1 x | Small Crow DLE-170M |
1 x | Big Crow DLE-170M |
2 x | Motor DLE 200cc Premium Muffler |
2 x | Silent-blocks DLE 170M |
2 x | Motor DLE 170 M- Paramotors |
1 x | Motor DLE 430 cc - Paramotors |
2 x | Crimping sleeves for cable 0.85 mm (10 pcs) |
2 x | Electric spoiler 250 mm (2 pcs) |
2 x | Horizontal cockpit anchor "tipe F3A" (2 pcs) |
2 x | Steering arm 16 mm Ø 3 mm (2 uds) |
1 x | Propeller POWER-PROP 14x9 |
1 x | Stainless steel cable Ø 0.52 mm - 15 kp (10 m) |
1 x | Propeller APC 14x8.5 Electric Pusher |
1 x | Cabin latch Fox MDM1 4m (pair) |
1 x | Screw-lock connector Ø 2 mm (2 uds) |
2 x | Steering arm 16 mm Ø 3 mm |
2 x | Stainless steel cable Ø 1.3 mm (10 m) |
2 x | One touch canopy lock |
1 x | Crimping sleeves for cable 1.3 mm (10 pcs) |
3 x | Steering arm 12 mm Ø 3 mm (2 uds) |
1 x | Steering arm 12 mm Ø 4 mm |
1 x | Propeller POWER-PROP 13x9 Izda |
1 x | Locking cable tie 4.6x203 (uds) |
1 x | Screw-lock pushrod conn snap Ø 1.5 mm (2 uds) |
2 x | Steering arm 12 mm Ø 4 mm (2 uds) |
1 x | L cockpit anchor "tipe F3A" (2 pcs) |
1 x | Canopy Lock V1 M3 Red (2 pcs) |
1 x | Screw-lock connector M2 (2 uds) |
1 x | Covered closure or fairings |
3 x | Stainless steel cable Ø 0.5 mm (20 m) |
2 x | Locking cable tie 2.5x100 (uds) |
1 x | Vertical cockpit anchor "tipe F3A" (2 pcs) |
2 x | Stainless steel cable Ø 0.62 mm (10 m) |
2 x | Stainless steel cable Ø 0.5 mm (2 m) |
2 x | SUS wire 3m (nylon coated) |
3 x | FALCON 20X9 CARBON PROPELLER (GAS) |
2 x | Canopy Latch |
1 x | Stainless steel cable Ø 0.88 mm - 60 kp (10 m) |
2 x | Cap closure 33/23.5mm (2 uds) |
1 x | Monokote BLANCO jet (1.8x0.65m) |
1 x | Walnut wood slat 1.5x1.5x1000 mm |
1 x | Ball Link ALU M3 - RH (1 pcs) |
1 x | Pine wood slat 2.0x2.0x1000 mm |
1 x | Steel tube (L 1000 mm Ø4 mm, Ø3,7 mm) |
1 x | Extinguisher CO2 - 2 Kg |
1 x | Ferrita con funda |
1 x | Nylon hinge 15x0,3 (10 pcs) |
1 x | DPSI V-Match |
2 x | Propeller FALCON 32,5x11 PUSHER Carbono |
2 x | Propeller POWER-PROP 13x9 |
1 x | Cierre cabina aluminio Ø4, I=10 mm |
1 x | Servo RHINO pro SHV digi 4 |
1 x | 89 mm double servo arm with bearing (2 pcs) |
1 x | Aluminium servo arm (2 uds) |
1 x | Blue aluminium servo arm V2-Hitec 1,25 inch M3 |
1 x | Red aluminium servo arm V2-Futaba 1,25" inch M3 |
1 x | Horns set HS-65HB/MG, 5065MG |
1 x | Blue aluminium servo arm V3-Hitec 1,0inch M3 |
1 x | aluminium servo arm V1-JR 1,0 inch M2 |
1 x | Servo arms set HS-65HB/MG/5065MG |
1 x | Servo Mount M (blue) |
