2 x | Canister combo DLE 120 cc |
1 x | Ignition unit for DA-70/100/120/150/170/200 |
1 x | Ignition for DA-35 (without pickup sensor) |
1 x | Piston ring for DA-60 and DA-120 |
1 x | Rear crankcase DA-50R |
1 x | Piston ring for DA-85 and DA-170 |
1 x | Prop washer DA-50R/60/70 |
1 x | L ELBOW DA-150 "normal" (2 pcs) |
1 x | Piston ring for DA-50R and DA-100 |
1 x | Steel conrod DA-50R and DA-60 |
1 x | Reed valve carrier for DA-85, DA-100L and DA-120 |
1 x | Carburator spacer block DA-50R |
1 x | Reed valve for DA-60/70 |
1 x | L ELBOW 90º ø 25 mm |
2 x | BOSCH spark plug cap for DA 50-R, DA 100 and DA 150 |
1 x | Woodruff key for DA50/85/100/150 and DA 200 |
1 x | L ELBOW DA-120 long (2 pcs) |
1 x | Cylinder DA-50R, DA-100, DA-100L |
1 x | Low speed needle DA-50R/100I |
1 x | Front axi for DA85/DA100/DA100L/DA120 |
1 x | Hifht speed needle DA-50R/100I |
1 x | Stainless steel silencer for DA 150/150L |
1 x | Piston pin for DA50R/DA100 |
1 x | Cylinder for DA-85/170 (1 piece) |
1 x | Cylinder for DA-60 and DA-120 |
1 x | Sandwich carbon + poplar 4mm + carbon 480x290 mm |
1 x | FALCON 20X9 CARBON PROPELLER (GAS) |
1 x | Propeller APC 14x8.5 Electric Pusher |
1 x | Straightened rod Ø 14.0 mm x 1000 mm |
1 x | Propeller POWER-PROP 14x9 |
1 x | Propeller POWER-PROP 14x9 Izda |
1 x | Motor ST 7-160 B |
1 x | DLE-111 Crankcase V2 Conversion Kit |
1 x | DLE 30 complete electronic ignition |
1 x | Ball bearing middle DA-120 |
1 x | Cylindergasket DA 170 |
1 x | Aluminium-screw, M5x16mm Red |
1 x | Aluminium-screw, M5x20mm Red |
1 x | DA-100 Bearing |
1 x | Aluminium-Plate, carb>reed valve carrier, DA-85 DA-100L and DA-1 |
1 x | Piston for DA-50R, DA-100, DA-100L |
1 x | Reed valve Retainer, black rubber for DA-85, DA-100L and DA-120 |
1 x | Carbon tube (L 1000 mm, Ø12 mm, Ø10 mm) |
1 x | Sandwich carbon + poplar 2mm + carbon 480x290 mm |
1 x | Circlick securite |
1 x | BALSA trip 6.0x6.0x1000 mm |
1 x | Breatex™ Non-woven absorber 150 g/m² Roll 20m |
1 x | Buy Perforated film 100 cm / 50 m |
1 x | 0,14 mm PVC servo wire extension, ZH micro conector. |
1 x | Carbon Non-crimp ST 100 g/m² 50 cm x 10 m |
1 x | 15 mm reinforced hinge |
|
6,111.71EUR |