| 2 x | Balanceradapter JST-XH (Heli 47G) 2-6 c. |
| 2 x | Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm) |
| 1 x | DPS Switch JR/JR |
| 1 x | Copper lacquer wire Ø0,2 mm (5 m) |
| 2 x | Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH |
| 2 x | CM-3 |
| 3 x | Circlick securite |
| 2 x | CC 03 |
| 1 x | Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm) |
| 3 x | APM2.6 Power module with 5.3V DC BEC |
| 1 x | Double conector with JR adapter and 200 mm extension |
| 3 x | Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH |
| 2 x | Connector Sub-D 2+5 Male |
| 2 x | CC 01 |
| 2 x | 2 LiPo XH>EH adapter |
| 2 x | Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm) |
| 2 x | "Y" charging 4mm wire (2 IN-1 OUT). |
| 1 x | Cabling for Fox MDM1 wings |
| 2 x | 30 cm BEC cable (male) |
| 2 x | Black copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | Connector CAN 15 |
| 2 x | CellPRO 4S Adaptader (GP/KO up to 4S) |
| 1 x | 3 LiPo XH>EH adapter |
| 2 x | Cabel charger transmitter GRAUPNER |
| 2 x | 4 LiPo XH>EH adapter |
| 1 x | CC 05 |
| 2 x | CC 02 |
| 2 x | 30 cm BEC cable (female) |
| 1 x | Dean "T" - Futaba Adapter |
| 2 x | MAX BEC |
| 1 x | SBEC Jeti |
| 1 x | MAX BEC 2D plus EX |
| 1 x | Multi-adapter balancer JST - TP |
| 2 x | PSC 6 |
| 1 x | SPS Remote switch actuator |
| 1 x | Male Prolonger TP 4/5S |
| 2 x | Extension 2/3 lipos JST/C |
| 2 x | Interruptor SAFET-SWITCH 12HV Twinbatt |
| 1 x | Extension 5 lipos JST/C - JST |
| 2 x | Male prolonguer XH 30 cm 6 cell cable of silicone 0,25 mm |
| 1 x | SPS 70V 100/200 A |
| 2 x | Extension 6 lipos XH > EH |
| 2 x | Servo slow down unit (0,7-14,7 sec ) |
| 1 x | Interruptor SPS 70v 60/120A |
| 2 x | Prolonguer for Balancer Thunder Power 6S |
| 1 x | Extension 5 lipos JST - JST/C |
| 1 x | Extension 5 lipos JST/C |
| 1 x | SWTU2 switch |
| 2 x | SBEC 40 |
| 2 x | Pins M connect Multipin connectors AWG 20-24 |
| 1 x | Magnetic Interruptor MULTIPLEX |
| 2 x | MAX BEC 2 |
| 2 x | Switching module high voltage SXH |
| 1 x | Male/Female prolonguer for Balancer Thunder Power 6S |
| 3 x | Interruptor RX/Batterie |
| 1 x | USB interface ALTIS |
| 1 x | Interface Realflight Simulator |
| 1 x | Slave-cable USB Easy Sim |
| 1 x | EasyFLY Addon |
| 1 x | Simulador RealFlight RF-9.5 S (sin emisora) |
| 1 x | Interface Jack Adapter IKARUS |
| 1 x | Civilian pilot "Gramps" size 9cm (Slimline) |
| 1 x | Xplorer1 anemometro |
| 2 x | Extension 2/3 lipos JST - JST/C |
| 1 x | Pilot "Anthony" (Slimline) |
| 1 x | Switc electronic 30 Amp |
| 1 x | Multi-adapter balancer JST/C - TP |
| 1 x | SBEC 30 D |
