| 1 x | Motor A2212/13T |
| 1 x | TWIST planeador gomas |
| 1 x | Bird (Aero-naut) |
| 1 x | LA500 housing-upper cyclic |
| 1 x | Blade holder center |
| 1 x | Screw M3x16 |
| 1 x | Motor wall |
| 1 x | Balls 4 mm |
| 1 x | Head lower part New |
| 1 x | Tail support (2 pcs) |
| 1 x | 120x60 mm SLH KOVO wheel |
| 1 x | Optical RPM Sensor |
| 1 x | Nylon hinge 15x0,3 (10 pcs) |
| 1 x | BALSA trip 3.0x3.0x1000 mm |
| 1 x | 140 mm rods + T patellas set for direction control |
| 1 x | Straightened rod Ø 1.0 mm x 1000 mm |
| 1 x | Red smoke canister 100 g |
| 1 x | Straightened threaded rod M2-1m |
| 2 x | Aluminium sheet 500x250x0,5mm |
| 1 x | Initior Receiver FRX2 Wireless |
| 1 x | Brass hexagonal rod Ø 4 mm x 1000 mm |
| 1 x | 3 copper lacquer wire Ø0,2 mm (1 m) |
| 1 x | Cable tie mounts 4.3 (4 uds) |
| 1 x | ABS Strip 1.5x8.0x1000 mm |
| 1 x | Extension silicon 30 cm male (Graupner) |
| 1 x | Circlick securite |
| 1 x | Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm) |
| 1 x | Straightened rod Ø 1.2 mm x 1500 mm |
| 1 x | Carbon Fabric Prepreg 200 g/m² (twill 2/2) 100 cm, roll/ 1 m |
| 1 x | Decorative caps, multicoloured, short |
| 1 x | White smoke canister 65 g |
| 1 x | Extinguisher CO2 - 2 Kg |
| 1 x | Decorative caps, multicoloured |
| 1 x | Aluminium tube (L 1000 mm, Ø4.0 mm, Ø3.1 mm) |
| 1 x | 100 mm rods + T patellas set for direction control |
| 1 x | Support XT60 conector (2 pcs) |
| 1 x | Carbon fabric 160 g/m² (twill weave) 127 cm, roll/ 10 m |
| 1 x | Straightened rod Ø 7.0 mm x 1000 mm |
| 1 x | Cabel "Y" 30 cm (graupner) |
| 1 x | Cabel "Y" 30 cm (Futaba) |
| 1 x | Clip fixing for wing (2 pcs) |
| 1 x | CM-3 |
| 1 x | 45 mm white plastic spinner for fixed propeller |
| 1 x | CC 03 |
| 1 x | Carbon fiber rod 0.5 mmx1000 mm |
| 1 x | Carbon fiber rod 1.5 mm x 1000 mm |
| 1 x | Carbon fiber flat 1000x3.0x0.5 mm |
| 1 x | Straightened rod Ø 5.5 mm x 1000 mm |
| 1 x | Extension silicon 30 cm female (Graupner) |
| 1 x | Carbon fiber rod 20 mmx1000 mm |
| 1 x | Straightened rod Ø 3.0 mm x 1000 mm |
| 1 x | 38x4,5 mm wires output (2 pcs) |
| 1 x | Foam plastic plates (310x210x8 mm) |
| 1 x | 42 mm white plastic spinner for fixed propeller |
| 1 x | Carbon fiber rod 4.0 mmx1000 mm |
| 1 x | 45 mm rods + T patellas set for direction control |
| 1 x | Carbon tube (L 1000 mm, Ø16 mm, Ø12 mm) |
| 1 x | Gates hinge black 30x16 mm (2 pcs) |
| 1 x | Brass hexagonal rod Ø 5 mm x 1000 mm |
| 1 x | Support Pitot JETI |
| 1 x | Pin hinge 26x11 mm (10 uds) |
| 1 x | Prolongador S-Bus JR/JR 10cm |
| 1 x | Micro flex hinge (12 uds) |
| 1 x | 28 mm tailwheel unit |
| 1 x | A/C quality beech plywood 600x300x5.0 mm |
| 1 x | Strip ABS 2.0x5.0x1000 mm |
| 1 x | Strip 1,5x1,5x330 mm |
| 1 x | Canopy Lock V1 M3 Blue (2 pcs) |
| 1 x | 67 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs) |
| 2 x | Brass hexagonal rod Ø 3 mm x 1000 mm |
| 1 x | Canopy Latch |
| 1 x | PCARD Wireless System |
| 1 x | Brass rod Ø 0.5 mm x 1000 mm |
| 1 x | Flap hinge (6 pcs) |
| 1 x | Balsa panel 2.5x100x1000 mm |
| 1 x | Balsa panel 10x100x1000 mm |
| 1 x | BALSA triangular 15x15x1000 mm |
| 1 x | 45 mm black plastic spinner for fixed propeller |
| 1 x | Buy Perforated film 145 cm / 50 m |
| 1 x | Foam plastic plates (310x210x3 mm) |
| 1 x | TP/TopFuel - XH 2/3S Adapter |
| 1 x | ABS 500 x 400 x 1 mm (white) |
| 1 x | White smoke bombs AX-60 (5 pcs) |
| 1 x | Pin type hinge Al 3,0x50 mm demount (2 pcs) |
| 1 x | Blue smoke canister 140 g |
| 1 x | BALSA trip 5.0x5.0x1000 mm |
| 1 x | Xplorer4 anemometro |
| 1 x | Electric rocket starters (6 pcs) |
| 1 x | BALSA triangular 6x6x1000 mm |
