133.50EUR

Rainbow Autogyro
[MEGARAIN]



Aut. Rainbow con 4 palas

Aut. Rainbow con 4 palas

Aut. Rainbow con 4 palas

Aut. Rainbow con 3 palas

Aut. Rainbow con 3 palas

Aut. Rainbow con 3 palas
Autogyro was first built in 1923 by Spanish engineer Juan de la Cierva. Its development went on during thirties and in Second World War II was used in armies usually for observation purposes. In Czechoslovakia was then flown by Bata company.
Autogyro model RAINBOW is designed for model builders who has basic experiences with motor modelc comntrolled by elevator and rudder (or ailerons). No problems with starts form hand or grassy field. Landing si easy even with autogyro flying only with autorotation. Thanks to relatively big rotor diameter is flying very straightforward. In the air you can handle situations in which other models would be practically lost. Side movements of autogyro RAINBOW are made by rotor tilt. Elevator works well in the whole range of speeds and in autorotation mode allows almost vertical and very slow landing. For trasportation of autogyro it is possible to turn rotor blades back over the airframe (by slackening of two blade bolts)
Flying time varies from 10 to 20 minutes (battery 3xLion,1350mAh , motor MEGA RC 400/15/7, propeller APC10x5 E). You can use rechargeable batteries with both higher or lower capacity.
It is absolutely necessary to take off and land against the wind!

Available Options:

Combos:



temporarily out of stock
temporarily out of stock

Reviews

Customers who bought this product also purchased
3 blades set
3 blades set

temporarily out of stock
temporarily out of stock

We Accept
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Glass fabric tape 225 g/m² (Silane, plain) 40 mm X 100m
1 x Sparkplug NGK CM6
1 x Cierva C30 Body Spain
1 x Carbon fibre tape 200 g/m² (unidirectional) 50 mm
1 x Carbon Fabric Prepreg 200 g/m² (twill 2/2) 100 cm, roll/ 1 m
1 x AIREX® Sheets C 70.55 (YELLOW) 1200x550x2.0 mm (10 pcs)
1 x AIREX® Sheets C 70.55 (YELLOW) 1200x550x1.2 mm (5 pcs)
1 x Head upper part
1 x Carbon fabric 200 g/m² (Aero, plain weave) 100 cm x 3m
1 x Carbon fibre sleeve 12k 170 mm x 5m
1 x Threaded coupler ALU M3 Ø 5 (2 uds)
1 x Crimping sleeves for 1.1 mm cable (10 pcs)
1 x Clevis plastico I=44 mm / hole 3mm / pin 2 (2 pcs)
1 x Oracover White 10 m
1 x Aluminium coupler M3/2 with ball bearing (1 pcs)
1 x Oratex White 2m
1 x Oracover Green10 m
1 x Brass control horn M2 short for wire (2 pcs)
1 x Oracover CARBON Metalic 1 m
1 x Horn 16,5x20 mm (2 pcs)
1 x Aluminium blue ball links M3 V1 (10 pcs)
1 x Monokote BLANCO jet (1.8x0.65m)
1 x Brass control horn M3 short for wire (2 pcs)
1 x Aro pasacable Ø20 mm (4 pcs)
1 x 261 mm M4/M4 6.0x4.0 mm shaft ship
1 x Straightened rod Ø 8.0 mm x 1000 mm
1 x 12 mm mast holder
1 x Straightened rod Ø 6.0 mm x 1000 mm
1 x Tube support Ø 6mm (10 pcs)
1 x Support FUEL DOT V3
1 x Rotorhead pushrod
1 x Bearing housing
1 x Simulador RealFlight RF-9.5 S (sin emisora)
1 x L-Connector 4.0 mm x 1000 mm
1 x Cable set PREMIUM, SUB-Done 4three fuselage/wing 160 cm
1 x L-Connector 1.0 mm x 1000 mm
1 x 10 mm Quick clamp_L (6 pcs)
1 x USB Mini Camera endoscope
1,292.92EUR
Manufacturers
Manufacturer Info
Mega Motor
Mega Motor Homepage
Other products
Languages
Español English
Currencies