| 1 x | 20,5x14,5 Falcon electric V2 (40 g) |
| 1 x | ABS I Strip 20x10x1000 mm |
| 1 x | Strip 2,0x2,0x330 mm |
| 1 x | Motor ST 7-160 B |
| 1 x | Cer clip DA-50R, DA-60 DA-100 DA-100L DA-120, 1 piece |
| 2 x | Carb Carrier, red DA-85, DA-100L and DA-120 |
| 1 x | Crankcase Gasket set for DA-60 / DA-120 |
| 1 x | Carburator spacer block DA-50R |
| 1 x | Cylinder for DA-60 and DA-120 |
| 1 x | Bearing upper rod DA-50R, DA-60, DA-100, DA-100L, DA-120 |
| 1 x | DA-50R Prop Hub |
| 1 x | Dia. 25x5 mm tefon tube for escape |
| 1 x | Cylinder for DA-85/170 (1 piece) |
| 1 x | Motor Moki 180 |
| 2 x | Drilling-template set for Moki engines Moki S150, S180, S215, S2 |
| 2 x | Motor Moki S 400 cc 5 cylinders |
| 1 x | Motor Moki S 250 cc 5 cylinders |
| 2 x | Escape Moki 100 BVT |
| 1 x | Air filter MOKI |
| 3 x | Baffles for Radial Moki S180/320 mm |
| 1 x | Motor Moki S 300 cc 5 cylinders |
| 1 x | Moki Exhaust Bend 200 mm |
| 1 x | DLE 55-RA Muffler |
| 1 x | Exhaust pipe BX 155 Right |
| 1 x | Escape O-Ring ZIMMERMANN FG-84/90 R3 |
| 1 x | Motor Eachine Racer 250 Brushless Motor - BG2204 2300kv - CCW th |
| 1 x | Propeller set 400 (2R+2L) |
| 1 x | Soporte grifo FESTO vertical (1 pcs) |
| 1 x | Support conector MPX (6 pcs) |
| 1 x | Support pump Xicoy X45 |
| 1 x | Gasket, Aluminium-Plate >reed valve carrier DA-170 |
| 1 x | Gasket, from reed valve carrier to carb carrier DA-150L/170 |
| 1 x | Stainless steel silencer for DA 150/150L |
| 1 x | Ignition for DA-50-R, DA-60, DA-85 |
| 1 x | Carburator screw DA50/60/100/120 |
| 1 x | Aluminium-screw, M5x20mm Red |
| 1 x | Reed valves with doubler, set for DA 85/100/120 |
| 1 x | Carburador DA-35, DA-50R-DA-100L , VM-60/70 |
| 1 x | L ELBOW DA-120 normal(2 pcs) |
| 1 x | Reed valve carrier, without reed valves DA-150L/170 |
| 1 x | Aluminium-Plate, carb>reed valve carrier, DA-85 DA-100L and DA-1 |
| 1 x | Piston pin for DA-60 DA-120 |
| 1 x | Motormount DA-100, DA-100L and DA-120 |
| 1 x | Carb spacer mounting block ,red DA-60/70 |
| 1 x | Pick up DA50/100/150 |
| 1 x | Aluminium-screw, M5x16mm Red |
| 1 x | Ignition unit for DA-70/100/120/150/170/200 |
| 1 x | Reed valve for DA 50-R |
| 1 x | Cylinder DA-50R, DA-100, DA-100L |
| 1 x | Propeller plate for DA-120 / DA-170 / DA-150 New Version |
| 1 x | Piston ring for DA-85 and DA-170 |
| 1 x | BOSCH spark plug cap for DA 50-R, DA 100 and DA 150 |
| 1 x | Prop hub for DA 150/200, old version |
| 1 x | Intake tube with flange and 2 M5x60 |
| 1 x | Gasket for motor DA 50-R |
| 1 x | Piston ring for DA-50R and DA-100 |
| 1 x | Piston for DA-50R, DA-100, DA-100L |
| 1 x | Stainless Steel Mini Pipe for Titan ZG 20 and ZG 23 |
| 2 x | Silencer ZG62, new version |
| 2 x | Prop washer for ZG45SL, ZG62/S/SL and ZG74B/ZG80B |
| 1 x | Plastic intake RAM tube for ZG 20 and 26 |
| 1 x | Silencer kit ZG 45/62 |
| 1 x | Sparkplug cap red, with spring ZG26SC, ZG26SCM and ZG231SLH |
| 1 x | Prop shaft ZG 23SL and ZG 26SC |
| 1 x | Regler autostarter MOKIS250 |
| 2 x | Pick up for motor Moki 250 cc 7 cylinders |
