59.00EUR

Glases Innovation Plus
[CMINNOVATIONP]



Set de gafas, cristales, funda y trapo
Do you have to wear prescription glasses? Fed up with seeing your buddies turn up at the field with great looking and practical glasses you just can't wear? We have the answer in the form of these stylish prescription model flying sunglasses, which have been especially developed for radio control model use.

At the heart of the design is a polycarbonate frame that houses your prescription lenses; this clips onto a main frame, which in turn houses the coloured shades that simply clip on to a hinged section. These hinges allow you to temporarily turn up the outer lenses in order to closely inspect a model in the pits etc.

Innovation Plus are polarised sunglasses. The polarised cristals greatly reduce glare, which is an effect caused by light hitting horizontally flat surfaces. Polarised lenses filter out this light to greatly enhance your visibility.

The de-centred, scratch resistant lenses have been optically balanced to negate the effects their curvature would otherwise have on your vision. Conforming to US ANSI Z80.3 plus British and European safety standard EN1836, our sunglasses are factory impact-tested, and offer great protection against flying debris should you suffer a mishap. All of our glasses carry the CE (European Union standard) compliance mark. The interchangeable lenses are: yellow (category 1) low light - these actually enhance light and contrast; beige (category 2) average sunlight; smoked mirror (category 3) bright sunlight; dark smoked (category 4), very bright conditions.

The glasses come with the interchangeable lenses, a cleaning cloth and a superb carry case with belt clip. All frames and the carry case display our 'Model Glasses' logo.

WILL THEY WORK FOR ME? - If you have a prescription (SPH) requirement that's less than plus or minus 4.00, our glasses will work just fine for you. Stronger prescriptions can cause distortion, due to the curvature of the tinted lenses when placed in front of the flat prescription clip. The de-centring calibration loses its effect where stronger prescriptions are required. If you have a requirement greater than plus or minus 4, please do not buy these glasses. Bi-focals, varifocals and prismatic lenses can be added - if in doubt, please consult your optician for advice.

IMPORTANT NOTE
When wearing Innovation Plus, some users may find they cannot see certain types of LCD or other electronic / digital transmitter displays. This is a normal cause of wearing polarised glasses. We recommend using the glasses with the front section flipped up, or the glasses removed, when model trimming prior to use.


few units
few units

Reviews

Customers who bought this product also purchased
Fiberglass plate 350x150x0.5 mm
Fiberglass plate 350x150x0.5 mm

few units
few units

Tape GFK 50 mm
Tape GFK 50 mm

few units
few units

Tape GFK 25 mm
Tape GFK 25 mm

few units
few units

MAX BEC
MAX BEC

few units
few units

Conector FUTABA Servo male  (10 pcs)
Conector FUTABA Servo male (10 pcs)

few units
few units

Conector FUTABA Servo female BLUE silicon (10 pcs)
Conector FUTABA Servo female BLUE silicon (10 pcs)

