50.00EUR 15.90EUR

Mini-Pix Esc 15 Amp
[KON4002]


This products have a good performance and can ensure high efficiency (90% including when you're operatting under full gas avoiding overheating and flight time low) and competing with explosion engine's performance.

General features:
- Only for brushless motors.
- Soft start that rapidly rise up to the maximum power (providing security).
- RPM control for the velocities of drifts and the main rotor, great for travel in and out of the maneuvers.
- Auto-Programmable mode (APM) that automatically adjusts the variator to the radio's gas channel and sets the strength of stopping, and current and fast start limitations.
- Supply limitation.
- High performance microprocessor design thas controles the heat dissipation.
- Overheatting protection.
- Superflex high temperature cables.
- You can work with or without sensorizar engines.

Pix variator features:
- The new Pix variators are effective and low-cost; they're designed for brushless motors and replace Swing Kontronik series. The desig is entirely new. Compared with their predecessors, this variators have new and improved performance characteristics.

- The operation has been reduced to essentials things. Do not you know anything about timing / frequency? No matter; you don´t have to be an expert in engines to manage your Pix. Like their predecessors, the Pix variators, adapt themselves automatically to the engine. Thanks to their APM mode, there is no need to program it. You can concentrate on the basics: connecting the battery and fly! It's that easy!

- All variators come with a Pix Li-Po integrated that can turned on and off simply by pressing a button. In fact, a major goal in its design, was to build the variator optimized to work with rotary engines of a large number of poles like Kontronik Dancer.

- The Pix variators are an attractive alternative in cost, compared to Jazz Kontronik if you do not want any specific function such as strong BEC, unlimited partial load condition or high voltage input.

- Moreover, now the PIX drives are programmed through the interface ProgCARD.


few units
few units

Reviews

Customers who bought this product also purchased
AXI2203/40 VPP
AXI2203/40 VPP

few units
few units

Propeller Pleg CAM Carbon 6x3
Propeller Pleg CAM Carbon 6x3

few units
few units

Categories
* OFFER MONTH *
Planes->
Sailplanes->
Autogyros->
Helicopters->
UAVs - RPAs->
Multicopters->
Hardware->
  
