2 x | Truck-trailer for gliders 720 x 239 mm |
1 x | Angle of incidence meter |
1 x | Propeller balancer |
2 x | Truck-trailer for gliders 720 x 285 mm |
1 x | Field folding model stand |
1 x | Field folding model stand SebArt |
1 x | Angle measurer |
1 x | Surface Indicator Gauge Small |
1 x | Medidor ángulos y/o incidencias |
2 x | SE Ring 240 mm (2 pcs) |
3 x | Tape GFK 38 mm |
2 x | SE Ring 360 mm (2 pcs) |
1 x | Marker ties (20 pcs) |
2 x | Cinta Goldfix 1m |
3 x | Tape GFK 50 mm |
4 x | SE Ring 250 mm (2 pcs) |
3 x | Tape GFK 25 mm |
2 x | Cable-Tie 1.66x71mm / 0.07x2.8″ (20 pcs) |
3 x | SE Ring HACKER 300 mm (2 pcs) |
3 x | Spikes Band (5 m) |
3 x | Foil for sticking flaps and ailerons |
1 x | RUDDOG Protection and Heat Shield Tape (2mx50mm) |
3 x | SE Ring 480 mm (2 pcs) |
3 x | SE Ring 450 mm (2 pcs) |
4 x | SE Ring 350 mm (2 pcs) |
2 x | 26 mm self adhesive Pinking Tape, saw tooth height 1.0 mm |
2 x | SE Ring 330 mm (4 pcs) |
1 x | 2 mm male connector (2 pcs) with safety connector |
1 x | Connectors banna oro 3 mm (M/F) |
1 x | Connectors DEANS (T) |
1 x | Connectors DEANS 4 pins (1 pair) |
1 x | Optotronix Aurora Plug |
2 x | Connectors banna gold 5,5 mm (M/F) |
1 x | Banna gold connector 2,5 mm (M/F) |
1 x | Connectors banna oro 2 mm (M/F) (ultralight) |
1 x | Connectors banna oro 6,0 mm (M/F) |
2 x | "Y" charging 4mm wire (2 IN-1 OUT). |
1 x | TP/TopFuel - JST-EH 4/5S Adapter |
1 x | Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm) |
1 x | USB HLS prog. interface |
1 x | Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH |
1 x | 3 LiPo XH>EH adapter |
1 x | Red copper lacquer wire Ø0,2 mm (5 m) |
2 x | Wing-connector: Glass / Carbon tube (13.7/12.5) x 1000 mm |
1 x | Aluminum Bayonet / strongal D12 mm / 0.5 m |
1 x | Hard aluminium thin-walled tube with fibreglass case ø30x1mm, 1m |
1 x | Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 100 m |
1 x | Tow hook for tug |
1 x | Aluminium cap bolt washer M3 black (8 pcs) |
1 x | Flat washer 2.7 mm (20 uds)pcs) |
1 x | Horn 6/27 with M3 Bearing |
1 x | Vasa model Catapult |
1 x | Threaded coupler Micro M2 Ø 0,8 mm (10 pcs) |
1 x | Cable servo PREMIUM MAXI 100m (blanco/rojo/azul) PVC |
1 x | Vacuum pump P1-N |
1 x | PROXXON - SILICON CARBIDE BELTS FOR BSL 220/E |
1 x | Starter EM Gear Power 250 |
3 x | 20x1000 mm Ring Strap Back To Back |
2 x | 5 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
1 x | Wing-connector: Glass / Carbon tube (26.5/25 x 25/23) x 1000 mm |
3 x | 10 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
5 x | SE Ring 300 mm (2 pcs) |
1 x | Keypad ALTIS V4 |
1 x | 2,3 mm Prop Drive Günther M4 |
1 x | Soporte carbono MR30 (2 pcs) |
1 x | MR30 connector female |
1 x | XH female balance (2S) connector (2 pcs) |
1 x | Carbon plate 350x150x1.0 mm |
1 x | MPX PCB "4 Pins", 5 pieces |
1 x | Dean "T" - Futaba Adapter |
1 x | Wing conexion 2 servos JR/Graupner 50 cm |
1 x | CM-3 |
1 x | MR30 connector male |
1 x | Conector MT-60 (pair) |
1 x | PSC 5 |
1 x | Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH |
1 x | 11 mm wing servo holder |
1 x | XT60 Connector with Holder Male 2pcs |
1 x | Bidule 111 3000 mm |
1 x | Extension 2/3 lipos JST/C |
1 x | Cabin latch Fox MDM1 4m (pair) |
1 x | Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm) |
2 x | MPX PCB "6 Pins", 5 pieces |
1 x | Interruptor RX/Batterie |
1 x | Balanceradapter JST-XH (Heli 47G) 2-6 c. |
1 x | Interruptor SAFET-SWITCH 12HV Twinbatt |
2 x | CC 02 |
1 x | MPX Support |
1 x | Cabel charger transmitter GRAUPNER |
1 x | Extension 2/3 lipos JST - JST/C |
1 x | XH LiPo extension lead |
2 x | 4 LiPo XH>EH adapter |
1 x | DPSI Ampere battery backer |
1 x | Connector Sub-D 2+5 Female |
1 x | Multi-adapter balancer JST/C - TP |
1 x | MPX screwable clips (4 pcs) |
1 x | 13 mm wing servo holder |
1 x | BULLIT Wing 1095 mm |
1 x | Contacto macho pin conector (10 pcs) |
1 x | SPS Remote switch actuator |
1 x | XT-60 connector (male) |
