| 2 x | Miniature brass strap hinge, 1 m |
| 1 x | Vasa model Catapult |
| 1 x | Nylon hinge 15x0,3 (10 pcs) |
| 2 x | Canopy hinges for Discus 2c, Discus 2a, Ventus 2cx (2pcs) |
| 1 x | 76 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs) |
| 1 x | Large flex hinge (12 uds) |
| 1 x | Pin type hinge Al 4,5x70 mm (2 pcs) |
| 1 x | Gates hinge black 30x16 mm (2 pcs) |
| 2 x | Nylon hinge for flaps 33x9 (2 pcs) |
| 2 x | Cylidric hinge 43 mm Ø 2,5 mm (5 pcs) |
| 1 x | Long pinned hinge (12 uds) |
| 1 x | Nylon hinge 20x15x0,3 (10 pcs) |
| 1 x | 48 x 10 mm cylidric hinge Ø 3,0 mm (10 pcs) |
| 1 x | Cylidric hinge 33 mm Ø 2 mm (5 pcs) |
| 1 x | Bungee HLG Premium |
| 1 x | Pin type hinge Al 3,0x50 mm demount (2 pcs) |
| 1 x | 15 mm reinforced hinge |
| 1 x | Fast'n EZ-CA-Hinge, lite (12 uds) |
| 1 x | 67 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs) |
| 1 x | Pin type hinge Al 4,5x70 mm demount (2 pcs) |
| 2 x | Pin type hinge Al 3,0x50 mm (2 pcs) |
| 1 x | 67 mm cylidric hinge Ø 4,5 mm (5 pcs) |
| 1 x | Flap hinge 33x9 mm (6 pcs) |
| 1 x | Unmounted aluminium pin 6x98 mm (2 pcs) |
| 1 x | Nylon hinge 20x20x0,3 (10 pcs) |
| 1 x | Xplorer1 anemometro |
| 1 x | Xplorer2 anemometro |
| 1 x | Xplorer3 anemometro |
| 1 x | Cierre cabina aluminio Ø5, I=16 mm |
| 1 x | Cable tie mounts 4.3 (4 uds) |
| 2 x | 45 mm rods set for direction control |
| 1 x | Cap closure 33/23.5mm (2 uds) |
| 1 x | Allen wheel collar M3x5 |
| 1 x | Clip fixing for wing (2 pcs) |
| 1 x | Cable grommet Ø 3.2 mm (4 uds) |
| 1 x | Aluminun wheel collar 3 mm Ø (4 uds) |
| 1 x | 41x5,5 mm wires output (2 pcs) |
| 1 x | 11 mm Rubber pads (14 pcs) |
| 1 x | Allen wheel collar M4x4 |
| 2 x | Aluminium alloy coupler for carbon tube 6/M4 |
| 1 x | Pilot "Goose" (Slimline) |
| 1 x | 200 mm extensión servo HITEC/JR |
| 1 x | Connectors banna oro 4 mm (M/F) (ultralight) |
| 1 x | Long pinned hinge (6 uds) |
| 1 x | Gates hinge aluminium (1 pcs) |
| 1 x | Small flex hinge (12 uds) |
| 1 x | Robart Door Hinge (Pk2) |
| 1 x | Pin type hinge Al 4,5x70 mm to wire (2 pcs) |
| 1 x | Wheel collar 3.5 mm Ø (4 uds) |
| 1 x | 43 x 10 mm cylidric hinge Ø 2,5 mm (10 pcs) |
| 1 x | Nylon hinge for flaps/gates 27x10,5 (2 pcs) |
| 1 x | Screw-lock connector Ø 2 mm (2 uds) |
| 1 x | Wing bolts M3 Steel screw blue (2 pcs) |
| 1 x | Cockpit aluminium closing |
| 1 x | Landing gear frontal support 25x32x16 |
| 1 x | Steering arm 12 mm Ø 4 mm (2 uds) |
| 1 x | Allen wheel collar M3x3 |
| 1 x | Stainless steel cable Ø 0.88 mm - 60 kp (10 m) |
| 1 x | Steering arm 16 mm Ø 3 mm |
| 1 x | Landing gear frontal support 29x26x13,5 |
| 1 x | Crimping sleeves for cable 0.85 mm (10 pcs) |
| 1 x | Cierre cabina aluminio Ø4, I=10 mm |
| 1 x | Triple rod con. 2mm Pushrod (2 pcs) |
| 1 x | Snap pin for micro clevis (10 uds) |
| 1 x | 140 mm rods set for direction control |
| 1 x | L cockpit anchor "tipe F3A" (2 pcs) |
| 1 x | Cable grommet Ø 5 mm (4 uds) |
| 1 x | Canopy Latch |
| 1 x | Cabin latch Fox MDM1 4m (pair) |
| 1 x | SUS wire 3m (nylon coated) |
