing bolts M3 Steel screw Red (2 pcs) |
1 x | Wheel collar 4 mm Ø (4 uds) |
1 x | Wheel collar 2 mm Ø (4 uds) |
1 x | Beech dowels 4.0 x 1000 mm |
1 x | Aluminun wheel collar 3 mm Ø (4 uds) |
1 x | Electronic fog horn |
1 x | Triple rod con. 3mm Pushrod (2 pcs) |
1 x | Carbon fiber rod 5.0 mmx1000 mm |
1 x | Cable grommet Ø 6.4 mm (4 uds) |
1 x | Clip fixing for wing (2 pcs) |
1 x | Hard brass tubing (L 1000 mm, Ø10.0 mm, Ø9.1 mm) |
1 x | Aqua RACE 70 (without motor) |
1 x | Clip mini fixing for wing (2 pcs) |
1 x | Wheel collar 5 mm Ø (4 uds) |
1 x | 100 mm rods set for direction control |
1 x | Allen wheel collar M3x5 |
1 x | Aluminun wheel collar 2 mm Ø (4 uds) |
1 x | Cable grommet Ø 5 mm (4 uds) |
1 x | Brass rod Ø 1.0 mm x 1000 mm |
1 x | 80 mm rods set for direction control |
1 x | Split pin 1x8 mm (10 uds) |
1 x | Window mounting channel Type H 2.5x0.5 (2 m) |
1 x | Aluminun wheel collar 6 mm Ø (4 uds) |
1 x | 140 mm rods + T patellas set for direction control |
1 x | Beech dowels 2.0 x 1000 mm |
1 x | 11 mm Rubber pads (14 pcs) |
1 x | 28 mm tailwheel unit |
1 x | 100 mm rods + T patellas set for direction control |
1 x | Bearing block for noseleg landing gear |
1 x | CC 11 Conector |
1 x | PSC 5 |
1 x | Wing bolts M6 Steel screw Red (2 pcs) |
1 x | Brass hexagonal rod Ø 3 mm x 1000 mm |
1 x | Pushrod greyline 3/2 with coupler M2 L: 1000 mm |
1 x | 31,0 mm propeller (rigth propeller) |
1 x | 2000A 12V Lithium Jump Starter with 150PSI Air inflator |
1 x | Propeller APC 11x7 SF |
1 x | Propeller APC 11x8.5 Electric |
1 x | Propeller APC 11x8 Electric |
1 x | Propeller APC 13x8 Electric |
1 x | Propeller APC 12x6 Electric |
1 x | Propeller APC 10x7 SF |
1 x | Bags wings/rudder ASPIRE |
1 x | F-4 Phantom Scale 1:7, Electric retract landing gear |
1 x | Support Pitot JETI |
1 x | Tapa estado carga XT-60 (6 pcs) |
1 x | Soporte filtro FESTO (4 pcs) |
1 x | Support XT60 conector (2 pcs) |
1 x | Propeller APC 10x5.5 MR Electric multirrotor PUSHER |
1 x | Propeller APC 10x4.7 |
1 x | Propeller APC 12x10 Electric |
1 x | Propeller APC 11x7 Electric |
1 x | Propeller APC 10x5 Electric |
1 x | Propeller APC 13x6.5 Electric |
1 x | Propeller APC 11x10 Electric |
1 x | Propeller APC 11x4.7 SF |
1 x | Propeller APC 13x4 Electric Pusher |
1 x | Propeller APC 14x10 Electric |
1 x | Propeller APC 13x6.5 Electric Pusher |
1 x | Propeller APC 10x3,8 SF |
1 x | Propeller APC 13x10 Electric |
1 x | Propeller APC 10x10 Electric |
1 x | Propeller APC 10x6 Electric |
1 x | Propeller APC 14x12 Electric |
1 x | Propeller APC 12x6 SF |
1 x | Propeller APC 10x4.7 SF Pusher |
1 x | Propeller APC 11x5.5 Electric Pusher |
1 x | Propeller APC 11x4.5 Electric Pusher |
|
8,538.23EUR |