59.00EUR

Glases Innovation Plus
[CMINNOVATIONP]



Set de gafas, cristales, funda y trapo
Do you have to wear prescription glasses? Fed up with seeing your buddies turn up at the field with great looking and practical glasses you just can't wear? We have the answer in the form of these stylish prescription model flying sunglasses, which have been especially developed for radio control model use.

At the heart of the design is a polycarbonate frame that houses your prescription lenses; this clips onto a main frame, which in turn houses the coloured shades that simply clip on to a hinged section. These hinges allow you to temporarily turn up the outer lenses in order to closely inspect a model in the pits etc.

Innovation Plus are polarised sunglasses. The polarised cristals greatly reduce glare, which is an effect caused by light hitting horizontally flat surfaces. Polarised lenses filter out this light to greatly enhance your visibility.

The de-centred, scratch resistant lenses have been optically balanced to negate the effects their curvature would otherwise have on your vision. Conforming to US ANSI Z80.3 plus British and European safety standard EN1836, our sunglasses are factory impact-tested, and offer great protection against flying debris should you suffer a mishap. All of our glasses carry the CE (European Union standard) compliance mark. The interchangeable lenses are: yellow (category 1) low light - these actually enhance light and contrast; beige (category 2) average sunlight; smoked mirror (category 3) bright sunlight; dark smoked (category 4), very bright conditions.

The glasses come with the interchangeable lenses, a cleaning cloth and a superb carry case with belt clip. All frames and the carry case display our 'Model Glasses' logo.

WILL THEY WORK FOR ME? - If you have a prescription (SPH) requirement that's less than plus or minus 4.00, our glasses will work just fine for you. Stronger prescriptions can cause distortion, due to the curvature of the tinted lenses when placed in front of the flat prescription clip. The de-centring calibration loses its effect where stronger prescriptions are required. If you have a requirement greater than plus or minus 4, please do not buy these glasses. Bi-focals, varifocals and prismatic lenses can be added - if in doubt, please consult your optician for advice.

IMPORTANT NOTE
When wearing Innovation Plus, some users may find they cannot see certain types of LCD or other electronic / digital transmitter displays. This is a normal cause of wearing polarised glasses. We recommend using the glasses with the front section flipped up, or the glasses removed, when model trimming prior to use.


few units
few units

Reviews

Customers who bought this product also purchased
Tape GFK 25 mm
Tape GFK 25 mm

few units
few units

MAX BEC
MAX BEC

few units
few units

Fiberglass plate 350x150x0.5 mm
Fiberglass plate 350x150x0.5 mm

few units
few units

Tape GFK 50 mm
Tape GFK 50 mm

few units
few units

Conector FUTABA Servo male  (10 pcs)
Conector FUTABA Servo male (10 pcs)

few units
few units

Conector FUTABA Servo female BLUE silicon (10 pcs)
Conector FUTABA Servo female BLUE silicon (10 pcs)

