18.00EUR

BATTWIN BATTERY REDUNDANCY SYSTEM
[SETBATTWIN]


BaTTwin was designed specifically for large RC models. It allows to use two identical batteries as the main power for the receiver and servos. Its main task is to diversify and power redundancy, thereby significantly reducing the risk of control loss in the case of failure of one battery or power pack. It should be added that BaTTwin it self also has two independent and redundant power circuits.

The device continuously monitors voltage level of both batteries and always charged the one with the higher momentary voltage - switching between battery is unobtrusive and cyclically without interruption to the power supply even at high power consumption. In case of use the same batteries they will be discharged simultaneously. The use of such two batteries for example. Lipo 7.4V 2200mAh - results that there is 4400mAh available for flight.

Protection against:
-In the case of an internal short-circuit in one battery, or contact one of the input side of BaTTwin (eg in a switch, or frayed wires). The receiver will constantly receive power from the second battery. Switching occurs transparently and without any interruption to the power supply and servos. However, in the case of short-circuit the battery, it is possible to catch fire of the battery. Shorting a one battery WILL NOT AFFECT efficient of a second battery.
-In case of failure of one battery (sudden voltage drop, or reduction in the capacity of the old package) receiver will constantly receive power from the second battery, switching takes place in a way that is not noticeable and without interruption to the power supply and servos.
-In case of disconnection of one battery (failure or malfunction in switch contacts). The receiver will continually receive power from the second battery, switching takes place in a way that is not noticeable and without interruption to the power supply and servos.
-Protection when connecting the battery in reverse polarity. There will be no voltage at the BaTTwin outputs.

Other functions
– BaTTwin has NO POWER CONSUMPTION in standby mode,
– designed primarily for high voltage receivers and servos (standard HV voltage 7.4V),
– possible to use with voltage regulator if necessary,
– prepared for additional chargin wires setup,
– high current capability up to 2x10A,
– wide range input voltage.


