| 1 x | SIMtransmitter 6 Mode 2 |
| 1 x | Interface Realflight Simulator |
| 1 x | RF9 Flight Simulator with Spektrum Controller |
| 1 x | Horn 16,5x20 mm (2 pcs) |
| 1 x | Threaded coupler ALU M2,5 Ø 3 (2 uds) |
| 1 x | LH long black aluminium horn L31xH30 (2pcs) |
| 1 x | Brass control horn M4 short for wire (4 pcs) |
| 1 x | Cable with accesories |
| 1 x | Horn 6/35 with M3 Bearing |
| 1 x | Threaded coupler ALU M3 Ø 4 (2 uds) |
| 1 x | Threaded coupler ALU M3 Ø 5 (2 uds) |
| 1 x | Horn 6/27 with M3 Bearing |
| 1 x | Brass control horn M4 short for wire (10pcs) |
| 1 x | 6 mm aluminium horn with patella |
| 2 x | Threaded coupler ALU M2 Ø 4 (2 uds) |
| 1 x | Brass control horn M2 short for wire (2 pcs) |
| 1 x | 6 mm red aluminium threaded horn with patella |
| 1 x | 6 mm blue aluminium threaded horn with patella |
| 1 x | Horn for flap control (1 pcs) |
| 1 x | Brass control horn M3 short for wire (2 pcs) |
| 2 x | SlowFlyer control horn (3 pcs) |
| 1 x | LH long aluminium horn L31xH30 (2pcs) |
| 1 x | Threaded coupler ALU M2,5 Ø 6 (2 uds) |
| 1 x | Gates hinge 30x16 mm (2 pcs) |
| 1 x | 15 mm reinforced hinge |
| 1 x | Large flex hinge (12 uds) |
| 1 x | Micro flex hinge (12 uds) |
| 1 x | Nylon hinge for flaps/gates 27x10,5 (2 pcs) |
| 1 x | Flap hinge (6 pcs) |
| 1 x | Gates hinge aluminium (1 pcs) |
| 1 x | Nylon hinge for flaps 33x9 (2 pcs) |
| 1 x | Cylidric hinge 33 mm Ø 2 mm (5 pcs) |
| 1 x | Pin type hinge Al 3,0x50 mm (2 pcs) |
| 2 x | Pin type hinge Al 4,5x70 mm to wire (2 pcs) |
| 1 x | 18 mm reinforced hinge |
| 2 x | Miniature brass strap hinge, 1 m |
| 1 x | Pin type hinge Al 3,0x50 mm demount (2 pcs) |
| 1 x | Fast'n EZ-CA-Hinge, lite (12 uds) |
| 1 x | Canopy hinges for Discus 2c, Discus 2a, Ventus 2cx (2pcs) |
| 1 x | Fast'n EZ-CA-Hinge (12 uds) |
| 1 x | 25 mm reinforced hinge |
| 2 x | Strip 3,5x1,75x330 mm |
| 1 x | Strip ABS 2.0x5.0x1000 mm |
| 2 x | ABS Strip 1.5x3.0x1000 mm |
| 1 x | Round Rod 2,0x1000 mm |
| 1 x | ABS Strip 1.5x6.0x1000 mm |
| 1 x | Round Rod 4,0x1000 mm |
| 1 x | Round Rod 2,5x1000 mm |
| 1 x | Vacuum sealing tape, 2.5 x 12 mm (up to 140 °C) 22 roll |
| 1 x | Carbon Non-Woven, 160 g/m² 100 cm 25 m |
| 1 x | AIREX® Sheets C 70.55 (YELLOW) 1200x550x2.0 mm (10 pcs) |
| 1 x | Carbon Non-Woven, 160 g/m² 127 cm 1 m |
| 1 x | AIREX® Sheets C 70.55 (YELLOW) 1200x550x4.0 mm (5 pcs) |
| 1 x | Vacuum sealing tape, 2.5 x 12 mm (up to 140 °C) 15 m |
| 1 x | Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 10 m |
| 1 x | Demoulding wedge red (40 x 20 mm) 5 pcs |
| 1 x | Carbon roving DowAksa / 24k / 1600 tex |
| 1 x | Carbon fabric 200 g/m² (Aero, plain weave) 100 cm x 5m |
| 1 x | Carbon Non-Woven, 160 g/m² 100 cm 5m |
| 1 x | Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 100 m |
| 1 x | ABS tube 6.0x4.0x1000 mm |
| 1 x | Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm) |
| 1 x | Glass fabric tape 130 g/m² (Silane, plain) 25 mm / 100M |
| 1 x | Carbon fibre tape 200 g/m² (unidirectional) 50 mm |
| 1 x | ARAMID honeycomb 1300x2600x2 mm |
| 1 x | Horn DUBRO 1/2A |
| 2 x | Micro control horn (2 pcs) |
| 1 x | Horn with ball 55x40 |
| 2 x | Horn 20x28,5 mm (2 pcs) |
| 1 x | Micro control horn T2 Ø 1 |
| 1 x | Extra long horn 60x30 |
| 1 x | Sanyo Eneloop AA 1,2 V battery 2000 mAh |
| 1 x | Gates hinge black 30x16 mm (2 pcs) |
| 1 x | Small pinned hinge (12 uds) |
| 1 x | 76 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs) |
| 1 x | Sanyo RX Battery Eneloop 6,0 V JR |
| 1 x | 48 mm cylidric hinge Ø 2,5 mm (5 pcs) |
