Top » Catalog » Motors & Turbines » Explosion » Gasoline » Zenoah/ZG » TC6500

419.00EUR

ZENOAH ZG 62 SL
[TC6500]

ZENOAH ZG 62 SL

In 1990 Komatsu reworked the cylinder specially for model aircraft purposes this S cylinder had the transfer passages altered as well as the combustion chamber. This resulted in an increase of 200 rpm in the 6,500 range. Fit a tuned pipe and the rpm is considerably increased, giving a power of 6,6 hp at 8,400 rpm.

The crankshaft is a hefty piece of forged steel, induction hardened, with a diameter of 15 mm and supported in two large ballraces, the conrod is a forged unit also induction hardened with caged roller bearings both ends, the gudgeon pin is hollow. There are two thin pegged rings. The ignition unit consists of two separate coils, both fixed to the side of the motor causing no interference with the cooling air. The standard Walbro pump carburettor is fitted with a choke.

The very wide and cleanly formed cooling fins allow the use of large propellers causing the motor to turn at relatively low speeds. For aerobatic aircraft like our CAP 21 the 22x10" or the 22x12" Menz S propeller has proved to be very good. Our big Tiger flies best with the 24x10". If you wish to, or must, reduce the noise still further, then you can pull the intake air out of the fuselage by fitting a 90 degree bend between the carburettor and motor. The intake noise is louder than the noise from the standard silencer. This bend by lengthening the intake tract allows the fitting of a 24x12" or 26x10" Menz S propeller, of course you are not going to get the maximum power from the motor by this method, but you have more than enough power to fly our big Tiger with the 62?s throttle set at just a rather fast tickover.

The lowest possible noise level in flight with lots of power is obtained with our Hydro-Mount-System, coupled with the Stainless steel silencer, sucking the intake air out of the fuselage and fitting a Super Silence 21x12" Carbon 3-blade propeller at 6,300 rpm. For higest performance use the Super Silence 24x10" Carbon 2-blade prop. It produces 130 N static thrust at 6500 rpm.

The ZG 62 SL is delivered complete with silencer, fitted with 40 mm prop hub, but without motormount.

Specifications:
Capacity: 62 cc
Bore: 47,5 mm
Stroke: 35 mm
Power: 4,3 hp
with tuned pipe: 6,6 hp
Weight: 2040 g without silencer and engine mount

under request

Reviews

Categories

* OFFER MONTH *
Planes->
Sailplanes->
Autogyros->
Helicopters->
UAVs - RPAs->
Multicopters->
Hardware->
Car/Trucks->
Motors & Turbines->
  Explosion->
    Oils/Smoke Liquids
    Gasoline->
      DA
      DLE Engines
      EME
      GAUI
      KOLM
      MOKI
      NGH motors
      OS Engines
      Roi-Import
      ROTO Motor - RM
      SAITO
      SEIDEL MOTOREN
      Spare DA
      Spare parts DLE
      Spare parts MVVS
      Spares Zenoah/ZG
      UMS Motor
      VALACH Motors
      Zenoah/ZG
      Accesories/Muflers
    Glow->
  Turbines->
  Electric->
  Rockets
Gas. Motor Paramotors
Acces. for Motors->
Paragliders/Parachutes/Windsock
Boats/Naval units->
FPV->
Robots->
CNC cut
Roof BOX
Crash kits
Outlet Zone->
Used
Merchandising HA

What's New?

Electric Landing Gear ULTIMATUM 3.0 (Elektron Re
1,160.39EUR

Information

Shipping & Returns
Privacy Notice
Conditions of Use
Financing
Point Program FAQ
Contact Us

