| 1 x | 30 cm BEC cable (male) |
| 3 x | Balanceradapter JST-XH (Heli 47G) 2-6 c. |
| 2 x | Dean "T" - Futaba Adapter |
| 2 x | Connector Sub-D 2+5 Male |
| 2 x | 3 copper lacquer wire Ø0,2 mm (1 m) |
| 1 x | UBEC 6A KAVAN |
| 2 x | CC 03 |
| 4 x | 4 LiPo XH>EH adapter |
| 1 x | Cabel charger transmitter GRAUPNER |
| 2 x | 5 LiPo XH>EH adapter |
| 3 x | 2 LiPo XH>EH adapter |
| 2 x | CM-3 |
| 2 x | Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm) |
| 1 x | BEC 3A FOXY |
| 2 x | 3 LiPo XH>EH adapter |
| 1 x | Connector CAN 15 |
| 2 x | 30 cm BEC cable (female) |
| 3 x | Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm) |
| 2 x | APM2.6 Power module with 5.3V DC BEC |
| 1 x | Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH |
| 3 x | CellPRO 4S Adaptader (GP/KO up to 4S) |
| 1 x | CC 05 |
| 2 x | Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH |
| 2 x | Copper lacquer wire Ø0,2 mm (5 m) |
| 2 x | Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm) |
| 2 x | Balance "Y" Wire 6S, 2x JST-XH / 1x JST-EH |
| 1 x | USB interface ALTIS |
| 3 x | PSC 6 |
| 1 x | Red copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | CC 01 |
| 2 x | TrainerCord (master-learner) |
| 2 x | Interruptor SPS 70v 60/120A |
| 2 x | Servo slow down unit (0,7-14,7 sec ) |
| 2 x | Circlick securite |
| 1 x | Male prolonguer XH 30 cm 6 cell cable of silicone 0,25 mm |
| 2 x | SPS 70V 140/280 A |
| 3 x | Multi-adapter balancer JST - TP |
| 1 x | Futaba External voltage input cable Futaba CA-RVIN-700 |
| 3 x | Female prolonguer XH 30 cm 6 cell cable of silicone 0,25 mm |
| 3 x | MPX-Dean "T" Adapter |
| 3 x | Magnetic Interruptor MULTIPLEX |
| 2 x | MPS Gas-Cap-Powerswitch |
| 2 x | CC 02 |
| 3 x | Opto Gas Engine Kill Switch |
| 1 x | TP/TopFuel - XH 2/3S Adapter |
| 3 x | Male/Female prolonguer for Balancer Thunder Power 6S |
| 2 x | Interruptor RX/Batterie |
| 3 x | MAX BEC 2 |
| 3 x | MAX BEC |
| 1 x | Adapter lead MPX/XT60 |
| 2 x | Extension 2/3 lipos JST/C |
| 1 x | Long Switch On/Off micro |
| 1 x | Extension 5 lipos JST/C - JST |
| 2 x | Pins M connect Multipin connectors AWG 20-24 |
| 2 x | Multi-adapter balancer JST/C - TP |
| 4 x | Extension 5 lipos JST - JST/C |
| 2 x | Extension 6 lipos XH > EH |
| 1 x | Prolonguer for Balancer Thunder Power 6S |
| 3 x | Extension 2/3 lipos JST - JST/C |
| 1 x | Extension 5 lipos JST/C |
| 2 x | SBEC 30 D |
| 1 x | Interruptor SAFET-SWITCH 12HV Twinbatt |
| 1 x | JETImodel DPS 40 |
| 2 x | SWTU2 switch |
| 2 x | Electronic switch JETI SP6 0-15v/6A |
| 1 x | MAX BEC 2D plus EX |
| 4 x | SPS 70V 100/200 A |
| 1 x | Futaba male 40 cm extension |
| 1 x | Spray EC Red 400ml |
| 1 x | Disposable Injector Bags (30x16cm) 100 pcs |
| 1 x | ABS tube 18.0x16.0x1000 mm |
| 1 x | Steel tube (L 1000 mm Ø6 mm, Ø5,7 mm) |
| 1 x | SPS Remote switch actuator |
| 2 x | DPSI Ampere battery backer |
| 3 x | Hacker X-Pro USB interface V2 |
| 1 x | Micro Switch button |
| 1 x | Male connector for 10 pines AWG |
| 1 x | Three-position switched channel, short |
| 3 x | Opto Gas Engine Kill Switch |
| 1 x | Female connector for 20 pines AWG |
| 1 x | USB HLS prog. interface |
| 1 x | SPARK Switch 7.4v |
| 1 x | SBEC 40 |
| 1 x | Adapter lead MPX/EC3 |
| 3 x | Double conector with JR adapter and 200 mm extension |
| 2 x | PWC6 PowerWingConnector for 6 servos with fuselage socket |