| 1 x | Nylon hinge 15x0,3 (10 pcs) |
| 1 x | Nylon hinge 20x20x0,3 (10 pcs) |
| 1 x | Cylidric hinge 43 mm Ø 2,5 mm (5 pcs) |
| 1 x | Nylon hinge 20x15x0,3 (10 pcs) |
| 1 x | RX Battery Eneloop 6,0 V JR 2500 mAh |
| 1 x | 43 x 10 mm cylidric hinge Ø 2,5 mm (10 pcs) |
| 1 x | Pin type hinge Al 4,5x70 mm (2 pcs) |
| 1 x | Cooler motor type 150 |
| 1 x | Peel ply 64 g/m² (plain weave) 150 cm x 20m |
| 1 x | Film release agent PVA 25 ml |
| 1 x | Carbon Non-crimp ST 100 g/m² 50 cm x 10 m |
| 1 x | Glass fabric 80 g/m² (silane, twill) 100 cm x 10m |
| 1 x | Sandwich Carbon fibre Rohacell (800 x 280 x 3 mm) |
| 1 x | Battery RX JETI LiIon RB 6200 7.2v |
| 1 x | Indoor Brushed motor kit |
| 1 x | PowerBox MERCURY SR2 |
| 1 x | Nut M1,6 |
| 1 x | TMM 1210-3S heli |
| 1 x | Charging Extension 50cm for 2 Battery |
| 1 x | Servo Fork |
| 1 x | PowerBox Competition SR2 |
| 1 x | Motor wall |
| 1 x | Rotorshape Elevator |
| 1 x | Blade holder center |
| 1 x | Power Box GPS Sensor III |
| 1 x | Coversion set HIROBO EX/EAGLE elektro |
| 1 x | Mobile Terminal |
| 1 x | PowerBox iGyro SRS |
| 1 x | PowerBox PowerExpander SRS |
| 1 x | OLED-Display for PowerBox Mercury SRS |
| 1 x | PowerBox Battery 4000 |
| 1 x | Blades 330mm |
| 1 x | Shaft sleeve LAMA |
| 1 x | Rudder |
| 1 x | Head upper part |
| 1 x | 2 piece mounting frame |
| 1 x | Nut M2 |
| 1 x | PowerBox MAG Sensor |
| 1 x | Blade holder metal LAMA |
| 1 x | Head lower part |
| 1 x | Head spacer |
| 1 x | Threaded coupler ALU Left M3 Ø 4 (2 uds) |
| 1 x | PowerBox iGyro 3xtra |
| 1 x | Screw M3x16 |
| 1 x | Balls 4 mm |
| 1 x | Tail support (2 pcs) |
| 1 x | Batetia LiFe 3200 mAh 6.6v MPX PowerBox |
| 1 x | LA500 rotor head shaft |
| 1 x | Pilot LA 500 |
| 1 x | Strip ABS 2.0x3.0x1000 mm |
| 1 x | LA500 Blades |
| 1 x | Strip 2,5x1,25x330 mm |
| 1 x | LA500 nose |
| 1 x | Thixotropic agent TM 100, tin/ 415 g (approx. 5 l) |
| 1 x | Glass Bubbles (0.12g) 400 G (aproxx 3.3 l) |
| 1 x | 30 cm DEANS female connector |
| 1 x | XH female balance (3S) connector (2 pcs) |
| 1 x | Connectors banna oro 2 mm (M/F) (ultralight) |
| 1 x | UHU hart 35 g |
| 1 x | Quicklock washer 1 mm (10 pcs) |
| 1 x | LA500 cyclic central part |
| 1 x | ABS Strip 1.0x2.0x1000 mm |
| 1 x | Round Rod 5,0x1000 mm |
| 1 x | Motor rotor LA-500 |
| 1 x | LA500 housing-lower cyclic |
| 1 x | Round Rod 6,0x1000 mm |
| 1 x | Carbon plate 350x150x1.0 mm |
| 1 x | PET film Mylar® A 350, 50 cm, roll/ 2 m |
| 1 x | Foam plastic plates (310x210x3 mm) |
| 1 x | Carbon plate 550x350x2.5 mm ECOTECH |
| 1 x | Sandwich carbon + poplar 2mm + carbon 480x290 mm |
| 1 x | Thermoforming sheet 0.5mm (0.02in) DIN A4 |
| 1 x | Peel ply 93 g/m² (plain weave) 150 cm x 5m |
| 1 x | Breatex™ Non-woven absorber 150 g/m² Roll 20m |
| 1 x | Glass fabric 49 g/m² (1,27 x 20 m) |
| 1 x | Carbon plate 550x350x1.5 mm ECOTECH |
| 1 x | Fiberglass plate 620x540x1,0 mm |
| 1 x | Glass fibre sleeve Ø 20 mm X 10m |
| 1 x | Styrene plate 320x120x0.5 mm |
| 1 x | Fiberglass plate 620x540x0,2 mm |
| 1 x | Glass fabric 160 g/m² (Twill weave) 100 cm x 5m |
| 1 x | Sistema LDS - Ø12 mm servos Ø 5/25 spline 60º (KST) pitch 4 mm |
| 1 x | Adapter lead MPX/XT60 |
| 1 x | Cable servo PREMIUM MAXI 200m (blanco/rojo/azul) PVC |
| 1 x | Cable servo PREMIUM MAXI 50m (blanco/rojo/azul) PVC |
| 1 x | 6 mm M3 variable horn |
| 1 x | Short adjustable control horn 3x24 |
| 1 x | Set Threaded coupler ALU M2,5 Ø 4 (2 uds) |
| 1 x | Ciano KAVAN Medium 20g |
| 1 x | |
| 1 x | Ball Bearing Oil 25 ml |
 |
| 6,563.12EUR |
