36.16EUR

Epoxy Casting Resin + Hardener "water-clear" (300 min)
[R1071023]


Epoxy Casting Resin + Hardener "water-clear" (300 min)

General information about the System Epoxy Casting Resin + Hardener "water-clear):
Two-component clear, colourless epoxy system.
The following properties distinguish it from the predecessor EP cast resin “crystal clear”:
Excellent UV resistance for epoxy resins*)
Supertransparent constituents
Polishable, hard surface
Excellent impact strength
Completely tackfree curing even in thin coats
Ideal for transparent coatings
Also suitable as a laminating resin system with a very long pot life
The system's reactivity was raised for smaller initial and casting quantities. An initial batch size of 400 g can be cast per mould without the surface collapsing. Casting thicknesses up to 40 mm are possible with larger initial quantities.

Like all reactive resin systems the casting quantity is limited by the generated reaction heat (exothermal reaction): often a lower curing temperature (e.g. at an ambient night temperature lower than 20 °C) can counteract too great an exothermal reaction.

Pot life : approx. 300 minutes

Mixing ratio:
100 : 37 parts by weight of resin to hardener
100 : 47 parts by volume of resin to hardener

Curing time: approx. 24–48 h

Processing:
Resin and hardener are homogenised for about two minutes at room temperature (23 °C). Afterwards the mixture is left to rest for approx. 20 minutes.
Leave the ready mixture on a flat surface for 48 hours. Please do not mix or otherwise move the product. The total curing time ranges from 24 to 48 hours.
Expertise for the resin system casting resin + hardener "water-clear": this system is not cytotoxic (cell damaging), important for applications in medical purposes!
*) This system has very good UV resistance for EP resins, but, like all epoxy resins, it can turn more or less yellow over time under high UV exposure. Therefore only conditionally suitable for outdoor applications or permanent exposure to artificial light sources.
Typical areas of application: Indoor: railway models, works of art, stage decorations, etc. (only occasionally exposed to UV sources).


temporarily out of stock
temporarily out of stock

Reviews
Categories
* OFFER MONTH *
Planes->
Sailplanes->
Autogyros->
Helicopters->
UAVs - RPAs->
Multicopters->
Hardware->
  
