| 1 x | Motor DA 170 |
| 1 x | Motor DA 60 |
| 1 x | DA 70 Twin Gas Engine |
| 1 x | Motor DA 85 |
| 1 x | Motor DA 100L |
| 1 x | Motor DA 150 |
| 1 x | Cer clip DA-50R, DA-60 DA-100 DA-100L DA-120, 1 piece |
| 1 x | L ELBOW DA-120 normal(2 pcs) |
| 1 x | Steel conrod DA-50R and DA-60 |
| 1 x | Piston pin for DA-60 DA-120 |
| 2 x | Cylinder for DA-60 and DA-120 |
| 1 x | Piston pin for DA50R/DA100 |
| 1 x | L ELBOW DA-120 long (2 pcs) |
| 1 x | BOSCH spark plug cap for DA 50-R, DA 100 and DA 150 |
| 3 x | Reed valve carrier for DA-85, DA-100L and DA-120 |
| 2 x | Woodruff key for DA50/85/100/150 and DA 200 |
| 1 x | Carburetor for DA150L/170 |
| 1 x | Carburador DA-35, DA-50R-DA-100L , VM-60/70 |
| 1 x | Pick up DA50/100/150 |
| 1 x | Reed valve carrier, without reed valves DA-150L/170 |
| 2 x | Ignition for DA-50-R, DA-60, DA-85 |
| 1 x | Rear crankcase DA-50R |
| 1 x | Low speed needle DA-50R/100I |
| 1 x | Crankshaft DA-120 |
| 1 x | Carb Carrier, red DA-85, DA-100L and DA-120 |
| 1 x | L ELBOW DA-150 "normal" (2 pcs) |
| 2 x | Piston ring for DA-60 and DA-120 |
| 1 x | Carburator spacer block DA-50R |
| 1 x | Hifht speed needle DA-50R/100I |
| 2 x | Piston ring for DA-85 and DA-170 |
| 3 x | Carb Carrier, red DA-150L/170 |
| 2 x | Prop washer for DA-85, DA-100, DA-100L, DA-120 |
| 1 x | Ignition unit for DA-70/100/120/150/170/200 |
| 1 x | L ELBOW 90º ø 25 mm |
| 1 x | Pitts Muffler for D.A. 120 |
| 1 x | Windsock Ozone L - 700 mm |
| 1 x | Carburetor DLE 170M |
| 1 x | OS GT15 W/E-4040 for airplane |
| 1 x | Hot Glue Stick BLACK |
| 1 x | Brass hexagonal rod Ø 3.5 mm x 1000 mm |
| 1 x | Horn 16,5x20 mm (2 pcs) |
| 2 x | Waterproof adhesive tape, width 19mm, length 25m |
| 1 x | Small aluminium horn red (2pcs) |
| 1 x | Crimping tool |
| 1 x | Silicone adhesive ELASTOSIL® E4, tube/ 90 ml |
| 1 x | Militarian pilot "Kamikaze" size 9cm (Slimline) |
| 1 x | Cable-Tie 1.66x71mm / 0.07x2.8″ (20 pcs) |
| 1 x | 2,0x50 mm allen screwdriver |
| 1 x | 26 mm self adhesive Pinking Tape, saw tooth height 1.0 mm |
| 1 x | 20x1000 mm Ring Strap Back To Back |
| 1 x | 20 mm carbon horn |
| 1 x | LH long black aluminium horn L31xH30 (2pcs) |
| 1 x | Screwdriver for Hexagon 1,27mm |
| 1 x | Straightened rod Ø 1.5 mm x 1000 mm |
| 1 x | 13 mm self adhesive Pinking Tape, saw tooth height 1.0 mm |
| 1 x | 14x60 mm Mini rings Tie Wraps (4 pcs) |
| 1 x | Release wax 250ml |
| 2 x | 1/6 Pilot "Tony" |
| 1 x | Oracover ROYAL RED 2m |
| 1 x | Ventus 1:4 set of instruments |
| 2 x | 1/12 Pilot "Fighter" |
| 1 x | 1,5x50 mm allen screwdriver |
| 1 x | Spray adhesive INFUTAC (Clear) 500 ml |
| 1 x | Oracover Brown 2 m |
| 1 x | Horn 13,5x16 mm (2 pcs) |
| 1 x | Battery LiPo GENS 3700 mAh 6S 22.2v 60C (Gens Ace) |
| 1 x | Lipo GENS 200 mAh 1s 3.7 45C (2 pcs) |
| 1 x | Battery LiPo GENS 450 mAh 3S 11.1V 25C (Gens Ace) |
| 1 x | Battery LiPo GENS 5000 mAh 4S 14,8V 40C (Gens Ace Hard Case) |
| 1 x | Battery LiPo GENS 5000 mAh 4S 14.8v 45C (Gens Ace) |
| 1 x | Battery LiPo GENS 5000 mAh 2S 7.4V 60C (Gens Ace) |
| 2 x | Battery LiPo GENS 5000 mAh 3S 11.1v 45C (Gens Ace) |
| 1 x | Ferrita 17x10x6.5 mm |
| 2 x | Battery LiPo GENS 2200 mAh 2S 7.4v 60C (Gens Ace) |
| 1 x | Battery LiPo GENS 5300 mAh 4S 14.8V 30C (Gens Ace) |