We Accept

Quick Find

Shopping Cart

2 x	Ferrita 27x14x7 mm
1 x	Ferrita con funda
1 x	White smoke canister 65 g
1 x	Screw-lock connector Ø 2 mm (2 uds)
1 x	Stainless steel cable Ø 0.62 mm (10 m)
1 x	Green smoke canister 65 g
1 x	Red smoke bombs AX-60 (5 pcs)
1 x	Remote electric ignition system
1 x	Red smoke canister 100 g
1 x	3l Smoke oil
1 x	Cabin latch Fox MDM1 4m (pair)
1 x	Steering arm 16 mm Ø 3 mm (2 uds)
1 x	Yellow smoke bombs AX-60 (5 pcs)
1 x	Smoke set "M"
2 x	White smoke canister 140 g
1 x	Steering arm 16 mm Ø 4 mm (2 uds)
1 x	L cockpit anchor "tipe F3A" (2 pcs)
2 x	SUS wire 3m (nylon coated)
1 x	Aluminium alloy coupler for carbon tube 6/M4
1 x	Yellow smoke canister 65 g
1 x	Cierre cabina aluminio Ø4, I=10 mm
1 x	Screw-lock connector M2 (2 uds)
1 x	Steering arm 12 mm Ø 4 mm (2 uds)
2 x	Crimping sleeves for cable 1.3 mm (10 pcs)
1 x	Cierre cabina aluminio Ø5, I=16 mm
1 x	Blue smoke canister 140 g
1 x	Cockpit plastic closing
1 x	"S" set for boats
1 x	"S" set for planes
1 x	B4-0 rocket charges (6 pcs)
1 x	White smoke bombs AX-60 (5 pcs)
2 x	Stainless steel cable Ø 1.3 mm (10 m)
1 x	Screw-lock pushrod conn snap Ø 1.5 mm (2 uds)
2 x	Covered closure or fairings
1 x	Stainless steel cable Ø 0.88 mm - 60 kp (10 m)
1 x	Crimping sleeves for cable 0.70 mm (10 pcs)
2 x	Stainless steel cable Ø 0.5 mm (20 m)
1 x	Locking cable tie 3.2x142 (uds)
1 x	Canopy Lock V1 M3 Red (2 pcs)
1 x	White smoke bombs AX-18 (5 pcs)
1 x	Steering arm 12 mm Ø 4 mm
1 x	Red smoke canister 140 g
1 x	Yellow smoke canister 140 g
1 x	Smoke set "Glider"
1 x	Green smoke canister 100 g
1 x	Micro screw-lock pushrod conn snap Ø 1 mm (2 uds)
1 x	Vertical cockpit anchor "tipe F3A" (2 pcs)
1 x	AX-60 starters (5 pcs)
2 x	Locking cable tie 4.6x203 (uds)
1 x	Yellow smoke canister 100 g
1 x	Electric rocket starters (6 pcs)
1 x	Locking cable tie 2.5x100 (uds)
1 x	Lock washer 3.2 mm (20 pcs)
1 x	Aluminium cap bolt washer M3 black (8 pcs)
1 x	Flat washer 1.7 mm (20 pcs)
2 x	Circlik for shaft 1.2 mm (10 pcs)
1 x	Aluminium wide washer M4 Blue (4 pcs)
1 x	Aluminium cap bolt washer M4 red (8 pcs)
1 x	Quicklock washer 3.5 mm (10 pcs)
2 x	M3 black washers (4 pcs)
2 x	Flat washer 2.2 mm (20 pcs)
1 x	Circlik for shaft 1.5 mm (10 pcs)
1 x	Circlik for shaft 1.9 mm (10 pcs)
1 x	Aluminium wide washer M4 Red (4 pcs)
1 x	Quicklock washer 2.5 mm (10 pcs)
2 x	Lock washer 2.7 mm (20 pcs)
2 x	Aluminium cap bolt washer M4 blue (8 pcs)
2 x	Ferrita 17x10x6.5 mm
1 x	PIX Hawk with accesories
1 x	PPM Encoder Module
1 x	Tube Pitot to PIXHAWK
1 x	Digital Air Speed Sensor And Pitot Tube Set
1 x	Oracover Yellow CUB 10 m
1 x	Ferrita 14x8x5.5 mm
1 x	TP/TopFuel - JST-EH 4/5S Adapter
1 x	Cabel charger transmitter GRAUPNER
1 x	CC 03
1 x	Streamline Stainless Steel Tubing 11.5x6.5x1000 m
1 x	Universal Colour Paste signal white (RAL 9003) 1 Kg
1 x	Premium servo extension 25cm
1 x	Kwik link AL M4 con Clip (2 pcs)
1 x	28x5 mm wires output (2 pcs)
1 x	Fully Threaded Steel Rod alumin 100 mm M3 (2 pcs)
1 x	White smoke canister 100 g
1 x	Fully Threaded Steel Rod alumin 90 mm M2,5 (2 pcs)
1 x	Lead with adhesive (2 pcs)
2 x	Fully Threaded Steel Rod Duralumin 70 mm M3 (2 pcs)
1 x	Fully Threaded Steel Rod alumin 80 mm M3 (2 pcs)
1 x	Initior Transmitter FTX2 Wireless
1 x	Control for forward wheel (MINI)
1 x	Soporte filtro FESTO (4 pcs)
1 x	Support Pitot JETI
1 x	Fully Threaded Steel Rod Duralumin 34 mm M3 (2 pcs)
1 x	Fully Threaded Steel Rod Duralumin 110 mm M3 (2 pcs)
1 x	Green smoke canister 140 g
1 x	Fully Threaded Steel Rod Duralumin 50 mm M3 (2 pcs)
1 x	Fully Threaded Steel Rod M3
1 x	Fully Threaded Steel Rod alumin 60 mm M3 (2 pcs)
1 x	Fully Threaded Steel Rod SUS303 70mm M3 (2 pcs)
1 x	Parachutist
1 x	Fully Threaded Steel Rod alumin 40 mm M3 (2 pcs)
2 x	Electric spoiler 250 mm (2 pcs)
1 x	Stainless steel cable Ø 0.5 mm (10 m)
1 x	Servo M2x5/16 screw (4 pcs)
1 x	Anodized aluminium M4x0,7x20 mm screw (4 blue pcs)
1 x	Anodized aluminium servo M4x5/8 screw (4 red pcs)
1 x	Blue Aluminium lock nut M2 (4 pcs)
1 x	Anodized alum. M4x0,7x25 mm Button Head screw (4 blue pcs)
1 x	Ventral support for AX-18/AX-60
1 x	Blind nut M2 (10 pcs)
1 x	Blind nut M5 (4 pcs)
1 x	Anodized aluminium M3x0,5x20 mm Sokect Head screw (4 lilac pcs)
1 x	Tapping Screw M2.9x13 (10 pcs)
1 x	Socket Head Screw M2,5x12
1 x	Quicklock washer 2 mm (10 pcs)
1 x	Lock washer 2.2 mm (20 pcs)
1 x	Socket Head Screw M2x12
1 x	Threaded insert M5 (10 pcs)
1 x	Tornillo cabeza boton M4x12 mm (5 pcs)
1 x	Aluminium wide washer M3 gold (4 pcs)
1 x	Tapping Screw M2.2x13 (10 pcs)
1 x	Treaded hexagonal socket insert M3 Br (4 pcs)
1 x	Spring lock washer 2.6 mm (20 pcs)
1 x	Spring lock washer 2.1 mm (20 pcs)
1 x	Socket Head Screw M2x5
1 x	Servo M2x7/16 screw (4 pcs)
1 x	Aluminium wide washer M3 blue (4 pcs)
1 x	M3-M4 rubber washer (8 pcs)
1 x	Steering arm 16 mm Ø 3 mm

2,948.05EUR