Top » Catalog » Acces. for Motors » Starters/CDi » SETOKW

16.00EUR

Opto Gas Engine Kill Switch
[SETOKW]

This kill switch is double Optically Coupled to isolate your ignition system from your radio system (No Interference!!). It also consist an additional safety functions.

Device features
• Includes a remote mountable ultra bright LED to indicate when the ignition is armed or not, or if the safety sequence protection is active.
• The LED diode informs also if Fail-Safe occured during flight (even after landing).
• Safety sequence protection for engine ignition powering up after model preparation.
• Double optically Coupled input/output is Isolated.
• Turning engine ignition ON or OFF directly from RC Transmitter
• No need to use additional mechanical switch for disconnecting ignition battery.
• 8 Bit microcontroller powered directly from RC receiver.
• 3,0 - 24,0 Volt Li-Po/Li-Ion/A123/Ni-Mh/NiCad Input (receiver side).
• 3,0 - 20,0 Volt Li-Po/Li-Ion/A123/Ni-Mh/NiCad MOSFET Output (ignition side).
• Possible to use one battery setup (independent two batteries setup by default).
• Max. current output: 5 Amp continous, 16 Amp peak
• Fail-Safe engine kill when interference or signal lose is longer then 1 second. (this function can be turned OFF).
• PPM-PCM 2048 – 1024 & 2.4Ghz Interface Support.
• Low Voltage Drop – Less than 150mv.
• 100% Surface Mount Technology.
• Heavy Gauge Wires 22AWG, universal connectors Futaba/JR.
• Small and light weight – only 15 Grams!

This device plugs into a spare receiver channel.

This is a must have safety device for any gas powered plane! This device allows you to safely kill your engine at anytime (on the ground, or inthe air!)

