2 x | Catalog AERO-NAUT 2016 |
2 x | SCHARNHORST accessories |
2 x | SCHARNHORST Battleship 1:200 |
1 x | La Capitania di Venetia 1:50 |
1 x | Reguladro ACTROCON 60A |
3 x | Vest clothes Hispano Aviación |
2 x | Landing gear retract neumatic (Jet Legend) |
1 x | Servo Controller Fibra optica |
2 x | Head core bushing |
1 x | Motor holder for AC 28/7 |
2 x | Rotorhead pushrod |
2 x | Blade holder center GFK 0,5 mm |
2 x | Blade holder upper |
2 x | Bearing 3x6x2,5 |
1 x | Shirt Hispano Aviación |
3 x | Softshell Hispano Aviación |
2 x | Ventus 1:4 set of instruments |
2 x | PIX Hawk with accesories |
1 x | Carbon fibre sleeve 12k 170 mm x 5m |
2 x | EC5-Set female, simple quality, 2 x female pin, 1 x blue housing |
1 x | Buy Perforated film 145 cm / 50 m |
1 x | Motor Mega AC 16/25/02 |
1 x | Tube Pitot to PIXHAWK |
1 x | DYNAMOMETER S-1580 |
1 x | Motor Mega AC 16/25/04 |
1 x | AIREX® Sheets C 70.55 (YELLOW) 1200x550x2.0 mm (20 pcs) |
2 x | Connectors banna oro 8,0 mm 5 pcs(Female) |
1 x | Motor Mega AC 22/20/03 |
1 x | Breatex™ Non-woven absorber 150 g/m² Roll 100m |
1 x | Conector Servo female 4 pines |
1 x | Carbon Fabric Prepreg 200 g/m² (twill 2/2) 100 cm, roll/ 1 m |
1 x | Motor Mega AC 16/07/08 |
1 x | Carbon fabric 245 g/m² (twill weave) 127 cm, roll/ 10 m |
1 x | Motor Mega AC 16/15/03 |
1 x | Motor Mega AC 16/20/02 |
1 x | Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 50 m |
1 x | EasyFLY Addon |
1 x | AIREX® Sheets C 70.55 (YELLOW) 1200x550x4.0 mm (5 pcs) |
1 x | ARAMID honeycomb 1300x2600x2 mm |
2 x | Connectors banna oro 2 mm (M/F) |
1 x | 9x4.7 * 22x12 carbon propeller |
1 x | IPACS Aerofly Professional Expansion Pack Vol. 1 PC-DVD |
1 x | Propeller APC 10x6 Electric Pusher |
1 x | Propeller APC 11x3.8 SF |
1 x | Propeller APC 11x10 Electric |
1 x | Propeller APC 11x7 SF |
1 x | Propeller APC 13x6.5 Electric Pusher |
1 x | Propeller APC 14x10 Electric |
1 x | Propeller APC 10x3,8 SF |
1 x | Propeller APC 12x6 Electric Pusher |
1 x | Propeller APC 10x6 Electric |
1 x | Propeller APC 11x5.5 Electric |
1 x | Propeller APC 11x4.5 Electric Pusher |
1 x | Propeller APC 10x5 Electric Pusher |
1 x | Antena FUTABA 35 mhZ 3PM/3FRF/4V/4Y/6EX/6X/6Y/7C |
1 x | Decorative caps, multicoloured |
1 x | Teacher-student connector T12FG/FX-30 |
1 x | Receiver bed (Blue) |
1 x | Three-function control switch by FUTABA |
1 x | Multiplex True Air Speed + Vario Sensor to M-LINK |
1 x | SWTU2 switch |
1 x | Switch Cap M (black) |
1 x | Antenna FUTABA 2.4GHz 3PM/8FG/14SG/18SZ/18M |
1 x | FPV Station for SE TX-Tray V1 |
1 x | Battery FUTABA 18MZ |
1 x | Tirpiz Battleship 1:200 |
1 x | Servo M2x9/16 screw (4 pcs) |
1 x | Sandwich carbon + poplar 4mm + carbon 480x290 mm |
1 x | OSD Telemetry sensor |
1 x | Adap/Exten for Futaba 12-14C |
1 x | Futaba Neckstrap |
1 x | Switch Cap L (black) |
1 x | JETImodel Addcap 820 |
1 x | Transmitter Balancer Futaba FF9-DX7-JR-Hitec |
1 x | Futaba Radio Case |
1 x | Switch Cap L (silver) |
1 x | MULTIPLEX ALUMINUM CASE "M-LINK" |
1 x | Contest-S-Pult-Carbon mc-20/mc-24 |
1 x | Wingstabi 9 DR M-Link Receiver |
1 x | Transmitter Balancer SPK DX-8 |
2 x | Screw M3x16 |
2 x | Head upper part |
2 x | Head core |
2 x | Head runner |
2 x | Bearing housing |
1 x | Conector BEC female (10 pcs) |
1 x | Blades 330mm |
1 x | Ball joint long |
1 x | Rotorshape Elevator |
1 x | Raer wall |
1 x | Tail support (2 pcs) |
1 x | Blade holder lower |
1 x | Wheel keeper washer |
1 x | Screws M1,6x6 Allen |
1 x | Balls 4 mm |
1 x | Head lower part New |
1 x | Washer 2.2×4 |
1 x | Tail boom |
1 x | Nut M2 securing |
1 x | Side Plate |
1 x | Nut M1,6 |
1 x | Servo TOPMODEL DS9010 T |
1 x | Connectors banna oro 4 mm (M/F) |
1 x | XH female balance (2S) connector (2 pcs) |
1 x | 2 mm male connector (2 pcs) with safety connector |
1 x | 13 mm wing servo holder |
1 x | Battery LiPo GENS 3700 mAh 6S 22.2v 60C (Gens Ace) |
1 x | Steel Screw M1x8 (10 pcs) |
1 x | AC-10 pre-rotacion with motor |
1 x | Steering lever |
1 x | Head lower part |
1 x | Servo Fork |
1 x | Side rudder |
1 x | Motor wall |
1 x | Rudder |
1 x | Blade holder center |
1 x | Grub screw M3x3 shouldered (2 pcs) |
1 x | 18 mm wing servo holder |
1 x | Gold antispark 5,5 mm plug |
1 x | Banna gold connector 2,5 mm (100 M/F pairs) |
1 x | 90x60 mm standart servo cover |
1 x | Connectors banna oro 2 mm (M/F) (ultralight) |
1 x | EC5-Set male, simple quality, 2 x female pin, 1 x blue housing |
1 x | FesEx-Uni6 System |
1 x | Connectors banna oro 3 mm (M/F) |
1 x | XH male balance (2S) connector (2 pcs) |
1 x | Conector BEC male (10 pcs) |
1 x | XH female balance (4S) connector (2 pcs) |
1 x | 58 mm micro servo cover |
1 x | Servo BMS-4112 |
1 x | Servo BLS-M55B 61.2kg |
1 x | Carbon plate 350x150x1.0 mm |
|
7,631.66EUR |