59.00EUR

Glases Innovation Plus
[CMINNOVATIONP]



Set de gafas, cristales, funda y trapo
Do you have to wear prescription glasses? Fed up with seeing your buddies turn up at the field with great looking and practical glasses you just can't wear? We have the answer in the form of these stylish prescription model flying sunglasses, which have been especially developed for radio control model use.

At the heart of the design is a polycarbonate frame that houses your prescription lenses; this clips onto a main frame, which in turn houses the coloured shades that simply clip on to a hinged section. These hinges allow you to temporarily turn up the outer lenses in order to closely inspect a model in the pits etc.

Innovation Plus are polarised sunglasses. The polarised cristals greatly reduce glare, which is an effect caused by light hitting horizontally flat surfaces. Polarised lenses filter out this light to greatly enhance your visibility.

The de-centred, scratch resistant lenses have been optically balanced to negate the effects their curvature would otherwise have on your vision. Conforming to US ANSI Z80.3 plus British and European safety standard EN1836, our sunglasses are factory impact-tested, and offer great protection against flying debris should you suffer a mishap. All of our glasses carry the CE (European Union standard) compliance mark. The interchangeable lenses are: yellow (category 1) low light - these actually enhance light and contrast; beige (category 2) average sunlight; smoked mirror (category 3) bright sunlight; dark smoked (category 4), very bright conditions.

The glasses come with the interchangeable lenses, a cleaning cloth and a superb carry case with belt clip. All frames and the carry case display our 'Model Glasses' logo.

WILL THEY WORK FOR ME? - If you have a prescription (SPH) requirement that's less than plus or minus 4.00, our glasses will work just fine for you. Stronger prescriptions can cause distortion, due to the curvature of the tinted lenses when placed in front of the flat prescription clip. The de-centring calibration loses its effect where stronger prescriptions are required. If you have a requirement greater than plus or minus 4, please do not buy these glasses. Bi-focals, varifocals and prismatic lenses can be added - if in doubt, please consult your optician for advice.

IMPORTANT NOTE
When wearing Innovation Plus, some users may find they cannot see certain types of LCD or other electronic / digital transmitter displays. This is a normal cause of wearing polarised glasses. We recommend using the glasses with the front section flipped up, or the glasses removed, when model trimming prior to use.


few units
few units

Reviews

Customers who bought this product also purchased
Tape GFK 25 mm
Tape GFK 25 mm

few units
few units

MAX BEC
MAX BEC

few units
few units

Fiberglass plate 350x150x0.5 mm
Fiberglass plate 350x150x0.5 mm

few units
few units

Tape GFK 50 mm
Tape GFK 50 mm

few units
few units

Conector FUTABA Servo male  (10 pcs)
Conector FUTABA Servo male (10 pcs)

few units
few units

Conector FUTABA Servo female BLUE silicon (10 pcs)
Conector FUTABA Servo female BLUE silicon (10 pcs)

