| 1 x | Gold antispark 4 mm plug |
| 1 x | Connectors banna oro 4 mm (M/F) |
| 1 x | XH male balance (2S) connector (2 pcs) |
| 1 x | 2 mm male connector (2 pcs) with safety connector |
| 1 x | EC5-Set male, simple quality, 2 x female pin, 1 x blue housing |
| 1 x | Connectors DEANS (T) |
| 1 x | Connectors banna oro 8,0 mm (M/F) |
| 1 x | MPX Sub-D Adaptor |
| 1 x | 2 mm female connector (2 pcs) with safety connector |
| 1 x | Conector AS150 7mm antichispazo (Set: 2 pares) |
| 1 x | 30 cm DEANS female connector |
| 1 x | Connectors banna oro 2 mm (M/F) (ultralight) |
| 1 x | XH male balance (4S) connector (2 pcs) |
| 1 x | XH female balance (4S) connector (2 pcs) |
| 1 x | XH female balance (5S) connector (2 pcs) |
| 1 x | Connectors banna oro 0,8 mm (M/F) |
| 1 x | Optotronix Aurora Plug |
| 1 x | Connectors banna oro 4 mm (M/F) (ultralight) |
| 1 x | 3 copper lacquer wire Ø0,2 mm (1 m) |
| 1 x | JETImodel SINGLE BEC |
| 1 x | Futaba External voltage input cable Futaba CA-RVIN-700 |
| 1 x | 30 cm BEC cable (male) |
| 1 x | MPX-Dean "T" Adapter |
| 1 x | "Y" charging 4mm wire (2 IN-1 OUT). |
| 1 x | 3 LiPo XH>EH adapter |
| 2 x | Adapter lead MPX/EC3 |
| 1 x | CC 02 |
| 1 x | Cabel charger transmitter GRAUPNER |
| 2 x | TP/TopFuel - XH 2/3S Adapter |
| 1 x | CC 05 |
| 1 x | CC 03 |
| 2 x | APM2.6 Power module with 5.3V DC BEC |
| 1 x | Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm) |
| 1 x | Adapter lead MPX/XT60 |
| 1 x | Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH |
| 1 x | Streamline Stainless Steel Tubing 12.3x7.7x1000 mm |
| 1 x | Motor DLE 170 M- Paramotors |
| 5 x | Profile ABS Square 1 x 1000 mm |
| 2 x | ABS angle 10,0x10,0x1000 mm |
| 1 x | Streamline Stainless Steel Tubing 17.8x12.4x1000 mm |
| 1 x | FALCON 20X9 CARBON PROPELLER (GAS) |
| 1 x | Cross Connector 4.0 mm x 1000 mm |
| 1 x | Fibra de vidrio 80 g/m² (2 m x 100 cm) |
| 2 x | ABS "T" angle 4.0x4.0x1000 mm |
| 1 x | ABS "T" angle 6.0x6.0x1000 mm |
| 2 x | T-Connector 4.0 mm x 1000 mm |
| 2 x | U Profile ABS 8,0x4,0x1000 mm |
| 1 x | Streamline Stainless Steel Tubing 6.3x3.5x1000 mm |
| 2 x | ABS angle 5,0x5,0x1000 mm |
| 1 x | L-Connector 1.5 mm x 1000 mm |
| 2 x | Flat Connector 4.0 mm x 1000 mm |
| 2 x | L-Connector 1.0 mm x 1000 mm |
| 1 x | Profile ABS Square 3 x 1000 mm |
| 1 x | ABS angle 2,0x2,0x1000 mm |
| 1 x | Streamline Stainless Steel Tubing 15.5x8.5x1000 mm |
| 3 x | Streamline Stainless Steel Tubing 19.5x9.8x1000 mm |
| 1 x | Propeller POWER-PROP 14x9 |
| 1 x | Streamline Stainless Steel Tubing 7.5x4.5x1000 mm |
| 3 x | U Profile ABS 1,0x2,0x1000 mm |
| 2 x | L-Connector 4.0 mm x 1000 mm |
| 3 x | ABS "T" angle 8.0x8.0x1000 mm |
| 1 x | Para-RC Trike "RC-Bullix" |
| 1 x | Hard aluminium thin-walled tube with fibreglass case ø30x1mm, 1m |
| 1 x | Crimping sleeves for cable 0.70 mm (10 pcs) |
| 1 x | Steering arm 16 mm Ø 4 mm |
| 1 x | 50m servo "Premium" wire (white/red/blue) |
| 1 x | U Profile ABS 3,0x6,0x1000 mm |
| 1 x | Sandwich carbon + poplar 4mm + carbon 480x290 mm |
| 1 x | Support Pitot JETI |
| 1 x | Prolonguer for Balancer Thunder Power 6S |
| 1 x | Female connector for 6 pines AWG |
| 1 x | Combustible Glow "KAVAN" air/heli 5% nitro |
| 1 x | Interruptor RX/Batterie |
| 1 x | Male connector for 12 pines AWG |
| 1 x | Red copper lacquer wire Ø0,2 mm (5 m) |
| 2 x | Connector Sub-D 2+5 Female |
| 1 x | USB interface ALTIS |
| 1 x | PWC6 PowerWingConnector for 6 servos with fuselage socket |
| 1 x | Fuel bottle 500 ccm |
| 1 x | SKY RC T400Q Charger 4x100w |
| 1 x | BETA 1400 ARF Red |
| 1 x | Female connector for 12 pines AWG |
