| 1 x | Big-Malibu XL Roof box with surfboard rack GREY |
| 1 x | Cap closure 33/23.5mm (2 uds) |
| 1 x | Electric spoiler 250 mm (2 pcs) |
| 1 x | Stainless steel cable Ø 0.5 mm (10 m) |
| 2 x | Extension 100 cm (Futaba) |
| 2 x | Cabel "Y" 15 cm |
| 1 x | Cable S.BUS 3 salidas 300 mm |
| 1 x | 0,14 mm PVC servo wire extension, ZH micro conector. |
| 1 x | Prolongador S-Bus JR/JR 20cm |
| 1 x | Extension 15 cm (Futaba) |
| 3 x | RF9 Flight Simulator with Spektrum Controller |
| 1 x | servo adapter lead, JST-SH socket - JR male Pin, for GR-12SH+HoT |
| 2 x | Adapter lead MPX/XT60 |
| 1 x | Aluminum Bayonet / strongal D12 mm / 0.5 m |
| 1 x | Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm) |
| 1 x | 30 cm BEC cable (female) |
| 1 x | Cabel charger transmitter GRAUPNER |
| 1 x | Balanceradapter JST-XH (Heli 47G) 2-6 c. |
| 1 x | "Y" charging 4mm wire (2 IN-1 OUT). |
| 1 x | Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm) |
| 1 x | Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH |
| 1 x | 3 LiPo XH>EH adapter |
| 1 x | Bec MR UBEC 5A (5v/6v/7v) |
| 1 x | Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm) |
| 1 x | BEC 3A FOXY |
| 1 x | Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH |
| 1 x | 4 LiPo XH>EH adapter |
| 1 x | BALSA trip 2.0x10.0x1000 mm |
| 2 x | Walnut wood slat 3.0x3.0x1000 mm |
| 1 x | BALSA trip 4.0x4.0x1000 mm |
| 1 x | BALSA trip 5.0x5.0x1000 mm |
| 2 x | BALSA trip 3.0x3.0x1000 mm |
| 1 x | BALSA trip 2.0x2.0x1000 mm |
| 1 x | Beech dowels 4.0 x 1000 mm |
| 1 x | BALSA trip 6.0x6.0x1000 mm |
| 1 x | Pine wood slat 2.0x10.0x1000 mm |
| 1 x | Pine wood slat 5.0x5.0x1000 mm |
| 1 x | Liston HAYA 10 x 10 x 1000 mm |
| 2 x | BALSA trip 8.0x8.0x1000 mm |
| 1 x | Beech dowels 2.0 x 1000 mm |
| 1 x | Walnut wood slat 1.5x1.5x1000 mm |
| 1 x | BALSA trip 3.0x5.0x1000 mm |
| 1 x | Pine wood slat 3.0x7.0x1000 mm |
| 1 x | Pine wood slat 3.0x5.0x1000 mm |
| 1 x | Pine wood slat 10x10x1000 mm |
| 1 x | Trailing edge BALSA 35x8x1000 mm |
| 2 x | Mahogany wood slat 3.0x3.0x1000 mm |
| 1 x | Pine wood slat 6.0x6.0x1000 mm |
| 1 x | Joint with bearing M3 22x5,5 |
| 1 x | M2/M1/6 3Diam short black ball link V1 (2 pcs) |
| 1 x | Ballast 700gr OPALE |
| 1 x | 1/4 Pilot "Heidi" |
| 1 x | Set cintas unión paracaídas 145 cm |
| 1 x | Motor A2212/13T |
| 1 x | Threaded coupler ALU Left M2,5 Ø 3 (2 uds) |
| 1 x | Silicone 0,25 qmm servos wire Graupner (5 m) |
| 1 x | Carbon fiber flat 1000x3.0x1.0 mm |
| 1 x | Carbon fiber flat 1000x3.0x1.0 mm |
| 1 x | Round Rod 5,0x1000 mm |
| 1 x | PVC 0,14 qmm servos wire JR/Graupner (5 m) |
| 1 x | Dumper propeller 6/8 mm |
| 1 x | 3,2 mm Prop Adapter M8 |
| 1 x | 6 mm Prop Adapter M8 |
| 1 x | Pine wood slat 2.0x2.0x1000 mm |
| 1 x | Cable silicona female batt. receptor 30 cm (Futaba) |
| 1 x | Prolongador S-Bus JR/JR 10cm |
| 1 x | Extension lead 15 cm Multiplex |
| 1 x | Extension S-Bus 1-2 silicon 30 cm FUTABA |
| 2 x | Interface Jack Adapter IKARUS |
| 1 x | Extension PVC 150 cm (Graupner) |
| 1 x | Slave-cable USB Easy Sim |
| 1 x | Extension silicon 30 cm male (Graupner) |
| 1 x | Futaba Female 40 cm extension |
| 3 x | GameCommander USB Universal |
| 1 x | Tarjeta programadora RAY G2 |
| 1 x | Jeti Advance Plus Program Card |
| 1 x | Extension silicon 100 cm (Graupner) |
| 1 x | Extension silicon 30 cm female (Graupner) |
