1 x | Optical RPM Sensor |
1 x | DYNAMOMETER S-1580 |
1 x | Parachute P4 |
2 x | Opale Rucksack |
1 x | Aramid 50 daN 50 m |
1 x | Wing OXY 5,0 m2 |
2 x | LUCAS pilot ARTF |
1 x | Paramotor BackPack XXS 2 |
1 x | Para-RC Mix |
1 x | Trike XL motor set (motor+esc+prop) |
1 x | Windsock Ozone L - 700 mm |
2 x | Parachute PV6 for F3J |
2 x | Parachute BACKUP X100 |
1 x | Windsock Ozone L -1200 mm |
1 x | Stainless steel cable Ø 0.52 mm - 15 kp (10 m) |
1 x | Locking cable tie 4.6x203 (uds) |
1 x | Electric spoiler 250 mm (2 pcs) |
1 x | Steering arm 16 mm Ø 3 mm (2 uds) |
1 x | L cockpit anchor "tipe F3A" (2 pcs) |
2 x | Canopy Latch |
1 x | Aluminium alloy coupler for carbon tube 6/M4 |
1 x | Steering arm 12 mm Ø 4 mm (2 uds) |
2 x | Screw-lock pushrod conn snap Ø 1.5 mm (2 uds) |
1 x | Cierre cabina aluminio Ø4, I=10 mm |
1 x | Steering arm 16 mm Ø 4 mm |
1 x | Stainless steel cable Ø 0.5 mm (10 m) |
1 x | Steering arm 12 mm Ø 3 mm (2 uds) |
1 x | Stainless steel cable Ø 0.5 mm (2 m) |
1 x | Stainless steel cable Ø 0.5 mm (20 m) |
1 x | DUPLEX USBa USB-Adapter for Jeti Duplex Items |
1 x | JETImodel SINGLE BEC |
1 x | 30 cm BEC cable (male) |
1 x | 3 copper lacquer wire Ø0,2 mm (1 m) |
1 x | CC 01 |
1 x | Copper lacquer wire Ø0,2 mm (5 m) |
1 x | 4 LiPo XH>EH adapter |
1 x | 2 LiPo XH>EH adapter |
1 x | 5 LiPo XH>EH adapter |
1 x | BEC 3A FOXY |
1 x | TP/TopFuel - XH 2/3S Adapter |
1 x | CellPRO 4S Adaptader (GP/KO up to 4S) |
1 x | CC 02 |
1 x | Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH |
1 x | Balance "Y" Wire 6S, 2x JST-XH / 1x JST-EH |
1 x | Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm) |
1 x | "Y" charging 4mm wire (2 IN-1 OUT). |
1 x | AIREX® Sheets C 70.55 (YELLOW) 1200x550x4.0 mm (5 pcs) |
1 x | Hexagonal ball head 2.0 x 50 mm |
1 x | Spring lock washer 3.1 mm (20 pcs) |
1 x | Para-RC Trike "RC-Bullix" |
1 x | Ballast 700gr OPALE |
1 x | 3 LiPo XH>EH adapter |
1 x | Short Switch On/Off micro |
1 x | Glider IKARUS |
1 x | Paramotor Trike XL |
1 x | Para-RC "RC-Evo-Cross" Rescue |
1 x | MAX pilot ARTF |
1 x | Allen wheel collar M4x6 |
1 x | Fully Threaded Steel Rod Duralumin 110 mm M3 (2 pcs) |
1 x | Tip wing protector 30x10 (2 pcs) |
1 x | Head lower part New |
1 x | 41x5,5 mm wires output (2 pcs) |
1 x | Tip wing protector 28x10x12 (2 pcs) |
1 x | Head core bushing |
1 x | Propeller diller for DA50, DLE55 red |
1 x | Propeller diller for EME35 and DLE35 |
1 x | Blade holder upper |
1 x | Steering lever |
1 x | Fully Threaded Steel Rod Duralumin 120 mm M3 (2 pcs) |
1 x | Nut M2 |
1 x | Crimping sleeves for cable 0.70 mm (10 pcs) |
1 x | Cable grommet Ø 3.2 mm (4 uds) |
1 x | Extension silicon 30 cm male (Futaba) |
1 x | Extension silicon 30 cm female (Graupner) |
1 x | Cable silicona macho batt. receptor 30 cm (Graupner) |
1 x | Servo M2x7/16 screw (4 pcs) |
1 x | Ball joint long |
1 x | Screws M1,6x6 Allen |
1 x | Propeller diller for DLE30/DLE35RA/DLE40/DLE55/DLE61/EME 55/DA-5 |
1 x | Crimping sleeves for cable 0.85 mm (10 pcs) |
1 x | Cable grommet Ø 6.4 mm (4 uds) |
1 x | Screws flush mount M2 |
1 x | Head spacer |
1 x | Blade holder center |
1 x | Head lower part |
1 x | Fully Threaded Steel Rod Duralumin 70 mm M3 (2 pcs) |
1 x | Landing gear frontal support 29x26x13,5 |
1 x | Alu-Cross for Backmount of A60-V2-Backmountmotors |
1 x | Fully Threaded Steel Rod Duralumin 80 mm M3 (2 pcs) |
1 x | Fully Threaded Steel Rod alumin 60 mm M3 (2 pcs) |
1 x | Control for forward wheel (MINI) |
1 x | Split pin 1x8 mm (10 uds) |
1 x | Cierva C30 simulated motor |
|
5,543.69EUR |