| 2 x | APM2.6 Power module with 5.3V DC BEC |
| 1 x | Balanceradapter JST-XH (Heli 47G) 2-6 c. |
| 2 x | Double conector with JR adapter and 200 mm extension |
| 1 x | BEC 3A FOXY |
| 2 x | 3 copper lacquer wire Ø0,2 mm (1 m) |
| 1 x | "Y" charging 4mm wire (2 IN-1 OUT). |
| 1 x | Copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | UBEC 6A KAVAN |
| 2 x | Connector Sub-D 2+5 Female |
| 2 x | 30 cm BEC cable (female) |
| 1 x | Dean "T" - Futaba Adapter |
| 2 x | Connector Sub-D 2+5 Male |
| 1 x | Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH |
| 2 x | Cabling for Fox MDM1 wings |
| 1 x | CC 02 |
| 2 x | CC 03 |
| 1 x | CC 05 |
| 1 x | CM-3 |
| 1 x | Connector CAN 15 |
| 1 x | Balance "Y" Wire 6S, 2x JST-XH / 1x JST-EH |
| 1 x | 5 LiPo XH>EH adapter |
| 1 x | Circlick securite |
| 1 x | Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm) |
| 1 x | Black copper lacquer wire Ø0,2 mm (5 m) |
| 2 x | 4 LiPo XH>EH adapter |
| 1 x | CellPRO 4S Adaptader (GP/KO up to 4S) |
| 1 x | Cabel charger transmitter GRAUPNER |
| 1 x | 3 LiPo XH>EH adapter |
| 1 x | Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm) |
| 1 x | 30 cm BEC cable (male) |
| 1 x | 2 LiPo XH>EH adapter |
| 1 x | Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm) |
| 1 x | Stickers-digit for marking |
| 1 x | FX three-position switched channel, long |
| 1 x | Micro Switch button |
| 2 x | Three-position switched channel, short |
| 1 x | Female connector JST SH 1.0mm with 10 cm wire |
| 2 x | wing/fuselage connector for 12 pines AWG 20-24 |
| 1 x | EWC3 40 cm wing connector |
| 1 x | Female connector for 12 pines AWG |
| 1 x | EWC6 40 cm wing connector |
| 1 x | Hacker X-Pro USB interface V2 |
| 1 x | Female connector for 20 pines AWG |
| 1 x | SPARK Switch 12v |
| 2 x | JETImodel Addcap 1640 |
| 1 x | Male connector for 10 pines AWG |
| 1 x | EWC3 100 cm wing connector |
| 1 x | Threaded coupler ALU Left M3 Ø 4 (2 uds) |
| 1 x | Threaded coupler ALU M3 Ø 4 (2 uds) |
| 1 x | Horn 5/15 with M2 Bearing |
| 2 x | Horn 5/20 with M2 Bearing |
| 2 x | Aluminum Bayonet / strongal D12 mm / 0.5 m |
| 2 x | LH long black aluminium horn L31xH30 (2pcs) |
| 2 x | Hard aluminium thin-walled tube with fibreglass case ø30x1mm, 1m |
| 1 x | Aluminum Bayonet / strongal D25 mm / 1 m |
| 1 x | Threaded coupler ALU M2,5 Ø 6 (2 uds) |
| 1 x | 6 mm red aluminium threaded horn with patella |
| 1 x | Cable control set |
| 1 x | Horn 13,5x16 mm (2 pcs) |
| 2 x | Brass control horn M4 short for wire (10pcs) |
| 2 x | Motor DLE 200cc Std |
| 1 x | Extension 6 lipos XH > EH |
| 1 x | Opto Gas Engine Kill Switch |
| 1 x | Extension 5 lipos JST/C |
| 1 x | Electronic switch JETI SP06 Opto |
| 1 x | PowerBox SparkSwitch RS |
| 1 x | SPS 70V 140/280 A |
| 1 x | Magnetic Interruptor MULTIPLEX |
| 1 x | SWTU2 switch |
| 1 x | Electronic switch JETI SP6 0-15v/6A |
| 1 x | Extension 2/3 lipos JST - JST/C |
| 2 x | SBEC Jeti |
| 1 x | MAX BEC |
| 1 x | Servo slow down unit (0,7-14,7 sec ) |
| 1 x | Opto Gas Engine Kill Switch |
| 1 x | SBEC 40 |
| 1 x | PSC 5 |
| 1 x | Male prolonguer XH 30 cm 6 cell cable of silicone 0,25 mm |
| 1 x | Silent-blocks DLE 170M |
| 1 x | Female prolonguer XH 30 cm 6 cell cable of silicone 0,25 mm |
| 1 x | MAX BEC 2 |
| 1 x | Male/Female prolonguer for Balancer Thunder Power 6S |
