88.70EUR

NF-3X-80 liner Kit
[NF-3X-80Liner]


NF-3 X is a unit designed for illumination of models with spread up to l.7 metres for flying at night. lt is used to power colour ultra bright LEDs (Light-Emitting Diode) It contains six independent current-powered outputs. Five outputs are powered with the nominal current of 20 mA. Two outputs are for position lights (P1, P2), two independently flashing ones for the anti—collision flash lights (F1, F2), and one output for the landing lights (L1). The sixth output (L2) is designed to power the landing headlight of 80, 150 or 350 mA (according to the respective type). Operation of the output L2 is one second delayed to the output L1. That produces an effect of phased switching by the pilot.

The unit offers eight different flashing combinations ( 0 -7 ) with one second period for F1 and F2 outputs. One of those combinations can be selected by couplers (jumpers) 1, 2, 4. The sum of numbers ofthe connected couplers represents the number of the selected combination. The unit can be used as controlled or non-controlled by pilot. lf controlled by pilot, the jumper "3p" allows you to select between 2-positions (Fly/Landing) or 3—positions (Off/Fly/Landing) control by the remote controller. With a 2-positions control the position and anti-collision lights start work when the unit is connected to the accumulator. However, the landing lights can be switched on and off by pilot. ln the 3-positions control system, all lights are off in the off-position. ln the fly-position the position and anti-collision lights are on and in the landing-position, all lights are on.
Unit is in non-controlled mode if the Rx cable is not connected to the receiver. ln this case the lights start work when the unit is connected to the accumulator and the "3p" jumper can be used to switch manually the landing lights off. Anti-collision and landing lights automatically begin to flash when the plane is unable to receive a signal from the remote controller. The receiver circuit and the light circuits are electrically separated by an opto-coupler. Unit is compatible with Graupner or Hitec type connectors.
The outputs maintain the nominal current in the wide range of voltage from 6V to 14V without the need to connect compensating resistance series in the circuit. The stabilization starts working from 4.5V, therefore it is possible to connect the unit with the used NiCd or NiMH batteries with 5 up to l0 cells or Li-Pol from 2 up to 3 cells. As the number ofthe cells of the powering accumulator increases, so does the number of diodes that can be connected (serially) in one circuit.

The NF-3X-80 Liner Set, besides control circuit, includes 1x5 mm 20 mAh green LED, 2x5 mm 20 mAh red LEDs, 6x5 mm 20 mAh white LEDs and 2x 25 mm 80 mAh white LED's


temporarily out of stock
temporarily out of stock

Reviews

Customers who bought this product also purchased
Transmitter Balancer Futaba T-10CG
Transmitter Balancer Futaba T-10CG

temporarily out of stock
temporarily out of stock

Servos security connector (2 pcs)
Servos security connector (2 pcs)

temporarily out of stock
temporarily out of stock

Extension silicon 75 cm (Futaba)
Extension silicon 75 cm (Futaba)

temporarily out of stock
temporarily out of stock

Extension silicon 50 cm (Futaba)
Extension silicon 50 cm (Futaba)

