59.00EUR

Glases Innovation Plus
[CMINNOVATIONP]



Set de gafas, cristales, funda y trapo
Do you have to wear prescription glasses? Fed up with seeing your buddies turn up at the field with great looking and practical glasses you just can't wear? We have the answer in the form of these stylish prescription model flying sunglasses, which have been especially developed for radio control model use.

At the heart of the design is a polycarbonate frame that houses your prescription lenses; this clips onto a main frame, which in turn houses the coloured shades that simply clip on to a hinged section. These hinges allow you to temporarily turn up the outer lenses in order to closely inspect a model in the pits etc.

Innovation Plus are polarised sunglasses. The polarised cristals greatly reduce glare, which is an effect caused by light hitting horizontally flat surfaces. Polarised lenses filter out this light to greatly enhance your visibility.

The de-centred, scratch resistant lenses have been optically balanced to negate the effects their curvature would otherwise have on your vision. Conforming to US ANSI Z80.3 plus British and European safety standard EN1836, our sunglasses are factory impact-tested, and offer great protection against flying debris should you suffer a mishap. All of our glasses carry the CE (European Union standard) compliance mark. The interchangeable lenses are: yellow (category 1) low light - these actually enhance light and contrast; beige (category 2) average sunlight; smoked mirror (category 3) bright sunlight; dark smoked (category 4), very bright conditions.

The glasses come with the interchangeable lenses, a cleaning cloth and a superb carry case with belt clip. All frames and the carry case display our 'Model Glasses' logo.

WILL THEY WORK FOR ME? - If you have a prescription (SPH) requirement that's less than plus or minus 4.00, our glasses will work just fine for you. Stronger prescriptions can cause distortion, due to the curvature of the tinted lenses when placed in front of the flat prescription clip. The de-centring calibration loses its effect where stronger prescriptions are required. If you have a requirement greater than plus or minus 4, please do not buy these glasses. Bi-focals, varifocals and prismatic lenses can be added - if in doubt, please consult your optician for advice.

IMPORTANT NOTE
When wearing Innovation Plus, some users may find they cannot see certain types of LCD or other electronic / digital transmitter displays. This is a normal cause of wearing polarised glasses. We recommend using the glasses with the front section flipped up, or the glasses removed, when model trimming prior to use.


few units
few units

Reviews

Customers who bought this product also purchased
MAX BEC
MAX BEC

few units
few units

Fiberglass plate 350x150x0.5 mm
Fiberglass plate 350x150x0.5 mm

few units
few units

Tape GFK 50 mm
Tape GFK 50 mm

few units
few units

Tape GFK 25 mm
Tape GFK 25 mm

few units
few units

Conector FUTABA Servo male  (10 pcs)
Conector FUTABA Servo male (10 pcs)

few units
few units

Conector FUTABA Servo female BLUE silicon (10 pcs)
Conector FUTABA Servo female BLUE silicon (10 pcs)

