| 2 x | Beech dowels 4.0 x 1000 mm |
| 1 x | Birch plywood plate 600x300x3.0 mm |
| 1 x | Balsa panel 6.0x100x1000 mm |
| 2 x | BALSA triangular 15x15x1000 mm |
| 1 x | Balsa panel 2.5x100x1000 mm |
| 1 x | quality beech plywood BIRCH 600x300x2.0 mm |
| 1 x | A/C quality beech plywood 600x300x5.0 mm |
| 1 x | BALSA trip 2.0x2.0x1000 mm |
| 1 x | Balsa panel 3.0x100x1000 mm |
| 1 x | Birch plywood plate 600x300x4.0 mm |
| 1 x | BALSA trip 5.0x5.0x1000 mm |
| 1 x | A/C quality beech plywood 600x300x0.6 mm |
| 1 x | Beech dowels 3.0 x 1000 mm |
| 1 x | A/C quality beech plywood 600x300x0.8 mm |
| 1 x | Balsa panel 10x100x1000 mm |
| 1 x | BALSA trip 4.0x4.0x1000 mm |
| 1 x | A/C quality beech plywood BIRCH 600x300x1.0 mm |
| 1 x | Balsa panel 4.0x100x1000 mm |
| 1 x | Beech dowels 2.0 x 1000 mm |
| 1 x | Balsa panel 2.0x100x1000 mm |
| 1 x | Black copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | 4 LiPo XH>EH adapter |
| 1 x | Adapter lead MPX/EC3 |
| 1 x | Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH |
| 1 x | Cable set PREMIUM, SUB-Done 4three fuselage/wing 160 cm |
| 3 x | CC 05 |
| 1 x | Double conector with JR adapter and 200 mm extension |
| 1 x | Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm) |
| 1 x | Copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | Bec MR UBEC 5A (5v/6v/7v) |
| 1 x | 3 LiPo XH>EH adapter |
| 1 x | Balanceradapter JST-XH (Heli 47G) 2-6 c. |
| 1 x | DPSI Ampere battery backer |
| 1 x | CellPRO 4S Adaptader (GP/KO up to 4S) |
| 1 x | DPS Switch JR/JR |
| 1 x | Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH |
| 1 x | Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm) |
| 1 x | BEC 3A FOXY |
| 1 x | Circlick securite |
| 1 x | Foil for sticking flaps and ailerons |
| 1 x | RUDDOG Protection and Heat Shield Tape (2mx50mm) |
| 1 x | |
| 3 x | SE Ring 330 mm (4 pcs) |
| 1 x | 20x1000 mm Ring Strap Back To Back |
| 1 x | 5 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
| 1 x | 20x200 mm battery rings |
| 2 x | 10 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
| 1 x | Tape GFK 38 mm |
| 2 x | SE Ring 360 mm (2 pcs) |
| 1 x | SE Ring 480 mm (2 pcs) |
| 1 x | SE Ring 450 mm (2 pcs) |
| 1 x | Spikes Band (5 m) |
| 2 x | SE Ring 350 mm (2 pcs) |
| 1 x | SE Ring 400 mm (2 pcs) |
| 1 x | 14x60 mm Mini rings Tie Wraps (4 pcs) |
| 1 x | 13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
| 1 x | 76 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs) |
| 1 x | Cylidric hinge 33 mm Ø 2 mm (5 pcs) |
| 1 x | Pin type hinge Al 3,0x50 mm (2 pcs) |
| 1 x | Long pinned hinge (6 uds) |
| 2 x | 43 x 10 mm cylidric hinge Ø 2,5 mm (10 pcs) |
| 2 x | Fast'n EZ-CA-Hinge (12 uds) |
| 1 x | 67 mm cylidric hinge Ø 5 mm (4 pcs) |
| 1 x | Large flex hinge (12 uds) |
| 1 x | Motor DLE 170 M- Paramotors |
| 1 x | Pine wood slat 2.0x2.0x1000 mm |
| 1 x | Ballast 700gr OPALE |
| 1 x | Straightened rod Ø 2.5 mm x 1000 mm |