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x BOSCH spark plug cap for DA 50-R, DA 100 and DA 150
2 x ‎Reed valve for DA-60/70
2 x Carburetor for DA150L/170
1 x Cylinder for DA-60 and DA-120
2 x Carburator spacer block DA-50R
1 x Hifht speed needle DA-50R/100I
2 x Cylinder DA-50R, DA-100, DA-100L
2 x Piston pin for DA-60 DA-120
1 x Piston pin for DA50R/DA100
1 x Ignition for DA-50-R, DA-60, DA-85
1 x Ignition unit for DA-70/100/120/150/170/200
1 x L ELBOW 90º ø 25 mm
1 x Reed valves, set DA-100/150/150L/170
2 x Reed valve carrier, without reed valves DA-150L/170
1 x L ELBOW DA-120 long (2 pcs)
2 x Stainless steel silencer for DA 150/150L
1 x Stainless steel silencer for DA 150/150L
1 x Pick up DA50/100/150
1 x Piston ring for DA-60 and DA-120
1 x Reed valve for DA 50-R
1 x Prop washer DA-50R/60/70
1 x Carburador DA-35, DA-50R-DA-100L , VM-60/70
2 x 2000A 12V Lithium Jump Starter with 150PSI Air inflator
1 x 
1 x Air filter MOKI
1 x Carburator gasket MOKI
1 x Motor Moki 180
2 x Motor Moki S 400 cc 5 cylinders
1 x Moki Exhaust Bend 200 mm
1 x Moki Pushrod S250 (1 pcs)
1 x Flange gasket MOKI carburetor
1 x Baffles for Radial Moki S180/320 mm
1 x Moki Carburetor Throttle Arm with Extension
1 x Motor MOKI S 350 cc 7 cylinder
1 x Moki Exhaust Bend 50VT
1 x Carburator Moki S 180
1 x Carburator Moki S250
1 x Motor Mount for TITAN ZG45 and ZG62, length 36 mm
1 x Silencer kit ZG 45/62
1 x Gasket Carburetor-Insulator ZG22/23/26/ZG231/G2D96-D/G230R
1 x Motor DA 150
1 x Gasket, Carburetor DA-150/170
1 x DA-50R Prop Hub
1 x Giant Scale Muffler D.A. 70 (2pcs)
1 x Carb spacer mounting block ,red DA-60/70
2 x Hifht speed needle DA-50R/100I
1 x Junta humo metalica G85 (DLE85/DLE170)
1 x Sparkplug 1/4-32 EVO 10GX
1 x Sparkplug 1/4-32
1 x Exhaust elbow for SAITO FA65/72/80/82a/91S/100/
1 x Junta humo metalica G30 (DLE30/DLE60)
1 x Spring clamp for tube Ø29 mm ext 1pc
1 x Sparkplug ROSSI R8
1 x Sparkplug NGK CM6
2 x Rear crankcase DA-50R
1 x Motor NGH GF30
1 x Motor holder for AC 28/7
1 x Straightened rod Ø 6.0 mm x 1000 mm
1 x Spare spinner 40/42 mm 3-Bl
1 x Cable coupler M2 (10 uds)
1 x Oratex Red Fokker 10 m
1 x Motor NGH GF 150 R5
1 x Gasket, insulator ZG 20
1 x Blades 330mm
1 x Central piece 42 mm 0º [6 mm]
1 x Header ZG 45/62, "wide"
1 x BOSCH spark plug cap for ZG 26SC/SCM, 231SLH, G230RC
1 x Piston ring for ZG 26SC/EI, ZG 26SCM ZG 26SLH and Zenoah G260RC/
1 x Motor GAUI F-50
1 x Gasket intake manifold - cylinder for ZG 74B/ZG 80G
1 x Sparkplug Champion RCJ-7Y for ZG
1 x Propeller POWER-PROP 7x7
1 x Motor GAUI F-50R (rear intake)
1 x 
1 x Low speed needle DA-50R/100I
1 x Cylinder for DA-85/170 (1 piece)
1 x Bearing upper rod DA-50R, DA-60, DA-100, DA-100L, DA-120
1 x Motor DLE 200cc Std
1 x Propeller FALCON 32,5x11 PUSHER Carbono
1 x Motor DLE 430 cc - Paramotors
1 x ESC 40A. Opto starter Kolm
1 x Engine Kolm BX-155-2 with starter
1 x Cylinder EME 35 cc
1 x Selfstarr DLE55, EME55/60, DLA56, SE 55
1 x Piñon motor autostarter 60cc
1 x Crankcase gasket DA 170
1 x Eachine EV800D 5 Inches 800x480 FPV VR Goggles Monitor
1 x 3-blades 20x10 carbon prop Super Silence
1 x 
1 x Spare white 38-45 mm spinner
1 x ARAMID honeycomb 1300x2600x2 mm
1 x 30 cm BEC cable (male)
1 x Oracover White 10 m
1 x Round Rod 6,0x1000 mm
1 x Protective Cover for wires Ø 10 mm 1000 mm
1 x Cabel charger transmitter GRAUPNER
1 x Walnut wood slat 2.0x2.0x1000 mm
1 x 1/4 Pilot "Mike"
1 x Kwik link AL M3 L:40 mm (2 pcs) + Pin Ø 2,5 mm
1 x 4 mm M3 red control terminal (4 pcs)
1 x Horn 5/20 with M2 Bearing
1 x BALSA triangular 6x6x1000 mm
1 x Glases Flitemaster
1 x Carbon fabric 160 g/m² (plain weave) 100 cm x 2 m
1 x Oracover Azul 2 m
1 x 50 mm white plastic spinner for folding propeller
1 x Prop rubber XS set 4 pieces
1 x Cable servo PREMIUM MAXI 200m (blanco/rojo/azul) PVC
1 x 5 line servos wire black (1 m)
1 x Carbon fibre tape 125 g/m², 3k, UD (50 mm) roll/ 10 m
1 x Horn 6/20 with M3 Bearing
1 x Medidor ángulos y/o incidencias
1 x Brass rod Ø 0.5 mm x 1000 mm
1 x 152x46 Ø6.0 mm aluminium core wheel
1 x Ball Link M2 with Ball and Hardware, 10 pcs
1 x Cable control set
1 x Spinner propeller pleg. 36 mm/6,0 mm/5º
1 x Straightened rod Ø 5.0 mm x 1000 mm
1 x 200 mm extensión servo HITEC/JR
1 x BALSA triangular 8x8x1000 mm
1 x Horn F3A de Titanium 16 mm (2 units)
1 x Spinner propeller pleg. 45 mm / 6,0 mm
1 x ABS Strip 1.0x5.0x1000 mm
1 x 1/6 Pilot "Tony"
1 x Protective open Cover for wires Ø 13 mm 1000 mm
1 x Crimping sleeves for 1.1 mm cable (10 pcs)
1 x Spinner propeller pleg. 38 mm/6,0 mm/7º
1 x Control horn long w/ball
1 x Support XT60 conector (2 pcs)
1 x Horn for flap control (1 pcs)
1 x Horn 5/15 with M2 Bearing
1 x Ball Link ALU M3 - RH (1 pcs)
1 x Oracover Azul Cielo 2 m
1 x 1/10 Pilot "Jack"
1 x Vasa model Catapult
1 x IKARUS plane
1 x Central piece 42 mm 0º
1 x Adapter lead MPX/EC3
1 x 1/7 Pilot "Japanese"
1 x Angle of incidence meter
1 x Field folding model stand
1 x 1/10 Pilot "Jimmy"
43,039.56EUR
Manufacturers
Languages
Español English
Currencies