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Silent-blocks DLE 170M
2 x Small Crow DLE-170M
3 x Motor DLE 170 M- Paramotors
2 x Propeller FALCON 32,5x11 PUSHER Carbono
2 x Big Crow DLE-170M
2 x Motor DLE 200cc Premium Muffler
3 x Motor DLE 430 cc - Paramotors
1 x METEOR 1.000 mm kit
1 x Softshell Hispano Aviación
1 x Motor DLE 200cc Std
1 x DLE Ignition unit
1 x Spark motor OS nº 8
1 x Spark motor OS nº 3
1 x SE Ring 400 mm (2 pcs)
1 x silicon 100 cm Futaba Extension Ø 0,35 mm
1 x SE Ring 250 mm (2 pcs)
1 x Brass hexagonal rod Ø 3 mm x 1000 mm
1 x Brass rod Ø 1.0 mm x 1000 mm
1 x Support Pitot JETI
1 x Canopy Lock V1 M3 Red (2 pcs)
1 x BEC 3A FOXY
1 x Prolongador S-Bus JR/JR 10cm
1 x Strip 1,5x1,5x330 mm
1 x TrainerCord (master-learner)
1 x Glases Stratus
1 x Premium servo extension 75cm
1 x Carbon fiber flat 1000x3.0x1.0 mm
1 x Glases Flitemaster
2 x Support conector MPX (6 pcs)
1 x Spray YELLOW Inca Lexan 150ml
1 x 20x1000 mm Ring Strap Back To Back
1 x Soporte grifo FESTO vertical (1 pcs)
1 x CC 03
1 x Towing hook
1 x Cut tube
1 x 2,0x50 mm allen screwdriver
1 x Cable S.BUS 3 salidas 100 mm
2 x Extension silicon 30 cm male (Futaba)
1 x ABS Strip 1.0x5.0x1000 mm
1 x Pad Screw Mount M3, up to 3mm / 0.12″, (10 pcs)
1 x Threaded coupler ALU Left M2,5 Ø 4 (2 uds)
1 x Towing hook
1 x Hobbylite Filler, Balsa colour
1 x Universal Colour Paste deep black 50 g
1 x Z Bender - S Type Tool
1 x 3 copper lacquer wire Ø0,2 mm (1 m)
2 x Black copper lacquer wire Ø0,2 mm (5 m)
1 x Copier 2x20 cm pcs
1 x Cap closure 33/23.5mm (2 uds)
1 x USB HLS prog. interface
1 x Canopy Latch
1 x Red copper lacquer wire Ø0,2 mm (5 m)
1 x 26 mm self adhesive Pinking Tape, saw tooth height 1.0 mm
1 x ABS Strip 1.0x2.0x1000 mm
1 x PROXXON - SANDING BELTS FOR BSL 220/E 120 GRIT (5 pcs)
1 x Round Rod 5,0x1000 mm
1 x Steering arm 16 mm Ø 3 mm
1 x ABS I Strip 10x5x1000 mm
2 x Squared carbon wing joinner 5x5x220 mm
1 x LH long black aluminium horn L31xH30 (2pcs)
1 x 
1 x Carbon fiber rod 20 mmx1000 mm
2 x Screwdriver for Hexagon 1,5mm
1 x Support Antena 2.4 Ghz (2 pcs)
1 x Support FUEL DOT V3
1 x CC 02
1 x Micro screw-lock pushrod conn snap Ø 1 mm (2 uds)
2 x 200 mm extensión servo HITEC/JR
1 x Brass hexagonal rod Ø 4 mm x 1000 mm
1 x Premium servo extension 25cm
1 x SUS wire 3m (nylon coated)
1 x Horizontal cockpit anchor "tipe F3A" (2 pcs)
1 x Horn 5/10 with M2 Bearing
1 x Carbon fiber rod 0.5 mmx1000 mm
1 x 5 LiPo XH>EH adapter
1 x Strip 3,5x1,75x330 mm
1 x Bungee HLG Premium
1 x Dean "T" - Futaba Adapter
1 x Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH
1 x Interface Realflight Simulator
1 x Small aluminium horn red (2pcs)
1 x Premium servo extension 50cm
1 x Release wax 250ml
1 x Stainless steel cable Ø 0.88 mm - 60 kp (10 m)
1 x Glases Nimbus "Black"
1 x Pasacables rectangular 40x15 mm (4 pcs)
