| 2 x | Brass rod Ø 1.0 mm x 1000 mm |
| 4 x | Brass hexagonal rod Ø 5 mm x 1000 mm |
| 1 x | Straightened threaded rod M2-1m |
| 3 x | Brass hexagonal rod Ø 3.5 mm x 1000 mm |
| 3 x | Straightened rod Ø 2.0 mm x 1000 mm |
| 4 x | Straightened rod Ø 6.0 mm x 1000 mm |
| 2 x | Straightened rod Ø 1.0 mm x 1000 mm |
| 1 x | Straightened rod Ø 3.0 mm x 1000 mm |
| 2 x | Straightened rod Ø 1.5 mm x 1000 mm |
| 2 x | Straightened rod Ø 4.5 mm x 1000 mm |
| 3 x | Straightened threaded rod M3 - 1m |
| 1 x | Straightened rod Ø 2.5 mm x 1000 mm |
| 2 x | Brass rod Ø 0.8 mm x 1000 mm |
| 2 x | Brass hexagonal rod Ø 4 mm x 1000 mm |
| 2 x | Straightened rod Ø 5.0 mm x 1000 mm |
| 3 x | Brass hexagonal rod Ø 3 mm x 1000 mm |
| 2 x | Straightened rod Ø 5.5 mm x 1000 mm |
| 1 x | Straightened rod Ø 0.5 mm x 1000 mm |
| 1 x | Straightened rod Ø 0.8 mm x 1000 mm |
| 2 x | Brass rod Ø 1.5 mm x 1000 mm |
| 2 x | Straightened rod Ø 4.0 mm x 1000 mm |
| 4 x | Brass rod Ø 0.5 mm x 1000 mm |
| 1 x | Motor A2212/13T |
| 1 x | Strip 2,5x1,25x330 mm |
| 3 x | Strip ABS 2.0x5.0x1000 mm |
| 1 x | ABS Strip 1.0x5.0x1000 mm |
| 3 x | ABS Strip 1.5x3.0x1000 mm |
| 1 x | Strip ABS 2.0x8.0x1000 mm |
| 1 x | Round Rod 3,0x1000 mm |
| 1 x | Round Rod 5,0x1000 mm |
| 2 x | Round Rod 6,0x1000 mm |
| 2 x | ABS Strip 1.0x3.0x1000 mm |
| 2 x | Strip 2,0x2,0x330 mm |
| 2 x | ABS I Strip 10x5x1000 mm |
| 2 x | Strip ABS 2.0x10.0x1000 mm |
| 2 x | Round Rod 1,5x1000 mm |
| 2 x | Round Rod 2,0x1000 mm |
| 3 x | ABS Strip 1.5x4.0x1000 mm |
| 1 x | Straightened rod Ø 1.5 mm x 1500 mm |
| 1 x | MPX-Dean "T" Adapter |
| 1 x | 30 cm BEC cable (female) |
| 1 x | CellPRO 4S Adaptader (GP/KO up to 4S) |
| 2 x | Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm) |
| 1 x | CC 03 |
| 1 x | Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH |
| 1 x | Adapter lead MPX/EC3 |
| 1 x | TrainerCord (master-learner) |
| 1 x | 3 copper lacquer wire Ø0,2 mm (1 m) |
| 1 x | Copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | Circlick securite |
| 1 x | Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm) |
| 1 x | Cabel charger transmitter GRAUPNER |
| 1 x | CC 02 |
| 1 x | 30 cm BEC cable (male) |
| 1 x | 5 LiPo XH>EH adapter |
| 1 x | Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH |
| 1 x | CC 05 |
| 1 x | Balanceradapter JST-XH (Heli 47G) 2-6 c. |
| 1 x | Bec MR UBEC 5A (5v/6v/7v) |
| 1 x | Dean "T" - Futaba Adapter |
| 1 x | TP/TopFuel - XH 2/3S Adapter |
| 1 x | "Y" charging 4mm wire (2 IN-1 OUT). |
| 2 x | Straightened rod Ø 8.0 mm x 1000 mm |
