Toni Clark

Stock

Prop hub screw DA85/100/120 & VM170/200/210	1.00EUR	Buy Now	temporarily out of stock
Prop shaft ZG 23SL and ZG 26SC	10.00EUR	Buy Now	under request
Prop washer for ZG45SL, ZG62/S/SL and ZG74B/ZG80B	11.00EUR	Buy Now	under request
Reduction gear 2.8:1 for ZG 38 inline version	329.99EUR	Buy Now	under request
Reed valve for DA 50-R	17.00EUR	Buy Now	temporarily out of stock
‎Reed valve for DA-60/70	16.00EUR	Buy Now	temporarily out of stock
Reed valve petal for DA 35/50R/100l carburator	5.50EUR	Buy Now	temporarily out of stock
Reed valve petal for DA 60 carburator	37.00EUR	Buy Now	temporarily out of stock
Reed valves with doubler, set for DA 85/100/120	2.00EUR	Buy Now	under request
Saito FG-36 motor support	60.60EUR	Buy Now	temporarily out of stock
Screw for mounting plate of DA100/120	1.00EUR	Buy Now	temporarily out of stock
Short reed valve petal for DA 100-R carburator	12.00EUR	Buy Now	few units
Silencer for ZG22, ZG23, ZG231SLH, G2D96-D	24.00EUR	Buy Now	under request
Silencer kit ZG 45/62	110.00EUR	Buy Now	under request
Silencer with rear exhaust DA-120	107.50EUR	Buy Now	temporarily out of stock
Silencer with rear exhaust MTW TDH 110	168.80EUR	Buy Now	under request
Silencer ZG62, new version	29.00EUR	Buy Now	under request
Simple take for fuel tank	2.00EUR	Buy Now	temporarily out of stock
Spark plug capZG 20/ZG 26EI with HT lead	33.95EUR	Buy Now	under request
Sparkplug cap red, with spring ZG26SC, ZG26SCM and ZG231SLH	4.00EUR	Buy Now	under request
Spring clamp for tube Ø50 mm	11.00EUR	Buy Now	temporarily out of stock
Spring Clip 16 mm teflon tube	1.75EUR	Buy Now	under request
Spring Clip 25 mm teflon tube	2.14EUR	Buy Now	temporarily out of stock
Spring Clip 28 mm teflon tube	2.15EUR	Buy Now	temporarily out of stock
Spring Clip Ø25 mm	1.48EUR	Buy Now	few units
Stainess steel exhaust flange for ZG20 / ZG22 / ZG23/ ZG26 / G23	5.00EUR	Buy Now	under request
Stainless Steel Bend D 12x0,4mm	9.00EUR	Buy Now	under request
Stainless Steel Bend D 15x0,4mm	11.00EUR	Buy Now	under request
Stainless Steel Bend D 18x0,5 mm	13.00EUR	Buy Now	under request
Stainless Steel Bend D 20x0,6mm	13.00EUR	Buy Now	under request
Stainless Steel Bend D 22x0,5mm	15.00EUR	Buy Now	under request
Stainless Steel Bend D 25x0,5mm	18.00EUR	Buy Now	under request
Stainless Steel Bend D 28x0,6mm	19.00EUR	Buy Now	under request
Stainless steel cable Ø 0.52 mm - 15 kp (10 m)	7.00EUR	Buy Now	temporarily out of stock
Stainless steel cable Ø 0.62 mm (10 m)	8.25EUR	Buy Now	temporarily out of stock
Stainless steel cable Ø 0.88 mm - 60 kp (10 m)	8.95EUR	Buy Now	temporarily out of stock
Stainless steel cable Ø 1.3 mm (10 m)	10.00EUR	Buy Now	temporarily out of stock
Stainless Steel Mini Pipe for Titan ZG 20 and ZG 23	119.00EUR	Buy Now	under request
Stainless Steel Muffler D.A. 35-70	91.00EUR	Buy Now	temporarily out of stock
Stainless Steel Muffler D.A. 50/100/120	122.00EUR	Buy Now	under request

Result Pages: [<< Prev] 1 2 3 4 5 ... [Next >>] Displaying 161 to 200 (of 240 products)