1 x | Red aluminium servo arm V1-Futaba 23 mm M2 |
1 x | Red aluminium servo arm V2-Futaba 1,0" inch M3 |
1 x | Red aluminium servo arm V2-Futaba 2,0 inch |
1 x | Rudder 2_Tray 4.5~5 inch |
1 x | Blue aluminium servo arm V1-Hitec 1,25" inch M3 |
1 x | Servo ROBBE FS-31 Pico Servo |
1 x | Mini neumatic retract 4 mm landing gear (Het-rc) |
3 x | Steering arm 16 mm Ø 4 mm |
2 x | Allen wheel collar M4x6 |
1 x | Mobile Terminal |
1 x | Snap long M2 (10 uds) |
1 x | T-Hose connector 2-2-2 mm |
1 x | Servo arm with 5 mm hole to FEMA 9810A |
1 x | Angled clevis with threaded rod M3 |
2 x | Allen wheel collar M4x4 |
2 x | Allen wheel collar M3x5 |
1 x | STEERING FRONT WHEEL SYSTEM BIDULE 55 |
1 x | Wheel collar 6 mm Ø (4 uds) |
1 x | 90 mm rods + T patellas set for direction control |
1 x | 38x4,5 mm wires output (2 pcs) |
1 x | 140 mm rods set for direction control |
1 x | Y-Hose connector 4-4-4mm |
2 x | Legs + electric brakes for Viper Jet 1700 mm |
1 x | 41x5,5 mm wires output (2 pcs) |
1 x | 28x5 mm wires output (2 pcs) |
1 x | Body for landing gear Ø 3 mm |
2 x | Aluminium alloy coupler for carbon tube 6/M4 |
1 x | Wing Joiner ULTIMATUM 2.0 m |
1 x | Steering arm 16 mm Ø 4 mm (2 uds) |
2 x | Trailing leg 131 mm |
1 x | 120x60 mm SLH KOVO wheel |
1 x | 100 mm rods set for direction control |
1 x | Wing bolts M3 Steel screw Red (2 pcs) |
3 x | Cable grommet Ø 3.2 mm (4 uds) |
1 x | Waterproof adhesive tape, width 19mm, length 25m |
1 x | Crystal Universal RX 35.170 Ch 77 |
2 x | Crystal TX 35.100 Ch 70 |
1 x | Crystal Universal RX 35.150 Ch 75 |
1 x | Crystal Universal RX 35.030 Ch 63 |
1 x | Xplorer2 anemometro |
1 x | Snap short M2 (10 uds) |
1 x | EXTRA NG 74" yello/blue/red (Skywing RC) |
1 x | Aluminum Bayonet / strongal D35 mm / 1 m |
1 x | Air pressure gauge |
1 x | Crimping sleeves for cable 0.70 mm (10 pcs) |
1 x | Split M1,2x10 (10 pcs) |
1 x | Bearing block for noseleg landing gear |
1 x | Wing bolts M3 Steel screw blue (2 pcs) |
1 x | Servo GO-1023MG 7.0 kg.cm 0.09s/60º |
1 x | Split pin 1x8 mm (10 uds) |
1 x | Cable grommet 9.5 mm (4 uds) |
2 x | Cable grommet Ø 5 mm (4 uds) |
2 x | Body for landing gear Ø 4 mm |
1 x | Epoxy L 40 min. (1 Kg) 715g Resina / 285g Hardener S (15 min) |
1 x | Manometer 4 mm |
1 x | Aluminun wheel collar 4 mm Ø (4 uds) |
2 x | USBCOM 5i |
1 x | HBC 10035-3 32-Bit |
1 x | EXTRA NG 74" white/red/blue (Skywing RC) |
1 x | Window mounting channel 5m |
1 x | Propeller POWER-PROP 7x7 |
1 x | 160 mm carbon undercarriage (2pcs) |