| 2 x | Straightened rod Ø 7.0 mm x 1000 mm |
| 1 x | Straightened rod Ø 14.0 mm x 1000 mm |
| 3 x | Aluminium rod Ø 4.0 mm x 3000 mm |
| 1 x | Militarian pilot "Kamikaze" size 9cm (Slimline) |
| 1 x | 45 mm rods set for direction control |
| 1 x | Vacuum pump 12 CFM |
| 1 x | Motor NGH GF30 |
| 1 x | Canister combo DLE 55 cc |
| 1 x | Motor NGH GT-9 V2 |
| 1 x | Hub DLE 30 |
| 1 x | Angle support XT60 conector |
| 1 x | Jet Afterburner Simulator NF-Jet2 |
| 1 x | Support pumb/filter Xicoy X45 |
| 1 x | NF-3 RC set |
| 1 x | Jet Afterburner Simulator NF-Jet1RY Set |
| 1 x | Motor DLE 20 cc |
| 1 x | Exhaust gasket DA50R DA100 DA200 |
| 1 x | Flat version carb bend for the ZG 62 |
| 1 x | Crankcase gasket DA 170 |
| 1 x | Tapa estado carga XT-60 (6 pcs) |
| 1 x | Exhaust gasket DA-60/120 |
| 1 x | ZENOAH ZG26 SCM Marine Engine |
| 1 x | NF-3X-80 liner Kit |
| 1 x | Motor DLE 40 cc Twin |
| 1 x | Cylinder ZG 26SC/SLH |
| 1 x | NF-1 RC set |
| 1 x | Rear bearing for motor 35/40 cc |
| 1 x | Motor EME 60 cc |
| 1 x | Motor DA 150 |
| 1 x | Motor EME 70 cc |
| 1 x | Motor DA 170 |
| 1 x | Motor Moki S 250 cc 5 cyl with autostarter |
| 1 x | Carburator Moki S400 |
| 1 x | CDI EME 55/60 cc |
| 2 x | Piston ring EME 35cc |
| 1 x | Piñon motor autostarter 60cc |
| 1 x | Flange gasket MOKI carburetor |
| 1 x | Motor DA 50-R |
| 1 x | Moki Carburetor Throttle Arm with Extension |
| 1 x | Seoul Power LED 3 watts PCB Sets: 1x white, 1x red, 1x green |
| 1 x | Motor EME 35 cc with electric starter |
| 1 x | Motor EME 35 cc |
| 1 x | Piston EME 35cc |
| 1 x | Baffles for Radial Moki S180/320 mm |
| 1 x | Propeller hub EME 60cc |
| 1 x | Air filter MOKI |
| 1 x | Carburator gasket MOKI |
| 1 x | Strip 1,5x1,5x330 mm |
| 2 x | Straightened rod Ø 1.2 mm x 1500 mm |
| 1 x | Beech dowels 3.0 x 1000 mm |
| 1 x | MAMBO 17 |
| 2 x | ABS Strip 1.0x4.0x1000 mm |
| 1 x | Strip ABS 2.0x3.0x1000 mm |
| 1 x | MZ-12, 6 Channel HoTT |
| 1 x | Foam plastic plates (310x210x2 mm) |
| 1 x | 40 mm 1/4" Race propeller (rigth hydropropeller) |
| 1 x | Adjustable brass horn threaded M3 |
| 1 x | V tail SILENT DREAM 2.200 mm (Elec or Glider) |
| 1 x | Motor holder for AC 28/7 |
| 1 x | ABS Strip 1.5x8.0x1000 mm |
| 1 x | Round Rod 1,25x1000 mm |
| 1 x | Cooler motor type 400 |
| 1 x | Spinner fixed propeller 60 mm / 5,0 mm |
| 1 x | Receiver replacement antenna, approx. 15 |
| 1 x | TMM 2512-3S heli |
| 1 x | ABS Strip 1.5x6.0x1000 mm |
| 1 x | Servo Arm aluminium ALU-STAR |
| 1 x | Canopy Latch |
 |
| 15,749.67EUR |