| 1 x | Snap short M2 (10 uds) |
| 1 x | Micro flex hinge (12 uds) |
| 1 x | 33 x 8 mm cylidric hinge Ø 2,5 mm (10 pcs) |
| 1 x | Cockpit latch closing I=10 mm |
| 1 x | Steering arm 16 mm Ø 4 mm (2 uds) |
| 1 x | Cockpit aluminium closing 5.4g |
| 1 x | Micro screw-lock pushrod conn snap Ø 1 mm (2 uds) |
| 1 x | Press fitting for 1,0 diam. steel cable (10 pcs) |
| 1 x | Lead with adhesive (2 pcs) |
| 1 x | Vertical cockpit anchor "tipe F3A" (2 pcs) |
| 1 x | Pin type hinge Al 6x98 mm (2 pcs) |
| 1 x | Steering arm 16 mm Ø 4 mm |
| 1 x | Small pinned hinge (12 uds) |
| 1 x | Canopy Lock V1 M3 Blue (2 pcs) |
| 1 x | 140 mm rods + T patellas set for direction control |
| 1 x | 100 mm rods + T patellas set for direction control |
| 1 x | Switch Cap M (blue) |
| 1 x | Interruptor FUTABA FX-MZ (2 Posic. corto) |
| 1 x | Switch Cap L (Blue) |
| 1 x | Switch Cap L (Red) |
| 1 x | Decorative caps, multicoloured, short |
| 1 x | Transmitter Balancer Futaba V |
| 1 x | Blue aluminium servo arm V3-Hitec 1,25inch M3 |
| 1 x | Gold aluminium servo arm V2-JR 1,25" inch M3 |
| 1 x | Blue aluminium servo arm V2-Hitec 1,0 inch M3 |
| 1 x | Servo GO-1023MG 7.0 kg.cm 0.09s/60º |
| 1 x | Red aluminium double servo arm FUTABA 40 mm M3 F3A |
| 1 x | Servo GO-1053 MG 20.0kg |
| 1 x | Gold aluminium double servo arm JR/Graupner 40 mm M3 F3A |
| 1 x | Blue aluminium servo arm V2-Hitec 1,5 inch M3 |
| 1 x | Savox Highvoltage Brushless Servo SB-2272MG (Tail rotor) |
| 1 x | Servo GO-1053MG 20 kg.cm 0.17s/60º |
| 1 x | Red aluminium servo arm V2-Futaba 1,5" inch M3 |
| 1 x | Servo GO-12S69MG 26kg.cm 0.10s/60º |
| 1 x | Gold aluminium servo arm V1-JR 1,25" inch M3 |
| 1 x | Servo GO-12S70MG 20.5kg.cm 0.06s/60º |
| 1 x | Birch plywood plate 600x300x4.0 mm |
| 1 x | Linden wood slat 3.0x3.0x1000 mm |
| 1 x | Birch plywood plate 600x300x2.5 mm |
| 1 x | Pine wood slat 6.0x6.0x1000 mm |
| 1 x | Linden wood slat 2.0x2.0x1000 mm |
| 1 x | Liston HAYA 10 x 10 x 1000 mm |
| 1 x | Beech dowels 4.0 x 1000 mm |
| 1 x | Pine wood slat 3.0x5.0x1000 mm |
| 1 x | Beech dowels 10 mm x 1000 mm |
| 1 x | Antena FUTABA 35 mhZ 3PM/3FRF/4V/4Y/6EX/6X/6Y/7C |
| 1 x | Three-function control switch by FUTABA |
| 1 x | Three-function control switch by FUTABA |
| 1 x | Switch Cap M (silver) |
| 1 x | Futaba S-Bus Rx/Gyro Link Lead |
| 1 x | Futaba Neckstrap |
| 1 x | Receiver bed (Blue) |
| 1 x | FPV Station for SE TX-Tray V1 |
| 1 x | Long adjustable control horn 3x34 |
| 1 x | Rudder forward 80x28 "type Kato" |
| 1 x | Small control horn with bearing (2 pcs) |
| 1 x | Battery FUTABA 18MZ |
| 1 x | Switch Cap L (black) |
| 1 x | Neck strap Double V2 |
| 1 x | BALSA trip 8.0x8.0x1000 mm |
| 1 x | 3,2 mm Prop Adapter M5 |
| 1 x | ABS tube 4.0x2.0x1000 mm |
| 1 x | ABS tube 9.0x7.0x1000 mm |
| 1 x | Red aluminium servo arm V1-Futaba 23 mm M2 |
| 1 x | Red aluminium servo arm V1-Futaba 17 mm M2 |
| 1 x | Servo GO-1070MG 40 kg.cm 0.10s/60º |
| 1 x | Brazo servo KAVAN doble aluminio 25T - 2.5" M3 |
 |
| 1,960.61EUR |
