2 x | Cable grommet 9.5 mm (4 uds) |
2 x | 80 mm rods set for direction control |
1 x | 100 mm rods + T patellas set for direction control |
1 x | Aluminun wheel collar 6 mm Ø (4 uds) |
2 x | Allen wheel collar M3x5 |
1 x | 28x5 mm wires output (2 pcs) |
1 x | 45 mm rods + T patellas set for direction control |
1 x | 250 mm / 16 mm Airbrakes |
1 x | Canopy Latch |
1 x | 100 mm rods set for direction control |
1 x | Aluminun wheel collar 3 mm Ø (4 uds) |
1 x | Cable grommet Ø 5 mm (4 uds) |
1 x | Allen wheel collar M3x3 |
1 x | Clip mini fixing for wing (2 pcs) |
2 x | 41x5,5 mm wires output (2 pcs) |
1 x | Aluminun wheel collar 5 mm Ø (4 uds) |
1 x | 38x4,5 mm wires output (2 pcs) |
2 x | Allen wheel collar M4x6 |
1 x | 11 mm Rubber pads (14 pcs) |
1 x | Aluminun wheel collar 2 mm Ø (4 uds) |
1 x | Cabin latch Fox MDM1 4m (pair) |
1 x | Cable grommet Ø 4 mm (4 uds) |
1 x | Cockpit aluminium closing |
1 x | Aluminun wheel collar 4 mm Ø (4 uds) |
2 x | Aluminun wheel collar 2.5 mm Ø (4 uds) |
1 x | 45 mm rods set for direction control |
1 x | PIX Hawk with accesories |
2 x | PPM Encoder Module |
1 x | Cockpit plastic closing |
1 x | Crimping sleeves for cable 0.85 mm (10 pcs) |
1 x | Tip wing protector 28x10x12 (2 pcs) |
1 x | Screw-lock pushrod conn snap Ø 1.5 mm (2 uds) |
1 x | Cable grommet Ø 6.4 mm (4 uds) |
1 x | Snap long M2 (10 uds) |
1 x | Control for forward wheel (MINI) |
1 x | Allen wheel collar M4x4 |
1 x | Split M1,2x10 (10 pcs) |
1 x | Tip wing protector 30x10 (2 pcs) |
1 x | Snap for floding prop for 2 mm axi |
1 x | Split pin 1.6x16 mm (10 uds) |
1 x | Landing gear frontal support 29x26x13,5 |
1 x | Threaded coupler ALU M3 Ø 4 (2 uds) |
1 x | Aluminium blue ball links M3 V1 (10 pcs) |
1 x | Z type of cable coupler Ø 2 (2 uds) |
1 x | Threaded coupler ALU M2,5 Ø 4 (2 uds) |
1 x | Xplorer3 anemometro |
1 x | Clevis plastico I=45 mm / hole 3mm / pin 1 (2 pcs) |
1 x | Brass ball links BS M3 V1 (10 pcs) |
1 x | Couple M4 for wire (10 pcs) |
1 x | Aluminium coupler M2/2 with ball bearing (1 pcs) |
1 x | Threaded coupler Micro M2 Ø 0,8 mm (10 pcs) |
1 x | Aluminium coupler M3/2 with ball bearing (1 pcs) |
1 x | Threaded coupler ALU M2 Ø 4 (2 uds) |
1 x | Kwik link AL M2,5 L:23 mm (2 pcs) + Pin Ø 1,6 mm |
1 x | Ball link Aluminio M3 (2 pcs) |
1 x | Ball link V1 Ø7 M4/3 (6 uds) |
1 x | Threaded coupler M2,5 Ø 2 mm (10 pcs) |
1 x | Straightened threaded rod M3 - 1m |
1 x | Straightened rod Ø 2.0 mm x 1000 mm |
1 x | Glases Stratus |
1 x | Wheel collar 6 mm Ø (4 uds) |
1 x | Conector XT-30 (hembra) |
1 x | Screw-lock connector Ø 2 mm (2 uds) |
1 x | 1/10 Pilot "Jack" |
1 x | Steering arm 12 mm Ø 4 mm (2 uds) |
1 x | Ball link M3 RPA's-UAV's |
1 x | Profile ABS Square 2 x 1000 mm |
1 x | ABS "T" angle 4.0x4.0x1000 mm |
1 x | Clip fixing for wing (2 pcs) |
1 x | Canopy Lock V1 M3 Red (2 pcs) |
1 x | Cable tie mounts 4.3 (4 uds) |
1 x | Tube Pitot to PIXHAWK |
1 x | Fully Threaded Steel Rod M2,0 (2 uds) 250mm |
1 x | Stainless steel cable Ø 0.88 mm - 60 kp (10 m) |
1 x | Fully Threaded Steel Rod Duralumin 110 mm M3 (2 pcs) |
1 x | Canopy Lock V1 M3 Blue (2 pcs) |
1 x | 140 mm rods set for direction control |
1 x | Wing bolts M3 Steel screw Red (2 pcs) |
|
690.81EUR |