| 1 x | FX three-position switched channel, long |
| 1 x | Male connector for 6 pines AWG |
| 1 x | Female connector for 6 pines AWG |
| 2 x | PowerBox SparkSwitch RS |
| 1 x | SPARK Switch 12v |
| 1 x | SPARK Switch 5.9v |
| 1 x | wing/fuselage connector for 6 pines AWG 20-24 (without pines) |
| 1 x | Propadapter for motor A50-V3 |
| 1 x | EME 55 cc carburetor WALBRO |
| 1 x | Check valve quick hose connector 4-4 mm |
| 1 x | 6,4x1000 mm 2:1 green termoretract tube |
| 1 x | 1000 ccm gasoline fuel tank |
| 1 x | 12,7x1000 mm 2:1 green termoretract tube |
| 1 x | Suction funnel for carburetor DA70- MVVW 190cc (red) |
| 1 x | 6,4x1000 mm 2:1 blue termoretract tube |
| 1 x | "Taxi Tank" Fuel Tank |
| 2 x | Jeti Box mini |
| 1 x | PROFI Box JETI |
| 1 x | Kontronik ProgUnit |
| 4 x | Ferrita 27x14x7 mm |
| 1 x | BALSA triangular 15x15x1000 mm |
| 1 x | 135 mm PVC transparent battery termo-retract 68 mm (1 m) |
| 1 x | Hose clips 6 mm |
| 1 x | Black "FUEL VENT" round aluminum overflow socket |
| 1 x | EXTREME FLIGHT RED MAGNETIC ROUND FILLER PLUG |
| 1 x | Deposito SECRAFT V2 1000 ml Gas |
| 1 x | 1,5x50 mm allen screwdriver |
| 2 x | Extension Arm for Carburetor (red) |
| 1 x | DLA 116 crankshaft |
| 1 x | 2,4x1000 mm 2:1 black termoretract tube |
| 1 x | EXTREME FLIGHT BLACK MAGNETIC ROUND FILLER PLUG |
| 1 x | Extra hard 250 ccm complete gasoline fuel tank |
| 1 x | 22m Fitting barb |
| 1 x | 4,8x1000 mm 2:1 black termoretract tube |
| 1 x | 0,14 mm PVC servo wire extension, ZH micro conector. |
| 1 x | Deposito combustible tipo "turbina" 330 ml |
| 1 x | Ball Bearings for motor A60-V2 |
| 1 x | PWC4 wing/fuselage connector for 4 servos |
| 1 x | Walnut wood slat 3.0x3.0x1000 mm |
| 1 x | EWC3 100 cm wing connector |
| 1 x | Xoar Electric Beechwood Prop 20x10 |
| 1 x | Propeller electric carbon 8.5x5 |
| 1 x | Spare spinner 65 mm 3-Bl |
| 1 x | Extension Arm for Carburetor |
| 1 x | 2,5x60 mm allen screwdriver |
| 1 x | 2,4x1000 mm 2:1 red termoretract tube |
| 1 x | 58 mm PVC transparent battery termo-retract 68 mm (1 m) |
| 1 x | Servo HITEC D-955 TW Titanium |
| 1 x | Aluminum Fold Prop Spinner 30 mm / 3.17 mm |
| 1 x | 30 mm Alu spinner 3 mm pleg. propeller |
| 1 x | Spinner NUT 1/4x28 |
| 3 x | PSC 5 |
| 1 x | EWC6 40 cm wing connector |
| 1 x | Male connector JST SH 1.0mm with 10 cm wire |
| 1 x | JETImodel Addcap 1640 |
| 1 x | wing/fuselage connector for 12 pines AWG 20-24 |
| 1 x | Male connector for 12 pines AWG |
| 2 x | Male connector for 16 pines AWG |
| 1 x | "Y" charging 4mm wire (2 IN-1 OUT). |
| 1 x | Female connector for 12 pines AWG |
| 1 x | Battery charging cable XT60 |
| 1 x | Connector Sub-D 2+5 Female |
| 1 x | Male Prolonger TP 4/5S |
| 1 x | TP/TopFuel - JST-EH 4/5S Adapter |
| 1 x | Spare white 30-36 mm spinner |
| 1 x | 16x10 tree blades propeller Master Airscrew |
| 1 x | Central piece 47 mm - 2,5º |
| 1 x | Propeller POWER-PROP 11x8 |
| 1 x | Propeller electric carbon 8.5x6 |
| 1 x | 40 mm black plastic spinner for fixed propeller |
| 1 x | Spare spinner 36 mm 3-Bl |
| 1 x | Xoar Electric Beechwood Prop 21x10 |
| 1 x | Propeller POWER-PROP 13x8 |
| 1 x | Ferrita 17x10x6.5 mm |
| 1 x | Alu-Cross for Backmount of A60-V2-Backmountmotors |
| 1 x | 6,4x1000 mm 2:1 black termoretract tube |
| 1 x | Walbro carburetor for MVVS 26/30/35/40 cc |
 |
| 5,873.71EUR |
