59.00EUR

Glases Innovation Plus
[CMINNOVATIONP]



Set de gafas, cristales, funda y trapo
Do you have to wear prescription glasses? Fed up with seeing your buddies turn up at the field with great looking and practical glasses you just can't wear? We have the answer in the form of these stylish prescription model flying sunglasses, which have been especially developed for radio control model use.

At the heart of the design is a polycarbonate frame that houses your prescription lenses; this clips onto a main frame, which in turn houses the coloured shades that simply clip on to a hinged section. These hinges allow you to temporarily turn up the outer lenses in order to closely inspect a model in the pits etc.

Innovation Plus are polarised sunglasses. The polarised cristals greatly reduce glare, which is an effect caused by light hitting horizontally flat surfaces. Polarised lenses filter out this light to greatly enhance your visibility.

The de-centred, scratch resistant lenses have been optically balanced to negate the effects their curvature would otherwise have on your vision. Conforming to US ANSI Z80.3 plus British and European safety standard EN1836, our sunglasses are factory impact-tested, and offer great protection against flying debris should you suffer a mishap. All of our glasses carry the CE (European Union standard) compliance mark. The interchangeable lenses are: yellow (category 1) low light - these actually enhance light and contrast; beige (category 2) average sunlight; smoked mirror (category 3) bright sunlight; dark smoked (category 4), very bright conditions.

The glasses come with the interchangeable lenses, a cleaning cloth and a superb carry case with belt clip. All frames and the carry case display our 'Model Glasses' logo.

WILL THEY WORK FOR ME? - If you have a prescription (SPH) requirement that's less than plus or minus 4.00, our glasses will work just fine for you. Stronger prescriptions can cause distortion, due to the curvature of the tinted lenses when placed in front of the flat prescription clip. The de-centring calibration loses its effect where stronger prescriptions are required. If you have a requirement greater than plus or minus 4, please do not buy these glasses. Bi-focals, varifocals and prismatic lenses can be added - if in doubt, please consult your optician for advice.

IMPORTANT NOTE
When wearing Innovation Plus, some users may find they cannot see certain types of LCD or other electronic / digital transmitter displays. This is a normal cause of wearing polarised glasses. We recommend using the glasses with the front section flipped up, or the glasses removed, when model trimming prior to use.


few units
few units

Reviews

Customers who bought this product also purchased
Fiberglass plate 350x150x0.5 mm
Fiberglass plate 350x150x0.5 mm

few units
few units

Tape GFK 50 mm
Tape GFK 50 mm

few units
few units

Tape GFK 25 mm
Tape GFK 25 mm

few units
few units

MAX BEC
MAX BEC

few units
few units

Conector FUTABA Servo male  (10 pcs)
Conector FUTABA Servo male (10 pcs)

few units
few units

Conector FUTABA Servo female BLUE silicon (10 pcs)
Conector FUTABA Servo female BLUE silicon (10 pcs)

