| 1 x | Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH |
| 1 x | Cabel charger transmitter GRAUPNER |
| 3 x | Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm) |
| 1 x | Balance "Y" Wire 6S, 2x JST-XH / 1x JST-EH |
| 2 x | 3 LiPo XH>EH adapter |
| 1 x | Bec MR UBEC 5A (5v/6v/7v) |
| 1 x | Red copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | CC 05 |
| 1 x | CM-3 |
| 1 x | CC 01 |
| 1 x | 2 LiPo XH>EH adapter |
| 1 x | APM2.6 Power module with 5.3V DC BEC |
| 1 x | 30 cm BEC cable (male) |
| 1 x | Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm) |
| 1 x | CC 03 |
| 3 x | JETImodel SINGLE BEC |
| 1 x | Balanceradapter JST-XH (Heli 47G) 2-6 c. |
| 2 x | Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm) |
| 2 x | Dean "T" - Futaba Adapter |
| 1 x | "Y" charging 4mm wire (2 IN-1 OUT). |
| 1 x | 13 mm self adhesive Pinking Tape, saw tooth height 1.0 mm |
| 1 x | Cinta Goldfix 1m |
| 1 x | SE Ring 300 mm (2 pcs) |
| 1 x | ABS Strip 1.5x6.0x1000 mm |
| 1 x | 20x1000 mm Ring Strap Back To Back |
| 1 x | Strip ABS 2.0x10.0x1000 mm |
| 1 x | ABS Strip 1.0x4.0x1000 mm |
| 1 x | Round Rod 3,0x1000 mm |
| 1 x | Round Rod 1,0x1000 mm |
| 2 x | ABS Strip 1.5x2.0x1000 mm |
| 1 x | Round Rod 2,0x1000 mm |
| 1 x | 14x60 mm Mini rings Tie Wraps (4 pcs) |
| 1 x | ABS Strip 1.5x8.0x1000 mm |
| 1 x | Round Rod 1,5x1000 mm |
| 1 x | 5 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
| 1 x | Strip 2,5x1,25x330 mm |
| 1 x | Round Rod 1,25x1000 mm |
| 1 x | Strip ABS 2.0x5.0x1000 mm |
| 1 x | Round Rod 2,5x1000 mm |
| 2 x | SE Ring 360 mm (2 pcs) |
| 1 x | SE Ring 400 mm (2 pcs) |
| 2 x | Round Rod 6,0x1000 mm |
| 1 x | SE Ring 350 mm (2 pcs) |
| 1 x | SE Ring 480 mm (2 pcs) |
| 1 x | Strip 1,5x1,5x330 mm |
| 1 x | Strip 3,5x1,75x330 mm |
| 1 x | 13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
| 2 x | Round Rod 4,0x1000 mm |
| 1 x | SE Ring 200 mm (2 pcs) |
| 1 x | Pad self adhesive, up to 3mm / 0.12″, (10 pcs) |
| 1 x | RUDDOG Protection and Heat Shield Tape (2mx50mm) |
| 3 x | ABS Strip 1.5x3.0x1000 mm |
| 1 x | |
| 1 x | SE Ring 330 mm (4 pcs) |
| 1 x | SE Ring 240 mm (2 pcs) |
| 1 x | ABS Strip 1.0x5.0x1000 mm |
| 1 x | Marker ties (20 pcs) |
| 1 x | Spikes Band (5 m) |
| 1 x | SE Ring HACKER 300 mm (2 pcs) |
| 2 x | Round Rod 5,0x1000 mm |
| 1 x | Strip 2,0x2,0x330 mm |
| 1 x | ABS Strip 1.5x4.0x1000 mm |
| 1 x | Horn 6/27 with M3 Bearing |
| 1 x | Parachute expulsion foam |
| 1 x | Parachutist |
| 1 x | Oracover CARBON Metalic 1 m |
| 1 x | SPS 70V 140/280 A |
| 1 x | 3 copper lacquer wire Ø0,2 mm (1 m) |
| 1 x | 5 LiPo XH>EH adapter |
| 1 x | DPSI Ampere battery backer |
| 2 x | Female prolonguer XH 30 cm 6 cell cable of silicone 0,25 mm |
| 1 x | Copper lacquer wire Ø0,2 mm (5 m) |
| 2 x | Adapter lead MPX/EC3 |
| 1 x | Extension 5 lipos JST/C - JST |
| 1 x | Female connector JST SH 1.0mm with 10 cm wire |
| 1 x | Double conector with JR adapter and 200 mm extension |
