| 2 x | Cylidric hinge 43 mm Ø 2,5 mm (5 pcs) |
| 1 x | Threaded coupler ALU M3 Ø 4 (2 uds) |
| 1 x | Cable servo PREMIUM 1 m (blanco/rojo/negro) AWG21 + AWG26 TPE |
| 1 x | BALSA triangular 10x10x1000 mm |
| 1 x | Xplorer1 anemometro |
| 1 x | Black silicone 0,25 mm² wire (25 m) |
| 1 x | Trailing edge BALSA 35x8x1000 mm |
| 1 x | ABS tube 7.0x6.0x1000 mm |
| 1 x | 76 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs) |
| 1 x | 1/12 Pilot "Cougar" |
| 1 x | Screw-lock pushrod conn snap Ø 1.5 mm (2 uds) |
| 1 x | Profile ABS Square 1 x 1000 mm |
| 1 x | Crimping sleeves for cable 1.3 mm (10 pcs) |
| 1 x | Carbon fabric 200 g/m² (Aero, plain weave) 100 cm x 3m |
| 1 x | Screw-lock connector Ø 2 mm (2 uds) |
| 1 x | Horn 5/10 with M2 Bearing |
| 1 x | Carbon Non-Woven, 160 g/m² 100 cm 5m |
| 2 x | Linden wood slat 3.0x3.0x1000 mm |
| 1 x | |
| 1 x | Glass fabric tape 49 g/m² (Interglas 02037, finish FE 600/800, p |
| 1 x | Vacuum bag, 1200 mm x 50 m |
| 1 x | Steel tube (L 1000 mm Ø7 mm, Ø6,7 mm) |
| 1 x | Walnut wood slat 3.0x3.0x1000 mm |
| 1 x | PVC 0,14 qmm servos wire Graupner (100 m) |
| 1 x | ABS tube 20.0x18.0x1000 mm |
| 1 x | 1/12 Pilot "Langley" |
| 1 x | Civilian pilot "Pamela" size 9cm (Slimline) |
| 1 x | Carbon Non-Woven, 160 g/m² 100 cm 10 m |
| 1 x | Flap hinge (6 pcs) |
| 1 x | Profile ABS Square 2 x 1000 mm |
| 1 x | Civilian pilot "Gramps" size 9cm (Slimline) |
| 1 x | RH long aluminium horn (2pcs) |
| 1 x | Cooler motor type 400 |
| 1 x | Cooler motor type 300 |
| 1 x | Pin type hinge Al 3,0x50 mm (2 pcs) |
| 1 x | ABS angle 2,0x2,0x1000 mm |
| 1 x | Crimping sleeves for cable 0.70 mm (10 pcs) |
| 1 x | Threaded coupler ALU M3 Ø 6 (2 uds) |
| 1 x | AIREX® Sheets C 70.55 (YELLOW) 1200x550x2.0 mm (20 pcs) |
| 1 x | ABS tube 8.0x6.0x1000 mm |
| 1 x | Thinwall Stainless Steel Tubing 28x0.6x1000 mm |
| 1 x | Round Rod 2,0x1000 mm |
| 1 x | Profile ABS Square 3 x 1000 mm |
| 1 x | Fast'n EZ-CA-Hinge, lite (12 uds) |
| 1 x | LH long black aluminium horn L31xH30 (2pcs) |
| 1 x | Round Rod 6,0x1000 mm |
| 1 x | Carbon Fabric Prepreg 200 g/m² (twill 2/2) 100 cm, roll/ 1 m |
| 1 x | Nylon hinge for flaps/gates 27x10,5 (2 pcs) |
| 1 x | PVC 0,14 qmm servos wire Hitec/Mpx (5 m) |
| 1 x | Indoor Brushed motor kit |
| 1 x | Silicone 0,14 qmm servos wire Graupner (100 m) |
| 1 x | Mahogany wood slat 2.0x2.0x1000 mm |
| 1 x | 50m servo "Premium" wire (white/red/blue) |
| 1 x | Locking cable tie 4.6x203 (uds) |
| 1 x | Steering arm 12 mm Ø 4 mm (2 uds) |
| 1 x | Round Rod 5,0x1000 mm |
| 1 x | Locking cable tie 3.2x142 (uds) |
| 1 x | Carbon fabric 160 g/m² (twill weave) 127 cm, roll/ 10 m |
| 1 x | ABS I Strip 10x5x1000 mm |
| 1 x | 1/6 Pilot "Garry" |
| 1 x | ABS Strip 1.5x6.0x1000 mm |
