2,499.93EUR

Turbina JetsMunt M166TS
[JETM166TS]


Turbina JetsMunt M166TS
Specifications:
Nominal thrust: 166N (37,4lb) at 124.000 RPM.
Idle thrust: 5,5N.
Idle RPM: 32,000.
Diameter: 102mm (4”).
Engine weight: 1.420g (3,12lb).
Installed weight: 1,535g (3,4lb).
Fuel: Kerosene/Diesel + 3% – 5% oil.
Fuel comsumption: @160N: 460g/min; @100N: 290g/min.
Start mode: Fast start, Dual glow plug Direct Kerosene.
Fast restart, typically <15 seconds.
Easily programmable maximum thrust in Newton or Pound.

Need a little more power, but want to keep your plane light? Want to have redundancy on a big, single engine model? The M166TS is the answer. 166N of thrust packed inside a small can of only 100mm diameter. Where a standard 110mm engine doesn’t fit, the M166 does!
Like all other JetsMunt engines, the M166TS use the same technology of brushless starters and pumps, coupled with our proprietary single wire digital bus, a very reliable communications system comparable to those used in high end cars and professional machines, immune to external electromagnetic noise and extremely low radiated energy.
Sensors and valves are installed inside the motor, simplifying installation. The engine has only one fuel input directly from the pump, and a 3-wire electrical connection to the ecu that carries the battery power and a bidirectional digital bus. All measures and data from the engine are transmitted to the ecu in digital data format. All engine parameters and timers are stored in the engine, installation parameters (radio settings, etc.) are stored in the ecu, enabling the swap of the engine without any adjustment.
This engine has dual igniter that allows a very fast start up sequence, typical 35 seconds, fast restart time of below 15 seconds plus adding the extra reliability in the case of a single igniter failure.
Includes engine and all ancillary accessories needed to run the engine, except the battery. Recomended LiPo 11,1v 2200mAh