| 1 x | Ferrita 27x14x7 mm |
| 1 x | Battery LiPo GENS 450 mAh 2S 7.4V 25C (Gens Ace) |
| 1 x | Battery LiPo GENS 5300 mAh 2S 7.4V 30C (Gens Ace) |
| 2 x | Battery LiPo GENS 160 mAh 2S 7.4V 30C (Gens Ace) |
| 1 x | Electric Fuel pump |
| 1 x | Variable Flow Smoke Pump System |
| 2 x | Sparkplug DLE CM6 |
| 1 x | Secraft Fuel system v2, red color |
| 1 x | ANGEL 48" pp orange/black/white |
| 1 x | Servo Arm 25T M3 KAVAN 6.5 / 19.6 mm |
| 1 x | Cabel "Y" 30 cm (Futaba) |
| 1 x | 0,14 mm PVC servo wire extension, ZH micro conector. |
| 1 x | Spark motor OS nº 3 |
| 1 x | Electric Fuel Pump 12V |
| 1 x | Gasket electric Fuel Pump |
| 1 x | Sparkplug Champion RCJ-7Y for ZG |
| 1 x | Exhaust gasket DA-60/120 |
| 1 x | 3 mm metalic joint for DA-35 or DA-75 cilinder/elbow |
| 1 x | Stainless steel silencer for DA 150/150L |
| 1 x | Prop screw for DA50/60/70, VN60/70, M5x45 |
| 1 x | Servo GO-1023MG 7.0 kg.cm 0.09s/60º |
| 1 x | Flex-headers for Valach VM 85B2-FS |
| 1 x | Fibreglass-Spinner BS ∅155 x 200 mm |
| 1 x | Stainless steel flange for VM 60/70/120/140 |
| 1 x | RM-85FSI 4-stroke inline gasoline engine |
| 1 x | RM-130FSI 4-stroke inline gasoline airplane 3 cylinder |
| 1 x | Spinner fixed propeller 60 mm / 5,0 mm |
| 1 x | 1/12 Pilot "Langley" |
| 1 x | 115x29 mm (4.50") Type jets aluminium core wheel |
| 1 x | Threaded coupler ALU M2,5 Ø 4 (2 uds) |
| 1 x | Threaded coupler ALU M3 Ø 5 (2 uds) |
| 1 x | Threaded coupler ALU M2 Ø 4 (2 uds) |
| 1 x | EDF Jet-Flex 80 - 8 Kg |
| 1 x | 1/4 Pilot "Mike" |
| 1 x | 100x50 mm SLH KOVO wheel |
| 1 x | 1/6 Pilot "Buddy" |
| 1 x | 170x54 mm SLH KOVO wheel with bearing and metal hub |
| 1 x | 110x55 mm C SLH KOVO wheel |
| 1 x | 102 mm INO spinner (carbon imitation) |
| 1 x | 1/7 Pilot "Japanese" |
| 1 x | 1/12 Pilot "Tom" |
| 1 x | Threaded coupler ALU M2,5 Ø 3 (2 uds) |
| 1 x | Threaded coupler ALU M2 Ø 3 (2 uds) |
| 1 x | Lipo GENS 2200 mAh 2s 7.4v 20c Soaring |
| 1 x | Ferrita con funda |
| 1 x | Lipo TATTU 16000 mAh 6S 22.2v 30C XT-90 |
| 1 x | PT 22x10 EL Propeller |
| 1 x | A/C quality beech plywood 600x300x6.0 mm |
| 1 x | Motor XPower F2915/12 XLight |
| 1 x | Lipo GENS 15000 mAh 3s 11.1v 100C 3S2P Bashing Series |
| 1 x | 3,0x60 mm allen screwdriver |
| 1 x | Battery LiPo GENS 4000 mAh 2S 7,4v RX (Gens Ace) |
| 1 x | Fresa corte diamante Ø 2.3mm (bola) |
| 1 x | Battery LiPo TATTU 70000 mAh 6S 22.2V 25C |
| 1 x | Lipo GENS Soaring 4000 mAh 2s 7.4v 30C |
| 1 x | Set brocas Ø 2.0-2.2-2.4-2.6 mm (4 pcs) |
| 1 x | Lipo GENS Soaring 2200 mAh 3S 11.1v 30C |
| 1 x | Battery LiPo GENS 4000 mAh 6S 22.2v 45C (Gens Ace) |
| 1 x | Battery LiPo TATTU 450 mAh 3S 11,1V 75C |
| 1 x | Battery LiPo GENS 2200 mAh 3S 11.1v 45C (Gens Ace) |
| 1 x | Sealing Iron Sleeve STD |
| 1 x | PROXXON - DRILL SET 0,5-3,2MM (10PCS.) |
| 1 x | 2000A 12V Lithium Jump Starter with 150PSI Air inflator |
| 1 x | Sandwich carbon + poplar 2mm + carbon 480x290 mm |
| 1 x | Epoxy L 40 min. (1 Kg) 715g Resina / 285g Hardener S (15 min) |
| 1 x | Fibra de vidrio 80 g/m² (2 m x 100 cm) |
| 1 x | Straightened rod Ø 1.0 mm x 1000 mm |
| 1 x | Battery Lipo TATTU 750 mAh 4S 14.8v 95C R-Line |
| 1 x | |
| 1 x | Battery LiPo GENS 5500 mAh 5S 18.5v 25C (Gens Ace) |
| 1 x | Sealing Iron Sleeve PROF |
 |
| 19,138.56EUR |
