1 x | F450/550 Quadcopter, landing gear |
1 x | Motor brushless 1806 - 2300 Kv Cuadracopter |
1 x | Futaba Female 40 cm extension |
1 x | Extension silicon 30 cm male (Futaba) |
1 x | 1/6 Pilot "Garry" |
1 x | Cable-Tie 1.66x71mm / 0.07x2.8″ (20 pcs) |
1 x | BALSA trip 2.0x2.0x1000 mm |
1 x | Ball link Aluminio M3 (2 pcs) |
1 x | 200 mm extensión servo HITEC/JR |
1 x | 13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
1 x | Aluminium cap bolt washer M3 red (8 pcs) |
1 x | Aluminium wide washer M4 Red (4 pcs) |
1 x | Ball link duraluminium M3 V1 (10 pcs) |
1 x | Threaded coupler M2 (10 uds) |
1 x | Threaded coupler Micro M2 Ø 0,8 mm (10 pcs) |
1 x | Threaded coupler M2,5 Ø 3 mm (10 pcs) |
1 x | XH female balance (5S) connector (2 pcs) |
1 x | Piloto RC Civil 1/5- 1/6 Scale 12" |
1 x | BALSA leading edge 8x10x1000 mm |
1 x | Z type of cable coupler Ø 1.8 (2 uds) |
1 x | Extension silicon 35 cm male (Futaba) |
1 x | SE Ring HACKER 300 mm (2 pcs) |
1 x | Carbon fiber rod 10 mm x 1000 mm |
1 x | Aluminium blue ball links M3 V1 (10 pcs) |
1 x | 20x200 mm battery rings |
1 x | Threaded coupler ALU M3 Ø 6 (2 uds) |
1 x | Ball link Aluminio M4 x 4 x 6 x 26mm (4 uds) |
1 x | Panasonic Eneloop AA 1,2 V battery 19>00 mAh |
1 x | Strip 3,5x1,75x330 mm |
1 x | Carbon fiber rod 6.0 mmx1000 mm |
1 x | 20x1000 mm Ring Strap Back To Back |
1 x | L cockpit anchor "tipe F3A" (2 pcs) |
1 x | Futaba Female 40 cm extension |
1 x | Extension S-Bus 1-2 silicon 30 cm FUTABA |
1 x | Prolongador S-Bus JR/JR 10cm |
1 x | Pine wood slat 1.5x3.0x1000 mm |
1 x | BALSA trip 3.0x5.0x1000 mm |
1 x | 1/4 Pilot "Mike" |
1 x | Aluminium cap bolt washer M4 blue (8 pcs) |
1 x | Quicklock washer 4 mm (10 pcs) |
1 x | Linden wood slat 3.0x3.0x1000 mm |
1 x | MPX Sub-D Adaptor |
1 x | Aluminium coupler M2/2 with ball bearing (1 pcs) |
1 x | Aluminium wide washer M3 blue (4 pcs) |
1 x | Circlik for shaft 1.9 mm (10 pcs) |
1 x | Carbon fiber rod 2.5 mmx1000 mm |
1 x | Xplorer4 anemometro |
1 x | M3 black washers (4 pcs) |
1 x | 10 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
1 x | ABS Strip 1.0x5.0x1000 mm |
1 x | RUDDOG Protection and Heat Shield Tape (2mx50mm) |
1 x | Aluminium coupler M2,5/2 with ball bearing (1 pcs) |
1 x | Threaded coupler ALU M2 Ø 4 (2 uds) |
1 x | Angled clevis with threaded rod M3 |
1 x | Flat washer 4.3 mm (20 pcs) |
1 x | Ball link Aluminio M3 (6 uds) 27x11.9x5.9 mm |
1 x | Ball link Aluminio M3 x 3 x 5 x 18mm (6 uds) |
1 x | Connectors DEANS 4 pins (1 pair) |
1 x | Pad self adhesive, up to 3mm / 0.12″, (10 pcs) |
1 x | Strip ABS 2.0x5.0x1000 mm |
1 x | Piloto JET 1:3,5 |
1 x | ABS I Strip 20x10x1000 mm |
1 x | Aceite DELUXE turbine Jet Oil 1 litro |
1 x | 800TVL CMOS camera for FPV |
1 x | Carbon fiber rod 5.0 mmx1000 mm |
1 x | Cable S.BUS 3 salidas 100 mm |
1 x | Conector BEC male (10 pcs) |
1 x | Carbon fiber rod 8.0 mmx1000 mm |
1 x | Round Rod 2,0x1000 mm |
1 x | Futaba male 40 cm extension |
1 x | 1/12 Pilot "Langley" |
1 x | XH male balance (4S) connector (2 pcs) |
1 x | Tape GFK 38 mm |
1 x | Carbon fiber rod 2.0 mmx1000 mm |
1 x | Ball link V1 Ø7 M4/3 (6 uds) |
1 x | Round Rod 1,25x1000 mm |
1 x | Z Bender - S Type Tool |
1 x | Walnut wood slat 2.0x2.0x1000 mm |
1 x | BALSA triangular 8x8x1000 mm |
1 x | SE Ring 450 mm (2 pcs) |
1 x | BALSA triangular 6x6x1000 mm |
1 x | Clevis plastico I=30 mm / hole 2.5mm / pin 1 (2 pcs) |
1 x | Cabel "Y" 30 cm (Futaba) |
1 x | Ball Link M2 with Ball and Hardware, 10 pcs |
1 x | Carbon fiber flat 1000x3.0x0.5 mm |
1 x | Ball Link ALU M3 - RH (1 pcs) |
1 x | Round Rod 3,0x1000 mm |
1 x | Carbon wing joinner 13,4 mm Ø 0,48 mm |
1 x | Carbon fiber rod 0.5 mmx1000 mm |
1 x | Mahogany wood slat 2.0x2.0x1000 mm |
1 x | Starter 12v (Max 90 and 15ccm) |
1 x | Trailing edge BALSA 35x8x1000 mm |
1 x | BALSA trip 10x10x1000 mm |
1 x | XH female balance (4S) connector (2 pcs) |
1 x | M3-M4 rubber washer (8 pcs) |
1 x | Piloto Jet "Green" 1/6 Scale |
1 x | Gold antispark 5,5 mm plug |
1 x | XH female balance (2S) connector (2 pcs) |
1 x | Cabel "Y" 30 cm (graupner) |
1 x | Carbon fiber rod 16 mm x 1000 mm |
1 x | Gold antispark 4 mm plug |
1 x | Connectors banna oro 2 mm (M/F) (ultralight) |
1 x | Piloto WWII USAAF 12" Scale 1/6 - 1/5 |
1 x | Threaded coupler M3 (10 uds) |
1 x | Towing hook <3m |
1 x | Wing-connector: Glass / Carbon tube (13.7/12.5) x 1000 mm |
1 x | SERVO HOLDER |
1 x | Vacuum sealing tape, 2.5 x 12 mm (up to 140 °C) 15 m |
1 x | Carbon Non-Woven, 160 g/m² 127 cm 5m |
1 x | Vacuum sealing tape, 2.5 x 12 mm (up to 140 °C) 22 roll |
1 x | Fixed launching hook |
1 x | Carbon fabric 160 g/m² (plain weave) 100 cm x 2 m |
1 x | Carbon fibre tape 200 g/m² (unidirectional) 50 mm |
|
1,993.69EUR |