  3D IMPRESION
  ABS Rods-Strips
  ABS/GFK/CFK plate
  Actuator
  Adapters->
  Adhesives/Resin/Epoxy->
    Cianocrylate->
    Epoxy->
      EMC-Vega
      KAVAN
      Loctite
      Resoltech
      Epoxy BSI
      Epoxy R-G
    Resin/Gelcoat
    Glass Bubbles
    Contact adhesive
  Altimeters->
  Amperimeters
  Anemometer
  Auto-Pilot
  Bags/Covers
  Batteries->
  BEC/Cables/Conectors/Interruptor
  Bungee Launchers
  Cables
  Cameras->
  Carbon rod
  Carbon/Brass/Steel/ABS/Aluminium
  Catalogues
  Chargers->
  Clevis
  Combustible->
  Connectors
  Control horns
  Controlers->
  Coverings/Thermoretrac
  Decals
  Extension
  Extinguisher
  Ferritas
  Glasses
  Hardware
  Hinges
  Instruments / Panels
  Lights/Ilumination->
  Linkages
  Merchandising
  Motor
  Pilots
  Pinion extractor
  Power supply system/Data Recordi->
  Profiles
  Propelers->
  Screws
  Servos->
  Simulators
  Smoke/Rocketry/Fireworks
  Spinners->
  Spray/Painting/Dope/Solder Paste
  Steel/brass Rod/Aluminium
  Support/CG/Incidenc.
  Tapes/Closed/Bridles
  Tools
  Towing
  Transmitters/Receivers->
  Undercarriage->
  Wheels & Axles->
  Wing Joiner
  Wood
Car/Trucks->
Motors & Turbines->
Gas. Motor Paramotors
Acces. for Motors->
Paragliders/Parachutes/Windsock
Boats/Naval units->
FPV->
Robots->
CNC cut
Roof BOX
Crash kits
Outlet Zone->
Used
Merchandising HA
We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Blue metalic ball link M3/3 azul (2 pcs)
1 x M2,5 5Diam black ball link V2 (2 pcs)
1 x Ball link M3 (6 uds)
1 x M2,5 5Diam metal ball link V3 (2 pcs)
1 x Joint with bearing M3 22x5,5
1 x Ball link M3 (10 pcs)
1 x M2/M1/6 3Diam short black ball link V1 (2 pcs)
1 x Ball link M3 RPA's-UAV's
1 x M2 5Diam black ball link V2 (2 pcs)
1 x Long ball link M2 (6 uds)
1 x Ball link M3 (10 pcs, flat ball)
1 x M3 Maxi ball link (2 uds)
1 x M2/M1/6 3Diam long black ball link V1 (2 pcs)
1 x M2,5 / 5Diam metal short ball link V3 (2 pcs)
1 x M3/5 Diam metal short ball link V3 (2 pcs)
1 x Ball link M2 (10 pcs)
1 x M2/M1/6 3Diam long black ball link V1 (6 pcs)
1 x Ball link M2,5 (10 pcs)
1 x 6 mm ball link M3 (10 pcs)
1 x Joint with bearing M2 22x5,5
1 x M3/5Diam metal ball link V3 (2 pcs)
1 x M3 Maxi ball link (2 uds)
1 x M2,5 Diam metal ball link V3 (2 pcs)
1 x Joint with bearing M2,5 22x5,5
3 x Initior Receiver FRX2 Wireless
2 x Blue smoke canister 140 g
1 x Yellow smoke canister 65 g
1 x PPM Encoder Module
2 x Parachutist
3 x Parachute expulsion foam
1 x Red smoke canister 140 g
2 x Red smoke bombs AX-60 (5 pcs)
2 x Green smoke canister 140 g
3 x Green smoke canister 65 g
1 x Motor A2212/13T
2 x Tube Pitot to PIXHAWK
2 x AX-60 starters (5 pcs)
2 x AX-60 starters (5 pcs)
1 x Black smoke bombs AX-60 (5 pcs)
2 x Digital Air Speed Sensor And Pitot Tube Set
1 x Smoke set "S"
2 x White smoke bombs AX-18 (5 pcs)
1 x B4-0 rocket charges (6 pcs)
2 x Yellow smoke canister 100 g
2 x Red smoke canister 65 g
1 x Mixers smoke bombs AX-60 (5 pcs)
2 x Ventral support for AX-18/AX-60
1 x 3l Smoke oil
1 x White smoke canister 65 g
1 x Couple M4 for wire (10 pcs)