few units
few units

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x ABS "T" angle 2.0x2.0x1000 mm
2 x Profile ABS triangular 4.0x1000 mm 90º
1 x Profile ABS triangular 2.0x1000 mm 90º
3 x ABS rectangular profile 10x5.0x1000 mm
1 x Profile ABS half cane 2.5x1000 mm
1 x Rubber profile 8-2 mm 2M
3 x Profile ABS half cane 2.0x1000 mm
1 x Profile ABS triangular 6.0x1000 mm 90º
1 x Rubber profile 10-2 mm 2M
1 x Cross Connector 4.0 mm x 1000 mm
2 x ABS "T" angle 4.0x4.0x1000 mm
2 x ABS angle 10,0x10,0x1000 mm
1 x Streamline Stainless Steel Tubing 10.5x5.7x1000 m
1 x Rubber profile 6-2 mm 2M
3 x ABS "T" angle 6.0x6.0x1000 mm
1 x Profile ABS half cane 8.0x1000 mm
1 x Profile ABS half cane 5.0x1000 mm
2 x L-Connector 4.0 mm x 1000 mm
3 x Profile ABS Square 2 x 1000 mm
1 x Profile ABS half cane 4x1000 mm
1 x ABS "T" angle 10.0x10.0x1000 mm
2 x Profile ABS triangular 4.0x1000 mm 60º
2 x Profile ABS half cane 3x1000 mm
1 x ABS angle 1.5x1.5x1000 mm
2 x Flat Connector 4.0 mm x 1000 mm
1 x Profile ABS Square 1 x 1000 mm
1 x ABS angle 3,0x3,0x1000 mm
2 x Profile ABS half cane 4x2.5x1000 mm
1 x Profile ABS half cane 6.0x1000 mm
3 x ABS "T" angle 8.0x8.0x1000 mm
1 x ABS angle 6,0x6,0x1000 mm
1 x U Profile ABS 8,0x4,0x1000 mm
1 x U Profile ABS 1,0x2,0x1000 mm
1 x Profile ABS Square 3 x 1000 mm
1 x ABS rectangular profile 12x6.0x1000 mm
1 x Profile ABS Square 4 x 1000 mm
1 x U Profile ABS 5,0x10,0x1000 mm
1 x L-Connector 1.0 mm x 1000 mm
1 x ABS angle 5,0x5,0x1000 mm
1 x Digital Air Speed Sensor And Pitot Tube Set
1 x Tube Pitot to PIXHAWK
1 x ABS angle 4,0x4,0x1000 mm
1 x U Profile ABS 3,0x6,0x1000 mm
1 x PIX Hawk with accesories
1 x ABS angle 2,0x2,0x1000 mm
1 x TrainerCord (master-learner)
2 x 30 cm BEC cable (female)
1 x CM-3
1 x 30 cm BEC cable (male)
1 x Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH
1 x APM2.6 Power module with 5.3V DC BEC
1 x CC 02
2 x Cabel charger transmitter GRAUPNER
1 x JETImodel SINGLE BEC
1 x TP/TopFuel - JST-EH 4/5S Adapter
1 x Balance "Y" Wire 6S, 2x JST-XH / 1x JST-EH
1 x 3 copper lacquer wire Ø0,2 mm (1 m)
1 x Cabel charger battery transmiter Futaba 2x0,5 qmm (50 cm)
1 x 5 LiPo XH>EH adapter
1 x DUPLEX USBa USB-Adapter for Jeti Duplex Items
1 x "Y" charging 4mm wire (2 IN-1 OUT).
1 x Futaba External voltage input cable Futaba CA-RVIN-700
1 x BEC 3A FOXY
1 x CC 05
1 x MPX-Dean "T" Adapter
1 x CC 03
1 x Adapter lead MPX/XT60
1 x Bec MR UBEC 5A (5v/6v/7v)
1 x Dean "T" - Futaba Adapter
1 x 48 x 10 mm cylidric hinge Ø 3,0 mm (10 pcs)
1 x 18 mm reinforced hinge
1 x Cylidric hinge 43 mm Ø 2,5 mm (5 pcs)
1 x White silicone 0,25 qmm wire (150 m)
1 x PVC 0,25 qmm servos wire Graupner (5 m)
1 x PVC 0,35 qmm servos wire Graupner (100 m)
1 x Pin type hinge Al 6x98 mm (2 pcs)
1 x Cabel PVC 2 x 0.25 mm2 (5 m) red-black
1 x Gates hinge aluminium (1 pcs)
1 x Unmounted aluminium pin 6x98 mm (2 pcs)
1 x Cylidric hinge 33 mm Ø 2 mm (5 pcs)
1 x Pin type hinge Al 3,0x50 mm demount (2 pcs)
1 x White silicone 0,25 qmm wire (100 m)
1 x Carbon fiber rod 7.0 mmx1000 mm
1 x 1 m servo "Premium" wire (white/red/blue)
1 x Cable Cargador FUTABA
1 x Silicone 0,25 qmm servos wire Graupner (100 m)
1 x 200m servo "Premium" wire (white/red/blue)
1 x Carbon fiber rod 2.0 mmx1000 mm
1 x Nylon hinge 20x20x0,3 (10 pcs)
1 x Carbon fiber flat 1000x3.0x0.5 mm
1 x Long pinned hinge (12 uds)
2 x 48 mm cylidric hinge Ø 2,5 mm (5 pcs)
2 x Nylon hinge for flaps/gates 27x10,5 (2 pcs)
2 x Carbon fiber rod 3.0 mm x 1000 mm
1 x White silicone 0,25 mm² wire (25 m)
1 x Long pinned hinge (6 uds)
1 x PVC 0,25 qmm 4 line servos wire JR/Graupner (5 m)
1 x Carbon fiber flat 1000x3.0x1.0 mm
1 x Pin type hinge Al 4,5x70 mm (2 pcs)
1 x Carbon fiber rod 0.5 mmx1000 mm
1 x Cable servo PREMIUM MAXI 1 m (blanco/rojo/azul) PVC
1 x 15 mm reinforced hinge
1 x PVC 0,14 qmm servo wire Futaba (5 m)
1 x PVC 0,14 qmm servos wire JR/Graupner (5 m)
1 x Nylon hinge for flaps 33x9 (2 pcs)
1 x Carbon fiber rod 1.5 mm x 2000 mm
2 x Squared carbon wing joinner 5x5x220 mm
1 x Carbon fiber rod 1.5 mm x 1000 mm
1 x Jeti Black cap
1 x PARTALL® Hi-Temp Wax, 340 g
1 x Wing-connector: Glass / Carbon tube (26.5/25 x 25/23) x 1000 mm
1 x PPM Encoder Module
2 x Medium pin type hinge (12 uds)
1 x XH 30 cm Female extension 0,25 mm2 silicone cable for 4 cell
1 x Silicone black 0,5 qmm wire ( 1 m)
1 x Carbon fiber rod 10 mm x 1000 mm
1 x Pin type hinge Al 3,0x50 mm (2 pcs)
1 x XH 30 cm Male extension 0,25 mm2 silicone cable for 3 cell
1 x 76 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs)
1 x Silicone black 4,0 qmm wire (25 m)
1 x Carbon fiber rod 8.0 mmx1000 mm
1 x 67 x 12 mm cylidric hinge Ø 4,5 mm (10 pcs)
1 x Fast'n EZ-CA-Hinge, lite (12 uds)
1 x Carbon fiber rod 16 mm x 1000 mm
1 x M2,5 5Diam black ball link V2 (2 pcs)
2,097.83EUR
Manufacturers
Languages
Español English
Currencies