1 x | Connectors MPX black female |
1 x | USB interface ALTIS |
1 x | Opto Gas Engine Kill Switch |
1 x | Conector XT-30 (macho) |
1 x | Connector Sub-D 2+5 Male |
2 x | Kontronik connector (10 connectors, 5 pairs) |
1 x | Aluminum Bayonet / strongal D25 mm / 1 m |
1 x | LED wire (blue - 2pcs) |
1 x | 4 mm Prop Adapter M6 |
1 x | Telemetry interface ALTIS 6 cm |
1 x | Device Terminal |
1 x | 5 mm Prop Adapter M6 |
3 x | 13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm |
2 x | SE Ring 200 mm (2 pcs) |
1 x | 14x60 mm Mini rings Tie Wraps (4 pcs) |
1 x | 20x200 mm battery rings |
2 x | 20 mm self adhesive Pinking Tape, saw tooth height 1.0 mm |
2 x | Pad self adhesive, up to 3mm / 0.12″, (10 pcs) |
1 x | SE Ring 400 mm (2 pcs) |
2 x | 13 mm self adhesive Pinking Tape, saw tooth height 1.0 mm |
2 x | Waterproof adhesive tape, width 19mm, length 25m |
2 x | MAX BEC 2D plus EX |
1 x | Connectors MPX 8 pins with support (black) 1 pair (male-female) |
1 x | DUPLEX USBa USB-Adapter for Jeti Duplex Items |
1 x | SWTU2 switch |
1 x | MPS Gas-Cap-Powerswitch |
1 x | Servo slow down unit (0,7-14,7 sec ) |
1 x | Cabling for Fox MDM1 wings |
1 x | Short Switch On/Off micro |
1 x | Manometer 4 mm |
1 x | Bidule 111 3000 mm Canopy |
1 x | Selfstart electronic switch |
1 x | ARTIST 1.560 mm |
1 x | APM2.6 Power module with 5.3V DC BEC |
1 x | Three-position switched channel, short |
1 x | Rigid coupling brass Ø 4 mm L: 25 mm |
1 x | Propeller RABOESCH M4 40 mm (3 Blades) (Right hydropropeller) |
1 x | 270 mm 3/3 mm shaft ship |
1 x | Servo HITEC HS-82 MG |
1 x | SyRen 50A 6V-30V Regenerative Motor Driver |
1 x | Reductora IPS dual-motor 10,7:1 with spinner |
1 x | Mounting frame MPX female connector |
1 x | Magnetic Interruptor MULTIPLEX |
1 x | Gold antispark 5,5 mm plug |
1 x | Male connector for 6 pines AWG |
1 x | Connectors MPX female |
1 x | Futaba External voltage input cable Futaba CA-RVIN-700 |
1 x | Extension 5 lipos JST/C - JST |
1 x | Connectors banna oro 4 mm (M/F) (ultralight) |
2 x | 3 copper lacquer wire Ø0,2 mm (1 m) |
1 x | MPX housing with flange (4 pcs) |
2 x | Female connector JST SH 1.0mm with 10 cm wire |
1 x | Female connector for 20 pines AWG |
1 x | 40 mm air cylinder |
1 x | wing/fuselage connector for 12 pines AWG 20-24 |
1 x | Mini neumatic retract 3 mm landing gear (Het-rc) |
1 x | Circlick securite |
1 x | Astra wing Joinner (Top Model) |
1 x | Male connector for 20 pines AWG |
1 x | Battery charging cable XT60 |
1 x | KOBY 70 LV Esc |
1 x | Esc KOSMIK 200 HV |
1 x | KOBY 40 LV Esc |
1 x | Esc KOSMIK 160+ HV COOL |
1 x | Swing 1000 |
1 x | DUBRO - CUB WHEELS (1/3 SCALE) (558TLC) - 2PCS |
1 x | Glass fabric tape 130 g/m² (Silane, plain) 25 mm / 100M |
1 x | Propeller RABOESCH M4 45 mm (3 Blades pr) (Right hydropropeller) |
1 x | Propeller RABOESCH M4 30 mm (3 Blades) (Right hydropropeller) |
1 x | L-Connector 1.5 mm x 1000 mm |
1 x | 261 mm M4/M4 6.0x4.0 mm shaft ship |
1 x | 290x4 mm M4 shaft ship |
1 x | 290 mm M5 Prop shaft |
1 x | Rigid coupling brass Ø 3 mm L: 20 mm |
1 x | Rigid coupling brass Ø 4.0 / 2.3 mm L: 20 mm |
1 x | 290 mm M4/M4 6.0x4.0 mm shaft ship |
1 x | L-Connector 4.0 mm x 1000 mm |
1 x | Cross Connector 4.0 mm x 1000 mm |
1 x | Rudder 107-06 |
1 x | Regulador Hobbywing Platinum 260A HV SBEC V5 |
1 x | Propeller 3x3 |
1 x | Prop Shaft Adapter 5 mm/M8 "long" |
1 x | 290 mm M4 7/8x212 mm shaft ship |
1 x | |
1 x | 3.2 mm Prop Adapter M8 |
1 x | Servo case HS-225MG/225BB/5245MG |
1 x | Servo HITEC HS-53 |
1 x | 5 mm Prop Adapter CN-Spinner |
1 x | Brazo servo aluminio HITEC HS-125MG/5125MG |
1 x | Servo HITEC D954 TW |
1 x | Servo HITEC HS-5245 MG Digi |
1 x | Servo HITEC D-955 TW Titanium |
1 x | Actuador lineal HLS12-100210-7.4v |
1 x | Servo HITEC HS-485 HB |
1 x | Servo lock HS-80/81/82/85 (2 pcs) |
1 x | HPP-21 PLUS PC Programmer for Hitec Digital Servos |
1 x | Servo HITEC HS-325 BB |
1 x | Pad Screw Mount M3, up to 3mm / 0.12″, (10 pcs) |
|
9,178.02EUR |