| 1 x | Tester LiPo/LiIon/LiMn/LiFe |
| 1 x | TP/TopFuel - XH 2/3S Adapter |
| 1 x | CC 03 |
| 1 x | ABS angle 3,0x3,0x1000 mm |
| 1 x | Streamline Stainless Steel Tubing 9.0x5.0x1000 mm |
| 1 x | JETImodel SINGLE BEC |
| 1 x | CM-3 |
| 1 x | Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH |
| 1 x | ABS angle 4,0x4,0x1000 mm |
| 1 x | 30 cm BEC cable (female) |
| 1 x | USB HLS prog. interface |
| 1 x | L-Connector 1.0 mm x 1000 mm |
| 1 x | "Y" charging 4mm wire (2 IN-1 OUT). |
| 1 x | U Profile ABS 8,0x4,0x1000 mm |
| 1 x | Streamline Stainless Steel Tubing 14.5x9.6x1000 mm |
| 1 x | Streamline Stainless Steel Tubing 7.5x4.5x1000 mm |
| 1 x | Profile ABS half cane 2.5x1000 mm |
| 1 x | Profile ABS half cane 2.0x1000 mm |
| 1 x | Cabel charger transmitter GRAUPNER |
| 1 x | Futaba External voltage input cable Futaba CA-RVIN-700 |
| 1 x | L-Connector 4.0 mm x 1000 mm |
| 1 x | CC 05 |
| 2 x | ABS "T" angle 6.0x6.0x1000 mm |
| 1 x | 5 LiPo XH>EH adapter |
| 1 x | TP/TopFuel - JST-EH 4/5S Adapter |
| 1 x | Adapter lead MPX/XT60 |
| 2 x | ABS angle 5,0x5,0x1000 mm |
| 1 x | CC 02 |
| 2 x | ABS angle 6,0x6,0x1000 mm |
| 1 x | Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm) |
| 1 x | Aluminum Bayonet / strongal D12 mm / 0.5 m |
| 1 x | 4 LiPo XH>EH adapter |
| 1 x | Wing-connector: Glass / Carbon tube (13.7/12.5) x 1000 mm |
| 1 x | Adapter lead MPX/EC3 |
| 1 x | Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH |
| 1 x | Streamline Stainless Steel Tubing 12.3x7.7x1000 mm |
| 1 x | 2 LiPo XH>EH adapter |
| 1 x | ABS "T" angle 4.0x4.0x1000 mm |
| 1 x | Streamline Stainless Steel Tubing 17.8x12.4x1000 mm |
| 1 x | Dean "T" - Futaba Adapter |
| 1 x | Aluminum Bayonet / strongal D25 mm / 1 m |
| 1 x | Profile ABS Square 2 x 1000 mm |
| 1 x | Streamline Stainless Steel Tubing 15.5x8.5x1000 mm |
| 1 x | TrainerCord (master-learner) |
| 1 x | L-Connector 1.5 mm x 1000 mm |
| 1 x | Hard aluminium thin-walled tube with fibreglass case ø30x1mm, 1m |
| 1 x | Bec MR UBEC 5A (5v/6v/7v) |
| 2 x | U Profile ABS 1,0x2,0x1000 mm |
| 2 x | Flat Connector 4.0 mm x 1000 mm |
| 2 x | Profile ABS half cane 3x1000 mm |
| 1 x | silicon 100 cm Futaba Extension Ø 0,35 mm |
| 1 x | Premium servo extension 25cm |
| 1 x | Cable S.BUS 3 salidas 300 mm |
| 2 x | Extension PVC 150 cm (Graupner) |
| 1 x | Futaba male 40 cm extension |
| 2 x | Futaba Female 40 cm extension |
| 1 x | Extension 30 cm (Futaba) |
| 2 x | Extension silicon 100 cm (Futaba) |
| 2 x | 200 mm extensión servo HITEC/JR |
| 1 x | Cable silicona female batt. receptor 30 cm (Futaba) |
| 1 x | Extension S-Bus 1-2 silicon 120 cm FUTABA |
| 1 x | Premium servo extension 75cm |
| 2 x | Extension 7.5 cm |
| 1 x | BALSA trip 6.0x6.0x1000 mm |
| 1 x | Pine wood slat 3.0x10.0x1000 mm |
| 1 x | BALSA trip 10x10x1000 mm |
| 1 x | Pine wood slat 2.0x10.0x1000 mm |
| 1 x | Beech dowels 4.0 x 1000 mm |
| 1 x | OBECHI sheet 2.0x3.0x1000 mm |
| 1 x | Pine wood slat 10x10x1000 mm |
| 1 x | Pine wood slat 5.0x5.0x1000 mm |
