59.00EUR

Glases Innovation Plus
[CMINNOVATIONP]



Set de gafas, cristales, funda y trapo
Do you have to wear prescription glasses? Fed up with seeing your buddies turn up at the field with great looking and practical glasses you just can't wear? We have the answer in the form of these stylish prescription model flying sunglasses, which have been especially developed for radio control model use.

At the heart of the design is a polycarbonate frame that houses your prescription lenses; this clips onto a main frame, which in turn houses the coloured shades that simply clip on to a hinged section. These hinges allow you to temporarily turn up the outer lenses in order to closely inspect a model in the pits etc.

Innovation Plus are polarised sunglasses. The polarised cristals greatly reduce glare, which is an effect caused by light hitting horizontally flat surfaces. Polarised lenses filter out this light to greatly enhance your visibility.

The de-centred, scratch resistant lenses have been optically balanced to negate the effects their curvature would otherwise have on your vision. Conforming to US ANSI Z80.3 plus British and European safety standard EN1836, our sunglasses are factory impact-tested, and offer great protection against flying debris should you suffer a mishap. All of our glasses carry the CE (European Union standard) compliance mark. The interchangeable lenses are: yellow (category 1) low light - these actually enhance light and contrast; beige (category 2) average sunlight; smoked mirror (category 3) bright sunlight; dark smoked (category 4), very bright conditions.

The glasses come with the interchangeable lenses, a cleaning cloth and a superb carry case with belt clip. All frames and the carry case display our 'Model Glasses' logo.

WILL THEY WORK FOR ME? - If you have a prescription (SPH) requirement that's less than plus or minus 4.00, our glasses will work just fine for you. Stronger prescriptions can cause distortion, due to the curvature of the tinted lenses when placed in front of the flat prescription clip. The de-centring calibration loses its effect where stronger prescriptions are required. If you have a requirement greater than plus or minus 4, please do not buy these glasses. Bi-focals, varifocals and prismatic lenses can be added - if in doubt, please consult your optician for advice.

IMPORTANT NOTE
When wearing Innovation Plus, some users may find they cannot see certain types of LCD or other electronic / digital transmitter displays. This is a normal cause of wearing polarised glasses. We recommend using the glasses with the front section flipped up, or the glasses removed, when model trimming prior to use.


few units
few units

Reviews

Customers who bought this product also purchased
MAX BEC
MAX BEC

few units
few units

Fiberglass plate 350x150x0.5 mm
Fiberglass plate 350x150x0.5 mm

few units
few units

Tape GFK 50 mm
Tape GFK 50 mm

few units
few units

Tape GFK 25 mm
Tape GFK 25 mm

few units
few units

Conector FUTABA Servo male  (10 pcs)
Conector FUTABA Servo male (10 pcs)

few units
few units

Conector FUTABA Servo female BLUE silicon (10 pcs)
Conector FUTABA Servo female BLUE silicon (10 pcs)