| 1 x | Moki Pushrod S250 (1 pcs) |
| 1 x | Carburator Moki S 180 |
| 1 x | Stainless Steel Silencer side outlet for ZG 20/23/26 |
| 1 x | ZENOAH ZG26 SCM Marine Engine |
| 1 x | Reduction gear 2.8:1 for ZG 38 inline version |
| 1 x | Muffler ZG 38/S/SC |
| 1 x | Piston ring for ZG 26SC/EI, ZG 26SCM ZG 26SLH and Zenoah G260RC/ |
| 1 x | Aluminium wide washer M3 gold (4 pcs) |
| 1 x | Aluminium cap bolt washer M4 blue (8 pcs) |
| 1 x | 12 mm floating pad (49 pcs) |
| 1 x | Aluminium wide washer M3 blue (4 pcs) |
| 1 x | ABS tube 12.0x10.0x1000 mm |
| 1 x | ABS Strip 1.5x8.0x1000 mm |
| 1 x | ABS "T" angle 10.0x10.0x1000 mm |
| 1 x | ABS Strip 1.5x2.0x1000 mm |
| 1 x | ZENOAH ZG 26SC with magneto ignition |
| 1 x | Moki Carburetor Throttle Arm with Extension |
| 1 x | Motor Moki S 250 cc 5 cyl with autostarter |
| 1 x | Flange gasket MOKI carburetor |
| 1 x | MOKI S250 Intake Bend |
| 1 x | Futaba External voltage input cable Futaba CA-RVIN-700 |
| 1 x | Cross Connector 4.0 mm x 1000 mm |
| 1 x | Profile ABS triangular 4.0x1000 mm 90º |
| 1 x | Profile ABS triangular 6.0x1000 mm 90º |
| 1 x | Strip 1,5x1,5x330 mm |
| 1 x | AIREX® Sheets C 70.55 (YELLOW) 1200x550x4.0 mm (5 pcs) |
| 1 x | PPM Encoder Module |
| 1 x | 2,4x1000 mm 2:1 black termoretract tube |
| 1 x | Extension silicon 10 cm (Futaba) |
| 1 x | ABS angle 10,0x10,0x1000 mm |
| 1 x | ABS angle 4,0x4,0x1000 mm |
| 1 x | MPX-Dean "T" Adapter |
| 1 x | Ball Link M2 with Ball and Hardware, 10 pcs |
| 1 x | Glases Innovation Plus |
| 1 x | Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 10 m |
| 1 x | 3 LiPo XH>EH adapter |
| 1 x | SE Ring 400 mm (2 pcs) |
| 1 x | 18 mm reinforced hinge |
| 1 x | Strip 3,5x1,75x330 mm |
| 1 x | Clevis plastico I=45 mm / hole 3mm / pin 1 (2 pcs) |
| 1 x | DYNAMOMETER S-1580 |
| 1 x | Profile ABS half cane 2.0x1000 mm |
| 1 x | 5 LiPo XH>EH adapter |
| 1 x | Cable coupler M3 (10 uds) |
| 1 x | Cable S.BUS 3 salidas 300 mm |
| 1 x | 105 mm PVC transparent battery termo-retract 68 mm (1 m) |
| 1 x | Cylidric hinge 43 mm Ø 2,5 mm (5 pcs) |
| 1 x | Carbon fabric 200 g/m² (Aero, plain weave) 100 cm x 5m |
| 1 x | Presto SF Light Filler styrene-free (420 g) |
| 1 x | 12,7x1000 mm 2:1 green termoretract tube |
| 1 x | Dean "T" - Futaba Adapter |
| 1 x | Profile ABS Square 2 x 1000 mm |
| 1 x | Cable coupler M2,5 (2 pcs) |
| 1 x | CC 01 |
| 1 x | Ferrita 17x10x6.5 mm |
| 1 x | Micro flex hinge (12 uds) |
| 1 x | Straightened rod Ø 2.5 mm x 1000 mm |
| 1 x | Canopy Latch |
| 1 x | M3 Maxi ball link (2 uds) |
| 1 x | Aluminun wheel collar 6 mm Ø (4 uds) |
| 1 x | Aluminium cap bolt washer M3 green (8 pcs) |
| 1 x | 100 mm rods set for direction control |
| 1 x | 38x4,5 mm wires output (2 pcs) |
| 1 x | Cable servo PREMIUM MAXI 10m (blanco/rojo/azul) PVC |
| 1 x | Blind nut M4 (4 pcs) |
| 1 x | 200m servo "Premium" wire (white/red/blue) |
| 1 x | Ventral support for AX-18/AX-60 |
| 1 x | M2,5 5Diam metal ball link V3 (2 pcs) |
| 1 x | Blue smoke canister 100 g |
 |
| 35,521.83EUR |
