| 1 x | Vasa model Catapult |
| 1 x | Fibra carbono 3k tela 160g/m2 100 cm x 5m |
| 1 x | Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 10 m |
| 1 x | Vacuum sealing tape, 2.5 x 12 mm (up to 140 °C) 22 roll |
| 1 x | Glass fabric tape 130 g/m² (Silane, plain) 25 mm / 100M |
| 2 x | Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 100 m |
| 1 x | AIREX® Sheets C 70.55 (YELLOW) 1200x550x6.0 mm (5 pcs) |
| 1 x | AIREX® Sheets C 70.55 (YELLOW) 1200x550x2.0 mm (10 pcs) |
| 1 x | Demoulding wedge red (40 x 20 mm) 5 pcs |
| 1 x | Fibra carbono tela 160g/m2 100 cm x 2 m (twill weave) |
| 1 x | Carbon Non-Woven, 160 g/m² 100 cm 25 m |
| 1 x | Glass fabric tape 130 g/m² (Silane, plain) 25 mm / 50M |
| 1 x | Carbon fabric 200 g/m² (Aero, plain weave) 100 cm x 5m |
| 1 x | ARAMID honeycomb 1300x2600x2 mm |
| 1 x | Glass fabric tape 225 g/m² (Silane, plain) 40 mm |
| 1 x | Carbon fabric 160 g/m² (plain weave) 100 cm x 2 m |
| 1 x | Glass fabric tape 49 g/m² (Interglas 02037, finish FE 600/800, p |
| 1 x | Xplorer2 anemometro |
| 1 x | 2 LiPo XH>EH adapter |
| 2 x | TP/TopFuel - JST-EH 4/5S Adapter |
| 1 x | JETImodel SINGLE BEC |
| 1 x | Dean "T" - Futaba Adapter |
| 1 x | CM-3 |
| 1 x | Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH |
| 1 x | Black copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | "Y" charging 4mm wire (2 IN-1 OUT). |
| 1 x | CellPRO 4S Adaptader (GP/KO up to 4S) |
| 1 x | Copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm) |
| 1 x | 3 LiPo XH>EH adapter |
| 1 x | 30 cm BEC cable (female) |
| 1 x | CC 02 |
| 1 x | USB HLS prog. interface |
| 1 x | ABS Strip 1.5x8.0x1000 mm |
| 1 x | Round Rod 1,5x1000 mm |
| 1 x | ABS Strip 1.5x3.0x1000 mm |
| 1 x | Round Rod 4,0x1000 mm |
| 1 x | ABS Strip 1.0x2.0x1000 mm |
| 1 x | Round Rod 2,0x1000 mm |
| 1 x | ABS Strip 1.0x3.0x1000 mm |
| 1 x | ABS I Strip 10x5x1000 mm |
| 1 x | Strip ABS 2.0x5.0x1000 mm |
| 1 x | ABS Strip 1.0x4.0x1000 mm |
| 1 x | Strip 3,5x1,75x330 mm |
| 1 x | ABS Strip 1.5x6.0x1000 mm |
| 1 x | Round Rod 5,0x1000 mm |
| 1 x | Strip ABS 2.0x8.0x1000 mm |
| 1 x | Strip 1,5x1,5x330 mm |
| 1 x | ABS Strip 1.0x5.0x1000 mm |
| 1 x | Round Rod 2,5x1000 mm |
| 1 x | Round Rod 1,0x1000 mm |
| 1 x | ABS I Strip 20x10x1000 mm |
| 1 x | Aluminum Bayonet / strongal D25 mm / 1 m |
| 1 x | Carbon fiber flat 1000x3.0x0.5 mm |
| 1 x | Kwik link AL M4 con Clip (2 pcs) |
| 1 x | Ball Link ALU M3 - RH (1 pcs) |
| 1 x | Cable grommet Ø 6.4 mm (4 uds) |
| 1 x | Long ball link M1.6 (6 uds) |
| 1 x | Connectors banana oro 6,0 mm Ultralight (M/F) |
| 1 x | Oracover Yellow CADMIO 2 m |
| 1 x | PVC plate 320 x 194 x 0.23 mm (brown) |
| 1 x | Fiberglass plate 620x540x0,3 mm |
| 1 x | Sandwich carbon + poplar 3mm + carbon 290x160 mm |
| 1 x | Carbon plate 550x350x3.0 mm ECOTECH |
| 1 x | Fiberglass plate 350x150x4.0 mm |
| 1 x | Fiberglass plate 620x540x1,0 mm |
| 1 x | Fiberglass plate 350x150x1.5 mm |
| 1 x | Fiberglass plate 350x150x0.5 mm |
| 2 x | Teflon rollers 80 mm x 15 mm Diam. |
| 2 x | Teflon rollers 40 mm x 15 mm Diam. |
| 1 x | Sandwich carbon + poplar 2mm + carbon 480x290 mm |
| 1 x | 120x60 mm SLH KOVO wheel |
| 1 x | Release film 100 cm x 50 m |
| 1 x | Carbon Fiber TeXtreme® 80 g/m² (plain) 100 cm, roll/ 10 m |