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x Glases Innovation Plus
2 x Glases Flitemaster
2 x Glases Nimbus "Black"
3 x Glases Nimbus
4 x Zurich Sport Sunglasse Dark Sensity BROWN Glasses
2 x Glases Stratus
3 x Zurich Sport Sunglasse Dark Sensity MAGENTA Glasses
2 x Glases Aspen
1 x Glases Moritz
1 x Extinguisher CO2 - 2 Kg
2 x CC 03
3 x Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm)
1 x 5 LiPo XH>EH adapter
3 x Glases Ace
1 x USB HLS prog. interface
1 x Cabel charger transmitter GRAUPNER
1 x Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH
2 x Balanceradapter JST-XH (Heli 47G) 2-6 c.
2 x Circlick securite
2 x TrainerCord (master-learner)
2 x Red copper lacquer wire Ø0,2 mm (5 m)
2 x CellPRO 4S Adaptader (GP/KO up to 4S)
1 x Futaba External voltage input cable Futaba CA-RVIN-700
2 x CC 05
2 x 3 LiPo XH>EH adapter
2 x Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm)
1 x Copper lacquer wire Ø0,2 mm (5 m)
1 x JETImodel SINGLE BEC
1 x DUPLEX USBa USB-Adapter for Jeti Duplex Items
1 x MPX-Dean "T" Adapter
1 x 30 cm BEC cable (female)
2 x CC 02
1 x 2 LiPo XH>EH adapter
2 x TP/TopFuel - JST-EH 4/5S Adapter
1 x 3 copper lacquer wire Ø0,2 mm (1 m)
1 x Balance "Y" Wire 6S, 2x JST-XH / 1x JST-EH
1 x Dean "T" - Futaba Adapter
1 x CM-3
1 x Connectors banna oro 8,0 mm (Male) 5 pcs.
1 x XH female balance (2S) connector (2 pcs)
1 x Connectors banna oro 8,0 mm (M/F)
1 x Connectors banna oro 2 mm (M/F)
1 x Connectors banana oro 6,0 mm Ultralight (M/F)
1 x Connectors DEANS 4 pins (1 pair)
1 x Gold antispark 4 mm plug
1 x 2 mm female connector (2 pcs) with safety connector
1 x Connectors banna oro 3,5 mm (M/F)
1 x MPX Sub-D Adaptor
1 x Banna gold connector 2,5 mm (100 M/F pairs)
1 x Connectors banna oro 0,8 mm (M/F)
1 x Conector BEC female (10 pcs)
1 x EC5-Set female, simple quality, 2 x female pin, 1 x blue housing
1 x Connectors banna gold 5,5 mm (M/F)
1 x Connectors banna oro 6,0 mm (M/F)
1 x XH male balance (2S) connector (2 pcs)
1 x XH female balance (4S) connector (2 pcs)
1 x XH female balance (3S) connector (2 pcs)
1 x Round Rod 6,0x1000 mm
1 x Dust collector for mould cleaning
1 x Spray EC Red 400ml
1 x Joint with bearing M3 22x5,5
3 x USB interface ALTIS
2 x 30 cm BEC cable (male)
2 x TP/TopFuel - XH 2/3S Adapter
2 x Connector CAN 15
1 x Connector Sub-D 2+5 Male
2 x SPS 70V 140/280 A
2 x Opto Gas Engine Kill Switch
1 x Female prolonguer XH 30 cm 6 cell cable of silicone 0,25 mm
2 x Multi-adapter balancer JST - TP
2 x Extension 6 lipos XH > EH
1 x Interruptor SPS 70v 60/120A
2 x Interruptor RX/Batterie
1 x Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH
1 x resin-hardener L-385 H-385 (5000 g)
1 x Hardener Aero EPH 161 (500 g)
1 x White gelcoat 1 Kg
1 x resin-hardener package L-385 with hardener H-385 (3.5 Kg)
1 x resin-hardener package L-385 with hardener H-385 (875 g)
1 x 
1 x GlassBubbles 2.5 g/cm³ Panda, tin (approx. 1 l)
1 x resin-hardener package L-385 with hardener H-385
1 x Glass Bubbles 0.20 g/cm³ Panda, tin/ 100 g (approx. 1 l)
1 x Glass Bubbles (0.12g) 400 G (aproxx 3.3 l)
1 x Epoxy Resin L + Hardener CL (60 min) kit/ 930 g
1 x Alignment dowels (2 parts, outer-Ø 8 mm) bag/ 100 pairs
1 x Epoxy Resin L (2.5 Kg)
1 x Thixotropic agent TM 100, tin/ 75 g (approx. 1 l)
1 x BEC 3A FOXY
1 x Jet Afterburner Simulator NF-Jet1RY Set
1 x NF-3XL set
1 x Jet Afterburner Simulator NF-Jet2
1 x Jet Afterburner Simulator NF-Jet3 RY
1 x NF-3m Heli Kit
1 x Lense for Spotlights, 20mm
1 x Aluminun wheel collar 6 mm Ø (4 uds)
1 x 48 mm cylidric hinge Ø 2,5 mm (5 pcs)
1 x Paramotor BackPack XXS (without accessories)
1 x Parachute BACKUP X100
1 x 8Wx2 Navigation & Strobe, 11mm Green/White
1 x NF-3 RC set
1 x MPX Support
1 x XT-60 connector (female)
1 x XH LiPo extension lead
1 x Magnetic Interruptor MULTIPLEX
2 x Male Prolonger TP 4/5S
1 x Extension 2/3 lipos JST - JST/C
1 x Male connector JST SH 1.0mm with 10 cm wire
1 x Male connector for 6 pines AWG
1 x Connector Sub-D 2+5 Female
1 x PSC 5
1 x ESC Ripmax QUANTUM 80A SBEC
1 x MPS Gas-Cap-Powerswitch
1 x Switching module high voltage SXH
1 x MAX BEC 2D plus EX
1 x SPS 70V 100/200 A
1 x Servo slow down unit (0,7-14,7 sec )
1 x SBEC 40
1 x UBEC 6A KAVAN
1 x Long Switch On/Off micro
1 x MAX BEC
1 x PowerBox SparkSwitch RS
1 x MAX BEC 2
1 x Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm)
1 x Male/Female prolonguer for Balancer Thunder Power 6S
1 x Extension 5 lipos JST - JST/C
1 x FesEx-Uni6 System
1 x Female connector for 6 pines AWG
1 x Extension 2/3 lipos JST/C
1 x Black copper lacquer wire Ø0,2 mm (5 m)
1 x "Y" charging 4mm wire (2 IN-1 OUT).
1 x Female connector JST SH 1.0mm with 10 cm wire
1 x Bec MR UBEC 5A (5v/6v/7v)
1 x XCALIBUR Fuel Tank with built in UAT
1 x ALPHA 1000mm BL ARTR
1 x JSM U/C Leg Springs for XCALIBUR (Pr) (6-12Kg)
1 x Tyres 70 mm Xclaibur (2 pcs)
6,515.98EUR
Manufacturers
Languages
Español English
Currencies