| 1 x | SPARK Switch 12v |
| 1 x | Electric Fuel Pump 12v |
| 1 x | BEC 3A FOXY |
| 2 x | Female connector JST SH 1.0mm with 10 cm wire |
| 1 x | UBEC 6A KAVAN |
| 1 x | Engine mounts for .09 - .19 engine |
| 1 x | Pin hinge 39x20 mm (10 uds) |
| 1 x | Glow starter with charger 230v |
| 1 x | USB HLS prog. interface |
| 1 x | XT60 Connector with Holder Male 2pcs |
| 1 x | SPARK Switch 5.9v |
| 1 x | BETA 1400 RTF Red |
| 2 x | Male connector for 6 pines AWG |
| 1 x | wing/fuselage connector for 3 pines AWG 20-24 |
| 1 x | Banna gold connector 2,5 mm (M/F) |
| 1 x | USB Interface REVOLECTRIX for CellPRO 10s |
| 2 x | Copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | Ciano KAVAN Thick 20g |
| 1 x | Adaptadores carga 6s JST-XH |
| 1 x | Anodized aluminium servo M4x5/8 screw (4 silver pcs) |
| 1 x | Blind nut M4 (10 pcs) |
| 1 x | Aluminium cap bolt washer M3 blue (8 pcs) |
| 1 x | Blind nut M2 (10 pcs) |
| 1 x | AL Axle Shaft 4.0x16 mm (2 uds) |
| 1 x | Aluminium cap bolt washer M4 green (8 pcs) |
| 1 x | Aluminium M2x12 mm screw (4 pcs) |
| 1 x | Aluminium wide washer M4 Blue (4 pcs) |
| 1 x | Spray adhesive INFUTAC (Clear) 500 ml |
| 1 x | Release wax 250ml |
| 1 x | Wheel collar 5 mm Ø (4 uds) |
| 1 x | Wheel collar 2 mm Ø (4 uds) |
| 1 x | DC Small for MultiLog & UltraLight |
| 1 x | Aluminun wheel collar 6 mm Ø (4 uds) |
| 1 x | Propeller APC 14x8.5 Electric Pusher |
| 1 x | Servo GO-1035MG 16 kg.cm 0.08s/60º |
| 1 x | Waterproof adhesive tape, width 19mm, length 25m |
| 2 x | Streamline Stainless Steel Tubing 9.0x5.0x1000 mm |
| 1 x | Profile ABS half cane 2.0x1000 mm |
| 1 x | DUPLEX 2.4EX Central Box 210 |
| 2 x | Profile ABS half cane 3x1000 mm |
| 1 x | Sandwich carbon + poplar 4mm + carbon 290x160 mm |
| 1 x | Sandwich carbon + poplar 3mm + carbon 290x160 mm |
| 1 x | Spray EC Red 400ml |
| 1 x | Nitroverdu 500 ml |
| 1 x | Partall paste 650 g |
| 1 x | DPSI LR-S (with push buttons) |
| 1 x | DPSI RV Mini 5 Magic |
| 1 x | Heat sink for Optotronix LEDs |
| 1 x | Cable-Tie 1.66x71mm / 0.07x2.8″ (20 pcs) |
| 1 x | FALCON 25X9 CARBON PROPELLER (GAS) |
| 1 x | Propeller FALCON 5-BL 24x23.5 |
| 1 x | Cover cap drop-shaped paintable 43 mm |
| 1 x | DPSI 2001 RV |
| 1 x | EWC3 40 cm wing connector |
| 1 x | Conector BEC female (10 pcs) |
| 1 x | 30 cm BEC cable (female) |
| 1 x | Shaft sleeve LAMA |
| 1 x | MAX BEC 2D plus EX |
| 1 x | Spinner 60 mm Black (Kavan) |
| 1 x | Metalic motor holder for class 550-600 |
| 1 x | Receiver bed (Blue) |
| 1 x | A50 Motor Mount Alu complete set |
| 1 x | PT 21x13 EL Propeller |
| 1 x | Superlight deluxe wheel 40 mm (2 pcs) |
| 1 x | Electronic switch JETI SP06 Opto |
| 1 x | PITTS CHALLENGER 87″ 2.20m (120cc) 02 ARF |
| 1 x | Debonder CA 20g |
| 1 x | SAVAGE Max Red 1080 mm |
| 1 x | Propeller balancer |
| 1 x | LiPo KAVAN 3700 mAh 14.8v 40/80C |
| 1 x | Servo GO-1023MG 7.0 kg.cm 0.09s/60º |
| 1 x | PSC 6 |
| 1 x | Logo 400 SE VBar |
| 1 x | Screw M3x30 (10 pcs) |
| 1 x | Nut for mounting M3 (4 pcs) |
| 1 x | Quicklock washer 3.5 mm (10 pcs) |
| 1 x | Nut for mounting M2 (4 pcs) |
| 1 x | Screw M3x20 (10 pcs) |
| 1 x | Nylon Screw M5x30 |
| 1 x | Screw KB 1.4x6 mm (10 pcs) |
| 1 x | Propeller POWER-PROP 11x9 |
| 1 x | Rubber profile 10-2 mm 2M |
| 1 x | ABS "T" angle 10.0x10.0x1000 mm |
| 1 x | U Profile ABS 5,0x10,0x1000 mm |
| 1 x | ABS angle 3,0x3,0x1000 mm |
| 1 x | Rubber profile 6-2 mm 2M |
| 1 x | BOSCH spark plug cap for ZG 26SC/SCM, 231SLH, G230RC |
| 1 x | Propeller POWER-PROP 16x8 |
| 1 x | Propeller MASTER AIRSCREW 9x6 |
| 1 x | FALCON 24X12 CARBON PROPELLER (GAS) |
 |
| 8,302.53EUR |