| 1 x | Premium servo extension 75cm |
| 1 x | EasyFLY Addon |
| 1 x | PROFI Box JETI |
| 1 x | Walnut wood slat 2.0x2.0x1000 mm |
| 1 x | Long Switch On/Off micro |
| 1 x | wing/fuselage connector for 16 pines AWG 20-24 |
| 1 x | Liston HAYA 8 x 8 x 1000 mm |
| 2 x | Linden wood slat 3.0x3.0x1000 mm |
| 1 x | quality beech plywood BIRCH 600x300x2.0 mm |
| 1 x | BALSA triangular 15x15x1000 mm |
| 1 x | Male connector for 20 pines AWG |
| 1 x | SPS Remote switch actuator |
| 1 x | A/C quality beech plywood 600x300x8.0 mm |
| 1 x | SPARK Switch 5.9v |
| 1 x | Connector CAN 15 |
| 1 x | BALSA triangular 6x6x1000 mm |
| 1 x | Birch plywood plate 600x300x1.2 mm |
| 1 x | Lite Plywood panel 600x300x3.0 mm |
| 1 x | DPSI Ampere battery backer |
| 1 x | Surface Indicator Gauge Small |
| 1 x | Simulador RealFlight RF-9.5 S (sin emisora) |
| 1 x | Birch plywood plate 600x300x4.0 mm |
| 1 x | USB interface ALTIS |
| 1 x | Extension 2/3 lipos JST - JST/C |
| 1 x | Interruptor RX/Batterie |
| 1 x | SBEC 40 |
| 2 x | A/C quality beech plywood 600x300x5.0 mm |
| 1 x | SIMtransmitter 6 Mode 2 |
| 1 x | A/C quality beech plywood 600x300x1.5 mm |
| 1 x | Servo slow down unit (0,7-14,7 sec ) |
| 1 x | DPSI magnetic switch actuator (housing) |
| 1 x | Pine wood slat 3.0x10.0x1000 mm |
| 1 x | Female connector for 10 pines AWG |
| 1 x | BALSA trip 10x10x1000 mm |
| 1 x | Pins M connect Multipin connectors AWG 20-24 |
| 1 x | Switching module high voltage SXH |
| 1 x | A/C quality beech plywood 1520x750x3.0 mm |
| 1 x | EDGE 540 1.73m SEAGULL Model |
| 1 x | ARS 300 91" ARF 2311mm ORANGE |
| 1 x | SLICK 360-B 104" (2640 mm) |
| 1 x | Sun Cover ULTIMATUM 2.0 (Hispano Aviacion) |
| 1 x | Servo AN-20 MGBBA |
| 1 x | ALU servo arm 3 mm shaft |
| 1 x | Sukhoi 29S 2,6 m White/Blue (SebART) |
| 1 x | Sebart 2.2 m YELLOW/BLACK (SebART) |
| 1 x | EXTRA 330 LX 2.34m ARF (LX-09) Pilot |
| 1 x | EDGE 540-A 74" (1880 mm) |
| 1 x | Sukhoi 29S 2,6 m,CF landing gear(SebART) |
| 1 x | EXTRA 330L 35% hardware pack (Precision Aerobatics) |
| 1 x | EDGE 540-A 91" (2310 mm) |
| 1 x | EXTRA NG 74" white/red/blue (Skywing RC) |
| 1 x | PITTS CHALLENGER 87″ 2.20m (120cc) 03 ARF |
| 1 x | PITTS CHALLENGER 87″ 2.20m (120cc) 02 ARF |
| 1 x | SLICK 103" Yellow/Blue ARF (Color 2) 2630 mm |
| 1 x | ALU servo arm 90º 3 mm shaft |
| 1 x | Servo AN-8 HBA |
| 1 x | Sukhoi 29S 2,6 m Yellow/Black (SebART) |
| 1 x | Servo TT ACE SHV 1504 MG |
| 1 x | Fuselage Bags JEEMO |
| 1 x | Hacker X-Pro USB interface V2 |
| 1 x | SPS 70V 140/280 A |
| 1 x | Male connector for 6 pines AWG |
| 1 x | Extension 5 lipos JST/C |
| 1 x | Female connector for 6 pines AWG |
| 1 x | Dean "T" - Futaba Adapter |
| 1 x | Balsa panel 5.0x100x1000 mm |
| 1 x | 12V Car Adapter |
| 1 x | Coversion set HIROBO EX/EAGLE elektro |
| 1 x | JEEMO Kit ARF Basic (2 color Carbon finish) XTRALIGHT |
| 1 x | Micro Crystal RX 35.010 Ch 61 |
| 1 x | Stainless steel cable Ø 0.5 mm (20 m) |
| 1 x | VIPER JET G2 Esq. 5 Green/White/Blue |
| 1 x | 9x4.7 * 22x12 carbon propeller |
| 1 x | Hovercraft sailcloth |
| 1 x | Program 5v SIO RS 232 |
| 1 x | 50N turbine start protection tube |
| 1 x | Motor mount class 48" |
| 1 x | PT 21x13 EL Propeller |
| 1 x | Sandwich carbon + poplar 2mm + carbon 480x290 mm |
| 1 x | BALSA triangular 10x10x1000 mm |
| 1 x | Three-position switched channel, short |
 |
| 22,244.44EUR |