2 x | Tip wing protector 40x14 (2 pcs) |
1 x | Wheel collar 4 mm Ø (4 uds) |
1 x | Triple rod con. 2mm Pushrod (2 pcs) |
1 x | Stainless steel cable Ø 0.5 mm (10 m) |
2 x | Micro screw-lock pushrod conn snap Ø 1 mm (2 uds) |
1 x | Landing gear frontal support 29x26x13,5 |
1 x | Sandwich carbon + poplar 4mm + carbon 290x160 mm |
1 x | Oracover GREY Seafire Sea 2m |
1 x | Turbina KINGTECH K320 G5 |
1 x | Burner Plug K30/ K45 |
2 x | Turbine KingTech K30G Restart |
1 x | T-Motor MN705-S Kv125 (pack 2 uds) |
1 x | Turbina KINGTECH K180 G4+ |
2 x | FOD Screen K140G/K180G/K210G |
1 x | Turbina KINGTECH K65 G4+ |
1 x | Filter KingTech |
1 x | KingTech Turbineoil 10L |
2 x | KingTech K100TP G4+ Turboprop |
1 x | KingTech K45TP G4 Turboprop |
1 x | KingTech Turbineoil 1L |
1 x | Power Pack SE Series JETCENTRAL |
1 x | T-Motor U7-V2.0 Kv420 |
1 x | Fully Threaded Steel Rod SUS303 65 mm M3 (2 pcs) |
1 x | Propeller CFK 14.5x10 Slim |
1 x | Crystal TX 35.050 Ch 65 |
1 x | Crystal TX 35.010 Ch 61 |
1 x | 26x12 BIELA 3Bl Pusher propeller |
1 x | 18x10 BIELA pusher propeller |
1 x | PowerBox MicroSwitch |
1 x | Wheel collar 5 mm Ø (4 uds) |
2 x | Festo Adaptor Tygon Large/4mm |
1 x | Spinner propeller pleg. 38 mm / 6,0 mm |
1 x | Spinner propeller pleg. 32 mm / 5,0 mm |
1 x | Servo GO-10S41MG 10.5 kg.cm 0.075s/60º |
1 x | Servo Arm 25T M3 KAVAN 6.5 / 19.6 mm |
1 x | Tip wing protector 30x10 (2 pcs) |
1 x | Propeller CFK 15.5x10 |
1 x | Propeller CFK 15x13 Slim |
1 x | Cable grommet Ø 4 mm (4 uds) |
1 x | Propeller CFK 14x10 |
1 x | Propeller CFK 12.5x6.5 |
1 x | USB HLS prog. interface |
1 x | Crystal Universal RX 35.090 Ch 69 |
1 x | Transmitter Crystal 35 Mc/s Ch 62 |
1 x | Crystal Universal RX 35.070 Ch 67 |
1 x | Crystal Universal RX 35.020 Ch 62 |
1 x | Receiver Crystal 35 Mc/s Ch 62 |
1 x | 26x18 BIELA propeller |
1 x | ZEUS F3A 2m |
1 x | Servo arm with 4 mm hole to FEMA 9810A |
1 x | T-Hose connector 4-4-4mm |
1 x | Quick hose connector 6-6 mm |
1 x | T-Hose connector 3-3-3 mm |
1 x | FESTO Filter 4 mm |
1 x | Y-Hose connector 2-2-2 mm |
1 x | FESTO connector 1/8 Quick 6mm 90º |
1 x | Landing gear axle Ø 5 mm (2 uds) |
2 x | Racor "Y" 3 mm |
1 x | Wheel collar 2 mm Ø (4 uds) |
1 x | Connectors banna oro 3,5 mm (M/F) |
1 x | CC 11 Conector |
1 x | Spinner propeller pleg. 42 mm/6,0 mm/0º |
1 x | Spinner propeller pleg. 45 mm / 6,0 mm |
1 x | Spinner propeller pleg. 40 mm / 5,0 mm |
1 x | 12 mm dogdrive props |
|
49,655.44EUR |