| 1 x | Mahogany wood slat 3.0x3.0x1000 mm |
| 1 x | BALSA trip 3.0x3.0x1000 mm |
| 1 x | Walnut wood slat 1.5x1.5x1000 mm |
| 1 x | BALSA leading edge 8x10x1000 mm |
| 1 x | Mahogany wood slat 1.5x1.5x1000 mm |
| 1 x | BALSA triangular 15x15x1000 mm |
| 1 x | Brass rod Ø 0.5 mm x 1000 mm |
| 1 x | Brass rod Ø 1.0 mm x 1000 mm |
| 1 x | Straightened rod Ø 2.0 mm x 1000 mm |
| 1 x | Straightened rod Ø 4.5 mm x 1000 mm |
| 1 x | Straightened rod Ø 1.5 mm x 1500 mm |
| 1 x | Straightened rod Ø 7.0 mm x 1000 mm |
| 1 x | Straightened rod Ø 1.2 mm x 1500 mm |
| 1 x | Straightened rod Ø 5.0 mm x 1000 mm |
| 1 x | Piloto WWII USAAF 12" Scale 1/6 - 1/5 |
| 1 x | Propeller balancer |
| 1 x | Battery Protection Circuit Board 22.2v 6s |
| 1 x | Green silicone 0,25 qmm wire (50 m) |
| 1 x | Fresa corte diamante Ø 2.3mm (bola) |
| 1 x | Cable servo PREMIUM MAXI 10m (blanco/rojo/azul) PVC |
| 1 x | Extra Hard Titanium Herxagon Screwdrivers |
| 1 x | SE Ring 200 mm (2 pcs) |
| 1 x | Sanyo RX Battery Eneloop 6,0 V JR |
| 2 x | Profile ABS half cane 7.0x1000 mm |
| 1 x | Multi-adapter balancer JST/C - TP |
| 1 x | Opto Gas Engine Kill Switch |
| 1 x | Sun Cover ULTIMATUM 2.0 (Hispano Aviacion) |
| 1 x | SPS 70V 140/280 A |
| 1 x | Wing-connector: Glass / Carbon tube (26.5/25 x 25/23) x 1000 mm |
| 1 x | SBEC Jeti |
| 1 x | PSC 5 |
| 1 x | 120x60 mm SLH KOVO wheel |
| 1 x | Switc electronic 30 Amp |
| 1 x | Extension silicon 50 cm (Graupner) |
| 1 x | Extension silicon 75 cm (Graupner) |
| 1 x | Profile ABS half cane 8.0x1000 mm |
| 1 x | Extension 90 cm (Futaba) |
| 2 x | Extension silicon 30 cm male (Graupner) |
| 1 x | Extension silicon 75 cm (Futaba) |
| 1 x | ABS "T" angle 8.0x8.0x1000 mm |
| 1 x | Cable silicona macho batt. receptor 30 cm (Futaba) |
| 1 x | Futaba Female 40 cm extension |
| 1 x | Extension 100 cm (Futaba) |
| 1 x | Extension silicon 35 cm (Futaba) |
| 1 x | Extension silicon 25 cm (Graupner) |
| 1 x | Profile ABS half cane 5.0x1000 mm |
| 1 x | Profile ABS triangular 6.0x1000 mm 90º |
| 1 x | Profile ABS triangular 4.0x1000 mm 90º |
| 1 x | Extension 15 cm (Futaba) |
| 1 x | Cabel "Y" 30 cm (Futaba) |
| 1 x | Linden wood slat 2.0x2.0x1000 mm |
| 1 x | BALSA trip 2.0x2.0x1000 mm |
| 1 x | Beech dowels 10 mm x 1000 mm |
| 1 x | Balanceradapter JST-XH (Heli 47G) 2-6 c. |
| 1 x | Opto Gas Engine Kill Switch |
| 1 x | Beech dowels 2.0 x 1000 mm |
| 1 x | BALSA triangular 8x8x1000 mm |
| 1 x | A/C quality beech plywood 600x300x6.0 mm |
| 1 x | A/C quality beech plywood 600x300x5.0 mm |
| 1 x | Balsa panel 5.0x100x1000 mm |
| 1 x | Balsa panel 1.0x100x1000 mm |
| 1 x | Balsa panel 6.0x100x1000 mm |
| 1 x | Birch plywood plate 600x300x1.5 mm |
| 1 x | A/C quality beech plywood 600x300x6.0 mm |
| 1 x | Streamline Stainless Steel Tubing 10.5x5.7x1000 m |
| 1 x | A/C economy plywood 600x300x6+.0 mm |
| 1 x | APM2.6 Power module with 5.3V DC BEC |
| 1 x | ABS angle 10,0x10,0x1000 mm |
| 1 x | A/C quality beech plywood BIRCH 600x300x1.0 mm |
| 1 x | ABS "T" angle 10.0x10.0x1000 mm |
 |
| 1,955.92EUR |