| 1 x | ABS tube 12.0x10.0x1000 mm |
| 1 x | ABS tube 4.0x3.0x1000 mm |
| 1 x | ABS angle 10,0x10,0x1000 mm |
| 1 x | L-Connector 1.0 mm x 1000 mm |
| 1 x | ABS angle 1.5x1.5x1000 mm |
| 1 x | Brass control horn M3 short for wire (2 pcs) |
| 1 x | Vertical cockpit anchor "tipe F3A" (2 pcs) |
| 1 x | Strip 2,5x1,25x330 mm |
| 1 x | SUS wire 3m (nylon coated) |
| 1 x | Civilian pilot "Curt" size 9cm (Slimline) |
| 1 x | Gates hinge |
| 1 x | Carbon tube (L 1000 mm, Ø1.5 mm, Ø0.7 mm) |
| 1 x | 1/6 Pilot "Buddy" |
| 1 x | White silicone 0,25 qmm wire (100 m) |
| 1 x | Threaded coupler ALU Left M3 Ø 4 (2 uds) |
| 1 x | 67 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs) |
| 1 x | Aluminium tube (L 1000 mm, Ø4.0 mm, Ø3.1 mm) |
| 1 x | Threaded coupler ALU M2,5 Ø 6 (2 uds) |
| 1 x | ABS tube 16.0x14.0x1000 mm |
| 1 x | Linden wood slat 2.0x2.0x1000 mm |
| 1 x | SERVO DES 588 BB MG |
| 1 x | Extension 30 cm (Futaba) |
| 1 x | Extension silicon 30 cm female (Futaba) |
| 1 x | XH male balance (4S) connector (2 pcs) |
| 1 x | Hot Glue Stick BLACK |
| 1 x | Connectors banna oro 0,8 mm (M/F) |
| 1 x | 2 mm male connector (2 pcs) with safety connector |
| 1 x | Prolongador S-Bus JR/JR 20cm |
| 1 x | Futaba male 40 cm extension |
| 1 x | MPX Sub-D Adaptor |
| 1 x | |
| 1 x | Nitroverdu 500 ml |
| 1 x | XH female balance (4S) connector (2 pcs) |
| 1 x | Cabel "Y" 15 cm |
| 1 x | Premium servo extension 75cm |
| 1 x | 11 mm Rubber pads (14 pcs) |
| 1 x | Propeller diller for DLE30/DLE35RA/DLE40/DLE55/DLE61/EME 55/DA-5 |
| 1 x | Propeller diller for DLE170 |
| 1 x | Aluminium ignition bad (red) |
| 1 x | aluminium servo arm V2-JR 2,0 inch M3 |
| 1 x | Cap Hispano Aviación |
| 1 x | Aluminium cap bolt washer M3 red (8 pcs) |
| 1 x | Walbro carburetor for MVVS 26/30/35/40 cc |
| 1 x | Suction funnel for carburetor WALBRO 20-80cc (red) |
| 1 x | 45 mm gas motor standoff |
| 1 x | 6 mm Quick clamp_S (10 pcs) |
| 1 x | DA 85 / DA 100 / DA 100 L carburetor |
| 1 x | 5 mm gas motor standoff |
| 1 x | Aluminium blue ball links M3 V1 (10 pcs) |
| 1 x | Adapters for 7.5 - 35cc aircraft and naval engines |
| 1 x | Antenna Hole Cap V1 (Silver) |
| 1 x | 10 mm floating pad (72 pcs) |
| 1 x | 15 mm floating pad (30 pcs) |
| 1 x | Aluminium cap bolt washer M4 blue (8 pcs) |
| 1 x | Adapter 5,0 mm M8 |
| 1 x | 2,3 mm Prop Drive Günther M4 |
| 1 x | 3 mm Long Prop Adapter M5 |
| 1 x | Adapter 5,0 mm M6 for spinner 40 mm fixed propeller |
| 1 x | Spare Part Frame Set for EACHINE RACER 250 |
| 1 x | Profile ABS triangular 2.0x1000 mm 90º |
| 1 x | Cable set PREMIUM, SUB-Done 4three fuselage/wing 160 cm |
| 1 x | Protective Cover for wires Ø 15 mm 1000 mm |
| 1 x | Protective open Cover for wires Ø 13 mm 1000 mm |
 |
| 3,115.59EUR |