temporarily out of stock

Reviews

Customers who bought this product also purchased

Spark motor OS nº 3

temporarily out of stock

Quick Find

Shopping Cart

2 x	Futaba male 40 cm extension
1 x	Extension silicon 30 cm female (Graupner)
1 x	Extension silicon 10 cm (Futaba)
1 x	Extension S-Bus 1-2 silicon 120 cm FUTABA
1 x	Futaba Female 40 cm extension
1 x	Extension silicon 75 cm (Futaba)
1 x	Extension silicon 50 cm (Futaba)
1 x	0,14 mm PVC servo wire extension, ZH micro conector.
1 x	Extension PVC 150 cm (Graupner)
1 x	Cable silicona macho batt. receptor 30 cm (Graupner)
2 x	Extension silicon 10 cm (Graupner)
1 x	Cable silicona female batt. receptor 30 cm (Futaba)
1 x	Extension silicon 50 cm (Graupner)
1 x	Extension silicon 25 cm (Futaba)
1 x	Cabel "Y" 30 cm (graupner)
1 x	Extension silicon 35 cm (Futaba)
1 x	Extension silicon 100 cm (Graupner)
1 x	servo adapter lead, JST-SH socket - JR male Pin, for GR-12SH+HoT
1 x	Extension silicon 100 cm (Futaba)
1 x	silicon 100 cm Futaba Extension Ø 0,35 mm
2 x	Futaba Female 40 cm extension
1 x	Pine wood slat 10x10x1000 mm
1 x	BALSA triangular 15x15x1000 mm
1 x	Pine wood slat 5.0x5.0x1000 mm
1 x	Liston HAYA 8 x 8 x 1000 mm
1 x	OBECHI sheet 2.0x3.0x1000 mm
2 x	Mahogany wood slat 3.0x3.0x1000 mm
3 x	BALSA trip 10x10x1000 mm
1 x	Beech dowels 2.0 x 1000 mm
2 x	Liston HAYA 10 x 10 x 1000 mm
1 x	BALSA trip 3.0x3.0x1000 mm
1 x	Pine wood slat 2.0x2.0x1000 mm
1 x	Linden wood slat 3.0x3.0x1000 mm
1 x	Beech dowels 10 mm x 1000 mm
1 x	BALSA triangular 6x6x1000 mm
1 x	BALSA trip 5.0x5.0x1000 mm
1 x	Linden wood slat 2.0x2.0x1000 mm
1 x	BALSA trip 4.0x4.0x1000 mm
1 x	BALSA trip 2.0x2.0x1000 mm
1 x	BALSA trip 2.0x10.0x1000 mm
1 x	Walnut wood slat 3.0x3.0x1000 mm
2 x	BALSA triangular 8x8x1000 mm
1 x	Pine wood slat 2.0x10.0x1000 mm
1 x	Mahogany wood slat 2.0x2.0x1000 mm
1 x	Walnut wood slat 2.0x2.0x1000 mm
1 x	Pine wood slat 3.0x7.0x1000 mm
1 x	Ventus 1:4 set of instruments
1 x	Circlick securite
1 x	Extension silicon 30 cm male (Futaba)
1 x	Extension silicon 35 cm male (Futaba)
1 x	Tube Pitot to PIXHAWK
1 x	Yellow smoke canister 65 g
1 x	ABS tube 5.0x4.0x156 mm
1 x	CF tube set (Ø 38 mm y Ø 14 mm)
1 x	Civilian pilot "Curt" size 9cm (Slimline)
1 x	Extension silicon 25 cm (Graupner)
1 x	Blue metalic ball link M2/2 azul (2 pcs)
1 x	Ball link M2,5 (10 pcs)
1 x	14x60 mm Mini rings Tie Wraps (4 pcs)
1 x	Cable S.BUS 3 salidas 300 mm
1 x	Carbon fiber rod 1.0 mm x 1000 mm
1 x	Balsa panel 2.0x100x1000 mm
2 x	A/C quality beech plywood 600x300x6.0 mm
1 x	A/C quality beech plywood 600x300x5.0 mm
1 x	A/C quality beech plywood 600x300x5.0 mm
1 x	Beech dowels 3.0 x 1000 mm
1 x	Birch plywood plate 600x300x1.5 mm
1 x	Pine wood slat 6.0x6.0x1000 mm
1 x	3 LiPo XH>EH adapter
1 x	PVC 0,25 qmm 4 line servos wire JR/Graupner (5 m)
1 x	Cabel "Y" 30 cm (Futaba)
1 x	Silicone 0,25 qmm servos wire Graupner (5 m)
1 x	Silicone 0,50 qmm servos wire Futaba (100 m)
1 x	Cabel charger transmitter GRAUPNER
1 x	Black copper lacquer wire Ø0,2 mm (5 m)
1 x	PVC 0,08 qmm Graupner servos wire (5 m)
1 x	3 copper lacquer wire Ø0,2 mm (1 m)
1 x	2 LiPo XH>EH adapter
1 x	Cable Cargador FUTABA