1 x 13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x Universal Colour Paste deep black 250 g
1 x SE Ring 240 mm (2 pcs)
1 x Antonov AN2 Scale 1/6 - 3m
1 x Extension silicon 10 cm (Futaba)
1 x Plasti Dip Liquid Tape 429 ml black
1 x DUPLEX USBa USB-Adapter for Jeti Duplex Items
1 x Balance "Y" Wire 7S, 2x JST-XH / 1x JST-EH
1 x Crimping tool
1 x Stainless steel cable Ø 1.3 mm (10 m)
1 x Hot Glue Stick BLACK
1 x Zurich Sport Sunglasse Dark Sensity BROWN Glasses
1 x Strip 2,0x2,0x330 mm
1 x Marker ties (20 pcs)
1 x Futaba male 40 cm extension
1 x Painting GHT Lexan Black 150 ml
1 x Carbon fiber rod 6.0 mmx1000 mm
1 x Carbon fiber rod 4.0 mmx1000 mm
1 x Steering arm 16 mm Ø 4 mm
1 x Crimping tool
1 x Kit wheel loader 966G II without electrics, without hydrauli
1 x Complete kit CAT 966G II WEDICO-construction-models
1 x FESTO Polyurethan tube for turbine 4x2,5x1000 mm (transparent)
1 x Epoxy Resin L 285 + Hardener 386, kit/ 675g
1 x resin-hardener package L-385 with hardener H-385 (875 g)
1 x Propeller electric carbon 8.5x6
1 x Sealing Iron Sleeve STD
1 x Quick hose connector 4-3 mm
1 x PT 16x10 E Propeller
1 x Straightened rod Ø 3.0 mm x 1000 mm
1 x Transmitter Balancer Futaba FF9-DX7-JR-Hitec
1 x Thixotropic agent TM 100, tin/ 415 g (approx. 5 l)
1 x Cable set PREMIUM, SUB-Done 4three fuselage/wing 160 cm
1 x servo adapter lead, JST-SH socket - JR male Pin, for GR-12SH+HoT
1 x Pump hose (Ø 6/8 mm) transparent
1 x Cable silicona female batt. receptor 30 cm (Futaba)
1 x Mold plugs XT-90
1 x Fabric scissors curved Premium, 16 cm / 6" length
1 x White gelcoat 1 Kg
1 x Brass hexagonal rod Ø 3.5 mm x 1000 mm
1 x 
1 x Carbon fiber flat 1000x3.0x1.0 mm
1 x Tapa estado carga XT-60 (6 pcs)
1 x Heat Seal Iron
1 x Interruptor SAFET-SWITCH 12HV Twinbatt
1 x EWC6 40 cm wing connector
1 x Female connector for 10 pines AWG
1 x Support ECU Xicoy X-45
1 x Mini-handed clamp
1 x Combustible Glow "KAVAN" air/heli 10% nitro
1 x Heli blades angle measurer
1 x Carbon fiber rod 1.5 mm x 2000 mm
1 x Laminating brush 10 mm, pack/ 50 pcs
1 x Brass rod Ø 1.5 mm x 1000 mm
1 x DPSI magnetic switch actuator (housing)
1 x Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm)
1 x Extension lead 15 cm Multiplex
1 x Prolongador S-Bus JR/JR 20cm
1 x Straightened rod Ø 0.8 mm x 1000 mm
1 x HPP-21 PLUS PC Programmer for Hitec Digital Servos
1 x Extension 15 cm (Futaba)
1 x Straightened threaded rod M3 - 1m
1 x resin-hardener L-385 H-385 (1250 g)
1 x Boxed KIT OF 7 Rotary Burrs FINE
1 x Epoxy Resin L (2.5 Kg)
1 x "Y" charging 4mm wire (2 IN-1 OUT).
1 x PROXXON - SANDING BELTS FOR BSL 220/E 80 GRIT (5 pcs)
1 x Straightened rod Ø 14.0 mm x 1000 mm
1 x Brass rod Ø 0.5 mm x 1000 mm
1 x SERVO HOLDER
1 x Carbon fiber rod 0.5 mmx1000 mm
1 x Carbon fiber rod 3.0 mm x 1000 mm
1 x Cabling for Fox MDM1 wings
1 x 4 LiPo XH>EH adapter
41,064.88EUR
Manufacturers
Languages
Español English
Currencies