| 1 x | Prolonguer for Balancer Thunder Power 6S |
| 1 x | PWC4 wing/fuselage connector for 4 servos |
| 1 x | TP/TopFuel - XH 2/3S Adapter |
| 1 x | Servo slow down unit (0,7-14,7 sec ) |
| 1 x | SPS Remote switch actuator |
| 1 x | SPARK Switch 7.4v |
| 1 x | Landing gear Rocket 400 |
| 1 x | Helices DJI Mavic Air 2 STEALTH "Black" (4x Ud) |
| 2 x | DUPLEX USBa USB-Adapter for Jeti Duplex Items |
| 1 x | Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH |
| 1 x | Tape GFK 38 mm |
| 1 x | Sparkplug 1/4-32 EVO 10GX |
| 1 x | GPS Expander Module |
| 1 x | Y Cable |
| 1 x | Spark motor OS Type F |
| 1 x | Sparkplug NGK CM6 |
| 1 x | Gates hinge |
| 1 x | Canopy hinges for Discus 2c, Discus 2a, Ventus 2cx (2pcs) |
| 1 x | Pin type hinge Al 3,0x50 mm demount (2 pcs) |
| 1 x | 15 mm reinforced hinge |
| 1 x | Nylon hinge for flaps/gates 27x10,5 (2 pcs) |
| 1 x | Pin type hinge Al 4,5x70 mm (2 pcs) |
| 1 x | Gates hinge 30x16 mm (2 pcs) |
| 1 x | Large flex hinge (12 uds) |
| 1 x | Nylon hinge 20x15x0,3 (10 pcs) |
| 1 x | Pin hinge 34x16 mm (10 uds) |
| 1 x | WingFix ULTRA Black Edition |
| 1 x | Field folding model stand SebArt |
| 1 x | 120x60 mm SLH KOVO wheel |
| 1 x | SIMtransmitter 6 Mode 2 |
| 1 x | 67 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs) |
| 1 x | Interface Jack Adapter IKARUS |
| 1 x | RF9 Flight Simulator with Spektrum Controller |
| 1 x | Propeller balancer |
| 1 x | 26 mm self adhesive Pinking Tape, saw tooth height 1.0 mm |
| 1 x | Cable-Tie 1.66x71mm / 0.07x2.8″ (20 pcs) |
| 1 x | ABS Strip 1.0x3.0x1000 mm |
| 1 x | ABS I Strip 20x10x1000 mm |
| 1 x | ABS Strip 1.0x2.0x1000 mm |
| 1 x | 20x200 mm battery rings |
| 1 x | JETImodel Addcap 1640 |
| 1 x | Female connector for 20 pines AWG |
| 1 x | Male prolonguer XH 30 cm 6 cell cable of silicone 0,25 mm |
| 1 x | Extension 2/3 lipos JST - JST/C |
| 1 x | Male connector for 10 pines AWG |
| 1 x | JETImodel DPS 40 |
| 1 x | Aluminium Hub for folding Props 37 mm M8 Shaft 5 mm |
| 1 x | Bearings for motors hacker A50 |
| 1 x | EDGE 540-A 105" (2660 mm) |
| 1 x | Hacker X-Pro USB interface V2 |
| 1 x | Electronic switch JETI SP06 Opto |
| 1 x | Extension 6 lipos XH > EH |
| 1 x | Interruptor RX/Batterie |
| 1 x | Female connector for 16 pines AWG |
| 1 x | DPSI magnetic switch actuator (housing) |
| 1 x | Female connector for 10 pines AWG |
| 1 x | EWC3 40 cm wing connector |
| 1 x | Magnetic Interruptor MULTIPLEX |
| 1 x | FX three-position switched channel, long |
| 1 x | Male connector for 16 pines AWG |
| 1 x | Male connector for 12 pines AWG |
| 1 x | Male/Female prolonguer for Balancer Thunder Power 6S |
| 1 x | Male connector for 20 pines AWG |
| 1 x | Male connector JST SH 1.0mm with 10 cm wire |
| 1 x | Extension 2/3 lipos JST/C |
| 1 x | Interruptor SAFET-SWITCH 12HV Twinbatt |
| 1 x | Disipador para motor Hacker B 20 (or motors up to Ø20 mm) |
| 1 x | Battery LiFe TopFuel 3100 mAh 4s MTAG 30C |
| 1 x | A40 Backmountset complete |
 |
| 3,805.71EUR |