| 2 x | PSC 6 |
| 1 x | SPS 70V 100/200 A |
| 1 x | Male Prolonger TP 4/5S |
| 3 x | Small Crow DLE-170M |
| 1 x | Extension 5 lipos JST - JST/C |
| 2 x | Silicone red 0,25 mm² wire (25 m) |
| 1 x | AIREX® Sheets C 70.55 (YELLOW) 1200x550x6.0 mm (5 pcs) |
| 1 x | Carbon fabric 160 g/m² (twill weave) 127 cm, roll/ 10 m |
| 1 x | Anodized aluminium servo M4x5/8 screw (4 blue pcs) |
| 1 x | Circlick securite |
| 1 x | Smoke set "Glider" |
| 2 x | 2 mm male connector (2 pcs) with safety connector |
| 1 x | Cable silicona female batt. receptor 30 cm (Futaba) |
| 2 x | DPS Switch JR/JR |
| 1 x | ABS tube 12.0x10.0x1000 mm |
| 1 x | Carbon fiber rod 16 mm x 1000 mm |
| 1 x | Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH |
| 2 x | Actuador lineal HLS12-100210-7.4v |
| 1 x | Motor DLE 430 cc - Paramotors |
| 1 x | DPSI magnetic switch actuator (housing) |
| 1 x | SBEC 30 D |
| 1 x | Horn mando small (2 pcs) |
| 1 x | Small aluminium horn red (2pcs) |
| 1 x | Extra long horn 60x30 |
| 1 x | Threaded coupler ALU M3 Ø 6 (2 uds) |
| 1 x | LH long aluminium horn L31xH30 (2pcs) |
| 1 x | Sistema LDS - Ø12 mm servos Ø 6/25 spline 60º (Futaba) pitch 7 m |
| 1 x | Rudder forward 80x28 "type Kato" |
| 1 x | 3,2x1000 mm 2:1 black termoretract tube |
| 1 x | Horn with ball 40x30 |
| 1 x | 3,2x1000 mm 2:1 red termoretract tube |
| 1 x | Wing-connector: Glass / Carbon tube (26.5/25 x 25/23) x 1000 mm |
| 1 x | 1,5x50 mm allen screwdriver |
| 1 x | Duralumium F3A horn 30x10x23,5 mm (2 pcs) |
| 1 x | 3,0x60 mm allen screwdriver |
| 1 x | 5 mm M2 variable inclined horn |
| 1 x | Horn 6/20 with M3 Bearing |
| 1 x | 1,2x1000 mm 2:1 black termoretract tube |
| 1 x | Flybar support metal LAMA |
| 1 x | Horn 6/27 with M3 Bearing |
| 1 x | 58 mm PVC transparent battery termo-retract 68 mm (1 m) |
| 1 x | Brass control horn M4 short for wire (4 pcs) |
| 2 x | Shaft sleeve LAMA |
| 1 x | TMM 1210-3S heli |
| 1 x | PWC6 PowerWingConnector for 6 servos with fuselage socket |
| 1 x | USB Interface REVOLECTRIX for CellPRO 10s |
| 1 x | Short Switch On/Off micro |
| 1 x | TMM 2512-3S heli |
| 1 x | Mini-Pix Esc 15 Amp |
| 1 x | PWC4 wing/fuselage connector for 4 servos |
| 1 x | Optotronix X-Carrier |
| 1 x | GPS Expander Module |
| 1 x | DUPLEX 2.4EX Central Box 320 + 2x Rsat2 + RC Switch |
| 1 x | DPSI LR-S (with push buttons) |
| 1 x | Red copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | SPS Remote switch actuator |
| 1 x | Bidule 170 ARF 3.48 m |
| 1 x | Bidule 55 2460 mm Cabina |
| 1 x | 21x14 Falcon electric carbon prop (64 g) |
| 1 x | Extension 2/3 lipos JST/C |
| 1 x | 12,7x1000 mm 2:1 green termoretract tube |
| 1 x | Transmitter Balancer Futaba V |
| 1 x | Switch Cap L (Blue) |
| 1 x | Multi-adapter balancer JST - TP |
| 1 x | PC-21 2.880 mm (w/o oracover) |
| 1 x | PC-21 XXL Bags |
| 1 x | Battery charging cable XT60 |
| 1 x | X-RAY Micro QR (Tail Tube) |
| 1 x | Chili F3K 2 wing servo mounted |
| 1 x | Telemetry interface ALTIS 6 cm |
| 1 x | Telemetry interface ALTIS 12 cm |
| 1 x | RX Battery Eneloop 6,0 V JR 2500 mAh |
| 1 x | Sanyo TX Battery Eneloop 9,6 V Hitec |
| 1 x | Battery LiFe TopFuel 3100 mAh 3s MTAG 30C |
| 1 x | XH LiPo extension lead |
| 1 x | Electron 22 mm Fitting barb |
| 1 x | Micro control horn T2 Ø 1 |
 |
| 19,047.63EUR |
