40.00EUR

NF-3m Heli Kit
[NF-3m Heli Kit]


The NF-3m Heli Kit is unit with cables and LEDs ready to install into an indoor helicopter. Length of cables correspond to models like EasyCopter, Blade or Lama. There are 6 lights (LEDs 3mm) installed : two position lights (Red and Green), two flashing lights (Red and White) and two landing lights (White).

NF-3m Heli Kit has cable into a receiver. This is ready to work with helicopters having a free channel to control the lights by a pilot. Operational voltage is expected by BEC, typical voltage is 5,0 V. Works from 4,5 V to 5,5 V.

The circuit is to be connected with a Graupner or Hitec connector directly to the receiver, being supplied with a voltage of 5V and with BEC circuit tolerance. The circuit has no other protection against reversed polarity than a connector lock. Diodes are supplied with this voltage. The output conntacts have a joint positive pole. Each output can be connected with one diode.
The F1 and F2 circuits (see manual) flash with one second period. Using three jumpers ( 1, 2, 4 ), one of the eight preset flashing combinations can be achieved i.e. one, two or three separated flashings. You can set the order number of the combination from 0 to 7 by means of the jumpers as follows: all jumpers, when disconnected, sum up to 0. The sum of number of the connected jumpers represents the number of the selected combination.

The unit NF-3m can also be connected as an uncontrolled unit when disconnecting the orange signal contact on the connector on the receiver. This can be either cut off or you can gently try to lift the lock on the connector and pull the contact out of the connector. Then isolate against touching by chance. If necessary, you can always push the contact back again. When connecting the unit as an uncontrolled one (without the orange contact) the position and the flashing lights are permanently switched on and the jumper "2p/3p" switches the landing lights.

The total average current consumption by all lights on is between 12 mA from a BEC. During 10 minutes of fly the light circuits burn only a little bit more than 1 % of capacity of a 700 mAh accumulator. Position and number of the installed LEDs depends on your own decision. However, you should keep in mind that, according to conventions, position lights are correspond with the green diode on the right and the red one on the left, in the flying direction. Usually the flashing light on the body is red and on the tail is white.

The NF-3m, besides control circuit, includes 1x3 mm 10 mAh green LED, 2x3 mm 10 mAh red LEDs and 3x3 mm 10 mAh white LEDs


temporarily out of stock
temporarily out of stock

Reviews

Customers who bought this product also purchased
Servo slow down unit (0,7-14,7 sec )
Servo slow down unit (0,7-14,7 sec )