1 x Aluminium coupler M2,5/2 with ball bearing (1 pcs)
1 x Z type of cable coupler Ø 1.8 (2 uds)
1 x Threaded coupler M2,5 Ø 3 mm (10 pcs)
2 x Clevis plastico I=44 mm / hole 3mm / pin 2 (2 pcs)
1 x Ball link Aluminio M4 x 4 x 6 x 26mm (4 uds)
1 x Oratex Natural White 2m
1 x Socket head ball link M3 (2 uds)
1 x Motor OS 3820-1200 electric
1 x T-shape holder metal LAMA
1 x Propeller mounting nuts Black / Silver Rocket 400 or Phatom simi
1 x Sun Cover BULL Mo1 2.6 (Hispano Aviacion)
1 x Sun Cover ULTIMATUM 2.0 (Hispano Aviacion)
1 x Threaded coupler ALU M2,5 Ø 4 (2 uds)
2 x Smoke set "M"
1 x Threaded coupler ALU M3 Ø 4 (2 uds)
1 x Turnbuckle M1,6x20/30 (2pcs)
1 x Threaded coupler ALU M2,5 Ø 3 (2 uds)
1 x DUPLEX 2.4EX Central Box 320
1 x Threaded coupler M2 (10 uds)
1 x Fuel bottle 500 ccm
1 x Rubber bushing with bracket "B" type (2 pcs)
1 x Threaded coupler ALU M2 Ø 4 (2 uds)
1 x Turnbuckle M1,6x17/27 (2pcs)
1 x wire tensioner (blue)
2 x PCARD Wireless System
1 x Aluminium blue ball links M3 V1 (10 pcs)
1 x Threaded coupler Micro M2 Ø 0,8 mm (10 pcs)
1 x Threaded coupler M2,5 Ø 2 mm (10 pcs)
1 x Ball link duraluminium M3 V1 (10 pcs)
2 x Threaded coupler M3 (10 uds)
1 x Universal Charging Lead - 500mm - 4mm to Glow Plug Igniter
1 x DUPLEX 2.4EX Central Box 220 + 2x Rsat2
1 x Turnbuckle M2x22/35 (2pcs)
1 x Threaded coupler ALU M3 Ø 6 (2 uds)
1 x Turnbuckle M2x29/43 (2pcs)
1 x "M" set
1 x Aluminium coupler M2/2 with ball bearing (1 pcs)
1 x Radial heatsink for MPJ AC25/35-xx motor
1 x Mini-Pix Esc 15 Amp
1 x Gyro 3-Ejes REFLEX V2 FMS
1 x Cooler motor type 280
1 x Glases Ace
1 x Glases Flitemaster
1 x TMM 2512-3S heli
1 x VTX 477 Carbon Rotorblade
1 x Combo 4 pcs AXI 2204 Multicopter
1 x 1804 2400KV Brushless Motor Qav 250 mini
1 x Motor Eachine Racer 250 Brushless Motor - BG2204 2300kv - CW thr
1 x Motor brushless 1806 - 2300 Kv Cuadracopter
1 x PROFI Box JETI
1 x Jeti Advance Pro Program Card
1 x KOBY 70 LV Esc
1 x Esc KOSMIK 200 HV
1 x Actrocon 60A ESC
1 x Actrocon 30A ESC
1 x AXI 2204 Multicopter
1 x ESC ALPHA 60A HV
1 x Propeller 10x4,7 SlowFlyer
1 x T-Motor MN705-S Kv125 (pack 2 uds)
1 x Motor brushless 1806 - 2300 Kv Cuadracopter
1 x Propeller 3x2
1 x Propeller 11x4,7 SlowFlyer
1 x Motor Eachine Racer 250 Brushless Motor - BG2204 2300kv - CCW th
1 x 1804 2400KV Brushless Motor Qav 250 mini
1 x Tarjeta programadora RAY G2
1 x Hacker X-Pro USB interface V2
1 x Receiver RSF08SB comatible FUTABA
1 x Receiver FUTABA R7014SB FASST Test
1 x "S" set for planes
1 x Receiver FUTABA R7108SB FASSTest/FASST
1 x Futaba R7114SB 2.4GHz FASTT/FASSTest S.BUS Receiver
1 x VIPER JET 2.2m + Electric landig Gear Deco: 01 Red-Blac-kWhit
1 x Connectors banna oro 3,5 mm (M/F)
1 x Cable servo PREMIUM MAXI 50m (blanco/rojo/azul) PVC
1 x BRASS CONTROL HORN M3x16 mm 2pcs
1 x Electric spoiler 440 mm (2 pcs)
1 x Glases Innovation Plus
1 x 2020 motor power ring
1 x AXI 2820/12 CYCLONE
1 x White smoke bombs AX-60 (5 pcs)
1 x UHU Por 50ml/40g
10,648.89EUR
Manufacturers
Manufacturer Info
R-G.de
R-G.de Homepage
Other products
Languages
Español English
Currencies