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Threaded coupler ALU M3 Ø 6 (2 uds)
1 x Ball Link ALU M3 - RH (1 pcs)
1 x Ball Link M2 with Ball and Hardware, 10 pcs
1 x Aluminium coupler M2/2 with ball bearing (1 pcs)
1 x Ball link Aluminio M3 (2 pcs)
1 x Ball link Aluminio M4 x 4 x 6 x 26mm (4 uds)
1 x Clevis plastico I=45 mm / hole 3mm / pin 1 (2 pcs)
1 x Clevis plastico I=30 mm / hole 2.5mm / pin 1 (2 pcs)
1 x Z type of cable coupler Ø 1 (2 uds)
1 x Threaded coupler Micro M2 Ø 0,8 mm (10 pcs)
1 x Z type of cable coupler Ø 2 (2 uds)
2 x Threaded coupler ALU M3 Ø 4 (2 uds)
1 x Clevis plastico I=26 mm / hole 2mm / pin 1 (2 pcs)
1 x Ball link duraluminium M3 V1 (10 pcs)
1 x Threaded coupler Micro M2 Ø 0,8 (10 pcs)
1 x Ball link V1 Ø7 M4/3 (6 uds)
1 x Kwik link AL M3 L:23 mm (2 pcs) + Pin Ø 1,6 mm
1 x Threaded coupler ALU M3 Ø 5 (2 uds)
1 x Angled clevis with threaded rod M3
1 x Aluminium red ball links M3 V1 (10 pcs)
1 x Kwik link AL M2,5 L:23 mm (2 pcs) + Pin Ø 1,6 mm
1 x Threaded coupler ALU M2,5 Ø 3 (2 uds)
1 x Aluminium blue ball links M3 V1 (10 pcs)
1 x Brass ball links BS M3 V1 (10 pcs)
1 x Threaded coupler M3 (10 uds)
1 x Threaded coupler ALU M2,5 Ø 6 (2 uds)
1 x Windsock Ozone L -1200 mm
2 x Glases Aspen
1 x Paramotor BackPack XXS 2
1 x Set cintas unión paracaídas 145 cm
2 x Paramotor Trike XL
2 x MAX pilot ARTF
1 x Zurich Sport Sunglasse Dark Sensity MAGENTA Glasses
1 x Glases Nimbus
2 x Zurich Sport Sunglasse Dark Sensity BROWN Glasses
1 x Aramid 50 daN 50 m
2 x Glases Flitemaster
1 x Wing OXY 5,0 m2
2 x Glases Nimbus "Black"
1 x Para-RC Mix
1 x Para-RC Trike "RC-Bullix"
2 x Paramotor Kit Camo H1.5/ Ben Red
3 x Rescue 1,8m2 / BackPack
2 x Parachute PV6 for F3J
1 x Wing OXY 0,5 pulgadas2
1 x Windsock Ozone L - 700 mm
1 x Opale Rucksack
1 x Glases Moritz
2 x 30 cm BEC cable (male)
1 x DUPLEX USBa USB-Adapter for Jeti Duplex Items
2 x Adapter lead MPX/XT60
1 x USB HLS prog. interface
1 x Balance "Y" Wire 6S, 2x JST-XH / 1x JST-EH
1 x Bec MR UBEC 5A (5v/6v/7v)
2 x 2 LiPo XH>EH adapter
1 x 4 LiPo XH>EH adapter
1 x Red copper lacquer wire Ø0,2 mm (5 m)
1 x Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm)
2 x Black copper lacquer wire Ø0,2 mm (5 m)
1 x CM-3
1 x Cabel charger transmitter GRAUPNER
2 x Circlick securite
1 x 30 cm BEC cable (female)
1 x 5 LiPo XH>EH adapter
1 x Balanceradapter JST-XH (Heli 47G) 2-6 c.
1 x APM2.6 Power module with 5.3V DC BEC
1 x DYNAMOMETER S-1580
1 x Xplorer3 anemometro
2 x Xplorer2 anemometro
1 x Tow hook for tug
1 x Adjustable launching hook
2 x SERVO HOLDER
1 x Fixed launching hook
1 x LOWER TOW HOOK
2 x Xplorer1 anemometro
2 x 2,3 mm Prop Drive Günther M4
1 x Pine wood slat 2.0x2.0x1000 mm
1 x Aluminium rod Ø 4.0 mm x 3000 mm
1 x Streamline Stainless Steel Tubing 6.3x3.5x1000 mm
1 x Clevis plastico I=44 mm / hole 3mm / pin 2 (2 pcs)
1 x Glases Ace
1 x Threaded coupler ALU Left M2,5 Ø 4 (2 uds)
1 x 3 mm Short Prop Adapter M5
1 x Trike XL motor set (motor+esc+prop)
1 x Parachute BACKUP X100
1 x Parachute P4
1 x Z type of cable coupler Ø 1.8 (2 uds)
1 x Para-RC "RC-Evo-Cross" Rescue
1 x Check valve quick hose connector 4-4 mm
1 x Tail wheel for 8-12 kg models
2 x Optical RPM Sensor
1 x Nylon gear block Ø 5 mm (2 uds)
1 x Three-position switched channel, short
1 x Connector CAN 15
1 x Tailwheel for 40/90 size
1 x Dual Sequencer Gear and Canopy
1 x Cabling for Fox MDM1 wings
1 x Propeller mounting nuts Black / Silver Rocket 400 or Phatom simi
1 x Aluminun wheel collar 3 mm Ø (4 uds)
1 x Nylon threaded block M6 (2 uds)
1 x Nylon gear block Ø 4 mm (2 uds)
1 x Aero shocks
1 x Landing gear clamp for Ø 3 mm (4 uds)
1 x Aluminun wheel collar 4 mm Ø (4 uds)
1 x DPSI magnetic switch actuator (housing)
1 x Aluminun wheel collar 2.5 mm Ø (4 uds)
1 x 28 mm tailwheel unit
1 x Polyurethan FESTO hose 3x0,5 mm, transparent
1 x 40 mm air cylinder
1 x PowerBox SparkSwitch RS
1 x PSC 5
1 x CC 02
1 x Retract undercarriage for gliders up to 2 Kg
1 x Body for landing gear Ø 4 mm
1 x Extension 5 lipos JST - JST/C
1 x Opto Gas Engine Kill Switch
1 x Landing gear strap medium (4 uds)
1 x USB interface ALTIS
1 x Propeller set 400 (2R+2L)
2 x CC 03
1 x Connector Sub-D 2+5 Female
1 x CC 01
1 x Selfstart electronic switch
1 x Festo 6mm Tubing Holder (10 uds)
1 x Nylon gear block Ø 6 mm (2 uds)
1 x Altimeter Altis V4
1 x GPS Altis
1 x Towing hook <3m
1 x 5 mm Prop Adapter M6
2 x Towing hook
1 x Fiberglass heat shield Ø 6 mm 1000 mm
1 x JR silicone servo wire 0,35 qmm / 5m
1 x Cable set PREMIUM Maxi, SUB-Done 4three fuselage/wing 200 cm
1 x Towing hook
1 x Device Terminal
1 x Telemetry interface ALTIS 6 cm
1 x Prop Shaft Adapter 4 mm/M8 "long" 35 mm
1 x DC Small for MultiLog & UltraLight
1 x SCHARNHORST accessories
1 x Spinner propeller pleg. 40 mm / 3,2 mm
1 x Banna gold connector 2,5 mm (M/F)
1 x Spinner Alumin. fixed propeller 40 mm / 4,0 mm
1 x Spinner propeller pleg. 40 mm / 5,0 mm
1 x Spinner propeller pleg. 40 mm / 5,0 mm
1 x Spinner propeller pleg. 30 mm / 4,0 mm
1 x Spinner Alumin. propeller pleg. 30 mm / 3,2 mm
1 x Spinner propeller pleg. 30 mm / 3,2 mm
1 x Spinner Alumin. propeller pleg. 40 mm / 3,0 mm
1 x Spinner propeller pleg. 40 mm / 4,0 mm
9,498.12EUR
Manufacturers
Languages
Español English
Currencies