temporarily out of stock
temporarily out of stock

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Paint gun for sprays
1 x Smoke set "M"
2 x Plasti Dip Liquid Tape 429 ml black
3 x Truck-trailer for gliders 720 x 239 mm
2 x White smoke bombs AX-60 (5 pcs)
2 x Propeller balancer
1 x Initior Receiver FRX2 Wireless
1 x Yellow smoke canister 100 g
1 x White smoke bombs AX-3 (10 pcs)
2 x Silicone adhesive ELASTOSIL® E4, tube/ 90 ml
1 x Red smoke canister 65 g
1 x Universal Colour Paste white 50 g
1 x Green smoke canister 100 g
3 x WingFix ULTRA Black Edition
1 x Electric rocket starters (6 pcs)
1 x Black smoke bombs AX-60 (5 pcs)
1 x Initior Transmitter FTX2 Wireless
1 x 
1 x Spray Graphit 33
1 x Angle measurer
1 x White smoke canister 140 g
2 x PARTALL® Hi-Temp Wax, 340 g
3 x Angle of incidence meter
1 x Green smoke canister 140 g
1 x 20 g tin paste
1 x 1000 ml sealer (DOPE)
3 x Propeller balancer
1 x Smoke set "Glider"
1 x PCARD Wireless System
1 x Release wax 250ml
1 x Spannlack 1000 ml
1 x Parachutist
3 x Medidor ángulos y/o incidencias
1 x 3l Smoke oil
1 x Spray adhesive AEROFIX 2
1 x Surface Indicator Gauge Small
1 x Spray EC Red 400ml
3 x Field folding model stand SebArt
3 x Field folding model stand
1 x Plasti Dip Liquid Tape 429 ml black
1 x White smoke bombs AX-18 (5 pcs)
1 x "S" set for boats
1 x White smoke bombs AX-9 (10 pcs)
2 x Spray adhesive INFUTAC (Clear) 500 ml
1 x Smoke set "S"
1 x Aluminun wheel collar 2.5 mm Ø (4 uds)
1 x Bungee HLG Premium
2 x Cap Hispano Aviación
1 x Vasa model Catapult
1 x Steel tube (L 1000 mm Ø12 mm, Ø11,7 mm)
1 x ABS tube 8.0x7.0x1000 mm
1 x Round Rod 5,0x1000 mm
1 x Red copper lacquer wire Ø0,2 mm (5 m)
1 x Motor DLE 170 M- Paramotors
1 x Receptor CORE PBR-26XS 26ch
1 x Plastic wheels 28 mm (2 pcs)
3 x Truck-trailer for gliders 720 x 285 mm
1 x Antenna Cloverleaf 5.8 GHz Tx - Rx
1 x Bateria LRP 2200-7.2v 6 cell NiMH
1 x Cylidric hinge 33 mm Ø 2 mm (5 pcs)
1 x Ball link Aluminio M3 x 3 x 5 x 18mm (6 uds)
1 x AC-10 pre-rotacion with motor
1 x Hot Glue Stick RED
1 x Dust collector for mould cleaning
1 x Aluminium servo arm (2 uds)
1 x 160 mm carbon undercarriage (2pcs)
1 x Remote electric ignition system
1 x PRO-HV Dual Action Valve
1 x Cargador para AA/AAA Ni-MH & Ni-Cd
1 x Mini neumatic retract landing gear
1 x Fail Safe air retract
1 x Angled clevis with threaded rod M3
1 x Wheel cover holder Ø 4 mm (2 uds)
2 x Aluminun wheel collar 3.5 mm Ø (4 uds)
1 x Aluminun wheel collar 4 mm Ø (4 uds)
1 x Landing gear axle Ø 5 mm (2 uds)
1 x Landing gear strap small (4 uds)
1 x T-Hose connector 2-2-2 mm
1 x Glider retract undercarriage 8-16 Kg 2.5-3.2(127 mm wheel)
1 x Aluminun wheel collar 2 mm Ø (4 uds)
1 x Landing gear strap medium (4 uds)
1 x Servo arm with 5 mm hole to FEMA 9810A
1 x "S" set for planes
1 x Nitroverdu 500 ml
1 x Green smoke canister 65 g
2 x Profile ABS Square 2 x 1000 mm
1 x Vest clothes Hispano Aviación
2 x ABS angle 1.5x1.5x1000 mm
2 x Flat Connector 4.0 mm x 1000 mm
1 x 13 mm self adhesive Pinking Tape, saw tooth height 0.5 mm
1 x Streamline Stainless Steel Tubing 7.5x4.5x1000 mm