temporarily out of stock
temporarily out of stock

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Tacometer mini ignition RCEXL
1 x Propeller diller for EME35 and DLE35
1 x Propadapter for motor A60-V2
3 x Propeller diller for DLE30/DLE35RA/DLE40/DLE55/DLE61/EME 55/DA-5
2 x Blocking screws M6 gas engine
1 x Alu-Cross for Backmount of A60-V2-Backmountmotors
2 x Adapters for 7.5 - 35cc aircraft and naval engines
2 x Propeller diller for DLE111 and DA85-150
2 x Propeller diller for DA50, DLE55 red
2 x Propadapter for motor A50
1 x Crimping tool
1 x Electric Landing Gear "Black Edition" ULTIMATUM 3.0 (Elektron Re
1 x Turbina KINGTECH K320 G5
1 x Conector MR-60 (pareja)
1 x Servo GO-1035MG 16 kg.cm 0.08s/60º
1 x EXTRA NG 74" yello/blue/red (Skywing RC)
1 x Adaptadores carga 6s JST-XH
1 x Paramotor BackPack XXS 2
1 x Opale Rucksack
1 x Para-RC "RC-Evo-Cross" Rescue
1 x Rescue 1,8m2 / BackPack
1 x PowerBox Smokepump JETs 2x outside
1 x Secraft Fuel system v2, red color
1 x PowerBox Smokepump
1 x Electric Fuel Pump 12V
1 x PowerFuel RX V2 Fuel Pump
1 x Electric Fuel pump
1 x Propadapter for motor A50-V3
1 x Ball Bearings for motor A60-V2
1 x Filler Gauges
1 x Recess mount-rem. glow plug set
1 x Refueling Cap V3 Black
1 x Gasket electric Fuel Pump
1 x EXTRA NG 74" white/red/blue (Skywing RC)
1 x Flat washer 1.7 mm (20 pcs)
2 x Gates hinge aluminium (1 pcs)
1 x ABS "T" angle 8.0x8.0x1000 mm
1 x Spring lock washer 4.1 mm (20 pcs)
1 x Rocket cardboard tube 25mm x 24mm x 230mm
1 x Motor OS 3820-1200 electric
1 x Rocket cardboard tube 50mm x 48mm x 250mm
1 x Rocket D9-7
1 x DG-303 ACRO 3750 mm (Airworld)
1 x GP 15 JETA
1 x ASW 20 5000 mm with winglets (Airwold)
1 x ASH 31 Mi Scale:1/3 - 7m, elevator
1 x BLANIK 50 V2 Silver/Orange (SebArt)
1 x DG-303 ACRO 3750 mm, winglets
1 x Propeller diller for DLE170
1 x 1/4 Pilot "Mike"
2 x Unmounted aluminium pin 6x98 mm (2 pcs)
1 x ABS "T" angle 6.0x6.0x1000 mm
1 x Ball link duraluminium M3 V1 (10 pcs)
1 x Z type of cable coupler Ø 1 (2 uds)
1 x Silicone 0,50 qmm servos wire Futaba (100 m)
1 x Civilian pilot "Curt" size 9cm (Slimline)
1 x 67 mm cylidric hinge Ø 5 mm (4 pcs)
1 x Slave-cable USB Easy Sim
1 x Simulador RealFlight RF-9.5 S (sin emisora)
1 x 1/6 Pilot "Buddy"
1 x Threaded coupler ALU M3 Ø 6 (2 uds)
1 x Nylon hinge 20x20x0,3 (10 pcs)
1 x Piloto JET 1:3,5
1 x Quicklock washer 3 mm (10 pcs)
1 x PVC 0,08 qmm Futaba servos wire (5 m)
1 x Aluminium cap bolt washer M3 black (8 pcs)
1 x PVC 0,14 qmm servos wire Graupner (100 m)
1 x Silicone 0,35 qmm servos cable Futaba (5 m)
1 x Spring lock washer 3.1 mm (20 pcs)
1 x Ball Link ALU M3 - RH (1 pcs)
2 x Nylon hinge for flaps 33x9 (2 pcs)
1 x M3-M4 rubber washer (8 pcs)
2 x Small pinned hinge (12 uds)
1 x Aluminium wide washer M4 Gold (4 pcs)
1 x Green silicone 0,25 qmm wire (50 m)
1 x Quicklock washer 2 mm (10 pcs)
1 x TP/TopFuel - XH 2/3S Adapter
1 x ABS angle 5,0x5,0x1000 mm
2 x Miniature brass strap hinge, 1 m
1 x DUPLEX USBa USB-Adapter for Jeti Duplex Items
1 x Actuator Electric 25 mm HIGH TORQUE
1 x Actuator Electric 25 mm
1 x Kit hydraulic brake
1 x Batería LiPo GENS 5000 mAh 5S 18.5V 60C (Gens Ace)
1 x SyRen 50A 6V-30V Regenerative Motor Driver
1 x Aluminium tube with fibreglass case ø35x1.5mm, 1m
1 x Pilatus PC-21 50E RED/WHITE (SebArt)
1 x 18 mm reinforced hinge
1 x 48 mm cylidric hinge Ø 2,5 mm (5 pcs)
1 x Silicone red 1,0 qmm wire (100 m)
1 x Flap hinge (6 pcs)
1 x Indoor hinge with servo arm integraded
1 x Cable set PREMIUM, fuselage/wing
1 x Electric coversion set
1 x 
1 x Ø 38 mm fiberglass motor-holder for electric motors
1 x Motor Mega AC 16/30/01
1 x Motor Mega AC 16/07/03
1 x Motor Mega AC 22/35 4S
1 x Anodized alum. M4x0,7x20 mm Flat Head screw (4 blue pcs)
1 x CC 03
1 x 1/6 Pilot "Cindy"
1 x Cabel charger battery transmiter Graupner 2x0,5 qmm (50 cm)
1 x 15 mm floating pad (30 pcs)
1 x Aluminium wide washer M3 gold (4 pcs)
1 x Aluminium wide washer M3 blue (4 pcs)
1 x Male connector JST SH 1.0mm with 10 cm wire
1 x 4 LiPo XH>EH adapter
1 x Blind nut M6 (4 pcs)
1 x 1/12 Pilot "Tom"
1 x PSC 5
1 x 1/12 Pilot "Fighter"
1 x Anodized aluminium servo M4x5/8 screw (4 blue pcs)
1 x Male connector for 6 pines AWG
1 x Cabel charger battery transmiter Multiplex 2x0,5 qmm (50 cm)
1 x AXI 2820/12 CYCLONE
1 x Aluminium tube with fibreglass case ø35x1.5mm, 500mm
1 x Pilatus PC-21 50E BLUE/WHITE (SebArt)
1 x PowerBox MicroSwitch
1 x Cylidric hinge 43 mm Ø 2,5 mm (5 pcs)
1 x Nylon hinge 20x15x0,3 (10 pcs)
1 x Round flex hinge (12 uds)
1 x Silicone black 0,75 qmm cable ( 1 m)
1 x Interface Jack Adapter IKARUS
1 x 43 x 10 mm cylidric hinge Ø 2,5 mm (10 pcs)
1 x Canopy hinges for Discus 2c, Discus 2a, Ventus 2cx (2pcs)
1 x Medium pin type hinge (12 uds)
1 x Silicone red 6,0 qmm wire (25 m)
1 x Small flex hinge (12 uds)
1 x Rocket D3-P
1 x Frontal support Speed 400/480
1 x Powerset FunJet 2 with Vectorcontrol unit
1 x Bearings for motor HACKER C50
1 x Motor Mega AC 16/25/03
1 x Motor Mega AC 22/45/03 E
1 x Propeller MEJZLIK 9,5x3 SF Carbon Indoor
1 x 1/6 Pilot "Tony"
1 x 1/12 Pilot "Langley"
1 x Blind nut M2 (10 pcs)
1 x Jet Afterburner Simulator NF-Jet3 RY
1 x NF-3X-80 liner Kit
1 x Pin type hinge Al 6x98 mm (2 pcs)
22,729.31EUR
Manufacturers
Manufacturer Info
Night Fly
Night Fly Homepage
Other products
Languages
Español English
Currencies