| 1 x | Piloto RC Civil 1/5- 1/6 Scale 12" |
| 1 x | Xplorer4 anemometro |
| 1 x | Long Switch On/Off micro |
| 1 x | Adapter lead MPX/EC3 |
| 1 x | Futaba External voltage input cable Futaba CA-RVIN-700 |
| 1 x | MPX-Dean "T" Adapter |
| 1 x | TP/TopFuel - XH 2/3S Adapter |
| 1 x | 5 LiPo XH>EH adapter |
| 2 x | TP/TopFuel - JST-EH 4/5S Adapter |
| 1 x | Adapter lead MPX/XT60 |
| 1 x | TrainerCord (master-learner) |
| 1 x | DUPLEX USBa USB-Adapter for Jeti Duplex Items |
| 1 x | BEC 3A FOXY |
| 1 x | Red copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | 3 copper lacquer wire Ø0,2 mm (1 m) |
| 1 x | USB HLS prog. interface |
| 1 x | Cylidric hinge 43 mm Ø 2,5 mm (5 pcs) |
| 1 x | Straightened rod Ø 3.0 mm x 1000 mm |
| 1 x | Trailing edge BALSA 35x8x1000 mm |
| 1 x | Locking cable tie 4.6x203 (uds) |
| 1 x | Prolongador S-Bus JR/JR 20cm |
| 1 x | Glases Aspen |
| 1 x | Clevis plastico I=26 mm / hole 2mm / pin 1 (2 pcs) |
| 1 x | Connector Sub-D 2+5 Female |
| 1 x | Black spiral protective cover for wires Ø 0,5/50 mm - 25 m |
| 1 x | Support ECU Xicoy X-45 |
| 1 x | SPS 70V 140/280 A |
| 1 x | wing/fuselage connector for 12 pines AWG 20-24 |
| 1 x | Three-position switched channel, short |
| 1 x | Opto Gas Engine Kill Switch |
| 1 x | Opto Gas Engine Kill Switch |
| 1 x | Sun Cover ULTIMATUM 2.0 (Hispano Aviacion) |
| 1 x | Sun Cover BULL Mo1 2.6 (Hispano Aviacion) |
| 2 x | GameCommander USB Universal |
| 1 x | PowerBox SparkSwitch RS |
| 1 x | Epoxy Resin L 285 + Hardener 386, kit/ 675g |
| 1 x | Hardener Aero EPH 161 (500 g) |
| 1 x | resin-hardener L-385 H-385 (625 g) |
| 1 x | resin-hardener L-385 H-385 (5000 g) |
| 1 x | Epoxy Resin L 285 + Hardener 285 (Aero), kit/ 1 kg |
| 1 x | Mould Resin P + Hardener EPH 161-P, kit/ 585 g |
| 1 x | Epoxy Resin L 285 + Hardener 386, kit/ 1.35 kg |
| 1 x | PSC 5 |
| 1 x | Epoxy Resin L (2.5 Kg) |
| 1 x | Civilian pilot "Joe" size 9cm (Slimline) |
| 1 x | Civilian pilot "Pamela" size 9cm (Slimline) |
| 1 x | 1/6 Pilot "Buddy" |
| 1 x | 1/4 Pilot "Heidi" |
| 1 x | 1/6 Pilot "Tony" |
| 1 x | Piloto Jet "Green" 1/6 Scale |
| 1 x | 1/7 Pilot "Japanese" |
| 1 x | 1/10 Pilot "Jimmy" |
| 1 x | 1/12 Pilot "Tom" |
| 1 x | 1/12 Pilot "Langley" |
| 1 x | 1/12 Pilot "Fighter" |
| 1 x | DPSI Micro SingleBat 5.9V/7.2V F3A Edition magnetic switch |
| 1 x | DPSI RV Mini 6 Magic with Gas-Cap switch |
| 1 x | DPSI V-Match |
| 1 x | Bec MR UBEC 5A (5v/6v/7v) |
| 1 x | Carburador OS (Type 40K) 46AXII |
| 1 x | Motor OS 81 FS 4T |
| 1 x | Captador OS GT 33 cc |
| 1 x | Axle for motor A50-L |
| 1 x | JETImodel Addcap 820 |
 |
| 4,968.31EUR |