| 1 x | Buy Perforated film 100 cm / 50 m |
| 1 x | Breatex™ Non-woven absorber 300 g/m² Roll 41 m |
| 1 x | Air pressure gauge |
| 1 x | Skies 2x 335 mm + 1x Esqui 250mm |
| 1 x | UBEC 6A KAVAN |
| 1 x | Female prolonguer XH 30 cm 6 cell cable of silicone 0,25 mm |
| 1 x | Exhaust elbow for SAITO FA65/72/80/82a/91S/100/ |
| 1 x | Male Prolonger TP 4/5S |
| 1 x | SBEC 30 D |
| 1 x | Connector Sub-D 2+5 Male |
| 1 x | PowerBox Smokepump |
| 2 x | Red copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | Electric Fuel Pump 12v |
| 1 x | Cabling for Fox MDM1 wings |
| 2 x | 30 cm BEC cable (male) |
| 1 x | PSC 6 |
| 1 x | Interruptor RX/Batterie |
| 1 x | Pins M connect Multipin connectors AWG 20-24 |
| 1 x | Servo slow down unit (0,7-14,7 sec ) |
| 1 x | EXTREME FLIGHT BLUE MAGNETIC ROUND FILLER PLUG |
| 1 x | 550 cc gasoline fuel tank complet |
| 1 x | Deposito DUBRO 3000cc-100oz |
| 1 x | 22m Fitting barb |
| 1 x | Extra hard 1500 ccm complete gasoline fuel tank |
| 1 x | 1/4 x 1/8" VITON tube for gas, kerosene, smoke (30 cm) |
| 1 x | EXTREME FLIGHT BLACK MAGNETIC ROUND FILLER PLUG |
| 1 x | Deposito SECRAFT V2 1000 ml Gas |
| 1 x | Balance "Y" Wire 6S, 2x JST-XH / 1x JST-EH |
| 1 x | 280 cc gasoline fuel tank complet |
| 1 x | SE Ring 300 mm (2 pcs) |
| 1 x | Tape GFK 25 mm |
| 1 x | Connector Sub-D 2+5 Female |
| 1 x | Pad Screw Mount M3, up to 3mm / 0.12″, (10 pcs) |
| 1 x | 26 mm self adhesive Pinking Tape, saw tooth height 1.0 mm |
| 1 x | Ring 320 mm length (5 pcs) |
| 1 x | 18 mm reinforced hinge |
| 1 x | Gates hinge |
| 1 x | 25 mm reinforced hinge |
| 1 x | Gates hinge aluminium (1 pcs) |
| 1 x | Gates hinge black 30x16 mm (2 pcs) |
| 1 x | Cylidric hinge 43 mm Ø 2,5 mm (5 pcs) |
| 1 x | Pin type hinge Al 4,5x70 mm (2 pcs) |
| 1 x | 3,9 mm ZG20-ZG38 servo arm |
| 1 x | Servo MKS 6100 DS |
| 1 x | Servo MKS HBL599 SL |
| 1 x | Micro flex hinge (12 uds) |
| 1 x | CC 01 |
| 1 x | Servo MKS HV747 |
| 1 x | Brazo servo MKS X8 Metal L:1.25/1.5 inc |
| 1 x | 48 mm cylidric hinge Ø 2,5 mm (5 pcs) |
| 1 x | Servo KST X10 V2.0 ala 10mm 28g 10.8Kg |
| 1 x | Servo KST X10 MINI wing 10mm 23g 7.5Kg |
| 1 x | Wheel Ø 90 mm (1 ud) Electron Retracts |
| 1 x | Wheel 28 mm |
| 1 x | 4" - 102 x 45 mm Ø5 mm aluminium core wheel |
| 1 x | 20 mm tail wheel for 0,5-1 Kg models |
| 1 x | Wheel 22 mm |
| 1 x | Wheel FEMA 165 mm / 8 mm |
| 1 x | Foam wheel Ø 38 mm (2 pcs) |
| 1 x | Wheel FEMA 112 mm / 6 mm |
| 1 x | 152x46 Ø6.0 mm aluminium core wheel |
| 1 x | Wheel 75 mm with electromagnet and brake disk (2 uds) |
| 1 x | Wheel FEMA 140 mm / 6 mm |
| 1 x | Wheel FEMA 152 mm / 8 mm |
| 1 x | Anodized aluminium servo M3x16 screw (4 red pcs) |
| 1 x | OBECHI sheet 2.0x3.0x1000 mm |
| 1 x | Walnut wood slat 1.5x1.5x1000 mm |
| 1 x | Mahogany wood slat 2.0x2.0x1000 mm |
| 1 x | Linden wood slat 3.0x3.0x1000 mm |
| 1 x | Servo KST BLS915 HV V8.0 25Kg 20mm 78g |
 |
| 4,244.37EUR |