1 x	Balance "Y" Wire 5S, 2x JST-XH / 1x JST-EH
1 x	Red copper lacquer wire Ø0,2 mm (5 m)
1 x	Silicone 0,14 qmm servos wire Graupner (100 m)
1 x	Aluminium ignition bad (blue)
1 x	Selfstarr DLE55, EME55/60, DLA56, SE 55
1 x	Propeller POWER-PROP 7x7
1 x	Power MULTIlight
1 x	10 mm gas motor standoff
1 x	110x55 mm C SLH KOVO wheel
1 x	Junta humo metalica G55 (DLE55/DLE111/DLE222)
1 x	115x29 mm (4.50") Type jets aluminium core wheel
1 x	200 mm extensión servo HITEC/JR
1 x	1/12 Pilot "Langley"
1 x	1/7 Pilot "Japanese"
1 x	1/10 Pilot "Jimmy"
1 x	120x60 mm C SLH KOVO wheel
1 x	1/10 Pilot "Jack"
1 x	Compact on-board starting system (9715)
1 x	GLOW 2C + accesories
1 x	Exhaust elbow for SAITO FA65/72/80/82a/91S/100/
1 x	1/4 Pilot "Heidi"
1 x	O-ring Saito FG-73 5cyl
1 x	1/12 Pilot "Cougar"
1 x	1/12 Pilot "Tom"
1 x	"Taxi Tank" Fuel Tank
1 x	160 mm carbon undercarriage (2pcs)
1 x	1/6 Pilot "Garry"
1 x	101x28 mm (4.0") Type jets aluminium core wheel
1 x	152x46 Ø6.0 mm aluminium core wheel
1 x	Opto Gas Engine Kill Switch
1 x	BALSA triangular 10x10x1000 mm
1 x	Red aluminium servo arm V2-Futaba 1,25" inch M3
1 x	aluminium servo arm V2-JR 2,0 inch M3
1 x	50x45 mm micro-mini servo cover
1 x	Servo TOPMODEL S7520 MG
1 x	Rudder 2_Tray 4~4.5 inch
1 x	Red aluminium servo arm V3-Futaba 1,0inch
1 x	Red aluminium servo arm V1-Futaba 15 mm iM2
1 x	Blue aluminium servo arm V2-Hitec 1,0 inch M3
1 x	Rudder 2_Tray 4.5~5 inch
1 x	Red aluminium servo arm V1-Futaba 20 mm M2
1 x	Rudder 2_Tray 3.5~4 inch
1 x	Red aluminium servo arm V3-Futaba 1,25inch M3
1 x	Red aluminium servo arm V2-Futaba 2,0 inch
1 x	Blue aluminium servo arm V1-Hitec 1,25" inch M3
1 x	Blue aluminium servo arm V1-Hitec 1,0" inch M2
1 x	Blue aluminium servo arm V2-Hitec 1,75" inch M3
1 x	Servo Mount S (red)
1 x	Red aluminium servo arm V2-Futaba 17 mm iM2
1 x	Oracover light Grey 2m
1 x	Monokote ROJO misil (1.8x0.65m)
1 x	Tapping Screw M2.2x13 (10 pcs)
1 x	Screw M3x30 (10 pcs)
1 x	Screw M3x8(10 pcs)
1 x	13 mm wing servo holder
1 x	Digital Air Speed Sensor And Pitot Tube Set
1 x	12,7x1000 mm 2:1 green termoretract tube
1 x	30 cm BEC cable (male)
1 x	135 mm PVC transparent battery termo-retract 68 mm (1 m)
1 x	5 LiPo XH>EH adapter
1 x	2,0x50 mm allen screwdriver
1 x	58 mm PVC transparent battery termo-retract 68 mm (1 m)
1 x	2 mm male connector (2 pcs) with safety connector
1 x	2,4x1000 mm 2:1 black termoretract tube
1 x	Concave-Convex sandpaper file 13 mm
1 x	Battery LiPo GRE18 600 mAh 7.4v
1 x
1 x	Ciano KAVAN Medium 20g
1 x	Cable coupler M2 (10 uds)
1 x	Connectors banna gold 5,5 mm (M/F)
1 x	DPSI 2001 RV
1 x	DPSI Micro SingleBat 5.9V/7.2V F3A Edition magnetic switch
1 x	45 mm aluminium spinner (Kavan)
1 x	150 mm inflatable superlight deluxe wheel (2 pcs)
1 x	Birch plywood plate 600x300x1.2 mm
1 x	Combustible Glow "KAVAN" air/heli 15% nitro
1 x	Combo KAVAN PRO 3536-1000 + RAY 40 SB
1 x	Connectors MPX 8 pins with support (black) 1 pair (male-female)
1 x	Extension 6 lipos XH > EH
1 x	Contacto macho pin conector (10 pcs)
1 x	120x60 mm SLH KOVO wheel
1 x	Propeller APC 11x6 Glow/Gas
1 x	Compact on-board starting system (9713)

3,482.44EUR