| 1 x | Glass fabric 80 g/m² (FK 144, twill weave) 100 cm, pack/ 1 m |
| 1 x | Stickers-digit for marking |
| 1 x | Fiberglass 25 g/m² 5000x1270 mm |
| 4 x | Ventus 1:4 set of instruments |
| 1 x | Glass fabric 49 g/m² (1,27 x 5 m) |
| 1 x | Angle support XT60 conector |
| 1 x | Sandwich carbon + poplar 4mm + carbon 290x160 mm |
| 1 x | Carbon Non-crimp ST 200 g/m² 50 cm x 5 m |
| 1 x | Glass fabric 80 g/m² (twill) 100 cm x 50m |
| 1 x | Soporte filtro FESTO (4 pcs) |
| 1 x | Junta selladora, Tacky Tape Gris 2.75mmx12mmx15m |
| 1 x | Glass fabric 80 g/m² (Interglas 05533, finish FK 144, twill weav |
| 1 x | Fiberglass 163 g/m² 1m x 50 m (Aero, finish FK 144, plain) |
| 1 x | Sheet Depron Aero 1250x800x3 mm |
| 1 x | Carbon Non-Woven, 240 g/m² 100 cm x 20 m |
| 1 x | Glass fabric 390 g/m² (silane, twill) 100 cm x 20m |
| 1 x | PET film Mylar® A 350, 50 cm, roll/ 5 m |
| 1 x | Glow starter with charger 230v |
| 2 x | Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 20 m |
| 1 x | MAX BEC 2 |
| 1 x | THERMIK XL 4000 mm |
| 1 x | Opto Gas Engine Kill Switch |
| 1 x | Opto Gas Engine Kill Switch |
| 1 x | USB Adaptor OPTronics |
| 1 x | Short Switch On/Off micro |
| 1 x | Lunak ARF 2000 mm Yellow (Hacker Model) |
| 1 x | PSC 6 |
| 1 x | USB Interface REVOLECTRIX for CellPRO 10s |
| 1 x | TAKEO 3.6m electric |
| 1 x | Battery RX JETI LiIon RB 2600 7.2v |
| 1 x | PWC4 wing/fuselage connector for 4 servos |
| 1 x | Prolonguer for Balancer Thunder Power 6S |
| 1 x | Switc electronic 30 Amp |
| 1 x | bavarianDEMON USB cable |
| 1 x | DPSI Micro SingleBat 5.9V/7.2V magnetic switch |
| 1 x | 14 mm portholes (10 pcs) |
| 1 x | 39,0 mm propeller (rigth propeller) |
| 1 x | 40 mm 1/4" Race propeller (rigth hydropropeller) |
| 1 x | Alfileres de cobre 0,7 x 7 mm, aprox.50 g |
| 1 x | Motor ACTRO 28-4-880 |
| 1 x | 25,0 mm 3-BL M4 hydro-propeller (rigth hydropropeller) |
| 1 x | 39,0 mm propeller (left propeller) |
| 1 x | Aqua RACE 70 (without motor) |
| 1 x | Motor ACTRO 50-2-760 |
| 1 x | 33,0 mm propeller (left propeller) |
| 1 x | 10 mm portholes (10 pcs) |
| 1 x | Propeller balancer |
| 1 x | CA Glue fast 20g |
| 1 x | Foaming agent for epoxy resins 200 g |
| 1 x | Hardener Aero EPH 161 (250 g) |
| 1 x | PARTALL® Hi-Temp Wax, 340 g |
| 1 x | AIREX® Sheets C 70.55 (YELLOW) 1200x550x1.2 mm (5 pcs) |
| 1 x | ARTIST 1.560 mm |
| 1 x | AC-10 pre-rotacion with motor |
| 1 x | Z Bender - S Type Tool |
| 1 x | Cylidric hinge 43 mm Ø 2,5 mm (5 pcs) |
| 1 x | Hot Glue Stick BLACK |
| 1 x | Fibra de vidrio 80 g/m² (10 m x 100 cm) |
| 1 x | Spinner NUT M10x1 |
| 1 x | Fiberglass 163 g/m² 1m x 5 m (Twill) |
| 1 x | Glass fabric 49 g/m² (1,27 x 20 m) |
| 1 x | Fibra de vidrio 80 g/m² (5 m x 100 cm) |
| 1 x | Spinner Alumin. fixed propeller 40 mm / 4,0 mm |
| 1 x | Spinner Alumin. fixed propeller 30 mm / 2,3 mm |
| 1 x | Glass fabric 25 g (2 m²) |
| 1 x | Chopped glass fibre strands 3 mm |
| 1 x | Glass fabric 49 g/m² (Finish FE 800, plain) 110 cm x 3m |
| 1 x | Spinner NUT 1/4x28 |
| 1 x | Spinner Alumin. fixed propeller 45 mm / 4,0 mm |
| 1 x | 51 mm INO spinner (carbon imitation) |
| 1 x | Support FUEL DOT V3 |
| 1 x | Spring clamp for tube Ø29 mm ext 1pc |
| 1 x | Hard aluminium thin-walled tube with fibreglass case ø30x1mm, 1m |
 |
| 9,240.55EUR |