temporarily out of stock
temporarily out of stock

Reviews
We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Propeller FALCON 32,5x11 PUSHER Carbono
1 x Stainless steel cable Ø 1.3 mm (10 m)
1 x PIX Hawk with accesories
1 x Oracover Yellow CUB 10 m
1 x Micro Crystal RX 35.070 Ch 67
1 x PVC 0,25 qmm 4 line servos wire JR/Graupner (5 m)
1 x Straightened rod Ø 2.0 mm x 1000 mm
2 x L cockpit anchor "tipe F3A" (2 pcs)
1 x Crystal RX 35.140 Ch 74
1 x Silicone 0,25 qmm servos wire Graupner (5 m)
1 x Antenna Cloverleaf 5.8 GHz Tx - Rx
1 x Crimping sleeves for cable 0.70 mm (10 pcs)
1 x Oracover Black 2 m
1 x PVC 0,14 qmm servos wire JR/Graupner (5 m)
1 x Oracover Yellow CUB 2 m
1 x Stainless steel cable Ø 0.52 mm - 15 kp (10 m)
1 x Oracover light Grey 2m
1 x RF9 Flight Simulator with Spektrum Controller
1 x Oratex Natural White 2m
1 x Straightened rod Ø 5.0 mm x 1000 mm
1 x Extension S-Bus 1-2 silicon 30 cm FUTABA
1 x Cabel PVC 2 x 0.25 mm2 (5 m) red-black
1 x PVC 0,25 qmm servos wire Graupner (5 m)
1 x PVC 0,08 qmm Futaba servos wire (5 m)
1 x Ball link Aluminio M3 x 3 x 5 x 18mm (6 uds)
1 x Simulador RealFlight RF-9.5 S (sin emisora)
1 x Brass rod Ø 1.5 mm x 1000 mm
1 x Digital precision scale up to 2000 g
1 x Micro Crystal RX 35.080 Ch 68
1 x Oratex Silver 2m
2 x Straightened threaded rod M3 - 1m
1 x Bateria LRP 2200-7.2v 6 cell NiMH
1 x Extension silicon 100 cm (Futaba)
1 x Dust collector for mould cleaning
1 x Prolongador S-Bus JR/JR 20cm
1 x Cable S.BUS 3 salidas 100 mm
1 x Oracover Azul Cielo 2 m
1 x Crystal TX 35.150 Ch 75
1 x Squared carbon wing joinner 5x5x220 mm
1 x Starter 12v (Max 180 and 30ccm)
1 x One touch canopy lock
1 x 200m servo "Premium" wire (white/red/blue)
1 x Cable silicona macho batt. receptor 30 cm (Graupner)
1 x Cable servo PREMIUM MAXI 1 m (blanco/rojo/azul) PVC
1 x Oracover Yellow CADMIO 2 m
1 x Slave-cable USB Easy Sim
1 x Oils Pumps Empty (1 liter)
1 x Cabel "Y" 15 cm
1 x Canopy Lock V1 M3 Blue (2 pcs)
1 x 10m servo "Premium" wire (white/red/blue)
1 x Oratex Natural White 20m
1 x Oracover White 10 m
2 x Oratex Antik 2m
1 x Brass hexagonal rod Ø 3 mm x 1000 mm
1 x Monokote ROJO misil (1.8x0.65m)
1 x PVC 0,14 qmm servos wire Hitec/Mpx (5 m)
1 x Premium servo extension 100cm
1 x Oratex White 2m
1 x 5 line servos wire black (1 m)
1 x Hard aluminium thin-walled tube with fibreglass case ø30x1mm, 1m
1 x Steel tube (L 1000 mm Ø5 mm, Ø4,7 mm)
1 x ARAMID honeycomb 1300x2600x2 mm
1 x ABS tube 12.0x10.0x1000 mm
1 x Switch moment button, 2 functions, long FUTABA
1 x Pilot "Anthony" (Slimline)
1 x Adap/Exten for Futaba 12-14C
1 x MULTIPLEX ALUMINUM CASE "M-LINK"
1 x AIREX® Sheets C 70.55 (YELLOW) 1200x550x6.0 mm (5 pcs)
1 x MPX Sub-D Adaptor
1 x 2 mm female connector (2 pcs) with safety connector
1 x Carbon fiber flat 1000x3.0x0.13 mm
1 x Connectors banna oro 4 mm (M/F)
1 x Truck-trailer for gliders 720 x 239 mm
1 x Fibra carbono tela 160g/m2 100 cm x 2 m (twill weave)
1 x 1/6 Pilot "John"
1 x Connector CAN 15
1 x 2 mm male connector (2 pcs) with safety connector
1 x Xplorer4 anemometro
1 x Carbon fibre tape 125 g/m², 3k, UD (25 mm) roll/ 10 m
1 x Conector Servo female 4 pines
1 x 1/6 Pilot "Cindy"