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Big-Malibu XL Roof box with surfboard rack GREY
1 x 2,5x60 mm allen screwdriver
1 x Stainless steel cable Ø 0.52 mm - 15 kp (10 m)
1 x Coupling bush 5 - 5 mm
2 x Spinner NUT M6
1 x Civilian pilot "Joe" size 9cm (Slimline)
1 x CRACK YAK (Mini) 600 mm
1 x Kwik link AL M3 L:23 mm (2 pcs) + Pin Ø 1,6 mm
1 x Militarian pilot "Fly Boy" size 9cm (Slimline)
1 x Vacuum pump 12 CFM
1 x Ball link M2,5 (10 pcs)
1 x Round Rod 3,0x1000 mm
1 x Horn 6/20 with M3 Bearing
1 x Screwdriver for Torx® TX6
1 x Spinner NUT M10x1
1 x Field folding model stand
1 x Ball link V1 Ø7 M4/3 (6 uds)
1 x Horn 6/35 with M3 Bearing
2 x Aluminium coupler M2,5/2 with ball bearing (1 pcs)
1 x Straightened rod Ø 14.0 mm x 1000 mm
1 x Flap hinge (6 pcs)
1 x Distanzstück motor OS 120 AX
1 x 1/12 Pilot "Cougar"
1 x Glases Aspen
4 x 26 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x Brass control horn M2 short for wire (2 pcs)
1 x Crimping tool
1 x M2,5 Diam metal ball link V3 (2 pcs)
1 x PROXXON - SILICON CARBIDE BELTS FOR BSL 220/E
1 x 40 mm 1/4" Race propeller (rigth hydropropeller)
1 x Beech dowels 4.0 x 1000 mm
2 x 20x200 mm battery rings
1 x Spinner NUT 1/4x28
1 x Threaded coupler ALU M2 Ø 4 (2 uds)
1 x Pilot "Goose" (Slimline)
1 x Angled clevis with threaded rod M3
1 x Locking cable tie 3.2x142 (uds)
2 x Ball Link ALU M3 - RH (1 pcs)
1 x Field folding model stand SebArt
1 x 1/4 Pilot "Heidi"
1 x Spinner Alumin. fixed propeller 30 mm / 2,3 mm
2 x Ball link Aluminio M3 x 3 x 5 x 18mm (6 uds)
1 x Crimping tool
1 x Vertical cockpit anchor "tipe F3A" (2 pcs)
1 x Receiver replacement antenna, approx. 15
1 x Round Rod 2,5x1000 mm
1 x Horn 5/20 with M2 Bearing
1 x Vacuum pump P1-N
1 x Straightened rod Ø 1.0 mm x 1000 mm
1 x M2/M1/6 3Diam short black ball link V1 (2 pcs)
1 x Strip 2,0x2,0x330 mm
1 x Digital scale up to 40 kg
1 x 50N turbine start protection tube
1 x Tank BULL MØ1 4L (CMJets)
1 x L-39 Albatros 138"/3.5m lenght ARF
1 x Servo KST BLS825 V8.0 HV 35Kg 8.4v
1 x Gear set HITEC HS-645MG/5645MG/5685MH
1 x 1/12 Pilot "Tom"
1 x Red aluminium servo arm V1-Futaba 17 mm M2
1 x Futaba 54 mm servo arm with ball link
1 x Hitec 38 mm servo arm
1 x 1/4 Pilot "Mike"
1 x Spinner NUT M5
1 x HV6150 Digital Servo
1 x Servo MKS HV69
1 x Brazo servo MKS X8 Metal L:1.25/1.5 inc
1 x Servo KST X06H - 1.8Kg.cm 7mm 6g
1 x Gear set HITEC HS-311/322/325BB
1 x Servo KST DS125MG servo ala 10mm 28g 7Kg
1 x Servo HITEC HS-311
1 x Servo HITEC D645 MW
1 x 102 mm aluminium spinner
1 x 110x55 mm SLH KOVO wheel
1 x Red aluminium servo arm V1-Futaba 20 mm M2
1 x Hitec 46 mm servo arm with ball link
1 x Futaba 30 mm servo rounded arm
1 x Blue aluminium servo arm V1-Hitec 1,0" inch M2
1 x Futaba 20 mm servo arm
1 x Red aluminium servo arm V1-Futaba 15 mm iM2
1 x 120x60 mm SLH KOVO wheel
1 x Futaba 17 mm servo arm with ball link HITEC
1 x Red aluminium servo arm V2-Futaba 1,25" inch M3
1 x Red aluminium servo arm V1-Futaba 1,25" inch M3
1 x Futaba 76/92 mm servo pull-pull double arm with ball link HUB Al
1 x Red aluminium servo arm V1-Futaba 1,5" inch M3
1 x Gold aluminium servo arm V2-JR 1,25" inch M3
1 x FUTABA 20 mm servo arm with ball link
1 x Hitec 20 mm servo arm
1 x Gold aluminium servo arm V2-JR 1,0" inch M3
1 x 152x46 Ø6.0 mm aluminium core wheel
1 x 1/6 Pilot "Tony"
1 x Futaba 76/92 mm servo pull-pull double arm with ball link
1 x SCANNER 46-55 Sport Scale 1:7 ARF
1 x EDGE 540 V3 (Superlite) ORANGE
1 x Equipment set XL
1 x PIX Hawk with accesories
1 x Xplorer4 anemometro
2 x Foil for sticking flaps and ailerons
1 x Spinner Alumin. fixed propeller 40 mm / 4,0 mm
1 x GameCommander USB Universal
1 x PARAGON Trainer 46-55 1580 mm
1 x 10 mm gas motor standoff
1 x 1/12 Pilot "Fighter"
1 x Blue aluminium servo arm V1-Hitec 20 mm M2
1 x Blue metalic ball link M2/2 azul (2 pcs)
2 x Spikes Band (5 m)
2 x SE Ring 350 mm (2 pcs)
1 x Cable coupler M2 (10 uds)
1 x Ball link Aluminio M3 (6 uds) 27x11.9x5.9 mm
1 x Ball link M1.6 (6 uds)
1 x Long ball link M2 (6 uds)
1 x SE Ring 360 mm (2 pcs)
2 x Pad Screw Mount M3, up to 3mm / 0.12″, (10 pcs)
2 x 5 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x RUDDOG Protection and Heat Shield Tape (2mx50mm)
1 x Waterproof adhesive tape, width 19mm, length 25m
1 x Kwik link AL M3 L:30 mm (2 pcs) + Pin Ø 1,6 mm
1 x Clevis plastico I=26 mm / hole 2mm / pin 1 (2 pcs)
1 x Kwik link AL M3 L:40 mm (2 pcs) + Pin Ø 2,5 mm
1 x M2 5Diam short black ball link V2 (2 pcs)
1 x Short ball link M2 (6 uds)
2 x SE Ring 330 mm (4 pcs)
1 x SE Ring 450 mm (2 pcs)
1 x Short ball link M1.6 (6 uds)
1 x Aluminium red ball links M3 V1 (10 pcs)
1 x Ball link M3 (10 pcs, flat ball)
1 x Couple M4 for wire (10 pcs)
1 x SE Ring 200 mm (2 pcs)
1 x 
1 x 13 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x Cinta Goldfix 1m
1 x Marker ties (20 pcs)
1 x SE Ring HACKER 300 mm (2 pcs)
1 x SE Ring 480 mm (2 pcs)
1 x Tape GFK 25 mm
10,783.64EUR
Manufacturers
Languages
Español English
Currencies