| 1 x | Propeller POWER-PROP 14x9 Izda |
| 1 x | Zurich Sport Sunglasse Dark Sensity BROWN Glasses |
| 1 x | Aluminum Bayonet / strongal D12 mm / 0.5 m |
| 1 x | 20x1000 mm Ring Strap Back To Back |
| 1 x | White smoke bombs AX-3 (10 pcs) |
| 1 x | SE Ring 480 mm (2 pcs) |
| 1 x | Smoke set "S" |
| 1 x | Circlik for shaft 1.5 mm (10 pcs) |
| 1 x | 2 mm female connector (2 pcs) with safety connector |
| 1 x | Conector BEC female (10 pcs) |
| 1 x | BALSA triangular 8x8x1000 mm |
| 1 x | BALSA trip 3.0x5.0x1000 mm |
| 1 x | Lock washer 4.3 mm (20 pcs) |
| 1 x | Conector Servo female 4 pines |
| 1 x | Support pumb/filter Xicoy X45 |
| 1 x | Gold antispark 4 mm plug |
| 1 x | Cylidric hinge 43 mm Ø 2,5 mm (5 pcs) |
| 1 x | BEC 3A FOXY |
| 2 x | TP/TopFuel - JST-EH 4/5S Adapter |
| 2 x | Propeller balancer |
| 1 x | Fast'n EZ-CA-Hinge (12 uds) |
| 2 x | Field folding model stand SebArt |
| 1 x | 67 mm cylidric hinge Ø 4,5 mm (5 pcs) |
| 2 x | USB HLS prog. interface |
| 2 x | 30 cm BEC cable (male) |
| 1 x | JETImodel SINGLE BEC |
| 1 x | Kwik link AL M4 con Clip (2 pcs) |
| 1 x | Clevis plastico I=26 mm / hole 2mm / pin 1 (2 pcs) |
| 1 x | Straightened rod Ø 14.0 mm x 1000 mm |
| 1 x | Clip fixing for wing (2 pcs) |
| 1 x | Ball link Aluminio M3 x 3 x 5 x 18mm (6 uds) |
| 1 x | Straightened rod Ø 1.5 mm x 1000 mm |
| 1 x | 250 mm / 16 mm Airbrakes |
| 2 x | Aluminun wheel collar 6 mm Ø (4 uds) |
| 2 x | Ball link Aluminio M3 (6 uds) 27x11.9x5.9 mm |
| 2 x | Straightened rod Ø 1.2 mm x 1500 mm |
| 1 x | Cable grommet Ø 3.2 mm (4 uds) |
| 2 x | Ball link duraluminium M3 V1 (10 pcs) |
| 1 x | 80 mm rods set for direction control |
| 2 x | Brass hexagonal rod Ø 3 mm x 1000 mm |
| 1 x | 28x5 mm wires output (2 pcs) |
| 2 x | Straightened rod Ø 2.0 mm x 1000 mm |
| 1 x | Brass rod Ø 1.0 mm x 1000 mm |
| 1 x | Clip mini fixing for wing (2 pcs) |
| 1 x | Canopy Latch |
| 1 x | BRASS CONTROL HORN M3x16 mm 2pcs |
| 1 x | Motor mount EDGE 540 48" |
| 1 x | Mini-Pix Esc 15 Amp |
| 1 x | Cargador para AA/AAA Ni-MH & Ni-Cd |
| 1 x | MPX PCB "Gender-Changer (5 pcs) |
| 1 x | Screw M3x5 (10 pcs) |
| 1 x | Quicklock washer 4 mm (10 pcs) |
| 1 x | Pan head screw M2x16 PH |
| 1 x | Quicklock washer 1.5 mm (10 pcs) |
| 1 x | SPS 70V 100/200 A |
| 1 x | Opto Gas Engine Kill Switch |
| 1 x | Servoholder Dymond DS 1800 MG Digital (2 pcs) |
| 1 x | Opto Gas Engine Kill Switch |
| 1 x | SBEC Jeti |
| 1 x | 3 LiPo XH>EH adapter |
| 1 x | Copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | Interruptor RX/Batterie |
| 2 x | Angle measurer |
| 1 x | Male Prolonger TP 4/5S |
| 1 x | Female connector for 6 pines AWG |
| 1 x | Black copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | Propeller balancer |
| 1 x | CellPRO 4S Adaptader (GP/KO up to 4S) |
| 2 x | Truck-trailer for gliders 720 x 285 mm |
| 1 x | Extension 2/3 lipos JST/C |
| 1 x | CC 02 |
| 1 x | Brass hexagonal rod Ø 4 mm x 1000 mm |
| 1 x | Screw M3x20 (10 pcs) |
| 1 x | Nut for mounting M4 (4 pcs) |
| 1 x | Screw M2.5x10 (10 pcs) |
| 1 x | Screw M4x30 (10 pcs) |
| 1 x | Pan Head Screw M1,6x6 (10 pcs) |
| 1 x | Screw KB 1.4x6 mm (10 pcs) |
| 1 x | Nut for mounting M2 (4 pcs) |
| 1 x | Screw M3x8(10 pcs) |
| 1 x | Pan Head Screw M1,6x8 (10 pcs) |
| 1 x | Nut for mounting M2,5 (4 pcs) |
| 1 x | Screw M2.5x5 (10 pcs) |
| 1 x | Quicklock washer 3 mm (10 pcs) |
| 1 x | Pan Head Screw M2x8 PH |
| 1 x | Nut for mounting M3 (4 pcs) |
| 1 x | Nut for mounting M3 (10 pcs) |
| 1 x | Nylon Screw M6x40 |
| 1 x | Screw M2x8 (10 pcs) |
| 1 x | Screw M2x6 (10 pcs) |