  3D IMPRESION
  ABS Rods-Strips
  ABS/GFK/CFK plate
  Actuator
  Adapters->
  Adhesives/Resin/Epoxy->
  Altimeters->
  Amperimeters
  Anemometer
  Auto-Pilot
  Bags/Covers
  Batteries->
  BEC/Cables/Conectors/Interruptor
  Bungee Launchers
  Cables
  Cameras->
  Carbon rod
  Carbon/Brass/Steel/ABS/Aluminium
  Catalogues
  Chargers->
  Clevis
  Combustible->
  Connectors
  Control horns
  Controlers->
    Brushless->
      Aero-Naut
      Hacker
      Jeti->
      KAVAN
      Kontronik->
        Accesorios
      MGM
      Otros
      RIPMAX
      ROI-Import
      Top Model
      YGE
    Brushed
    Program Cards
  Coverings/Thermoretrac
  Decals
  Extension
  Extinguisher
  Ferritas
  Glasses
  Hardware
  Hinges
  Instruments / Panels
  Lights/Ilumination->
  Linkages
  Merchandising
  Motor
  Pilots
  Pinion extractor
  Power supply system/Data Recordi->
  Profiles
  Propelers->
  Screws
  Servos->
  Simulators
  Smoke/Rocketry/Fireworks
  Spinners->
  Spray/Painting/Dope/Solder Paste
  Steel/brass Rod/Aluminium
  Support/CG/Incidenc.
  Tapes/Closed/Bridles
  Tools
  Towing
  Transmitters/Receivers->
  Undercarriage->
  Wheels & Axles->
  Wing Joiner
  Wood
Car/Trucks->
Motors & Turbines->
Gas. Motor Paramotors
Acces. for Motors->
Paragliders/Parachutes/Windsock
Boats/Naval units->
FPV->
Robots->
CNC cut
Roof BOX
Crash kits
Outlet Zone->
Used
Merchandising HA
We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Round Rod 6,0x1000 mm
1 x ABS Strip 1.0x3.0x1000 mm
2 x Strip 2,5x1,25x330 mm
2 x Strip ABS 2.0x3.0x1000 mm
1 x Strip 2,0x2,0x330 mm
2 x Round Rod 2,5x1000 mm
2 x Round Rod 1,0x1000 mm
2 x Strip ABS 2.0x8.0x1000 mm
1 x Round Rod 2,0x1000 mm
2 x ABS Strip 1.5x4.0x1000 mm
2 x Round Rod 1,25x1000 mm
2 x ABS Strip 1.5x8.0x1000 mm
1 x Round Rod 1,5x1000 mm
2 x Round Rod 3,0x1000 mm
1 x ABS Strip 1.0x4.0x1000 mm
2 x ABS I Strip 10x5x1000 mm
2 x Strip 3,5x1,75x330 mm
2 x Strip ABS 2.0x5.0x1000 mm
2 x Servoholder Dymond DS 1800 MG Digital (2 pcs)
1 x XH male balance (2S) connector (2 pcs)
1 x Cabel charger transmitter GRAUPNER
1 x Conector Servo female 4 pines
1 x Futaba External voltage input cable Futaba CA-RVIN-700
1 x MPX-Dean "T" Adapter
1 x XH male balance (3S) connector (2 pcs)
1 x Connectors banna gold 5,5 mm (M/F)
1 x Conector BEC female (10 pcs)
1 x CM-3
1 x TP/TopFuel - XH 2/3S Adapter
1 x Banna gold connector 2,5 mm (100 M/F pairs)
1 x Red copper lacquer wire Ø0,2 mm (5 m)
1 x Optotronix Aurora Plug
1 x CC 03
1 x Connectors banna oro 2 mm (M/F) (ultralight)
1 x Gold antispark 5,5 mm plug
1 x Connectors DEANS 4 pins (1 pair)
2 x Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm)
1 x Conector AS150 7mm antichispazo (Set: 2 pares)
1 x Banna gold connector 2,5 mm (M/F)
1 x Connectors DEANS (T)
1 x Conector BEC male (10 pcs)
1 x Copper lacquer wire Ø0,2 mm (5 m)
1 x 4 LiPo XH>EH adapter
1 x CC 01
1 x 30 cm BEC cable (male)
1 x Connectors banna oro 4 mm (M/F) (ultralight)
1 x EC5-Set female, simple quality, 2 x female pin, 1 x blue housing
2 x Balanceradapter JST-XH (Heli 47G) 2-6 c.
1 x Futaba Female 40 cm extension
1 x Prolongador S-Bus JR/JR 20cm
2 x Futaba male 40 cm extension
1 x Extension silicon 100 cm (Futaba)
2 x Premium servo extension 75cm
1 x Premium servo extension 100cm
1 x Extension 7.5 cm
2 x Extension PVC 150 cm (Graupner)
1 x Extension 30 cm (Futaba)
1 x Extension silicon 35 cm male (Futaba)
2 x Extension silicon 100 cm (Graupner)
2 x Extension silicon 30 cm male (Graupner)
1 x Premium servo extension 50cm
2 x SERVO DES 806 Pignons
1 x SERVO DES 806 Pignons
2 x SERVO DES 568 MG
2 x SERVO DES 658 BB MG
2 x SERVO DES 707 BB MG
1 x Servo HBS 690BB HV Digital
1 x Xplorer3 anemometro
1 x Xplorer4 anemometro
1 x Xplorer2 anemometro
1 x Servo MKS HBL599 SL
1 x 1/6 Pilot "Tony"
1 x "S" set for planes
1 x 1/12 Pilot "Langley"
1 x Servo FUTABA HPS-A700 Digital S-Bus
1 x 11 mm wing servo holder
1 x Balsa panel 3.0x100x1000 mm
1 x Servo HITEC D-955 TW Titanium
1 x Gear set HITEC HS-65 HB
2 x Strip ABS 2.0x10.0x1000 mm
2 x ABS Strip 1.5x2.0x1000 mm
1 x Support FUEL DOT V3
1 x Support Antena 2.4 Ghz (2 pcs)
2 x Support ECU Xicoy X-45
1 x DYNAMOMETER S-1580
1 x Gear for D 200 BX
1 x Protector Connector Dean-T (1 pair)
2 x Round Rod 5,0x1000 mm
1 x Contacto macho pin conector (10 pcs)
1 x Extension 5 lipos JST/C - JST
1 x Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH
1 x Red 3m5 mm connector holder
1 x Adapter lead MPX/EC3
1 x PIN Connector female (100 pcs)
1 x Red 4 mm connector holder
1 x Wing connector 8pin with pin strip, plug & socket
1 x Female connector for 16 pines AWG
1 x Micro Switch button
1 x SPARK Switch 5.9v
1 x PIX Hawk with accesories
1 x ABS Strip 1.0x5.0x1000 mm
1 x Male connector for 6 pines AWG
1 x SPARK Switch 12v
1 x USB Interface REVOLECTRIX for CellPRO 10s
1 x servo adapter lead, JST-SH socket - JR male Pin, for GR-12SH+HoT
1 x silicon 100 cm Futaba Extension Ø 0,35 mm
1 x 0,14 mm PVC servo wire extension, ZH micro conector.
1 x Extension S-Bus 1-2 silicon 30 cm FUTABA
1 x 89 mm double servo arm with bearing (2 pcs)
1 x PET film Mylar® A 350, 50 cm, roll/ 5 m
1 x Glass fabric tape 130 g/m² (Silane, plain) 25 mm / 50M
1 x Glass fabric tape 49 g/m² (Interglas 02037, finish FE 600/800, p
1 x PET film Mylar® A 350, 50 cm, roll/ 2 m
1 x Extension silicon 30 cm female (Graupner)
1 x Cable silicona macho batt. receptor 30 cm (Graupner)
1 x Cable S.BUS 3 salidas 300 mm
1 x Cabel "Y" 30 cm (graupner)
1 x Xplorer1 anemometro
1 x Aluminium red ball links M3 V1 (10 pcs)
1 x Peel ply 95 g/m² (plain weave) 20 mm x 100 m
1 x Peel ply 64 g/m² (plain weave) 150 cm x 20m
1 x Glass fabric 80 g/m² (FK 144, twill weave) 100 cm, pack/ 1 m
1 x KOLIBRI 90 LV-I Esc
1 x KOBY 40 LV Esc
1 x KOLIBRI 140 LV Esc
1 x JIVE 100+LV Esc
1 x Mini-Pix Esc 15 Amp
1 x Support pumb/filter Xicoy X45
2 x ABS I Strip 20x10x1000 mm
1 x Soporte grifo FESTO vertical (1 pcs)
1 x 12 mm portholes (10 pcs)
1 x 31,0 mm propeller (rigth propeller)
1 x 3 mm Prop Adapter M6
1 x Strip 1,5x1,5x330 mm
1 x ABS Strip 1.5x3.0x1000 mm
1 x Round Rod 4,0x1000 mm
1 x JIVE 80+HV Esc
1 x KOBY 90 LV Esc
1 x JIVE 120+HV Esc
1 x Esc KOSMIK 160 HV
6,022.19EUR
Manufacturers
Manufacturer Info
KontroniK
KontroniK Homepage
Other products
Languages
Español English
Currencies