Quick Find

Shopping Cart

1 x	3 LiPo XH>EH adapter
1 x	CellPRO 4S Adaptader (GP/KO up to 4S)
2 x	Balance "Y" Wire 6S, 2x JST-XH / 1x JST-EH
1 x	5 LiPo XH>EH adapter
1 x	APM2.6 Power module with 5.3V DC BEC
1 x	4 LiPo XH>EH adapter
1 x	Cabel charger transmitter GRAUPNER
1 x	3 copper lacquer wire Ø0,2 mm (1 m)
1 x	Connector CAN 15
1 x	CC 05
1 x	DPS Switch JR/JR
1 x	Circlick securite
1 x	CM-3
1 x	Double conector with JR adapter and 200 mm extension
1 x	BEC 3A FOXY
1 x	UBEC 6A KAVAN
1 x	Dean "T" - Futaba Adapter
2 x	CC 03
1 x	CC 01
1 x	30 cm BEC cable (female)
1 x	CC 02
1 x	Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm)
1 x	Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm)
1 x	"Y" charging 4mm wire (2 IN-1 OUT).
1 x	2 LiPo XH>EH adapter
1 x	Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH
1 x	30 cm BEC cable (male)
1 x	Connector Sub-D 2+5 Male
1 x	Copper lacquer wire Ø0,2 mm (5 m)
2 x	20x1000 mm Ring Strap Back To Back
2 x	SE Ring 400 mm (2 pcs)
1 x	SE Ring 360 mm (2 pcs)
1 x	14x60 mm Mini rings Tie Wraps (4 pcs)
2 x	SE Ring 200 mm (2 pcs)
1 x	5 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
2 x	SE Ring 300 mm (2 pcs)
1 x	Pad Screw Mount M3, up to 3mm / 0.12″, (10 pcs)
2 x
3 x	13 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
2 x	Cable-Tie 1.66x71mm / 0.07x2.8″ (20 pcs)
2 x	RUDDOG Protection and Heat Shield Tape (2mx50mm)
1 x	Cinta Goldfix 1m
1 x	10 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
3 x	SE Ring 350 mm (2 pcs)
1 x	Big-Malibu XL Roof box with surfboard rack GREY
2 x	800TVL CMOS camera for FPV
1 x	Camera Sony 4140+673 CCD with Built-in 200mw TX + antenna
2 x	Strip ABS 2.0x8.0x1000 mm
1 x	Strip 1,5x1,5x330 mm
1 x	ABS Strip 1.5x6.0x1000 mm
1 x	ABS Strip 1.5x8.0x1000 mm
1 x	Strip 2,0x2,0x330 mm
1 x	Strip 2,5x1,25x330 mm
1 x	Round Rod 2,5x1000 mm
1 x	Round Rod 6,0x1000 mm
1 x	Round Rod 1,0x1000 mm
1 x	Strip ABS 2.0x3.0x1000 mm
1 x	ABS I Strip 10x5x1000 mm
1 x	Initior Transmitter FTX2 Wireless
1 x	Wing-connector: Glass / Carbon tube (26.5/25 x 25/23) x 1000 mm
1 x	Canopy Latch
1 x	3,0x60 mm allen screwdriver
1 x	Opto Gas Engine Kill Switch
1 x	Fully Threaded Steel Rod M2,5 (2 uds)
1 x	Waterproof adhesive tape, width 19mm, length 25m
1 x	20x200 mm battery rings
1 x	Support pumb/filter Xicoy X45
1 x	Support Filtro FESTO
1 x	Support FUEL DOT V3
1 x	Sun Cover PC 21 XXL (JMB Jets)
1 x	Soporte grifo FESTO (2 pcs)
1 x	13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x	SE Ring 330 mm (4 pcs)
1 x	Support conector MPX (6 pcs)
2 x	Support ECU Xicoy X-45
2 x	SE Ring HACKER 300 mm (2 pcs)
2 x	26 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
2 x	Foil for sticking flaps and ailerons
1 x	Servo KST X20 8.4-50 V8.0 45kg 8.4v Softstar
1 x	Servo KST BLS815 HV V2.0 Servo 20mm 70g 20Kg
1 x	Brazo servo aluminio KST 25T-5V2,3515,325,125,135,145X10,X12,A13
1 x	Servo KST X10 V2.0 ala 10mm 28g 10.8Kg
1 x	ALU servo arm 3 mm shaft
1 x	Servo KST X08 Plus 9g HV servo
1 x	DINO Glider ARC
1 x	Fournier RF-4D
1 x	X-RAY Micro QR (Rudder)
1 x	E-FUN BUG (ROI-Import)
1 x	Glider PIROL
1 x	1/4 Pilot "Mike"
1 x	Civilian pilot "Gramps" size 9cm (Slimline)
1 x	1/10 Pilot "Jimmy"
1 x	Pilot "Goose" (Slimline)
1 x	1/6 Pilot "Garry"
1 x	Civilian pilot "Joe" size 9cm (Slimline)
1 x	1/6 Pilot "Cindy"
1 x	Civilian pilot "Pamela" size 9cm (Slimline)
1 x	1/6 Pilot "Tony"
1 x	Piloto RC Civil 1/5- 1/6 Scale 12"
1 x	Piloto JET 1:3,5
1 x	Futaba Female 40 cm extension
1 x	Prolongador S-Bus JR/JR 10cm
1 x	Cable S.BUS 3 salidas 100 mm
1 x	Extension S-Bus 1-2 silicon 30 cm FUTABA
1 x	Premium servo extension 75cm
1 x	USB HLS prog. interface
1 x	Pin type hinge Al 3,0x50 mm demount (2 pcs)
1 x	Mini DART 2 F3K carbon light 1m Green
1 x	Chili Race F3K (aramid nose)
2 x	X-RAY Micro QR (Elevator)
1 x	BABY glider (Aero-naut)
1 x	1/12 Pilot "Cougar"
1 x	servo adapter lead, JST-SH socket - JR male Pin, for GR-12SH+HoT
1 x	Cabel "Y" 15 cm
1 x	0,14 mm PVC servo wire extension, ZH micro conector.
1 x	Extension S-Bus 1-2 silicon 120 cm FUTABA
1 x	Suncover 100cc Red
1 x	Piston ring for ZG 26SC/EI, ZG 26SCM ZG 26SLH and Zenoah G260RC/
1 x	Covered closure or fairings
1 x	Spikes Band (5 m)
1 x	Tape GFK 25 mm
1 x	SLICK 360-B 104" (2640 mm)
1 x	Angle support XT60 conector
1 x	PT 16x10 E Propeller
1 x	Soporte filtro FESTO (4 pcs)
1 x	Crimping sleeves for cable 1.3 mm (10 pcs)
1 x	EXTRA NG 74" white/red/blue (Skywing RC)

6,536.57EUR

Manufacturers

Bestsellers

Reviews

There are currently no product reviews

Languages

Currencies

Specials

USB Interface REVOLECTRIX for CellPRO 10s
~~20.86EUR~~
9.90EUR

Insurance