1 x EC5-Set male, simple quality, 2 x female pin, 1 x blue housing
1 x Connectors banna oro 4 mm (M/F) (ultralight)
1 x 30 cm DEANS female connector
1 x Connectors banna oro 2 mm (M/F) (ultralight)
1 x 1/12 Pilot "Fighter"
1 x ABS tube 20.0x18.0x1000 mm
1 x WingFix ULTRA Black Edition
1 x Pilot "Adolf" Legends Series (Slimline)
1 x ABS tube 8.0x7.0x1000 mm
1 x Gold antispark 5,5 mm plug
1 x Switch Cap M (black)
1 x Wing connector 8pin with pin strip, plug & socket
1 x AIREX® Sheets C 70.55 (YELLOW) 1200x550x2.0 mm (20 pcs)
2 x Interruptor FUTABA FX-MZ (2 Posic. corto)
1 x Transmitter Crystal 35 Mc/s Ch 77
1 x DPS Switch JR/JR
1 x DPSI Micro - RCS
1 x Filter Capacitor JR
1 x Blue metalic ball link M3/3 azul (2 pcs)
1 x Carbon fiber rod 10 mm x 1000 mm
1 x DPSI Micro - DualBat 5.9/7.2 MPX-2xMPX dual
1 x Carbon Non-Woven, 160 g/m² 127 cm 1 m
1 x Carbon fiber rod 0.5 mmx1000 mm
1 x Black "FUEL VENT" round aluminum overflow socket
1 x Carbon fiber rod 1.5 mm x 1000 mm
1 x Carbon Non-Woven, 240 g/m² 100 cm x 5m
1 x Straightened rod Ø 14.0 mm x 1000 mm
1 x Carbon fiber rod 8.0 mmx1000 mm
1 x Brass rod Ø 0.5 mm x 1000 mm
1 x DPSI Micro - RCS RV
1 x Birch plywood plate 600x300x4.0 mm
1 x Straightened rod Ø 8.0 mm x 1000 mm
1 x Straightened rod Ø 5.5 mm x 1000 mm
1 x DPSI Micro-DualBat 5.9V / 7.2V MPX-JR
1 x Straightened rod Ø 1.5 mm x 1000 mm
1 x Brass rod Ø 1.0 mm x 1000 mm
1 x DPSI Micro MPS
1 x Straightened threaded rod M2-1m
1 x DPSI RV Mini 5 Magic
1 x Blue metalic ball link M2/2 azul (2 pcs)
1 x Batetia LiFe 3200 mAh 6.6v MPX PowerBox
1 x Landing gear frontal support 29x26x13,5
1 x PVC transparent battery termo-retract 195 mm (1 m)
1 x BlueCom™ Adapter (Android / WP)
1 x Screw-lock connector M2 (2 uds)
1 x Horizontal cockpit anchor "tipe F3A" (2 pcs)
1 x Pushrod greyline 3/2 with coupler M3 L: 1000 mm
1 x Screw-lock pushrod conn snap Ø 1.5 mm (2 uds)
1 x External LED's (2 pcs)
1 x Charger SKY RC D200 neo
1 x Fully Threaded Steel Rod Duralumin 120 mm M3 (2 pcs)
1 x Connectors banna oro 2 mm (M/F)
1 x Carbon fiber rod 6.0 mmx1000 mm
1 x Carbon tube (L 1000 mm, Ø4 mm, Ø3 mm)
1 x Fully Threaded Steel Rod Duralumin 50 mm M3 (2 pcs)
1 x Fully Threaded Steel Rod Duralumin 34 mm M3 (2 pcs)
1 x Carbon tube (L 1000 mm, Ø6 mm, Ø4 mm)
1 x Tubo Teflon Ø25 mm x 10cm
1 x Transmitter Balancer SPK DX-8
1 x ABS 500 x 400 x 1 mm (white)
1 x T-Hose connector 4-4-4mm
1 x Quick hose connector 4-4 mm
1 x Fiberglass heat shield Ø 6 mm 1000 mm
1 x Switch Cap M (blue)
1 x Extension silicon 30 cm female (Graupner)
1 x Breatex™ Non-woven absorber 300 g/m² Roll 41 m
1 x Switch Cap M (silver)
1 x Futaba Neckstrap
1 x Carbon fabric 160 g/m² (plain weave) 100 cm x 3 m
1 x Transmitter Stick Ends V1 Red - M3 (2 pcs)
1 x Civilian pilot "Gramps" size 9cm (Slimline)
1 x Legs + electric brakes for Viper Jet 1700 mm
1 x Pilot WWII US Navy Pacific 12" Scale 1/6-1/5
1 x Carbon fiber rod 4.0 mmx1000 mm
1 x PowerBox MAG Sensor
1 x Pushrod octagone 4/3
1 x Fully Threaded Steel Rod M2,5 (2 uds)
1 x Locking cable tie 2.5x100 (uds)
6,142.79EUR
Manufacturers
Manufacturer Info
Setlo
Setlo Homepage
Other products
Languages
Español English
Currencies