| 1 x | Extension silicon 10 cm (Graupner) |
| 1 x | 140 mm rods set for direction control |
| 1 x | Futaba Female 40 cm extension |
| 1 x | Straightened rod Ø 2.0 mm x 1000 mm |
| 1 x | BALSA triangular 10x10x1000 mm |
| 1 x | Strip 2,0x2,0x330 mm |
| 1 x | Brass rod Ø 1.0 mm x 1000 mm |
| 1 x | White smoke bombs AX-18 (5 pcs) |
| 1 x | Straightened rod Ø 1.5 mm x 1500 mm |
| 1 x | Green smoke canister 65 g |
| 1 x | Beech dowels 10 mm x 1000 mm |
| 1 x | Extension silicon 10 cm (Futaba) |
| 1 x | Balsa panel 5.0x100x1000 mm |
| 1 x | 67 mm cylidric hinge Ø 5 mm (4 pcs) |
| 1 x | Green smoke canister 100 g |
| 1 x | Bungee HLG Premium |
| 1 x | BALSA trip 4.0x4.0x1000 mm |
| 1 x | Contest-S-Pult-Carbon mc-20/mc-24 |
| 1 x | 50 mm black plastic spinner for fixed propeller |
| 1 x | Carbon fibre tape 125 g/m², 3k, UD (25 mm) roll/ 10 m |
| 1 x | Pasacables rectangular 40x15 mm (4 pcs) |
| 1 x | Sun Cover PC 21 XXL (JMB Jets) |
| 1 x | Brass rod Ø 1.5 mm x 1000 mm |
| 1 x | Conector JAPAN G2 Set 5 pares |
| 1 x | Smoke set "M" |
| 1 x | Extension silicon 30 cm male (Futaba) |
| 1 x | Nylon hinge 20x15x0,3 (10 pcs) |
| 1 x | Fibreglass-Spinner BS ∅155 x 200 mm |
| 1 x | BALSA trip 8.0x8.0x1000 mm |
| 1 x | Parachutist |
| 1 x | AIREX® Sheets C 70.55 (YELLOW) 1200x550x1.2 mm (5 pcs) |
| 1 x | 36 mm red plastic spinner for fixed propeller |
| 1 x | Copper lacquer wire Ø0,2 mm (5 m) |
| 1 x | Carbon fiber rod 0.5 mmx1000 mm |
| 1 x | Carbon fabric 68 g/m² (style 493 aero, plain weave) 100 cm |
| 1 x | Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 50 m |
| 1 x | PPM Encoder Module |
| 1 x | Green smoke canister 140 g |
| 1 x | 11 mm Rubber pads (14 pcs) |
| 1 x | Cable grommet Ø 6.4 mm (4 uds) |
| 1 x | Extension PVC 150 cm (Graupner) |
| 1 x | 100 mm rods set for direction control |
| 1 x | BALSA trip 2.0x2.0x1000 mm |
| 1 x | TrainerCord (master-learner) |
| 1 x | Canopy hinges for Discus 2c, Discus 2a, Ventus 2cx (2pcs) |
| 1 x | Carbon fibre tape 200 g/m² (unidirectional) 50 mm |
| 1 x | Balsa panel 8.0x100x1000 mm |
| 1 x | Carbon fabric 245 g/m² (twill weave) 127 cm, roll/ 10 m |
| 1 x | Conector JR Servo female (10 pcs) |
| 1 x | Tow hook for tug |
| 1 x | Kwik link AL M3 L:40 mm (2 pcs) + Pin Ø 2,5 mm |
| 1 x | LA500 nose |
| 1 x | LA500 pre-rotation gear |
| 1 x | Motor A10-7 L 4,4:1 |
| 1 x | Axle for motor A20-S (3 uds) |
| 1 x | Brass ball links BS M3 V1 (10 pcs) |
| 1 x | Screws M1,6x6 Allen |
| 1 x | Bearing 3x6x2,5 |
| 1 x | Tail boom |
| 1 x | Red aluminium servo arm V1-Futaba 1,5" inch M3 |
| 1 x | Aluminium red ball links M3 V1 (10 pcs) |
| 1 x | Aluminium cap bolt washer M3 green (8 pcs) |
| 1 x | Pilot LA 500 |
| 1 x | LA500 tail empennage |
| 1 x | Motor A50-14 L 8-Polos Electric turbine |
| 1 x | Motor B20-10 L + 4:1 gearbox |
| 1 x | Axi for motor A40-L Motor 8-Pole-Electric Turbine |
| 1 x | Motor B40 10L + MAXON 4,4:1 Keramik |
| 1 x | Motor A50-10L Turnado V3 Glider |
| 1 x | Motor A20-26 M EVO |
| 1 x | Motor A200-8 |
| 1 x | Motor A30-12 XL Glider |
| 1 x | Motor A20-20 L EVO |
| 1 x | Shaft for A60-L V4 |
| 1 x | Backmountset complete A40 |
| 1 x | Motor A30-10 XL V4 |
| 1 x | Motor A50-14L Turnado V3 Glider |
| 1 x | Shaft for A60-20/22/24S (120 mm) |
| 1 x | Motor A60-5XS V4 28-pole kv420 |
| 1 x | Motor A40-10S V4 14-Pole |
| 1 x | Shaft for A60-XS-V2 (112,5mm) |
| 1 x | Motor A50-12 L V4 |
| 1 x | Motor A50-16 S V4 |
| 1 x | Axle for motor A30-XL V2 |
| 1 x | Motor A30-14 M V2 6 Poles |
| 1 x | Shaft for A60-L (140mm) |
| 1 x | Motor B20-18 L + 4:1 gearbox |
| 1 x | Motor A20-22 L EVO |
| 1 x | Motor B40-10 L |
 |
| 7,440.63EUR |