Comentarios
Aceptamos
Búsqueda Rápida
 
Use palabras clave para encontrar el producto que busca.
Búsqueda Avanzada
1 x Set Cilindro-Piston ensamblado MVVS 30cc
1 x Junta culata MVVS 30 cc (3 pcs)
1 x Arillo pistón para motor 58/116 cc
1 x Chaveta MVVS 45/50/58 cc
1 x Toma MVVS presurización 26-175 cc
1 x Set juntas carburador Walbro 116/152cc
1 x Junta escape MVVS 26 cc
1 x Aceite PUTOLINE TT Light semi-sintético (1l)
1 x Motor DLE 170 M - Paramotores
2 x Corona grade autoarranque DLE-170M
1 x Motor Saito FG-60 R3, 60 cc
1 x Junta cilindro / aislante para ZG 38 / S / SC
1 x Aceite DELUXE turbine Jet Oil 1 litro
1 x Arandela abierta 2.6 mm (20 pcs)
1 x Horn de mando 5/20 con rótula M2
1 x Pasta para estaño 20 g
1 x Arandela abierta 4.1 mm (20 pcs)
1 x Pegatinas números para marcar
1 x Arandela abierta 3.1 mm (20 pcs)
1 x Acople ALU M2,5 Ø 4 (2 uds)
1 x Horn corto de latón M3 para cable (2 pcs)
1 x Soporte para aviones
1 x Arandela 4.3 mm (20 pcs)
1 x Relleno balsa HobbyLite
1 x Acople ALU M3 Ø 5 (2 uds)
1 x Arandela dentada 3.2 mm (20 pcs)
1 x Pistola para botes de pintura
1 x Acople ALU M2,5 Ø 6 (2 uds)
1 x Horn aluminio RH largo (2pcs)
1 x Arandela abierta 2.1 mm (20 pcs)
1 x Disolvente barniz tensor 500 ml
2 x Pasta universal color blanco 50 g
1 x Horn 13,5x16 mm (2 pcs)
1 x Acople ALU Izda. M2,5 Ø 4 (2 uds)
1 x Arandela conica ancha alumino M3 azul (4 pcs)
1 x Cámara Sony 4140+673 CCD Board con emisor 5,8 GHz 200mw + antena
1 x Arandela conica alumino M3 rojo (8 pcs)
1 x Circlick para eje 1.2 mm (10 pcs)
2 x Relleno Presto SF Light Filler styrene-free (420 g)
1 x Soporte para aviones SebArt
1 x Horn de mando 6/27 con rótula M3
1 x Arandela conica ancha alumino M4 Azul (4 pcs)
1 x Horn con ball 40x30
1 x Horn aluminio roscado 6 mm con rótula
1 x Horn de mando 6/35 con rótula M3
1 x Acople ALU M2 Ø 3 (2 uds)
1 x Conjunto de mandos arriostrados
1 x Horn corto de latón M4 para cable (10 pcs)
1 x Arandela conica ancha alumino M4 Oro (4 pcs)
1 x Acople ALU Izda. M3 Ø 4 (2 uds)
1 x Arandela de bloqueo 3.5 mm (10 pcs)
1 x Junta carburador DLE 111 (V1)
1 x Encendido para motor DLE 55 RA
1 x Cigüeñal DLE 40
1 x Arandela delantera helice DLE 85/111/120
1 x Escape DLE-60 Izda
1 x Chaveta DLE 111 Old
1 x Aro pasacable Ø20 mm (4 pcs)
1 x Soporte conector MPX empotrado (6 pcs)
1 x Soporte tubo Ø 6mm (10 pcs)
1 x Encendido para motor DLE 111/120/170
1 x Carburador DLE 170
1 x Bomba Combustible RX V2
1 x Bomba de humo JETs PowerBox 2 salidas
1 x Pipa bujía DLE-111
1 x Escape DLE 55
1 x Juntas motor DLE40
1 x Cilindro DLE 20-RA
1 x Cilindro DLE 30 - DLE 60
1 x Carburador DLE 30
1 x Carburador DLE 170M
1 x Carburador DLE 20
2 x Pasacables rectangular 40x15 mm (4 pcs)
1 x Motor DA 170
1 x Motor DA 120
1 x Motor DA 85
1 x Aceite Humo Blue 5 l
1 x Aceite rodamientos 25 ml
1 x Servo HITEC D950 TW
1 x Bancada servo alas HS80/HS81/82/85 (2 pcs)
1 x Servo HITEC HS-56 BB
1 x Servo HITEC HS-5087 MH
1 x Programador HPP-21 PLUS HITEC digital servos PC
1 x Servo HITEC HS-5475 HB Digi
1 x Ahesivo en spray AEROFIX 2
1 x Servo HITEC D85 MG
1 x Sandwich carbon + poplar 2mm + carbon 480x290 mm
1 x PIT (Aero-Naut)
1 x Helice FALCON 32,5x11 PUSHER Carbono
1 x Horn DUBRO 1/2A
1 x Tuerca autoempotrable M6 (4 pcs)
1 x Colector admision 90º Largo
1 x Servo KST DS125MG servo ala 10mm 28g 7Kg
1 x Tarjeta SD HC 8 GB
1 x SERVO DES 806 Piñones
1 x Arrancador EM Gear Power 80
1 x Base para servo
1 x Tuerca autoblocante M6 (10 pcs)
1 x Servo HBS 690BB HV Digital
1 x Tuerca para insertar hexagonal M4 Br (4 pcs)
1 x Tuerca autoblocante M3 aluminio azul (4 pcs)
1 x Tuerca autoempotrable M5 (4 pcs)
1 x Tuerca hexagonal M4 (20 pcs)
1 x Acople ALU M2 Ø 4 (2 uds)
1 x Horn aluminio LH largo L31xH30 (2pcs)
1 x Tapaporos 1000 ml (DOPE)
1 x Spray grafito 33
1 x Equilibrador hélices
1 x Carro remolque para veleros 720 x 285 mm
1 x Horn de mando largo con rodamiento (2 ud)
1 x Servo KST X06H - 1.8Kg.cm 7mm 6g
1 x Cera desmoldemante "Alta Temperatura" 340g
1 x Horn aluminio pequeño azul (2pcs)
1 x Tuerca hexagonal M1 (10 pcs)
1 x Tuerca hexagonal M1,6 (10 pcs)
1 x Servo KST X10 MINI ala 10mm 23g 7.5Kg
1 x Brazo servo aluminio HITEC HS-125MG/5125MG
1 x Soporte ECU Xicoy X-45
1 x Motor Moki 180
1 x Motor GAUI F-50R (rear intake)
1 x Soporte bomba Xicoy X45
1 x Soporte Angular conector XT-60 (2 pcs)
1 x Pipa Jet 40N-80N (200 mm)
1 x Colador protector turbina 83 x 32 mm
1 x Turbina JetsMunt M122 NG
17,946.74EUR
Fabricantes
Información del Fabricante
Jets Munt
Jets Munt Página Principal
Otros productos
Idiomas
Español English
Monedas