2 x ABS "T" angle 2.0x2.0x1000 mm
1 x U Profile ABS 3,0x6,0x1000 mm
1 x Streamline Stainless Steel Tubing 19.5x9.8x1000 mm
2 x ABS angle 10,0x10,0x1000 mm
1 x Streamline Stainless Steel Tubing 9.0x5.0x1000 mm
2 x Profile ABS half cane 2.0x1000 mm
1 x Profile ABS Square 4 x 1000 mm
2 x Softshell Hispano Aviación
1 x Shirt Hispano Aviación
1 x 3,2 mm Prop Adapter M5
1 x Motor mount EDGE 540 48"
1 x 3 mm Short Prop Adapter M5
1 x CellPRO 4S Adaptader (GP/KO up to 4S)
1 x 90x45 mm hard foam KOVO wheel
1 x 82 mm aluminium spinner.
1 x 82 mm INO spinner (carbon imitation)
1 x RUDDOG Protection and Heat Shield Tape (2mx50mm)
1 x B4-0 rocket charges (6 pcs)
1 x A/C quality beech plywood 600x300x5.0 mm
1 x Carbon fiber rod 14 mmx1000 mm
1 x 101x28 mm (4.0") Type jets aluminium core wheel
1 x O-Ring SAITO FG-60 R3
1 x E-FUN BUG (ROI-Import)
1 x DYNAMOMETER S-1580
1 x Copier 5x20 cm pcs
1 x Birch plywood plate 600x300x3.0 mm
1 x Blind nut M6 (4 pcs)
1 x Birch plywood plate 600x300x4.0 mm
1 x Black "FUEL VENT" round aluminum overflow socket
1 x Cable video GoPro
1 x Battery Protection Circuit Board 22.2v 6s
1 x Carbon fibre sleeve 12k 170 mm x 5m
1 x Carbon fiber rod 6.0 mmx1000 mm
1 x EDF Jet-Flex 80 - 8 Kg
1 x Copier 2x20 cm pcs
1 x Tube bender
1 x 280 cc gasoline fuel tank complet
1 x Crystal Universal RX 35.070 Ch 67
1 x Spinner plastic 63 mm Red 2Bl
1 x Crystal Universal RX 35.090 Ch 69
1 x Escape Moki 100 BVT
1 x Retract undercarriage for gliders up to 2 Kg
1 x Cross Connector 4.0 mm x 1000 mm
1 x Profile ABS half cane 4x2.5x1000 mm
1 x Nut for 515/518/519 spinner special for Hacker
1 x Brake disc Electron Retracts
1 x F3A carbon 95 mm spinner
1 x Spinner Alumin. fixed propeller 50 mm / 4,0 mm
1 x Fibreglass-Spinner BS ∅155 x 200 mm
1 x 102 mm INO spinner (carbon imitation)
1 x Y-Hose connector 3-3-3 mm
1 x Body for landing gear Ø 4 mm
1 x Nylon gear block Ø 5 mm (2 uds)
1 x ER-40eVo Set B [Complet Set + GS200]
1 x Racor "Y" 3 mm
1 x Spinner Alumin. fixed propeller 50 mm / 5,0 mm
1 x Spinner INO 82 mm Chrome (Imitacion metal)
1 x Y-Hose connector 4mm
1 x Spinner Alumin. fixed propeller 45 mm / 6,0 mm
1 x Aluminun wheel collar 6 mm Ø (4 uds)
1 x Retract Landing gear ER40 Combo Custom complete
1 x 45 mm white plastic spinner for fixed propeller
1 x Wheel collar 3 mm Ø (4 uds)
1 x Jeti Black cap
1 x ABS angle 2,0x2,0x1000 mm
1 x Profile ABS half cane 8.0x1000 mm
1 x Profile ABS half cane 3x1000 mm
1 x ABS "T" angle 8.0x8.0x1000 mm
1 x ABS angle 4,0x4,0x1000 mm
1 x Profile ABS half cane 4x1000 mm
1 x Profile ABS triangular 4.0x1000 mm 60º
1 x ABS rectangular profile 10x5.0x1000 mm
1 x U Profile ABS 5,0x10,0x1000 mm
1 x ABS rectangular profile 12x6.0x1000 mm
1 x Savox Highvoltage Brushless Servo SB-2272MG (Tail rotor)
1 x VTX 477 Carbon Rotorblade
1 x Logo 400 SE VBar
1 x Propeller 8x4,3 SlowFlyer
1 x Motor PERMAX BL-O 3520-920 (Extra 330 SC)
1 x Blade Holder Full (4 blades)
13,005.05EUR
Manufacturers
Manufacturer Info
Night Fly
Night Fly Homepage
Other products
Languages
Español English
Currencies