| 1 x | Screws 2,2 x 6,5 mm (20 pcs) |
| 1 x | Pan Head Screw M2x6 PH |
| 1 x | Screw M4x12 (10 pcs) |
| 1 x | USB Interface REVOLECTRIX for CellPRO 10s |
| 1 x | Pins M connect Multipin connectors AWG 20-24 |
| 1 x | Short Switch On/Off micro |
| 1 x | TrainerCord (master-learner) |
| 1 x | Switc electronic 30 Amp |
| 1 x | Prolonguer for Balancer Thunder Power 6S |
| 1 x | wing/fuselage connector for 16 pines AWG 20-24 |
| 1 x | Servo slow down unit (0,7-14,7 sec ) |
| 1 x | SBEC 30 D |
| 1 x | wing/fuselage connector for 12 pines AWG 20-24 |
| 1 x | SPARK Switch 7.4v |
| 1 x | PSC 6 |
| 1 x | UBEC 6A KAVAN |
| 1 x | TP/TopFuel - XH 2/3S Adapter |
| 1 x | Red copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | SPARK Switch 5.9v |
| 1 x | Multi-adapter balancer JST - TP |
| 1 x | Servo Dymond D 37 Eco |
| 1 x | Gear for D 200 BX |
| 1 x | PWC6 PowerWingConnector for 6 servos with fuselage socket |
| 1 x | Gear for MICRO BB |
| 1 x | SBEC 40 |
| 1 x | SWTU2 switch |
| 1 x | Switching module high voltage SXH |
| 1 x | USB interface ALTIS |
| 1 x | SPARK Switch 12v |
| 1 x | wing/fuselage connector for 6 pines AWG 20-24 (without pines) |
| 1 x | 30 cm BEC cable (female) |
| 1 x | Female connector JST SH 1.0mm with 10 cm wire |
| 1 x | Tester LiPo/LiIon/LiMn/LiFe |
| 1 x | Angle of incidence meter |
| 2 x | Medidor ángulos y/o incidencias |
| 1 x | Truck-trailer for gliders 720 x 239 mm |
| 1 x | Balanceradapter JST-XH (Heli 47G) 2-6 c. |
| 1 x | Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm) |
| 1 x | Brass rod Ø 1.5 mm x 1000 mm |
| 1 x | Aluminium alloy coupler for carbon tube 6/M4 |
| 1 x | Cable grommet Ø 5 mm (4 uds) |
| 1 x | Straightened rod Ø 1.0 mm x 1000 mm |
| 1 x | Straightened rod Ø 0.8 mm x 1000 mm |
| 1 x | Ball Link M2 with Ball and Hardware, 10 pcs |
| 1 x | Threaded coupler Micro M2 Ø 0,8 mm (10 pcs) |
| 1 x | Ball link Aluminio M4 x 4 x 6 x 26mm (4 uds) |
| 1 x | Aluminium red ball links M3 V1 (10 pcs) |
| 1 x | LH long black aluminium horn L31xH30 (2pcs) |
| 1 x | Brass control horn M4 short for wire (10pcs) |
| 1 x | Threaded coupler ALU M3 Ø 4 (2 uds) |
| 1 x | Aluminun wheel collar 3.5 mm Ø (4 uds) |
| 1 x | Aluminium blue ball links M3 V1 (10 pcs) |
| 1 x | Kwik link AL M3 L:30 mm (2 pcs) + Pin Ø 2,0 mm |
| 1 x | Ball Link ALU M3 - RH (1 pcs) |
| 2 x | Clevis plastico I=30 mm / hole 2.5mm / pin 1 (2 pcs) |
| 1 x | Kwik link AL M4 L:40 mm (2 pcs) + Pin Ø 2,5 mm |
| 1 x | Threaded coupler M3 (10 uds) |
| 1 x | Angled clevis with threaded rod M3 |
| 1 x | Clevis plastico I=45 mm / hole 3mm / pin 1 (2 pcs) |
| 1 x | Kwik link AL M3 con Clip (2 pcs) |
| 1 x | Threaded coupler M2 (10 uds) |
| 1 x | Fully Threaded Steel Rod alumin 90 mm M3 (2 pcs) |
| 1 x | Fully Threaded Steel Rod alumin 60 mm M3 (2 pcs) |
| 1 x | Pushrod octagone 3/2 with coupler M2 |
| 1 x | Fully Threaded Steel Rod alumin 30 mm M3 (2 pcs) |
| 1 x | Fully Threaded Steel Rod M3 |
| 1 x | Extension 100 cm (Futaba) |
| 1 x | 200 mm extensión servo HITEC/JR |
| 1 x | Extension 90 cm (Futaba) |
| 1 x | M3 INDUSTRIAL ball link (2 uds) |
| 1 x | Premium servo extension 75cm |
| 1 x | Restrictor FESTO 3/3 mm |
| 1 x | Futaba 50/60 mm servo pull-pull double arm with ball link |
| 1 x | Futaba 38 mm servo arm with ball link |
| 1 x | Ball link M2,5 (10 pcs) |
| 1 x | F3A carbon 85 mm spinner for Hacker Q-80 |
| 1 x | T-shape holder metal LAMA |
| 1 x | 45 mm white plastic spinner for fixed propeller / 4,0 mm axi |
| 1 x | 20 mm carbon horn |
| 1 x | Small aluminium horn red (2pcs) |
 |
| 3,046.24EUR |
